2AAP8-VIFANORDICBluetooth Speaker

HELSINKI owner’s manual 2 1 Read these instructions. 2 Keep these instructions. 3 Heed all warnings. 4 Follow all instructions. 5 Do not use this apparatus near water. 6 Clean only with dry cloth. 7 Do not block any ventilation openings. Install in accordance with the manufac- turer’s instructions. 8 Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9 Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third ground- ing prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet consult an electrician for replace- ment of the obsolete outlet. 10 Make sure the power cord is not stepped on or otherwise interferred with, particu- larly at the mains socket and where it exits the apparatus. 11 Only use attachments/accessories specified by the manufacturer. 12 Use only with the cart, stand, tripod, bracket or table speci- fied by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 13 Unplug this apparatus during lightning storms or when unused for long periods of time. 14 Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as damage to the power cord or plug, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally or has been dropped. 15 To completely disconnect unit power from the AC mains, disconnect the unit’s power cord from the mains socket. WARNING: • To reduce the risk of fire and electric shock do not expose this apparatus to rain or moisture. • Do not place objects filled with liquids such as vases on the apparatus. • Do not open the appartus. There are no user-serviceable parts inside. Risk of electric shock inside. The lightning flash and arrow head within the triangle is a warning sign alerting you of dangerous voltage inside the product. The exclamation point within the triangle is a warning sign alert- ing you to important instructions accompanying the product. IMPORTANT SAFETY INSTRUCTIONS Regulatory Safety Information 3 This device complies with Part 15 of the FCC Rules. Its operation is subject to the following two conditions: 1. This device may not cause harmful interfer- ence, and 2. This device must accept any interference received, including interference that may cause undesired operation. Cet appareil est conforme à la section 15 des ré- glementations de la FCC. Le fonctionnement de l’appareil est sujetaux deux conditions suivantes: 1. Cet appareil ne doit pas provoquer d’interférences néfastes, et 2. Cet appar- eil doit tolérer les interférences reçues, y compris celles qui risquent de provoquer un fonctionnement indésirable. Note: This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason- able protection against harmful interference in a residential installation. This product gen- erates, uses, and can radiate radio frequency energy and, if not installed and used in accord- ance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interfer- ence will not occur in a particular installation. If this product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/ TV technician for help. Changes or modifications not expressly ap- proved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two con- ditions: 1. This device may not cause interference, and 2. This device must accept any interference, including interference that may cause un- desired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radioexempts de licence. L’exploitation est au- torisée aux deux conditions suivantes : 1. l’appareil ne doit pas produire de brouil- lage, et 2. l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en comprom- ettre le fonctionnement. Vifa Denmark A/S Mariendalsvej 2A DK-8800 - Denmark www.vifa.dk IMPORTANT STATEMENTS: 4 You’ve chosen well The Vifa Helsinki. A loudspeaker for anyone who values exclusive Nordic design and authentic sound. It’s designed to be intuitive for you to use. This manual just spells out the details - for instance, how to connect wirelessly in a flash. Enjoy! 5 Product care ..................................................................................6 Connecting to Helsinki Connecting with Bluetooth .............................................................8 Connecting with Bluetooth - NFC ...................................................9 Wired connection ........................................................................10 Product functions Buttons and indicators on Helsinki ...............................................12 Status indicator .............................................................................13 Battery charge ..............................................................................14 Reset and set …

Text truncated - open the document above for the full version.

Page 1 of 5 External PHOTO: Model:VIFA040 Page 2 of 5 Page 3 of 5 Page 4 of 5 Page 5 of 5

HELSINKI DESIGNED BY VIFA DENMARK A/S - ASSEMBLED IN CHINA VIFA DENMARK A/S, MARIENDALSVEJ 2A, 8800 VIBORG, DENMARK MODEL: VIFA040 Portable Wireless Speaker FCC ID: 2AAP8-VIFANORDIC IC: 9043A-VIFANORDIC CAN ICES-3(B)/NMB-3(B) Input: 12V 1,8A This device contains Li-Ion rechargeable battery (19Wh) S/N 01234567891234567 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Page 1 of 1 External PHOTO: Model: VIFA040 Attach label here

Page 1 of 4 Internal PHOTO: Model:VIFA040 Page 2 of 4 Page 3 of 4 Chip Antenna Page 4 of 4

RF Exposure Requirements Product Description: Bluetooth Speaker Model No.: VIFA040 FCC ID: 2AAP8-VIFANORDIC According to the KDB-4474498 D01 V05r02, the following RF exposure evaluation shall to demonstrate RF exposure compliance. Bluetooth (Classic mode) Tx frequency range: 2402~2480MHz Device category: Removable device Maximum Conducted Output Power: 7.79 dBm Maximum Output Power: 6.01 mW Minimum Distance: 5 mm Limit: 10 mW Source-based time-averaged output power is 6.01 mW ＜10 mW Bluetooth (BLE mode) Tx frequency range: 2402~2480MHz Device category: Removable device Maximum Conducted Output Power: 8.39 dBm Maximum Output Power: 6.90 mW Minimum Distance: 5 mm Limit: 10 mW Source-based time-averaged output power is 6.90 mW ＜10 mW So the transmitter complies with the RF exposure requirements and the SAR is not required.

