2A72Z-D-01Kids Walkie Talkies

T his device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. RF Exposure Statement SAR tests are conducted using standard operating positions According FCC standards with the device transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. This model product has been tested and meets the FCC RF exposure guidelines with the test distance 25 mm for face up condition. The highest SAR1g value is 0.052 W/Kg. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC exposure requirements, and should be avoided. This radio complies with FCC exposure limits for general population/uncontrolled RF exposure environment at operating duty factors of up to 50%

Shenzhen Moliao technology co., LTD Federal Communications Commission Authorization and Evaluation Division Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 8/30/2024 U.S. Agent Designation Shenzhen Moliao technology co., LTD acknowledges their consent for the following contact located in the United States to act as their agent for service of process for the equipment for which authorization is sought (FCC ID: 2A72Z-D-01): Name and company of U.S. agent: UUX GROUP INC Physical U.S. address of agent: 36 South 18th Avenue, Suite A Brighton, CO USA 80601 FRN of U.S. agent: 0033701590 Email address of U.S. agent: [email protected] UUX GROUP INC acknowledges their obligation to accept service of process on behalf of Shenzhen Moliao technology co., LTD. Shenzhen Moliao technology co., LTD with the FRN 0032693111 accepts its obligation to maintain an agent for service of process in the United States for no less than one year after either the grantee has permanently terminated all marketing and importation of the applicable equipment within the U.S., or the conclusion of any Commission-related administrative or judicial proceeding involving the equipment, whichever is later. By signing this form, we confirm the above and that we are aware of the application requirements listed under § 2.911(d)(7). The information provided in this letter is based on the referenced rule parts of Title 47 of the CFR as well as KDB 986446 D01. An expiration date for this letter does not exist. In case the U.S. agent changes, the grantee is obligated to notify the FCC within 30 days via the granting TCB. Sincerely, Signature Kaizhi Huang Manager Shenzhen Moliao technology co., LTD Signature Jack Fu Manager UUX GROUP INC 48_[model] US_Agent_2.911(d)(7) - U, V05

FCC ID: 2A72Z-D-01 FCC ID: 2A72Z-D-01 FCC ID: 2A72Z-D-01

FCC ID: 2A72Z-D-01

FCC ID: 2A72Z-D-01 Antenna FCC ID: 2A72Z-D-01

Page1of18 CALIBRATIONDATA PROBECALIBRATIONDATA Page2of18 Page3of18 Page4of18 Page5of18 Page6of18 Page7of18 Page8of18 Page9of18 Page10of18 DAECALIBRATIONDATA Page11of18 Page12of18 Page13of18 DIPOLECALIBRATION DATA Page14of18 Page15of18 Page16of18 Page17of18 Page18of18

