2AA2P-MRC101TXWMS500 Transmitter

For Technical Support Call: 1-800-843-7222 McKinley-Ross WaterSwitch™ Rev. 10/6/13 McKinley-Ross Installation/User Manual ™ WaterSwitch For Technical Support Call: 1-800-843-7222 Warnings SAFETY STATEMENT PLEASE REVIEW THE FOLLOWING SAFETY STATEMENTS BEFORE YOU BEGIN THIS INSTALLATION. BATTERY WARNINGS: Contains non-spillable, sealed, lead-acid battery and alkaline batteries. Batteries must be recycled or disposed of properly. At the end of battery useful life, under various state and local laws, it may be illegal to dispose of this battery into the municipal waste stream. Discard used batteries according to state and local laws. Dispose of the battery packs only at approved recycling or disposal sites. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Replace the internal battery pack only with a OEM recommended equivalent to avoid the risk of fire or explosion resulting in personal injury. USE ONLY CHARGER PROVIDED WITH UNIT. Do not recharge with adapters other than the ones supplied with this unit. Do not plug charger into extension cord, only plug into properly grounded electrical outlet. Do not submerge in water or allow any component in this system to get wet. This unit is not waterproof. WARNING: Operating Temperature. This product is designed for a maximum ambient temperature of 40° degrees C. WARNING: Install product in accordance with local and National Electrical Codes. 43 McKinley-Ross WaterSwitch™ For Technical Support Call: 1-800-843-7222 FCC/IC Statements: Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the in- structions, may cause harmful interference to radio communications. Howev- er, there is no guarantee that interference will not occur in a particular instal- lation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux con- ditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'uti- lisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. MODEL: McKinley-Ross Transmitter FCC ID: 2AA2P-MRC101TX IC: 11429A- MRC101TX This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 3 McKinley-Ross WaterSwitch™ WARNING EXPLOSIVE ATMOSPHERE: Do not install or operate the system in the presence of flammable gases or fumes. Operation of any electrical equipment in such an environment constitutes a definite safety hazard. WARNING ELECTRICAL SHOCK HAZARD: To avoid electrical shock hazard, disconnect power cord or turn off circuit breaker to all appliances BEFORE in- stalling appliance adapter and before removing covers from appliances. ESD CAUTION: This product uses components which can be damaged by electrostatic discharge (ESD). To avoid damage, be sure to follow proper procedures for handling, storing and transporting parts and subassemblies which contain ESD sensitive components. WARNING: Do not work on plumbing, equipment or cables during periods of lightning activity “Changes or modifications not expressly approved by McKinley-Ross Cor- poration could void the user's authority to operate the equipment.” Note, the critical element is that if the user modifies the device, they void any authority to operate the equipment. For Technical Support Call: 1-800-843-7222 Installation Notes 1. The WaterSwitch™ must be installed by a McKinley-Ross certified installer . 2. All paperwork must be filled out, signed and originals submitted to your dealer as part of the installation. 3. Complete Post-installation checklist. Cus- tomer Acceptance Form. 4. The owner will receive a Warranty Card and Owner’s Manual as part of the instal- lation. 5. WaterSwitch™ system customer familiari- zation accomplished and form signed. 6. Catch water that may drain from pipes and supply lines to avoid damage to floors and walls. 7. Some state and local codes require the unit to be installed by a licensed plumber. 8. Always follow local, state and national code. 41 McKinley-Ross WaterSwitch™ For Technical Support Call: 1-800-843-7222 Installer Notes 5 McKinley-Ross WaterSwitch™ Initial Inspection 6 Installing the Manifold 7 Installed Manifold 8 Installing Control Panel Mount 9 Installing Flow Switches 10 Installing Appliance Adapters 12 Installing Motion Sensors 14 Leak Check 15 Transmitter Wiring 16 Battery Installation 19 Sensor Setup 20 Transmitter Testing 28 Control Panel Wiring 30 Manifold Wiring 32 Transmitter Names 34 Manifold Diagram 36 Testing System 38 Inst…

Text truncated - open the document above for the full version.

