2AAEG-GFCS916LOW POWER REMOTE TRANSMITTER-MOMENTARILY OPERATED TRANSMITTER

Rev14 2013-09-15 FCC/IC 1 Brehon Agrisystems Inc. is not responsible or liable for indirect, special, or consequential damages arising out of or in connection with the use or performance of the product or other damage with respect to any economic loss, loss of property, loss of revenue or profit, or costs of removal, installation, or reinstallation. G.Force Remote Control SWING AUGER MOVER & FULL BIN ALARM XLDR Series INSTALLATION and OPERATING INSTRUCTIONS The G.Force Remote Control is designed to provide the ultimate in convenience and safety to perform tasks remotely. It is a radio frequency (RF) controlled device that allows operation of a motor, gate, chute, etc. from a hand held transmitter operated remotely. The Transmitter, which operates at 916 MHz FM, transmits encoded information to the Receiver, which then decodes the information and performs the desired function. When coupled with the electromechanical driver, this system may be used to operate a motor, open a swinging gate, close a chute, turn a valve, etc. The Transmitter and Receiver are designed to operate within 300' but actual range is dependent on operating environment. Features :  Simplicity of design and quality of engineering.  Power On/Off switch on Receiver Console  Direction Control switch on Console  LED Indicator lights.  9v Transmitter Battery  Ease of installation/removal when not in use.  All controls can be by either Manual Switch or Remote Control  Multiple Transmitters can operate a single Receiver.  Multiple Receivers can be operated by a single Transmitter.  Receivers are “Channel selectable”  Optional Auxiliary 12VDC output for remote-controlled light or other device Manufactured By: Brehon Agrisystems Inc. 102 – 2750 Faithful Ave. Saskatoon, SK S7K 6M6 (306) 933 2655 phone/fax Web: www.brehonag.com Email: [email protected] Rev14 2013-09-15 FCC/IC 2 Brehon Agrisystems Inc. is not responsible or liable for indirect, special, or consequential damages arising out of or in connection with the use or performance of the product or other damage with respect to any economic loss, loss of property, loss of revenue or profit, or costs of removal, installation, or reinstallation. Specifications: Transmitter: (FCC/IC Model GFCS916) Power: 9 volt dc battery Frequency: 916 MHz Modulation: FM Indicators: Power/Transmit Red LED Case Size: 2.5” x 4.2” x .8” Weight: .25 lb. Range: 300’+ (depending on environment) Antenna: 1.3” Fixed Mini Tuned Security Code: Preprogrammed unique identifier Functions: 2 to 9 Button (depending on Model) Receiver: (FCC/IC Model GFCS916) Power In: 12 vdc Power Out: 12 vdc @ 100 amps max Standby: 40mA Power Input: 4ga. 2-conductor wire with “powerpole” connectors Indicators: Power On Red LED Receive/Learn RF Data Yellow LED Channel Active Green LED Options: Multi-Channel Operation (1-4) Main Power On/Off Switch Manual Switch Control Antenna: 3” Flexible Tuned Compliance Statement: This device complies with part 15 of the FCC Rules / Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation estautorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit acceptertout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. Rev14 2013-09-15 FCC/IC 3 Brehon Agrisystems Inc. is not responsible or liable for indirect, special, or consequential damages arising out of or in connection with the use or performance of the product or other damage with respect to any economic loss, loss of property, loss of revenue or profit, or costs of removal, installation, or reinstallation. Electric Motor Drive Electrical: 12vdc @ 100A Full Load Torque: 1125 in-lb Speed: 60 rpm no load Output Shaft: ¾” keyed and drilled Duty Cycle: 5% Overall Size: 4” x 6” x 15” Weight: 16 lb. MECHANICAL ASSEMBLY DRAWING Rev14 2013-09-15 FCC/IC 4 Brehon Agrisystems Inc. is not responsible or liable for indirect, special, or consequential damages arising out of or in connection with the use or performance of the product or other damage with respect to any economic loss, loss of property, loss of revenue or profit, or costs of removal, installation, or reinstallation. INSTALLATION INSTRUCTIONS Mechanical Installation: The G.Force Swing Auger Mover is designed to clamp directly onto the swing auger tube at the lowest point. Using the six 7/16 x 2-1/2” bolts provided, tighten the clamp around the tube such that the main beam is horizontal when the hopper is on level ground and the auger is at its normal working height. Clamps are available for 10”, 12”, 13”, 14” and 16” Augers. There is a grease nipple located on each axle sleeve. Grease before first operation and thereafter, as needed. Think Safety: Do Not install or operate where damage to property or persons may occur. MOUNTING POSITION Clamp the Swing Auger Mover Drive at the lowest point possible on the swing auger tube so that, on level ground, the Main Beam is level without extending the jack, and all of the wei ght is off the inside wheels of hopper. Rev14 2013-09-15 FCC/IC 5 Brehon Agrisystems Inc. is not responsible or liable for indirect, special, or consequential damages arising out of or in connection with the use or performance of the product or other damage with respect to any economic loss, loss of property, loss of revenue or profit, or costs of removal, installation, or reinstallation. Electrical Installation: The G.Force Swing Auger Mover is provided with pre-cut wire lengths with color-coded connectors attached. Cable Schedule: Tractor Power Cable - 12’ c/w Red/Black PowerPole Connector. Conso…

Text truncated - open the document above for the full version.

