2ABEAACR1501iCamPRO

Amaryllo/ACR1501 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC INFORMATION The equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no grantee that interference will not occur in a particular installation. If this equipment dose cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. The user should not modify or change this equipment without written approval form Amaryllo International B.V. Modification could void authority to use this equipment. IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. No change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device.

910805 1 Amaryllo International B.V. Singel 540, 1017AZ Amsterdam, the Netherlands Date: Aug. 07, 2015 Federal Communications Commission 7435 Oakland Mills Road Columbia MD 21046 c.c. UL Verification Services Certification Division 47173 Benicia Street Fremont, CA 94538, USA To whom it may concern: On behalf of Amaryllo International B.V., I hereby declare that our product identified as FCC ID: 2ABEAACR1501, will permanently disable the Wi-Fi 2.4GHz channel 12 and channel 13 operations by software. It cannot be enabled/overridden by the end users or unauthorized third parties via any other means.. Sincerely Yours,

Amaryllo International B.V. Singel 540, 1017AZ Amsterdam, the Netherlands Date: Aug. 07, 2015 Federal Communications Commission 7435 Oakland Mills Road Columbia MD 21046 c.c. UL Verification Services Certification Division 47173 Benicia Street Fremont, CA 94538, USA To whom it may concern: I, the undersigned, hereby authorize ELECTRONICS TESTING CENTER, TAIWAN, and hereafter referred to as ETC, to act on our behalf in all manners relating to application for equipment authorization, including signing of all documents relating to these matters. Any and all acts carried out by ELECTRONICS TESTING CENTER, TAIWAN, on our behalf shall have the same effect as acts of our own. I, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 853(a). In authorizing ETC as our agent, we still recognize that we are responsible to: a)comply with the relevant provisions of the certification program; b)make all necessary arrangements for the conduct of the evaluation, including provision for examining documentation and access to all areas, records (including internal audit reports) and personnel for the purposes of evaluation (e.g. testing, inspection, assessment, surveillance, reassessment) and resolution of complaints; c)make claims regarding certification only in respect of the scope for which certification has been granted; d)do not use our product certification in such a manner as to bring the Certification Division into disrepute and not make any statement regarding our product certification which the Certification Division may consider misleading or unauthorized; e) upon suspension or cancellation of certification, discontinue use of all advertising matter that contains any reference thereto and return any certification documents as required by the Certification Division; f) use certification only to indicate the products are certified as being in conformity with specified standards; g) endeavor to ensure that no certificate or report nor any part thereof is used in a misleading manner; h) ensure that any reference to our product certification in communication media such as documents, brochures or advertising, complies with the requirements of the Certification Division; i) keep a record of all complaints made known to the us relating to the product’s compliance with requirements of the relevant standard and to make these records available to the Certification Division when requested; j) take appropriate action with respect to such complaints and any deficiencies found in products or services that affect compliance with the requirements for certification; k) document the actions taken. This authorization is valid until further written notice from the applicant. Sincerely Yours, REMARK: 1. This authorization letter will be sent along with your application when filing with the Certification Division. 2. Please follow the format and type it on company letterhead and send original to us. 3. Authorized signature must be in agreement with grantee code contact in FCC database.

Amaryllo International B.V. Singel 540, 1017AZ Amsterdam, the Netherlands Federal Communications Commission 7435 Oakland Mills Road Columbia MD 21046 Subject: Request for Confidentiality FCC ID:2ABEAACR1501 To Whom It May Concern: Pursuant to the provisions of Sections 0.457 and 0.459 of the Commission’s rules (47 CFR §§ 0.457, 0.459), we are requesting the Commission to withhold the following attachments as confidential document from public disclosure indefinitely. (Delete any of items which is not applicable to your device) Schematic Diagram Block Diagram Theory of Operation Parts List Tune-Up Procedure Above mentioned document contains detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market. It is our understanding that all measurement test reports, FCC ID label format and correspondent during certification review process cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. Best Regards

ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 1 of 16 Sheets Rev. No 2.0 CONSTRUCTION PHOTOS OF EUT (A) EUT 1. 2. ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 2 of 16 Sheets Rev. No 2.0 CONSTRUCTION PHOTOS OF EUT 3. 4. ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 3 of 16 Sheets Rev. No 2.0 CONSTRUCTION PHOTOS OF EUT 5. 6.

ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 4 of 16 Sheets Rev. No 2.0 CONSTRUCTION PHOTOS OF EUT 7. ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 5 of 16 Sheets Rev. No 2.0 CONSTRUCTION PHOTOS OF EUT 8. 9. ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 6 of 16 Sheets Rev. No 2.0 CONSTRUCTION PHOTOS OF EUT 10. 11. ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 7 of 16 Sheets Rev. No 2.0 CONSTRUCTION PHOTOS OF EUT 12. 13. ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 8 of 16 Sheets Rev. No 2.0 CONSTRUCTION PHOTOS OF EUT 14. 15. ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 9 of 16 Sheets Rev. No 2.0 CONSTRUCTION PHOTOS OF EUT 16. 17. ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 10 of 16 Sheets Rev. No 2.0 CONSTRUCTION PHOTOS OF EUT 18. 19. ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 11 of 16 Sheets Rev. No 2.0 CONSTRUCTION PHOTOS OF EUT 20. 21. ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 12 of 16 Sheets Rev. No 2.0 CONSTRUCTION PHOTOS OF EUT 22. 23. ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 13 of 16 Sheets Rev. No 2.0 CONSTRUCTION PHOTOS OF EUT 24. 25. ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 14 of 16 Sheets Rev. No 2.0 CONSTRUCTION PHOTOS OF EUT 26. 27. Antenna1 ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 15 of 16 Sheets Rev. No 2.0 CONSTRUCTION PHOTOS OF EUT 28. Antenna2

Rev. No 2.0 FCC Part 15 EMI TEST REPORT of E.U.T. : iCamPRO FCC ID. : 2ABEAACR1501 Model No. : ACR1501, ACR1501R1, ACR1501R2, ACR1501R3, ACR1501R4, ACR1501R5, ACR1501R6, ACR1501R7, ACR1501R8, ACR1501R9 for APPLICANT : Amaryllo International B.V. ADDRESS : Singel 540, 1017AZ Amsterdam, the Netherlands Test Performed by ELECTRONICS TESTING CENTER, TAIWAN NO. 34. LIN 5. DINGFU VIL., LINKOU DIST., NEW TAIPEI CITY, TAIWAN, 24442, R.O.C. Tel : (02)26023052 Fax : (02)26010910 http://www.etc.org.tw ; e-mail: [email protected] Report Number : 15-04-RBF-022-04 ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Rev. No 1.0 TEST REPORT CERTIFICATION Applicant : Amaryllo International B.V. Singel 540, 1017AZ Amsterdam, the Netherlands Manufacturer : Amaryllo International B.V. Singel 540, 1017AZ Amsterdam, the Netherlands Description of EUT a) Type of EUT : iCamPRO b) Trade Name : Amaryllo c) