2A4G2-AG-NEONWireless RF Controller Addressable RGB Lights

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction

ShenzhenAirgooTechnologyCo.,Ltd.. ModelDifference Productdescription:WirelessRFControllerAddressableRGBLights Modelname:AG-NEON-DLS30-2 AG-NEON-LS2,AG-NEON-LS3,AMDRGB0002,AGCL0011, AGCL0012,MINILED-02,AGUSB0004,AG-PSUCABLE-02, AGML0013 TradeName:N/A FCCID:2A4G2-AG-NEON AllthemodelarethesamecircuitandRFmodule,onlyformodelname. Regards Sincerely Client’ssignature: Client’sname/title:ZHAOZHI(N/A) Contactinformation/address:2Floor,Building1,No.10QinghuaRoad,LonghuaStreet,Longhua District,Shenzhen,China

C5266091_X8_Ed.1 1/1 LetterofAuthorization <ShenzhenAirgooTechnologyCo.,Ltd.> Company:ShenzhenAirgooTechnologyCo.,Ltd.. Address:2Floor,Building1,No.10QinghuaRoad,LonghuaStreet,Longhua District,Shenzhen,China ProductName:WirelessRFControllerAddressableRGBLights ModelNumber:AG-NEON-DLS30-2 AG-NEON-LS2,AG-NEON-LS3,AMDRGB0002,AGCL0011, AGCL0012,MINILED-02,AGUSB0004,AG-PSUCABLE-02, AGML0013 FCCIdentifier:2A4G2-AG-NEON WeauthorizeLGAITechnologicalCenterS.A.,RondadelaFontdelCarme,s/n, 08193Bellaterra,Spain,toactonourbehalfonallmattersconcerningthe abovenamedequipment. AnyindividualwithinLGAITechnologicalCenterS.A.isauthorizedtoactonour behalfandtakeactionontheapplication. WedeclarethatauthorizeLGAITechnologicalCenterS.A.,RondadelaFontdel Carme,s/n,08193Bellaterra,Spain,isallowedtoforwardallinformation relatedtotheapprovalprojecttotheFederalCommunicationCommissionand todiscussanyissuesconcerningtheapprovalapplication.Anyandallacts carriedoutbyLGAITechnologicalCenterS.A.onourbehalfshallhavethe sameeffectasactsofourown. Name:ZHAOZHIDate:2022-02-21 Title:N/A Signatureofapplicant:

C5266091_X10_Ed.1 1/1 <ShenzhenAirgooTechnologyCo.,Ltd.> OfficeofEngineeringTechnology FederalCommunicationsCommission 7435OaklandMillsRoad Columbia,MD21046 Date:2022-02-21 Subject:RequestforConfidentiality FCCID:2A4G2-AG-NEON ToWhomItMayConcern, PursuanttotheprovisionsofSections0.457and0.459ofCommission'srules (47CFR0.457,0.459),wearerequestingtheCommissiontowithholdthefollowing attachment(s)asconfidentialdocumentfrompublicdisclosure. ExhibitsLong-Term Confidentiality Short-Term Confidentiality IDLabel/LocationNoNo AttestationStatementNoNo ExternalPhotosNo BlockDiagram Schematics TestReportNoNo TestSetupPhotosNo User’sManual InternalPhotos PartsList/TuneUp RFExposureInfo OperationalDescription CoverLetter(s)NoNo SDRSoftware/SecurityInfoNo Abovementioneddocumentcontainsdetailedsystemandequipmentdescriptionare consideredasproprietaryinformationinoperationoftheequipment.Thepublic disclosureofabovedocumentsmightbeharmfultoourcompanyandwouldgive competitoranunfairadvantageinthemarket. Itisourunderstandingthatallmeasurementtestreports,FCCIDlabelformatand correspondentduringcertificationreviewprocesscannotbegrantedasconfidential documentsandthoseinformationwillbeavailableforpublicreviewoncethegrantof equipmentauthorizationisissued. Sincerely, Signature: Name:ZHAOZHI Title:N/A