Transmitter Label: This device complies with part 15 of the FCC Rules / Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC ID 2AAEG-GFCS916 IC ID 11133A-GFCS916 Size: 5/8” x 1” This label would be applied on the back exterior of the transmitter case immediately below the belt clip. Receiver Label: Replace “Trade name” with “G. Force Systems” Replace “Model number” with “Model: GFCS916” Add Industry Canada mark “IC” on RHS of label Size: 1” x 2” This label would be applied on the exterior of the receiver enclosure.

Transmitter Label: This device complies with part 15 of the FCC Rules / Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC ID 2AAEG-GFCS916 IC ID 11133A-GFCS916 Size: 5/8” x 1” This label would be applied on the back exterior of the transmitter case immediately below the belt clip. Receiver Label: Replace “Trade name” with “G. Force Systems” Replace “Model number” with “Model: GFCS916” Add Industry Canada mark “IC” on RHS of label Size: 1” x 2” This label would be applied on the exterior of the receiver enclosure.

Test Report Serial No.: 180913-T1252-E-15O Report Issue Date: 9/26/2013 Measurement Date(s): Sept 13-Sept 20, 2013 Report Revision No.: Revision 1.0 FCC Rule Part(s): 47 CFR §2; §15.231 FCC Test Firm Reg. No.: Accredited IC Standard(s): RSS-210 RSS-Gen IC Test Site No.: IC 3874A-1 Test Lab Certificate No. 2470.01 Applicant: Brehon Agrisystems Inc. FCC ID: 2AAEG-GFCS916 IC: 11133A-GFCS916 DUT Model: GFCS916 DUT Type: Transmitter Remote Control Tx Freq.: 916 MHz 2012 Celltech Labs Inc. This document is not to be reproduced in whole or in part without the prior written permission of Celltech Labs Inc. Page 1 of 18 Compliance Test Report RF MEASUREMENT REPORT FCC & IC Name CELLTECH LABS INCORPORATED Test Lab Information Address 21-364 Lougheed Road, Kelowna, British Columbia V1X 7R8 Canada FCC Accredited (ISO 17025 - A2LA Test Lab Certificate No. 2470.01) Test Lab Registration No.(s) IC 3874A-1 Name Brehon Agrisystems Inc. Applicant Information Address 102-2750 Faithfull Ave., Saskatoon, SK, S7K 6M6 FCC 47 CFR Part 2; 15.231, 15B IC RSS-210 Issue 8; RSS-Gen Issue 3 Standard(s) & Procedure(s) ANSI C63.4-2003 FCC Part 15 Periodic Operational Devices (DSC) Device Classification(s) IC Low-power License-exempt Momentarily Operated Devices (Category 1) Application Type FCC/IC New Certification FCC ID: 2AAEG-GFCS916 Device Identifier(s) IC ID: 11133A-GFCS916 Device Under Test (DUT) Remote control momentarily operated transmitter. Device Model(s) Tested GFCS916 This wireless device has demonstrated compliance with the applicable technical standards as indicated in the measurement report and was tested in accordance with the measurement procedures specified in FCC 47 CFR Rule Part 2 and Rule Part 15.231; Industry Canada RSS-210, RSS-Gen; and ANSI C63.4-2003. I attest to the accuracy of data. All measurements were performed by me or were made under my supervision and are correct to the best of my knowledge and belief. I assume full responsibility for the completeness of these measurements and vouch for the qualifications of all persons taking them. The results and statements contained in this report pertain only to the device(s) evaluated. This test report shall not be reproduced partially, or in full, without the prior written approval of Celltech Labs Inc. Test Report Approved By Glen Westwell Celltech Labs Inc. Test Report Serial No.: 180913-T1252-E-15O Report Issue Date: 9/26/2013 Measurement Date(s): Sept 13-Sept 20, 2013 Report Revision No.: Revision 1.0 FCC Rule Part(s): 47 CFR §2; §15.231 FCC Test Firm Reg. No.: Accredited IC Standard(s): RSS-210 RSS-Gen IC Test Site No.: IC 3874A-1 Test Lab Certificate No. 2470.01 Applicant: Brehon Agrisystems Inc. FCC ID: 2AAEG-GFCS916 IC: 11133A-GFCS916 DUT Model: GFCS916 DUT Type: Transmitter Remote Control Tx Freq.: 916 MHz 2012 Celltech Labs Inc. This document is not to be reproduced in whole or in part without the prior written permission of Celltech Labs Inc. Page 2 of 18 TABLE OF CONTENTS 1.0 REFERENCES .................................................................................................................................................... 4 1.1 Normative References ......................................................................................................................................... 4 2.0 PASS/FAIL CRITERIA......................................................................................................................................... 4 3.0 FACILITIES AND ACCREDITATIONS ................................................................................................................ 5 4.0 GENERAL INFORMATION ................................................................................................................................. 5 4.1 DUT Description & Specifications........................................................................................................................ 5 DEVICE OPERATION ............................................................................................................................................... 6 5.0 FIELD STRENGTH OF THE FUNDAMENTAL AND SPURIOUS EMISSIONS.................................................. 7 5.1 References .......................................................................................................................................................... 7 5.2 Limits ................................................................................................................................................................... 7 5.3 Environmental conditions .................................................................................................................................... 7 5.4 Equipment list ...................................................................................................................................................... 8 5.5 Test Measurement Configuration. ....................................................................................................................... 9 6.0 OCCUPIED BANDWIDTH ................................................................................................................................. 13 6.1 References ........................................................................................................................................................ 13 6.2 Limits ................................................................................................................................................................. 13 6.3 Environmental conditions .................................................................................................................................. 13 6.4 Setup drawing.................................................................................................................................................... 13 6.5 Test Data: ...............................................................................................…

Text truncated - open the document above for the full version.