2A6G4-YAI707Remote control

Producer: Shenzhen Y.love Technology Co., Ltd. Add: No.9, Xinmu Xinyuan Industrial Park, Pinghu Longgang, Shenzhen, China 1.You must charge the toy in a safe place. 2. Water-based lube is suggested as lubricant. Do not apply massage oil or hand cream to the toy surface. 3.Stop using it if you feel uncomfortable or you find the toy is no longer smooth or has sharp edges. 4. Not recommended to use it below one meter in the water. 5.After use, the toy should be cleaned immediately. Warm water and soap can be used to clean the toy, with special detergent,disinfectant or 75% alcohol sometimes.Long term use is not recommended. 6. Wash thoroughly with clean water flow. 7. Do not expose to direct sunlight for long time. 8.Store it well beyond the reach of children. 9. The product contains lithium battery. Please put it in the non-recycle bin for disposal. 10. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. 11. Children shall not play with the appliance. 12. Cleaning and user maintenance shall not be made by children without supervision. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment . This transmitter must not be colocated or operating in conjunction with any other antenna or transmitter. FCC WARNING Product/remote 400mAh/170mAh rechargeable lithium battery

U.S. AGENT LETTER OF ATTESTATION Date: 2026-7-16 FEDERAL COMMUNICATIONS COMMISSION Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements CFR 47 §2.911(d)(7) Filing FCC ID: 2A6G4-YAI707 Shenzhen Y.love Technology Co., Ltd. certifies that, as of the date of the application, Iconsigh is our designated U.S. agent for service of process for the above referenced FCC ID. Shenzhen Y.love Technology Co., Ltd. (“the Applicant”) accepts to maintain an agent for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-related proceeding involving the equipment. Iconsigh accepts, as of the date of the filing of the application, the obligation of the designated U.S. agent for service of process for the above referenced FCC ID. Designated U.S. Agent Information: Company Name: Iconsigh Address: 2310 Homestead Road, Suite C1, Los Altos, CA, 94024, USA FRN: 0033398652 Tel.: +1 (408) 320-9867 Email: [email protected] Signed by (printed name): Benjamin Kaur Signature: Applicant: Shenzhen Y.love Technology Co., Ltd. Address: No.9,Xinmu Xinyuan Industrial Park, Pinghu, Longgang, Shenzhen,Guangdong, China FRN: 0032266355 Tel: 13189709310 Email: [email protected] Signed by (printed name): Eva Xiong Signature:

Bay Area Compliance Laboratories Corp. (Dongguan) EXHIBIT No.: 2602U63608E-RF-EXP Page 1 / 5 EUT EXTERNAL PHOTOS Bay Area Compliance Laboratories Corp. (Dongguan) EXHIBIT No.: 2602U63608E-RF-EXP Page 2 / 5 Bay Area Compliance Laboratories Corp. (Dongguan) EXHIBIT No.: 2602U63608E-RF-EXP Page 3 / 5 Bay Area Compliance Laboratories Corp. (Dongguan) EXHIBIT No.: 2602U63608E-RF-EXP Page 4 / 5 Bay Area Compliance Laboratories Corp. (Dongguan) EXHIBIT No.: 2602U63608E-RF-EXP Page 5 / 5 *****END *****

Bay Area Compliance Laboratories Corp. (Dongguan) EXHIBIT No.: 2602U63608E-RF-INP Page 1 / 6 EUT INTERNAL PHOTOS Bay Area Compliance Laboratories Corp. (Dongguan) EXHIBIT No.: 2602U63608E-RF-INP Page 2 / 6 Bay Area Compliance Laboratories Corp. (Dongguan) EXHIBIT No.: 2602U63608E-RF-INP Page 3 / 6 Bay Area Compliance Laboratories Corp. (Dongguan) EXHIBIT No.: 2602U63608E-RF-INP Page 4 / 6 Bay Area Compliance Laboratories Corp. (Dongguan) EXHIBIT No.: 2602U63608E-RF-INP Page 5 / 6 Antenna Bay Area Compliance Laboratories Corp. (Dongguan) EXHIBIT No.: 2602U63608E-RF-INP Page 6 / 6 *****END *****

Bay Area Compliance Laboratories Corp. (Dongguan) Report No.: 2602U63608E-RF-00 Report Template Version: FCC-15.231a-V2.0 Page 30 of 30 EXHIBIT C - RF EXPOSURE EVALUATION Applicable Standard §1.1307(b)(3)(i) For single RF sources (i.e., any single fixed RF source, mobile device, or portable device, as defined in paragraph (b)(2) of this section): A single RF source is exempt if: (A) The available maximum time-averaged power is no more than 1 mW, regardless of separation distance. This exemption may not be used in conjunction with other exemption criteria other than those in paragraph (b)(3)(ii)(A) of this section. Medical implant devices may only use this exemption and that in paragraph (b)(3)(ii)(A); Measurement Result Frequency (MHz) Maximum EIRP 1-mW Test Exemption dBm mW 433.92 -27.92 0.002 Compliant Note: 1. This device maximum E-Field level is 67.28 dBμV/m at 3m, so the EIRP power is -27.92 dBm. 2. Pout EIRP(dBm)=Field Strength of Fundamental(dBuV/m)-95.2 Result: Compliant. RF Exposure is exemption. ****** END OF REPORT*****

