2A83O-EGHFS7Wmotion sensor light

Manual Instructions Regulator max. (clockwise) = maximum reach (approx.8m) Regulator min. (counterclockwise) = minimum reach (approx.1m) Regulator max. (clockwise) = longest time (approx.5 min.) Regulator min. (counterclockwise) = shortest time (approx.5 sec.) Regulator max. (clockwise) = maximum Lux (approx.3000) Regulator min. (counterclockwise) = minimum Lux (approx.1) The response threhold for the light can be steplessly adjusted between approximately 1-3000 Lux Tips: cloudy room is about 5-50 Lux, the evening room is about 10 Lux 0.3W 20 2450MHz
± 50MHz (a) Equipment authorized under Supplier's Declaration of Conformity shall include a compliance statement that contains the information set forth in § 2.1077 of this chapter and a statement identical or similar to the following: "This device complies with part 18 of the FCC Rules." (b) The compliance information may be placed in the instruction manual, on a separate sheet, on the packaging, or electronically as permitted under §2.935 of this chapter. There is no specific format for this information. §18.212 Compliance information. Information on the following matters shall be provicded to the user in the instruction manual or on the packaging if an instruction manual is not provided for any type of ISM equipment: (a) The interference potential of the device or system (b) Maintenance of the system (c) Simple measures that can be taken by the user to correct interference. (d) Manufacturers of RF lighting devices must provide an advisory statement, either on the productpackaging or with other user documentation, similar to the following: This product may cause interference to radio equipment and should not be installed near maritime safety communications equipment or other critical navigation or communication equipment operating between 0.45-30 MHz. Variations of this language are permitted provided all the points of the statement are addressed and may be presented in any legible font or text style. §18.213 Information to the user.

DATE:2022-10-21 Federal Communications Commission Authorization & Evaluation Division 7345 Oakland Mills Road Columbia, Maryland 21046 Authority to Act asAgent On our behalf, I appoint Jason Wu of Global United Technology Services Co., Ltd.and No. 123- 128, Tower A, Jinyuan Business Building, No.2, Laodong Industrial Zone, Xixiang Road, Baoan District, Shenzhen, Guangdong, China to act as our agent in the preparation of this application for equipment certification. I certify that submitted documents properly describe the device or system for which equipment certification is sought. I also certify that each unit manufactured, imported or marketed, as defined in the Federal Communications Commission’s regulations will have affixed to it a label identical to that submitted for approval with this application. For instances where our authorized agent signs the application for certification on our behalf, I acknowledge that all responsibility for complying with the terms and conditions for certification, still resides with Shenzhen Qianyue electronic Co., Ltd. and 5F 4.Building Shankeng Neihuan Road Longgang Shenzhen China Signature: Name: Qian Long Title: Vice manager Company: Shenzhen Qianyue electronic Co., Ltd.

Differences Declaration To whom concern, We company Shenzhen Qianyue electronic Co., Ltd. hereby declares: The product models EGHFS7W, EGHF12W, ENL02W, EHFS12W, ENL05W are identical in the same PCB layout, interior structure and electrical circuits, The differences are housing appearance, size, color and model name for commercial purpose. Authorized signature: Date: 2022-10-21

Shenzhen Qianyue electronic Co., Ltd. DATE : 2022-10-21 Equipment Autorisation Division Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 FCC ID: 2A83O--EGHFS7W Product Name: motion sensor light Request for Confidentiality Pursuant to Sections 0.457 and 0.459 of the commissions rules, we hereby request that the following documents be held confidential:  Schematics  Block diagram  Operation description These materials contain trade secrets and proprietary information and are not customarily released to the public. The public disclosure of this information might be harmful to the company and provide unjustified benefits to our competitors. Signature: Name: Qian Long Title: Vice manager Company: Shenzhen Qianyue electronic Co., Ltd.

FCC ID: 2A83O-EGHFS7W

FCC ID: 2A83O-EGHFS7W RF Exposure Evaluation Limits The criteria listed in the following table shall be used to evaluate the environment impact of human exposure to radio frequency (RF) radiation as specified in 1.1307(b) Limits for Maximum Permissible Exposure (MPE) Frequency range (MHz) Electric field strength (V/m) Magnetic field strength (A/m) Power density (mW/cm 2 ) Averaging time (minutes) (A) Limits for Occupational/Controlled Exposures 0.3–3.0 614 1.63 *(100) 6 3.0–30 1842/f 4.89/f *(900/f 2 ) 6 30–300 61.4 0.163 1.0 6 300–1500 f/300 6 1500–100,000 5 6 (B) Limits for General Population/Uncontrolled Exposure 0.3–1.34 614 1.63 *(100) 30 1.34–30 824/f 2.19/f *(180/f 2 ) 30 30–300 27.5 0.073 0.2 30 300–1500 f/1500 30 1500–100,000 1.0 30 f = frequency in MHz Friis transmission formula: Pd = (Pout*G)/(4*pi*r 2 ) Where Pd = power density in mW/cm 2 , Pout = output power to antenna in mW; G = gain of antenna in linear scale, Pi = 3.1416; R = distance between observation point and center of the radiator in cm Pd id the limit of MPE, 1 mW/cm 2 . If we know the maximum gain of the antenna and the total power input to the antenna, through the calculation, we will know the distance r where the MPE limit is reached. Test Procedure Software provided by client enabled the EUT to transmit and receive data at lowest, middle and highest channel individually. FCC ID: 2A83O-EGHFS7W Test Result of RF Exposure Evaluation Frequency (MHz) RF power generated by equipment (dBm) RF power generated by equipment (mW) Power Density at R=20cm (mW/cm 2 ) Limit (mW/cm 2 ) Result 2400~2500 0 1 0.0002 1.0 PASS Antenna gain: 0dbi The max power density is less than MPE exempt limit, so it is compliance.