EUTPHOTO(ExternalPhotos)

Label and label location Wireless RF Controller Addressable RGB Lights FCC ID:2A4G2-AG-NEON

EUTPHOTO(InternalPhotos) ANT ※※※※※ENDOFREPORT※※※※※

Project No.: ZKT-2202150638E Page 1 of 29 FCC TEST REPORT FCC ID: 2A4G2-AG-NEON Report Number. .............................. : ZKT-2202150638E Date of Test ........................................ Feb. 11, 2022 to Feb. 18, 2022 Date of issue .................................... : Feb. 18, 2022 Total number of pages ...................... 29 Test Result ..................................... : PASS Testing Laboratory. ........................ : Shenzhen ZKT Technology Co., Ltd. Address .......................................... : 1/F, No. 101, Building B, No. 6, Tangwei Community Industrial Avenue, Fuhai Street, Bao'an District, Shenzhen, China Applicant's name ......................... : Shenzhen Airgoo Technology Co., Ltd. Address .......................................... : 2 Floor, Building 1, No.10 Qinghua Road, Longhua Street, Longhua District, Shenzhen, China Manufacturer's name ................... : Shenzhen Dongfang Qiyi Photoelectric Technology Co., Ltd. Address .......................................... : 4th Floor, 6th Building, Xitian Fourth Industrial Zone, Gongming, Guangming New District, Shenzhen Test specification: Standard ........................................... : FCC CFR Title 47 Part 15 Subpart C Section 15.231 ANSI C63.10:2013 Test procedure ................................. : / Non-standard test method ............. : N/A Test Report Form No. .................... : TRF-EL-108_V0 Test Report Form(s) Originator .... : ZKT Testing Master TRF .................................... : Dated: 2020-01-06 This device described above has been tested by ZKT, and the test results show that the equipment under test (EUT) is in compliance with the FCC requirements. And it is applicable only to the tested sample identified in the report. This report shall not be reproduced except in full, without the written approval of ZKT, this document may be altered or revised by ZKT, personal only, and shall be noted in the revision of the document. Product name ................................. : Wireless RF Controller Addressable RGB Lights Trademark ...................................... : airgoo Model/Type reference ...................... : AG-NEON-DLS30-2 AG-NEON-LS2, AG-NEON-LS3, AMDRGB0002, AGCL0011, AGCL0012, MINILED-02, AGUSB0004, AG-PSUCABLE-02, AGML0013 Ratings ............................................. : DC 3V Battery Project No.: ZKT-2202150638E Page 2 of 29 Testing procedure and testing location: Testing Laboratory ................................... : Shenzhen ZKT Technology Co., Ltd. Address ...................................................... :1/F, No. 101, Building B, No. 6, Tangwei Community Industrial Avenue, Fuhai Street, Bao'an District, Shenzhen, China Alen He Tested by (name + signature) .................... : Joe Liu Reviewer (name + signature) ..................... : Lake Xie Approved (name + signature) .................... : Project No.: ZKT-2202150638E Page 3 of 29 Table