Note: This device has been tested and found to comply with the standard(s) listed, this test report merely corresponds to the test sample. It is not permitted to copy extracts of these test result without the written permission of the test laboratory. This report shall not be reproduced except in full, without the written approval of Guangdong Asia Hongke Test Technology Limited. If there is a need to alter or revise this document, the right belongs to Guangdong Asia Hongke Test Technology Limited, and it should give a prior written notice of the revision document. This test report must not be used by the client to claim product endorsement. Guangdong Asia Hongke Test Technology Limited B1/F, Building 11, Junfeng Industrial Park, Chongqing Road, Heping Community, Fuhai Street, Bao'an District, Shenzhen, Guangdong, China. TEST REPORT Product Name : Kids Walkie Talkies Brand Name : N/A Model : D-01 Series Model : N/A FCC ID : 2A72Z-D-01 Applicant : Shenzhen Moliao technology co., LTD Address : 416, Floor 4, Building 36, Bantian 3rd Industrial Zone, Bantian Community,Bantian Street, Longgang District, Shenzhen Manufacturer : Shenzhen Moliao technology co., LTD Address : 416, Floor 4, Building 36, Bantian 3rd Industrial Zone, Bantian Community,Bantian Street, Longgang District, Shenzhen Standard(s) : FCC CFR Title 47 Part 95B Date of Receipt : July 22, 2024 Date of Test : July 23, 2024~ Aug 23, 2024 Issued Date : Aug 26, 2024 Issued By: Guangdong Asia Hongke Test Technology Limited B1/F, Building 11, Junfeng Industrial Park, Chongqing Road, Heping Community, Fuhai Street, Bao'an District, Shenzhen, Guangdong, China Tel.: +86 0755-230967639 Fax.: +86 0755-230967639 Reviewed by: Approved by: Leon.yi Sean She Page 2 of 23 Report No.: AiTDG-240722001FW1 Report Revise Record Report Version Issued Date Notes M1 Aug 26, 2024 Initial Release Page 3 of 23 Report No.: AiTDG-240722001FW1 Contents 1 TEST SUMMARY .................................................................................................................................................... 4 1.1 TEST STANDARDS ......................................................................................................................................................... 4 1.2 TEST SUMMARY ........................................................................................................................................................... 4 1.3 TEST FACILITY .............................................................................................................................................................. 5 1.4 MEASUREMENT UNCERTAINTY ........................................................................................................................................ 5 2 GENGENERAL INFORMATION ................................................................................................................................ 6 2.1 ENVIRONMENTAL CONDITIONS ........................................................................................................................................ 6 2.2 GENERAL DESCRIPTION OF EUT ...................................................................................................................................... 6 2.3 DESCRIPTION OF TEST MODES AND TEST FREQUENCY .......................................................................................................... 6 2.4 SPECIAL ACCESSORIES ................................................................................................................................................... 7 2.5 EQUIPMENT LIST FOR THE TEST ....................................................................................................................................... 7 3 TEST CONDITIONS AND RESULTS ........................................................................................................................... 8 3.1 MAXIMUM TRANSMITTER POWER ................................................................................................................................... 8 3.2 OCCUPIED BANDWIDTH AND EMISSION MASK ................................................................................................................. 11 3.3 MODULATION CHARACTERISTIC ..................................................................................................................................... 14 3.4 FREQUENCY STABILITY ................................................................................................................................................. 18 3.5 TRANSMITTER RADIATED SPURIOUS EMISSION ................................................................................................................. 20 4 TEST SETUP PHOTOGRAPHS OF EUT .................................................................................................................... 23 5 EXTERNAL PHOTOGRAPHS OF EUT ...................................................................................................................... 23 6 INTERNAL PHOTOGRAPHS OF EUT ...................................................................................................................... 23 Page 4 of 23 Report No.: AiTDG-240722001FW1 1 TEST SUMMARY 1.1 Test Standards The tests were performed according to following standards: FCC Rules Part 95: PERSONAL RADIO SERVICES. ANSI C63.10: 2013: American National Standard for Testing Unlicensed Wireless Devices ANSI C63.26:2015: American National Standard of procedures for compliance testing of transmitters used in licensed radio services. 1.2 Test Summary Description of Test Item Standard clause Verdict Maximum Transmitter Power FCC Part 95.567 PASS Modulation Characteristic FCC Part 2.1047 FCC Part 95.575 PASS Occupied Bandwidth and Emission Mask FCC Part 2.1049 FCC Part 95.573 FCC Part 95.579 PASS Radiated Spurious Emission FCC Part 95.579 PASS Frequency Stability FCC Part 2.1055 FCC Part 95.565 PASS Page 5 of 23 Report No.: A…

Text truncated - open the document above for the full version.