McKinley-Ross Corporation 100 Winters St., West Point, VA 23181 Local: 804-843-7222 Fax: 804-843-2021 NoMoreWaterDamage.com 11/25/2013 To Whom It May Concern: We hereby delegate CKC Certification Services, LLC (CKC CS) power of attorney to act on our behalf in matters pertaining to certification of products. The actions of CKC CS shall be considered the same as our own. Sincerely, Tahsin Durak Director of Engineering McKinley-Ross Corporation

McKinley-Ross Corporation 100 Winters St., West Point, VA 23181 Local: 804-8 43-7222 Fax: 804-843-2021 NoMoreWaterDamage.com 1/13/2014 Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 Subject: Request for Permanent Confidentiality To whom it may concern: In accordance with 47CFR Section 0.457 and Section 0.459 pertaining to confidential material, we hereby request to hold permanently confidential all information contained within the below identified exhibits/document categories submitted pursuant to radio equipment certification requirements for FCC ID: 2AA2P-MRC101TX Block Diagram Schematics, Built of Materials, Operation description. The above material contains trade secrets and proprietary information as specified by 47CFR 0.457(d) and technical data, which would customarily be guarded from competitors. The public disclosure of this information might be harmful to our company and provide unjustified benefits to our competitors. Sincerely, Tahsin Durak Director of Engineering McKinley-Ross Corporation

External photos of McKinley-Ross Transmitter

MODEL: WMS500 Transmitter FCC ID: 2AA2P-MRC101TX IC: 11429A-MRC101TX This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This report contains a total of 99 pages and may be reproduced in full only. Partial reproduction may only be done with the written consent of CKC Laboratories, Inc. McKinley-Ross Corp. ADDENDUM TO TEST REPORT 94389-4 Water Switch Transmitter Model: WMS500 Tested To The Following Standards: FCC Part 15 Subpart C Sections 15.231 & RSS-210 Issue 8 Report No.: 94389-4A Date of issue: January 9, 2014 This test report bears the accreditation symbol indicating that the testing performed herein meets the test and reporting requirements of ISO/IEC 17025 under the applicable scope of EMC testing for CKC Laboratories, Inc. We strive to create long-term, trust based relationships by providing sound, adaptive, customer first testing services. We embrace each of our customers’ unique EMC challenges, not as an interruption to set processes, but rather as the reason we are in business. Page 2 of 99 Report No.: 94389-4A TABLE OF CONTENTS Administrative Information ......................................................................................................................................... 4 Test Report Information .......................................................................................................................................... 4 Revision History ....................................................................................................................................................... 4 Report Authorization ............................................................................................................................................... 4 Test Facility Information .......................................................................................................................................... 5 Software Versions .................................................................................................................................................... 5 Site Registration & Accreditation Information ........................................................................................................ 5 Summary of Results ................................................................................................................................................. 6 Conditions During Testing........................................................................................................................................ 6 Equipment Under Test ............................................................................................................................................. 7 Peripheral Devices ................................................................................................................................................... 7 FCC Part 15 Subpart C .................................................................................................................................................. 8 15.207 AC Conducted Emissions .............................................................................................................................. 8 15.31(e) Voltage Variations ..................................................................................................................................... 9 15.231(a) Types of Momentary Signals ................................................................................................................. 12 RSS-210 A1.1.1 / Types of Momentary Signals ...................................................................................................... 17 15.231(b) Field Strength of Fundamental & Spurious Emissions .......................................................................... 22 RSS-210 A1.1.2 / Field Strength of Fundamental & Spurious Emissions ............................................................... 35 15.231 (c) -20dBc Occupied Bandwidth ................................................................................................................ 48 RSS-210 A1.1.3 / 99% Bandwidth .......................................................................................................................... 52 15.231(d) Frequency Stability ................................................................................................................................ 56 RSS-210 A1.1.4 / Frequency Stability ..................................................................................................................... 56 15.231(e) Reduced Field Strengths ........................................................................................................................ 56 RSS-210 A1.1.5 / Reduced Field Strengths ............................................................................................................ 56 Page 3 of 99 Report No.: 94389-4A Appendix A: Test Date – 12/24/2013 ........................................................................................................................ 57 Summary of Results ............................................................................................................................................... 58 Conditions During Testing...................................................................................................................................... 58 Equipment Under Test ........................................................................................................................................... 59 Peripheral Devices ................................................................................................................................................. 59 FCC Part 15.231 ......................................................................................................................................................... 60 15.231(a) Types of Momentary Signals ................................................................................................................. 60 RSS-210 A1.1.1 / Types of Momentary Signals ..…

Text truncated - open the document above for the full version.

Test Setup 15.31e X - Axis Y - Axis Z – Axis Appendix A Testing X Axis Y Axis Z Axis