2AA35CF0378Remote Control

Direction for use 1. On the first use, please press the button at the end of the insole continually until the flashing LED light is GREEN. And then press the lock button of the remote control continually until the LED light is off. 2. Remote Control “1” (Power On) First gear, green LED light on the insoles “2” (Power On) Second gear, green LED light will flash slowly on the insoles “3” (Power On) Third gear, green LED light will flash quickly on the insoles “LOCK” (Power Off) Power off, green light is disappeared 3. Instruction for manual operation: First: Press the button at the end of the insole First gear, green LED light on the insoles Second: Press the button at the end of the insole Second gear, green LED light will flash slowly on the insoles Third: Press the button at the end of the insole Third gear, green LED light will flash quickly on the insoles Fourth: Press the button at the end of the insole Power off, green light should disappeared 4. The heated insoles can be cut according to your shoe size. 1. Please cut around the dimension lines (outside the white lines). Do not cut beyond the solid line as this may permanently damage the insole. 2. If you need to cut the heated insoles, please do not cut the heel area where the battery is located, you should only cut around the toe area. Charging When the heated insole is charging, the LED shows red. When it is fully charged, the RED light turns off. On the initial start, you should charge for 3-4 hours. Rechargeable Heated Insoles with Remote Control and three heat settings. 1 2 3 www.warmawear.com Thank you for purchasing , we also supply these fabulous products. Made in PRC DO NOT WASH clean with a damp cloth only Note: Before charging, switch off the insoles. You can recharge at anytime. Do not put into water, fire, or on high temperature places. Do not wear the for ball games or other sports activities. This item should only be used inside a shoe. Please do not clip or twine the USB cable, and do not disassemble the heating elements. Please do not insert sharp items in the insoles, such as pins. Please turn off the insoles when not in use. Do not disassemble the heating element or any of the inner parts. Properties Power 2.5W 0.5W *2PCS Battery 3.7V 1400mAh Lithium Polymer battery Charger 5.0V Double output Synthetic upper, Over charge protection. Working temperature and time Setting 1: up to 50°C (approx 3 Hours) Setting 2: up to 45°C (approx 5 Hours) Setting 3: up to 40°C (approx 7 Hours) Working temperature time depends on ambient temperature, these times are calculated on an Ambient temperature of -20°C to 10°C Heated Scarf CF0375 Heated Socks CF0094 Heated Gloves CF0373 Sizes NO.1 Size, EUR: 36-38, UK: 3½-5, USA: 4½-6 NO.2 Size, EUR: 39-41, UK: 6-7½, USA: 7-8½ NO.3 Size, EUR: 42-44, UK: 8-9½, USA: 8½-10½ NO.4 Size, EUR: 45-47, UK: 10½-12, USA: 11½-13 + – This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Shenzhen Leadfar Industry Co.,LTD Address: No.73 ShaTian North Road, ShaTian, KengZi, PingShan, ShenZhen, China 518122 Tel: 0755-28827937 Fax: 0755-84289965 2014-09-22 To: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD Confidentiality Request regarding application for certification of FCC ID: 2AA35CF0378 We hereby request confidential treatment of information accompanying this application as outlined below: - Schematics Diagram - Block Diagram - Operation description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 & 0.459 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Client’s name / title : Yuegui Chen /The development Manager Contact information / address : No.73 ShaTian North Road, ShaTian, KengZi, PingShan, China 518122 Tel: 0755-28827937 Fax: 0755-84289965

SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: 2AA35CF0378 Report No.:LCS1409150630E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 1 of 3 1. EXTERIOR PHOTOGRAPHS OF EUT Fig.1 Fig.2 SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: 2AA35CF0378 Report No.:LCS1409150630E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 2 of 3 Fig.3 Fig.4 SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: 2AA35CF0378 Report No.:LCS1409150630E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 3 of 3 Fig.5 Fig.6

SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD FCC ID:2AA35CF0378 Report No.:LCS1409150630E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd. Page 1 of 1 LABEL AND LOCATION Size:L:2cm*W:1.5cm Label And Location

SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: 2AA35CF0378 Report No.:LCS1409150630E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 1 of 2 1. INTERIOR PHOTOGRAPHS OF EUT Fig.1 Fig.2 SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: 2AA35CF0378 Report No.:LCS1409150630E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 2 of 2 Fig.3 Fig.4 Antenna

SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: 2AA35CF0378 Report No.: LCS1409150630E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 1 of 25 FCC TEST REPORT For Shenzhen Leadfar Industry Co., Ltd. Remote Control Model No.: CF0378 Additional model No.: CF0379 Prepared for : Shenzhen Leadfar Industry Co., Ltd. Address : No.73 ShaTian North Road, ShaTian, KengZi, PingShan, ShenZhen, China 518122 Prepared by : Shenzhen LCS Compliance Testing Laboratory Ltd. Address : 1/F., Xingyuan Industrial Park, Tongda Road, Bao’an Avenue, Bao’an District, Shenzhen, Guangdong, China Date of receipt of test sample : September 15, 2014 Number of tested samples : 1 Serial number : Prototype Date of Test : September 15, 2014 –September 22, 2014 Date of Report : September 22, 2014 SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: 2AA35CF0378 Report No.: LCS1409150630E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 2 of 25 FCC TEST REPORT FCC CFR 47 PART 15 C(15.231): 2013 Report Reference No. .............. : LCS1409150630E Date of Issue ................................ : September 22, 2014 Testing Laboratory Name ......... : Shenzhen LCS Compliance Testing Laboratory Ltd. Address ........................................ : 1/F., Xingyuan Industrial Park, Tongda Road, Bao’an Avenue, Bao’an District, Shenzhen, Guangdong, China Testing Location/ Procedure ........ : Full application of Harmonised standards ■ Partial application of Harmonised standards □ Other standard testing method □ Applicant’s Name ....................... : Shenzhen Leadfar Industry Co., Ltd. Address ........................................ : No.73 ShaTian North Road, ShaTian, KengZi, PingShan, ShenZhen, China 518122 Test Specification Standard ....................................... : FCC CFR 47 PART 15 Subpart C : 2013, ANSI C63.4-2003 Test Report Form No. ................ : LCSEMC-1.0 TRF Originator ............................ : Shenzhen LCS Compliance Testing Laboratory Ltd. Master TRF .................................. : Dated 2011-03 Shenzhen LCS Compliance Testing Laboratory Ltd. All rights reserved. This publication may be reproduced in whole or in part for non-commercial purposes as long as the Shenzhen LCS Compliance Testing Laboratory Ltd. is acknowledged as copyright owner and source of the material. Shenzhen LCS Compliance Testing Laboratory Ltd. takes no responsibility for and will not assume liability for damages resulting from the reader's interpretation of the reproduced material due to its placement and context. Test Item Description. ............... : Remote Control Trade Mark .................................. : N/A Model/ Type reference ................. : CF0378 Ratings ......................................... : DC 12.0V by Battery Result ......................................... : Positive Compiled by: Supervised by: Approved by: Jacky Li/ File administrators Danny Huang/ Technique principal Gavin Liang/ Manager SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: 2AA35CF0378 Report No.: LCS1409150630E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 3 of 25 FCC--TEST REPORT Type / Model........................... : CF0378 EUT......................................... : Remote Control Applicant............................... : Shenzhen Leadfar Industry Co., Ltd. Address.................................. : No.73 ShaTian North Road, ShaTian, KengZi, PingShan, ShenZhen, China 518122 Telephone............................... : 0755-28827937 Fax.......................................... : 0755-84289965 Manufacturer........................ : Shenzhen Leadfar Industry Co., Ltd. Address................................... : No.73 ShaTian North Road, ShaTian, KengZi, PingShan, ShenZhen, China 518122 Telephone............................... : 0755-28827937 Fax.......................................... : 0755-84289965 Factory................................... : Shenzhen Leadfar Industry Co., Ltd. Address................................... : No.73 ShaTian North Road, ShaTian, KengZi, PingShan, ShenZhen, China 518122 Telephone............................... : 0755-28827937 Fax.......................................... : 0755-84289965 Test Result Positive The test report merely corresponds to the test sample. It is not permitted to copy extracts of these test result without the written permission of the test laboratory. Test Report No. : LCS1409150630E September 22, 2014 Date of issue SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: 2AA35CF0378 Report No.: LCS1409150630E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 4 of 25 TABLE OF CONTENTS 1. GENERAL INFORMATION .................................................................................................................................. 5 1.1. DESCRIPTION OF DEVICE (EUT) ........................................................................................................................... 5 1.2. OBJECTIVE ............................................................................................................................................................ 5 1.3. ENVIRONMENTAL CONDITIONS............................................................................................................................. 5 1.4. HOST SYSTEM CONFIGURATION LIST AND DETAILS ............................................................................................. 6 1.5. EXTERNAL I/O PORT ............................................................................................................................................. 6 1.6. EUT OPERATION ........................................................…

Text truncated - open the document above for the full version.

SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: 2AA35CF0378 Report No.:LCS1409150630E _______________________________________________________________________________________________ This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 1 of 1 1. TEST SETUP PHOTOGRAPHS 1.1. Photo of Radiated Emissions Measurement (X Position) Fig.1 Fig.2