Page1of38 SARTestReport ReportNo.:AGC01516240801FH01 FCCID: 2A72Z-D-01 PRODUCTDESIGNATION: KidsWalkieTalkies BRANDNAME: N/A MODELNAME: D-01 APPLICANT: ShenzhenMoliaotechnologyco.,LTD DATEOFISSUE: Aug.21,2024 STANDARD(S): IEEEStd.1528:2013 FCC47CFRPart2§2.1093 IEEEStdC95.1™-2005 REPORTVERSION: V1.0 AttestationofGlobalCompliance(Shenzhen)Co.,Ltd. ReportNo.:AGC01516240801FH01 Page 2 of 38 ReportReviseRecord ReportVersionReviseTimeIssuedDateValidVersionNotes V1.0/Aug.21,2024ValidInitialRelease ReportNo.:AGC01516240801FH01 Page 3 of 38 TestReport ApplicantNameShenzhenMoliaotechnologyco.,LTD ApplicantAddress 416,Floor4,Building36,Bantian3rdIndustrialZone,BantianCommunity, BantianStreet,LonggangDistrict,Shenzhen ManufacturerNameShenzhenMoliaotechnologyco.,LTD ManufacturerAddress 416,Floor4,Building36,Bantian3rdIndustrialZone,BantianCommunity, BantianStreet,LonggangDistrict,Shenzhen FactoryNameShenzhenMoliaotechnologyco.,LTD FactoryAddress 416,Floor4,Building36,Bantian3rdIndustrialZone,BantianCommunity, BantianStreet,LonggangDistrict,Shenzhen ProductDesignationKidsWalkieTalkies BrandNameN/A ModelNameD-01 EUTVoltageDC3.7V ApplicableStandard IEEEStd.1528:2013 FCC47CFRPart2§2.1093 IEEEStdC95.1™-2005 DateofreceiptoftestitemAug.09,2024 TestDateAug.16,2024 ReportTemplateAGCRT-US-PTT/SAR(2021-04-20) Note:Theresultsoftestinginthisreportapplytotheproduct/systemwhichwastestedonly. PreparedBy TheaHuang (ProjectEngineer) Aug.21,2024 ReviewedBy CalvinLiu (Reviewer) Aug.21,2024 ApprovedBy MaxZhang (AuthorizedOfficer) Aug.21,2024 ReportNo.:AGC01516240801FH01 Page 4 of 38 TABLEOFCONTENTS 1.SUMMARYOFMAXIMUMSARVALUE...........................................................................................................5 2.GENERALINFORMATION................................................................................................................................6 2.1.EUTDESCRIPTION..........................................................................................................................................6 3.SARMEASUREMENTSYSTEM.........................................................................................................................7 3.1.THEDASY5SYSTEMUSEDFORPERFORMINGCOMPLIANCETESTSCONSISTSOFFOLLOWINGITEMS....................7 3.2.DASY5E-FIELDPROBE..................................................................................................................................8 3.3.DATAACQUISITIONELECTRONICSDESCRIPTION.................................................................................................8 3.4.ROBOT...........................................................................................................................................................9 3.5.LIGHTBEAMUNIT............................................................................................................................................9 3.6.DEVICEHOLDER............................................................................................................................................10 3.7.MEASUREMENTSERVER................................................................................................................................10 3.8.PHANTOM..................................................................................................................................................11 4.SARMEASUREMENTPROCEDURE.............................................................................................................12 4.1.SPECIFICABSORPTIONRATE(SAR)...............................................................................................................12 4.2.SARMEASUREMENTPROCEDURE.................................................................................................................13 5.TISSUESIMULATINGLIQUID.........................................................................................................................15 5.1.THECOMPOSITIONOFTHETISSUESIMULATINGLIQUID.....................................................................................15 5.2.TISSUEDIELECTRICPARAMETERSFORHEADANDBODYPHANTOMS...............................................................15 5.3.TISSUECALIBRATIONRESULT.........................................................................................................................16 6.SARSYSTEMCHECKPROCEDURE.............................................................................................................17 6.1.SARSYSTEMCHECKPROCEDURES..............................................................................................................17 7.EUTTESTPOSITION.......................................................................................................................................19 7.1.TESTPOSITION.............................................................................................................................................19 8.SAREXPOSURELIMITS.................................................................................................................................20 9.TESTFACILITY................................................................................................................................................21 10.TESTEQUIPMENTLIST................................................................................................................................22 11.MEASUREMENTUNCERTAINTY..................................................................................................................23 12.POWERMEASUREMENT..............................................................................................................................27 13.TESTRESULTS.............................................................................................................................................28 13.1.SARTESTRESULTSSUMMARY...................................................................................................................28 APPENDIXA.SAR…

Text truncated - open the document above for the full version.

FCC ID: 2A72Z-D-01