ITL Page 1 of 48 Report No.: 15010136-2 TEST REPORT Applicant: Guoguang Electric Co., Ltd Address of Applicant: No.8 Jinghu Road, Xinhua Street, Huadu Reg, Guangzhou, China Manufacturer: Vifa Denmark A/S Address of Manufacturer: Mariendalsvej 2A, 8800 Viborg, Denmark Product name: Portable Wireless Speaker Model: VIFA040 Rating(s): Input : 100-240Vac, 50/60Hz, 600mA Max (For Switching Power Supply) DC 12V, 1.8A (For main) Trademark: Vifa Standards: 47 CFR PART 15 Subpart C: 2013 section 15.247 ANSI C63.4 : 2003 FCC ID: 2AAP8-VIFANORDIC IC ID: 9043A- VIFANORDIC Data of Receipt: 2015-01-23 Date of Test: 2015-01-23~2015-04-03 Date of Issue: 2015-04-03 Test Result Pass* * In the configuration tested, the test item complied with the standards specified above. Authorized for issue by: Test by: Reviewed by: Apr.03.2015 Jumy Qiu Apr.03.2015 Pauler Li Project Engineer Project Engineer Date Name/Position Signature Date Name/Position Signature ITL Page 2 of 48 Report No.: 15010136-2 Possible test case verdicts: test case does not apply to the test object ..: N/A test object does meet the requirement ........: P (Pass) test object does not meet the requirement ..: F (Fail) Testing Laboratory information: Testing Laboratory Name .......... : I-Test Laboratory Address : 1-2 floor, South Block, Building A2 , No 3 Keyan Lu, Science City, Guangzhou, Guangdong Province, P.R. China Testing location : Same as above Tel : 0086-20-32209330 Fax : 0086-20-62824387 E-mail : [email protected] General remarks: The test results presented in this report relate only to the object tested. The results contained in this report reflect the results for this particular model and serial number. It is the responsibility of the manufacturer to ensure that all production models meet the intent of the requirements detailed within this report. This report would be invalid test report without all the signatures of testing technician and approver. This report shall not be reproduced, except in full, without the written approval of the Issuing testing laboratory. Note: / ITL Page 3 of 48 Report No.: 15010136-2 1 Test Summary Test Test Requirement Test method Result Antenna Requirement FCC PART 15 C section 15.247 (c) and Section 15.203 FCC PART 15 C section 15.247 (c) and Section 15.203 PASS 6 dB Bandwidth FCC PART 15 C section 15.247 (a)(2) RSS 210 A8.2 (a) ANSI C63.10:2009 Clause 6.9 and KDB 558074 D01 v03r02 PASS Maximum Peak Output Power FCC PART 15 C section 15.247(b)(3) RSS 210 A8.4 ANSI C63.10:2009 Clause 6.10 and KDB 558074 D01 v03r02 (Power Output Option 2-Method #1). PASS Peak Power Spectral Density FCC PART 15 C section 15.247(e) RSS 210 A8.2 (b) ANSI C63.10:2009 Clause 6.11 and KDB 558074 D01 v03r02 (PSD Option 1). PASS Conducted Spurious Emission (30MHz to 25GHz) FCC PART 15 C section 15.209 &15.247(d) RSS 210 A8.5 ANSI C63.10:2009 Clause 6.7 and KDB 558074 D01 v03r02 PASS Radiated Spurious Emission 30 MHz to 25 GHz) FCC PART 15 C section 15.209 &15.247(d) RSS 210 A8.5 ANSI C63.10:2009 Clause 6.4, 6.5 and 6.6 & KDB 558074 D01 v03r02 PASS Band Edges Measurement FCC PART 15 C section 15.247 (d) &15.205 ANSI C63.10:2009 Clause 6.9 & KDB 558074 D01 v03r02 PASS Conducted Emissions at Mains Te r m i n al s FCC PART 15 C section 15.207 RSS GEN Table 2 ANSI C63.10:2009 Clause 6.2 PASS ITL Page 4 of 48 Report No.: 15010136-2 2 Contents Page TEST REPORT....................................................................................................................................................................... 1 1 TEST SUMMARY......................................................................................................................................................... 2 2 CONTENTS................................................................................................................................................................... 2 3 GENERAL INFORMATION........................................................................................................................................ 2 3.1 CLIENT INFORMATION............................................................................................................................................ 2 3.2 GENERAL DESCRIPTION OF E.U.T........................................................................................................................ 2 3.3 DETAILS OF E.U.T................................................................................................................................................. 2 3.4 DESCRIPTION OF SUPPORT UNITS........................................................................................................................ 2 3.5 TEST LOCATION..................................................................................................................................................... 2 3.6 DEVIATION FROM STANDARDS.............................................................................................................................. 2 3.7 ABNORMALITIES FROM STANDARD CONDITIONS.................................................................................................. 2 3.8 OTHER INFORMATION REQUESTED BY THE CUSTOMER....................................................................................... 2 3.9 TEST FACILITY....................................................................................................................................................... 2 3.10 MEASUREMENT UNCERTAINTY.............................................................................................................................. 2 4 INSTRUMENTS USED DURING TEST.................................................................................................................... 2 5 TEST RESULTS........................................................................................................................................................... 2 5.1 E.U.T. TEST CONDITIONS...........................…

Text truncated - open the document above for the full version.

Page 1 of 2 TEST PHOTO: Model:VIFA040 Page 2 of 2