2AAO6YLT-13Remote Control

MODEL Y LT-13 INDOOR REMOTE CONTROLLER FCC ID : 2AAO6Y LT-13 FEDERAL COMMUNICATIONS COMMISSION This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures : - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. SPECIFICATIONS Frequency --- 315MHz Receiver Power Input --- AC 125V Electrical Outlet Receiver Power Output --- 15 Amps / 125 Volts / 1875 Watts Resistive or general purpose --- 5 Amps / 125 Volts Tungsten

DATE; July 25, 2013 Nemko Canada Inc 303 River Road Ottawa, Ontario, Canada K1V 1H2 Attn: Director of Certification Authority to Act as Agent On our behalf, I appoint _ Shenzhen Timeway Technology Consulting Co., Ltd _， East 5/Block 4, Anhua Industrial Zone, No.8,Tairan Rd. CheGongMiao, FuTian District， __ Hanson _ Chueng ____________, (Name and address，person). to act as our agent in the preparation of this application for equipment certification. I certify that submitted documents properly describe the device or system for which equipment certification is sought. I also certify that each unit manufactured, imported or marketed, as defined in the Federal Communications Commission’s regulations will have affixed to it a label identical to that submitted for approval with this application. For instances where our authorized agent signs the application for certification on our behalf, I acknowledge that all responsibility for complying with the terms and conditions for certification, as specified by Nemko Canada Inc, still resides with ___( applicant name and address). __ Ningbo Yaling Electric Appliance Co.,Ltd./_ No. 16 Industry Road, Zhangqi Town, Cixi, China Dated this July 25, 2013 Agency agreement expiration date: Usually Give 8 - 12 Months By: Zhou Pei Zhou Signature Printed Title: Manager On behalf of : Ningbo Yaling Electric Appliance Co.,Ltd. Telephone: 0086-574-63753656

We Ningbo Yaling Electric Appliance Co., Ltd. Hereby Declare that The product Remote Control, with Model Number: YLT-12, TNRC13PK, YLT- 13, TNRC21, UTTNRC21, 0141479, 916-3692, TNRC22PK, TNRC23PK, HLRC23PK, 0357408 are all identical in interior structure, electrical circuits and components. And just the outlet is different. For YLT-12 and TNRC13PK, there is only one outlet and just the model name is different. For the others, there are two outlets and only the model name is different. Your assistance on this matter is highly appreciated. Dated this July 25, 2013 Agency agreement expiration date: Usually Give 8 - 12 Months By: Zhou Pei Zhou Signature Printed Title: Manager On behalf of : Ningbo Yaling Electric Appliance Co.,Ltd. Telephone: 0086-574-63753656

( Y LT- 1 3 ) Front View Back View Photo for the EUT (YLT-12) Front View Back View ( Y LT- 1 2 )

Label Location

Photo for the EUT ( Y LT- 1 3 ) Interior View ( Y LT- 1 3 ) Interior View ( Y LT- 1 3 ) Interior View ( Y LT- 1 3 ) Interior View ( Y LT- 1 2 ) Interior View ( Y LT- 1 2 ) Interior View ( Y LT- 1 2 )

