2AANA-SEM-Q7Clock Radio With USB Charger

OPERATING INSTRUCTIONS MODEL: Q-7-BTPFU2 2x USB-CHARGING SPEAKER SYSTEM WITH FM PLL RADIO TUNER AND ALARM CLOCK E-2 WARNING: To reduce the risk of electric shock, do not remove cover (or back). No user-serviceable parts inside. Refer servicing to qualified service personnel. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The exclamation point within the triangle is a warning sign alerting you of important instructions accompanying the product. The lightning flash and arrowhead within the triangle is a warning sign alerting you of "dangerous voltage" inside the product. CAUTION DO NOT EXPOSE TO DRIPPING OR SPLASHING LIQUIDS! NOTE: CAUTION SYMBOLS ARE PRINTED ON REAR OF UNIT. PLEASE REFER TO INSTRUCTION MANUAL. WARNING:TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO DRIPPING OR SPLASHING LIQUIDS. PLEASE NOTE: YOU WILL FIND THE RATING LABEL FOR THIS PRODUCT LOCATED ON THE REAR OF THE UNIT. THE APPARATUS SHOULD NOT BE EXPOSED TO DRIPPING OR SPLASHING AND NO OBJECTS FILLED WITH LIQUIDS SHOULD BE PLACED ON THE APPARATUS. THE MARKING AND RATING LABEL IS LOCATED AT REAR ENCLOSURE OF THE APPARATUS. UNDER THE INFLUENCE OF ELECTROSTATIC PHENOMENON, THE PRODUCT MAY MALFUNCTION AND USER TO POWER RESET. BATTERY SHOULD NOT BE EXPOSED TO EXCESSIVE HEAT SUCH AS SUNSHINE, FIRE OR THE LIKE. CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE. The device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the product. NOTE: This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures : -Reorient or relocate the receiving antenna. -Increase the separation between the product and receiver. - Connect the product into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. E-4 E-3 LOCATION OF CONTROLS 1. SPEAKER 2. LED DISPLAY 3. BACK-UP BATTERY COMPARTMENT (BOTTOM OF UNIT) 4. USB-1 SOCKET (DC CHARGER: 5V/1000mA) 5. USB-2 SOCKET (DC CHARGER: 5V/500mA) 6. VOLUME DOWN ( ) KEY 7. VOLUME UP ( ) KEY 8. MEMORY KEY 9. SLEEP KEY 10. ON/ OFF KEY 11. SKIP ( ) / SEARCH ( ) KEY 12. SKIP ( ) / SEARCH ( ) KEY 13. AL-SET/ AL-MODE KEY 14. FUNCTION/ CL-SET KEY 15. PLAY/ PAUSE / PAIR KEY 16. SNOOZE/ DIMMER KEY 17. AUX INPUT SOCKET 18. DC JACK (DC 5V ) 19. FM ANTENNA WIRE - - - FRONT VIEW: BACK VIEW: 1 TOP VIEW: 3 6 7 8910 1112 13 14 15 16 17 18 19 2 4 5 AC OPERATION (EXTERNAL AC-DC POWER ADAPTOR) - THIS SET IS EQUIPPED WITH A "DC-JACK" CAPABLE OF ACCEPTING AC-ADAPTORS WITH A RATING OF DC = 5V, 2A, AND WITH A PLUG WITH THE FOLLOWING POLARITIES AS SHOWN (CENTER POSITIVE) : - PLEASE USE ONLY THE SUPPLIED AC-ADAPTOR TO OPERATE THE UNIT. USE OF OTHER ADAPTORS MAY DAMAGE THE UNIT OR CAUSE IT TO MALFUNCTION. - PLUG THE TAIL END OF THE AC-ADAPTOR INTO THE DC-JACK (SOCKET) ON THE REAR OF THE UNIT. - INSERT THE PLUG OF THE AC-ADAPTOR INTO A WALL OUTLET WITH AC-POWER. - PRESS THE "ON/ OFF" KEY TO SWITCH ON THE UNIT. - THIS UNIT IS DESIGNED TO OPERATE WITHOUT EVER BEING TOTALLY POWERED "OFF". IT WILL EITHER BE "ON" OR IN "STANDBY MODE". - IN STANDBY MODE, THE BACK-LIGHT OF THE DIGITAL DISPLAY WILL BE DIMMED BUT THE DISPLAY WILL SHOW THE CURRENT TIME (CLOCK FUNCTION). - ANYTIME DURING STANDBY MODE, YOU CAN SWITCH "ON" THE UNIT BY PRESSING THE "ON/ OFF" KEY. - SAVE ENERGY BY SWITCHING THE SYSTEM TO "STANDBY" MODE WHEN NOT IN USE. POWER SUPPLY - OPEN THE BATTERY DOOR AT THE BOTTOM OF UNIT. - INSERT 2 PCS "AAA-CELL" (UM-4/LR03 TYPE) BATTERIES IN THE BATTERY COMPARTMENT. THESE 2 BATTERIES ARE FOR BACKUP OF THE "CLOCK" DURING BRIEF POWER OUTAGES. BACK UP BATTERIES - + DIMMER FUNCTION THIS SET HAS A DIMMER FUNCTION TO ADJUST THE BRIGHTNESS LEVEL OF THE DISPLAY BACKLIGHT. SIMPLY ADJUST IT AS DESIRED BY PRESSING THE SNOOZE/ DIMMER KEY REPEATEDLY (HI-BRIGHTNESS / LOW-BRIGHTNESS / OFF) THE DISPLAY BACKLIGHT WILL ALWAYS RETURN TO HI-BRIGHTNESS AS THE DEFAULT, AFTER THE UNIT BEEN RESET. DIGITAL CLOCK FUNCTION - THE SET HAS A BUILT-IN DIGITAL CLOCK. (THE DISPLAY WILL CONTINUOUSLY SHOW THE CURRENT TIME). HOW TO SET CORRECT TIME: SWITCH UNIT TO "STAND-BY" MODE PRESS & HOLD FUNC./ CL-SET KEY FOR 3 SECONDS DISPLAY SHOWS HOUR OR HOUR (FLASHING) 12H 24H PRESS SKIP- / SEARCH- OR SKIP+ /SEARCH+ KEY TO SELECT 12-HOUR OR 24-HOUR CLOCK DISPLAY SYSTEM & PRESS FUNC./CL-SET KEY TO CONFIRM YOUR SELECTION. PRESS REPEATEDLY TO SET THE CORRECT HOUR IN THE DISPLAY & PRESS TO CONFIRM. SKIP- / SEARCH- OR SKIP+ /SEARCH+ KEY FUNC./ CL-SET KEY CORRECT TIME IS NOW SET & WILL BE SHOWN IN THE DISPLAY. PRESS REPEATEDLY TO SET THE CORRECT MINUTE IN THE DISPLAY & PRESSTO CONFIRM SKIP- / SEARCH- OR SKIP+ /SEARCH+ KEY FUNC./ CL-SET KEY 1. 2. 3. 4. 5. 6. E-6 E-5 ALARM FUNCTION - THIS SET IS EQUIPPED WITH 2 ALARM MODES: BUZZER RADIO. BEFORE SETTING THE ALARM, MAKE SURE TO SET THE CLOCK (SEE "DIGITAL CLOCK FUNCTION" IN THE PREVIOUS SECTION) . AND PREPARE FOR THE ALARM SETTIN…