Report Template Version: FCC-15.231a-V2.0 Page 1 of 30 TEST REPORT Applicant: Shenzhen Y.love Technology Co., Ltd. Address: No.9,Xinmu xinyuan Industrial Park,Pinghu Longgang,Shenzhen City,China Product Name: Remote control FCC ID: 2A6G4-YAI707 Standard(s): 47 CFR Part 15, Subpart C(15.231) ANSI C63.10-2020 Report Number: 2602U63608E-RF-00 Report Date: 2026/8/3 The above device has been tested and found compliant with the requirement of the relevant standards by Bay Area Compliance Laboratories Corp. (Dongguan). Reviewed By:Alice Tan Approved By: Pedro Yun Title: Project Engineer Title: RF Supervisor Bay Area Compliance Laboratories Corp. (Dongguan) No.12, Pulong East 1 st Road, Tangxia Town, Dongguan, Guangdong, China Tel: +86-769-86858888 Fax: +86-769-86858891 www.baclcorp.com.cn Note: The information marked ▲ is provided by the applicant, the laboratory is not responsible for its authenticity and this information can affect the validity of the result in the test report. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested. This report cannot be reproduced except in full, without prior written approval of the Company. This report is valid only with a valid digital signature. The digital signature may be available only under the Adobe software above version 7.0. This report may contain data that are not covered by the accreditation scope and shall be marked with ★.This report must not be used by the client to claim product certification, approval, or endorsement by NVLAP, NIST, or any agency of the U.S. Government. Each test item follows the test standard(s) without deviation. Bay Area Compliance Laboratories Corp. (Dongguan) Report No.: 2602U63608E-RF-00 Report Template Version: FCC-15.231a-V2.0 Page 2 of 30 CONTENTS DOCUMENT REVISION HISTORY ................................................................................................ 4 1. GENERAL INFORMATION .......................................................................................................... 5 1.1 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ............................................................. 5 1.2 ACCESSORY INFORMATION ...................................................................................................................... 5 1.3 ANTENNA INFORMATION DETAIL▲ ........................................................................................................ 5 1.4 EQUIPMENT MODIFICATIONS ................................................................................................................... 5 2. SUMMARY OF TEST RESULTS .................................................................................................. 6 3. DESCRIPTION OF TEST CONFIGURATION ........................................................................... 7 3.1 EUT OPERATION CONDITION .................................................................................................................. 7 3.2 EUT EXERCISE SOFTWARE ...................................................................................................................... 7 3.3 SUPPORT EQUIPMENT LIST AND DETAILS ............................................................................................... 7 3.4 SUPPORT CABLE LIST AND DETAILS ........................................................................................................ 7 3.5 BLOCK DIAGRAM OF TEST SETUP ............................................................................................................ 7 3.6 TEST FACILITY .......................................................................................................................................... 8 3.7 MEASUREMENT UNCERTAINTY ................................................................................................................ 8 4. REQUIREMENTS AND TEST RESULT ...................................................................................... 9 4.1 AC LINE CONDUCTED EMISSIONS ........................................................................................................... 9 4.2 RADIATION EMISSIONS ........................................................................................................................... 10 4.2.1 Applicable Standard ........................................................................................................................................... 10 4.2.2 EUT Setup .......................................................................................................................................................... 11 4.2.3 EMI Test Receiver & Spectrum Analyzer Setup ................................................................................................ 12 4.2.4 Test Procedure .................................................................................................................................................... 13 4.2.5 Corrected Amplitude & Margin Calculation ...................................................................................................... 13 4.2.6 Test Result .......................................................................................................................................................... 14 4.3 20 DB EMISSION BANDWIDTH: ............................................................................................................... 20 4.3.1 Applicable Standard ........................................................................................................................................... 20 4.3.2 EUT Setup .......................................................................................................................................................... 20 4.3.3 Test Procedure .................................................................................................................................................... 20 4.3.4 Test Result ....................................................…

Text truncated - open the document above for the full version.

Bay Area Compliance Laboratories Corp. (Dongguan) EXHIBIT No.: 2602U63608E-RF-00-TSP Page 1 / 3 TEST SETUP PHOTOGRAPHS Radiated Emission 9k-30MHz Parallel View Radiated Emission 9k-30MHz Perpendicular View Bay Area Compliance Laboratories Corp. (Dongguan) EXHIBIT No.: 2602U63608E-RF-00-TSP Page 2 / 3 Radiated Emission 9k-30MHz Ground-parallel View Radiated Emission 30M-1GHz View Bay Area Compliance Laboratories Corp. (Dongguan) EXHIBIT No.: 2602U63608E-RF-00-TSP Page 3 / 3 Radiated Emission Above 1GHz View *****END *****