ISO/IEC17025 Accredited Lab. Report No: FCC 1306132 File reference No: 2013-07-10 Applicant: Ningbo Yaling Electric Appliance Co., Ltd Product: Remote Control Brand Name: Model No: YLT-12,TNRC13PK, YLT-13,TNRC21, UTTNRC21, 0141479, 916-3692, TNRC22PK, TNRC23PK, HLRC23PK, 0357408 Test Standards: FCC Part 15 Subpart B: 2009 Test result: It is herewith confirmed and found to comply with the requirements set up by ANSI C63.4&FCC Part 15 regulations for the evaluation of electromagnetic compatibility Approved By Terry Tong Manager Dated: July 10, 2013 Results appearing herein relate only to the sample tested The technical reports is issued errors and omissions exempt and is subject to withdrawal at SHENZHEN TIMEWAY TECHNOLOGY CONSULTING CO., LTD East 5/Block 4, Anhua Industrial Zone, No.8, Tairan Rd. Chegongmiao, FuTian District, Shenzhen, CHINA. Tel (755) 83448688 Fax (755) 83442996 Report No: 1306132 Page 2 of 27 Date: 2013-07-10 "The report refers only to the sample tested and does not apply to the bulk production. This report is issued in confidential to the client and it will be strictly treated as such by the Shenzhen Timeway Technology Consulting Co., Ltd. It may not be reproduced rather in its entirety or in part and it may not be used for illegal purpose. The client to whom the report is issued may, however, show or send it . or a certified copy there of prepared by the Shenzhen Timeway Technology Consulting co., Ltd to his customer. Supplier or others persons directly concerned. Shenzhen Timeway Technology Consulting co., Ltd will not, without the consent of the client enter into any discussion of correspondence with any third party concerning the contents of the report. In the event of the improper use of the report. The Shenzhen Timeway Technology Consulting co., Ltd reserves the rights to withdraw it and to adopt any other remedies which may be appropriate." Special Statement： The testing quality ability of our laboratory meet with "Quality Law of People's Republic of China" Clause 19. The testing quality system of our laboratory meet with ISO/IEC-17025 requirements, which is approved by CNAS. This approval result is accepted by MRA of APLAC. Our test facility is recognized, certified, or accredited by the following organizations: CNAS-LAB Code: L2292 The EMC Laboratory has been assessed and in compliance with CNAS-CL01 accreditation criteria for testing Laboratories (identical to ISO/IEC 17025:2005 General Requirements) for the Competence of testing Laboratories. FCC-Registration No.: 899988 The EMC Laboratory has been registered and fully described in a report filed with the (FCC) Federal Communications commission. The acceptance letter from the FCC is maintained in our files. Registration No.: 899988. IC- Registration No.: IC5205A-02 The EMC Laboratory has been registered and fully described in a report filed with the (IC) Industry Canada. The acceptance letter from the IC is maintained in our files. Registration IC No.: 5205A-02. VCCI- Registration No.: R-3015 and C-3332 The EMC Laboratory has been registered and fully described in a report filed with the (VCCI) Voluntary Control Council for Interference. The acceptance letter from the VCCI is maintained in our files. Registration IC No.: R-3015 and C-3332 Report No: 1306132 Page 3 of 27 Date: 2013-07-10 "The report refers only to the sample tested and does not apply to the bulk production. This report is issued in confidential to the client and it will be strictly treated as such by the Shenzhen Timeway Technology Consulting Co., Ltd. It may not be reproduced rather in its entirety or in part and it may not be used for illegal purpose. The client to whom the report is issued may, however, show or send it . or a certified copy there of prepared by the Shenzhen Timeway Technology Consulting co., Ltd to his customer. Supplier or others persons directly concerned. Shenzhen Timeway Technology Consulting co., Ltd will not, without the consent of the client enter into any discussion of correspondence with any third party concerning the contents of the report. In the event of the improper use of the report. The Shenzhen Timeway Technology Consulting co., Ltd reserves the rights to withdraw it and to adopt any other remedies which may be appropriate." Test Report Conclusion Content 1.0 General Details ................................................................................................ 4 1.1 Test Lab Details................................................................................................ 4 1.2 Applicant Details.............................................................................................. 4 1.3 Description of EUT ............................................................................................4 1.4 Test Uncertainty................................................................................................ 4 1.5 Submitted Sample............................................................................................. 4 1.6 Test Duration.................................................................................................. 4 2.0 List of Measurement Equipment........................................................................ 5 2.1 Conducted Emission Test..................................................................................... 5 2.2 Radiated electromagnetic disturbance test................................................................. 5 3.0 Technical Details............................................................................................. 5 3.1 Investigations Requested..................................................................................... 5 3.2 Test Standards.................................................................................................. 5 4.0 Power line Conducted Emission Test..................................................................... 6 5.0 Radiated Disturbance Test...............................…

Text truncated - open the document above for the full version.

Conducted test View Radiated emission test view--