Global United Technology Services Co., Ltd. Report No.: GTS202209000111F01 Authorized Signature: Robinson Luo Laboratory Manager This results shown in this test report refer only to the sample(s) tested, this test report cannot be reproduced, except in full, without prior written permission of the company. The report would be invalid without specific stamp of test institute and the signatures of compiler and approver. Page 1 of 24 TEST REPORT Applicant: Shenzhen Qianyue electronic Co., Ltd. Address of Applicant: 5F 4.Building Shankeng Neihuan Road Longgang Shenzhen China Manufacturer/ Factory: Shenzhen Qianyue electronic Co., Ltd. Address of Manufacturer/ Factory: 5F 4.Building Shankeng Neihuan Road Longgang Shenzhen China Equipment Under Test (EUT) Product Name: motion sensor light Model No.: EGHFS7W, EGHF12W, ENL02W, EHFS12W, ENL05W FCC ID: 2A83O-EGHFS7W Applicable standards: FCC CFR Title 47 Part 18 Date of sample receipt: September 15, 2022 Date of Test: September 15, 2022-October 10, 2022 Date of report issued: October 11, 2022 Test Result : Pass * * In the configuration tested, the EUT complied with the standards specified above. Report No.: GTS202209000111F01 Global United Technology Services Co., Ltd. No. 123-128, Tower A,Jinyuan Business Building, No.2, Laodong Industrial Zone, Xixiang Road, Baoan District, Shenzhen, Guangdong, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 2 of 24 2 Version Version No. Date Description 00 October 11, 2022 Original Prepared by: Date: October 11, 2022 Project Engineer Reviewed by: Date: October 11, 2022 Reviewer Report No.: GTS202209000111F01 Global United Technology Services Co., Ltd. No. 123-128, Tower A,Jinyuan Business Building, No.2, Laodong Industrial Zone, Xixiang Road, Baoan District, Shenzhen, Guangdong, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 3 of 24 3 Contents 1 COVER PAGE ........................................................................................................................................... 1 2 VERSION .................................................................................................................................................. 2 3 CONTENTS .............................................................................................................................................. 3 4 TEST SUMMARY ..................................................................................................................................... 4 5 GENERAL INFORMATION ...................................................................................................................... 5 5.1 GENERAL DESCRIPTION OF EUT ......................................................................................................... 5 5.2 TEST MODE AND TEST VOLTAGE .......................................................................................................... 5 5.3 DESCRIPTION OF SUPPORT UNITS ....................................................................................................... 5 5.4 DEVIATION FROM STANDARDS ............................................................................................................. 5 5.5 ABNORMALITIES FROM STANDARD CONDITIONS .................................................................................... 5 5.6 TEST FACILITY .................................................................................................................................... 6 5.7 TEST LOCATION .................................................................................................................................. 6 6 TEST INSTRUMENTS LIST ..................................................................................................................... 7 7 TEST RESULTS AND MEASUREMENT DATA ...................................................................................... 9 7.1 RADIATED EMISSION ........................................................................................................................... 9 7.2 CONDUCTED EMISSIONS ................................................................................................................... 13 8 TEST SETUP PHOTO ............................................................................................................................ 16 9 EUT CONSTRUCTIONAL DETAILS ..................................................................................................... 18 Report No.: GTS202209000111F01 Global United Technology Services Co., Ltd. No. 123-128, Tower A,Jinyuan Business Building, No.2, Laodong Industrial Zone, Xixiang Road, Baoan District, Shenzhen, Guangdong, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 4 of 24 4 Test Summary Test Item Section in CFR 47 Result Radiated Emissions FCC Part18 Clause18.305 Pass Conducted Emissions AC power port FCC Part18 Clause18.307 Pass Frequency Range of Measurement FCC Part18 Clause18.309 Pass Prohibited frequency bands FCC Part18 Clause18.303 Note 1 Pass: The EUT comply with the essential requirements in the standard. Note 1: No intended operating frequency used in the prohibited bands Report No.: GTS202209000111F01 Global United Technology Services Co., Ltd. No. 123-128, Tower A,Jinyuan Business Building, No.2, Laodong Industrial Zone, Xixiang Road, Baoan District, Shenzhen, Guangdong, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 5 of 24 5 General Information 5.1 General Description of EUT Product Name: motion sensor light Model No.: EGHFS7W, EGHF12W, ENL02W, EHFS12W, ENL05W Test Model No: EGHFS7W Remark: All above models are identical in the same PCB layout, interior structure and electrical circuits. The differences are housing appearance, size, color and model name for commercial purpose. Test sample(s) ID: GTS202209000111-1 Sample(s) Status Engineer sample Microwave frequency: 2450± 50.0 MHz HF sensor output: 1mW …

Text truncated - open the document above for the full version.

Radiated Emission Conducted Emission