Text truncated - open the document above for the full version.

FCC ID: 2AANA-SEM-Q7 External Photo FCC ID: 2AANA-SEM-Q7 FCC ID: 2AANA-SEM-Q7 FCC ID: 2AANA-SEM-Q7

FCC ID: 2AANA-SEM-Q7 Internal Photo FCC ID: 2AANA-SEM-Q7 FCC ID: 2AANA-SEM-Q7 FCC ID: 2AANA-SEM-Q7 FCC ID: 2AANA-SEM-Q7 FCC ID: 2AANA-SEM-Q7 FCC ID: 2AANA-SEM-Q7 FCC ID: 2AANA-SEM-Q7 FCC ID: 2AANA-SEM-Q7

Report No.: HKES141200240502 Page: 1 of 24 Authorized Signature: CHEN Jian-feng, Jeffrey The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of SGS IECC Limited or testing done by SGS IECC Limited in connection with, distribution or use of the product described in this report must be approved by SGS IECC Limited in writing. This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. FCC ID:2AANA-SEM-Q7 Member of the SGS Group (SGS SA) FCC Test Report Application No.: HKES141200240501 Applicant: S.E.M. INDUSTRIES Address: 35/F., Tower A, Billion Centre No.1 Wang Kwong Road, Kowloon Bay, Kowloon Hong Kong Product Information: Product Description: Clock Radio with USB Charger Model: Q-7-BTPFU2, Q-7-PFU2, Q-7-PFM3U2, Q-7-BTPFM3U2, Q-7-BT, Q-7, Q7 ♣ ♣ Please refer to section 2 of this report which indicates which item was actually tested and which were electrically identical. Brand Name: S.E.M/ S-LOGO/ NIL/ S-DIGITAL/ SDIGITAL/ S.E.M. AUDIO LABORATORIES Product Class : Low Power Communication Device – Transmitter (2.4 GHz) FCC ID: 2AANA-SEM-Q7 Requirement: CFR 47 FCC PART 15 SUBPART C, 2014 - Intentional Radiators (Section 15.249) Date of Receipt: 2014-12-08 Date of Test: 2015-01-09 to 2015-01-12 Date of Issue: 2015-01-20 Test Result : PASS* In the configuration tested, the EUT complied with the requirements for the relevant clauses of Federal Communications Commission Rules as specified above. Report No.: HKES141200240502 Page: 2 of 24 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. FCC ID: 2AANA-SEM-Q7 Member of the SGS Group (SGS SA) 2 Test Summary Test Test Requirement Test Method Result Conducted Emission (150KHz to 30MHz) FCC PART 15, SUBPART C: 2014 ANSI C63.4:2003 PASS Radiated Emission (9kMHz to 1GHz) FCC PART 15, SUBPART C: 2014 ANSI C63.4:2003 PASS Radiated Emission above 1 GHz FCC PART 15, SUBPART C: 2014 ANSI C63.4:2003 PASS Band edge / 20 dB Bandwidth FCC PART 15, SUBPART C: 2014 ANSI C63.4:2003 Marker-Detla measurement PASS ♣ Item no.: Q-7-BTPFU2, Q-7-PFU2, Q-7-PFM3U2, Q-7-BTPFM3U2, Q-7-BT, Q-7, Q7 According to the confirmation from the applicant, the above models are identical in all electrical aspects in relating to the circuit design, PCB layout and construction. The differences are the model no. trade name, color, cosmetic outlook and silkscreen. Therefore only the item Q-7-BTPFU2 was tested in this report. Report No.: HKES141200240502 Page: 3 of 24 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsificat…

Text truncated - open the document above for the full version.

FCC ID: 2AANA-SEM-Q7 Setup Photo Radiated emission FCC ID: 2AANA-SEM-Q7 FCC ID: 2AANA-SEM-Q7 Conducted emission