of Contents Page 1. VERSION 5 2. SUMMARY OF TEST RESULTS 6 2.1 TEST FACILITY 7 2.2 MEASUREMENT UNCERTAINTY 7 3.GENERAL INFORMATION 8 3.1 GENERAL DESCRIPTION OF EUT 8 3.2 DESCRIPTION OF TEST MODES 9 3.3 BLOCK DIGRAM SHOWING THE CONFIGURATION OF SYSTEM TESTED 9 3.4 DESCRIPTION OF SUPPORT UNITS(CONDUCTED MODE) 9 3.5 EQUIPMENTS LIST FOR ALL TEST ITEMS 10 4. EMC EMISSION TEST 12 4.1 CONDUCTED EMISSION MEASUREMENT 12 4.1.1 POWER LINE CONDUCTED EMISSION LIMITS 12 4.1.2 TEST PROCEDURE 13 4.1.3 DEVIATION FROM TEST STANDARD 13 4.1.4 TEST SETUP 13 4.1.5 EUT OPERATING CONDITIONS 13 4.1.6 TEST RESULTS 13 4.2 RADIATED EMISSION MEASUREMENT 14 4.2.1 RADIATED EMISSION LIMITS 14 4.2.2 TEST PROCEDURE 15 4.2.3 TEST SETUP 16 4.2.4 EUT OPERATING CONDITIONS 17 4.2.5 TEST RESULTS 17 5.1 APPLIED PROCEDURES / LIMIT 22 5.2 TEST PROCEDURE 22 5.3 DEVIATION FROM STANDARD 22 5.4 TEST SETUP 22 5.5 EUT OPERATION CONDITIONS 22 5.6 TEST RESULTS 23 6. CALCULATION OF AVERAGE FACTOR 24 7. DWELL TIME 26 7.1 APPLICABLE STANDARD 26 7.2 TEST PROCEDURE 26 7.5 EUT OPERATION CONDITIONS 26 7.6 TEST RESULTS 27 Project No.: ZKT-2202150638E Page 4 of 29 Table of Contents Page 8. ANTENNA REQUIREMENT 28 9. TEST SETUP PHOTO 29 10. EUT CONSTRUCTIONAL DETAILS 29 Project No.: ZKT-2202150638E Page 5 of 29 1. VERSION Report No. Version Description Approved ZKT-2202150638E Rev.01 Initial issue of report Feb. 18, 2022 Project No.: ZKT-2202150638E Page 6 of 29 2. SUMMARY OF TEST RESULTS Test procedures according to the technical standards: FCC Part15 (15.231) , Subpart C Standard Section Test Item Judgment Remark 15.207 Conducted Emission N/A 15.209,15.231b Fundamental &Radiated Spurious Emission Measurement PASS 15.231c Occupy Bandwidth PASS 15.231a Dwell time PASS 15.203 Antenna Requirement PASS NOTE: (1)” N/A” denotes test is not applicable in this Test Report Project No.: ZKT-2202150638E Page 7 of 29 2.1 TEST FACILITY Shenzhen ZKT Technology Co., Ltd. Add. : 1/F, No. 101, Building B, No. 6, Tangwei Community Industrial Avenue, Fuhai Street, Bao'an District, Shenzhen, China FCC Test Firm Registration Number: 692225 Designation Number: CN1299 IC Registered No.: 27033 CAB identifier: CN0110 2.2 MEASUREMENT UNCERTAINTY The reported uncertainty of measurement y ± U，where expended uncertainty U is based on a standard uncertainty multiplied by a coverage factor of k=2，providing a level of confidence of approximately 95 %。 No. Item Uncertainty 1 3m camber Radiated spurious emission(9KHz-30MHz) U=4.5dB 2 3m camber Radiated spurious emission(30MHz-1GHz) U=4.8dB 3 3m chamber Radiated spurious emission(1GHz-6GHz) U=4.9dB 4 3m chamber Radiated spurious emission(6GHz-40GHz) U=5.0dB 5 Conducted disturbance U=3.2dB 6 RF Band Edge U=1.68dB 7 RF power conducted U=1.86dB 8 RF conducted Spurious Emission U=2.2dB 9 RF Occupied Bandwidth U=1.8dB 10 RF Power Spectral Density U=1.75dB 11 humidity uncertainty U=5.3% 12 Temperature uncertainty U=0.59°C Project No.: ZKT-2202150638E Page 8 of 29 3. GENERAL INFORMATION 3.1 GENERAL DESCRIPTION OF EUT Equipment Wireless RF Con…

Text truncated - open the document above for the full version.

EUTTESTPHOTO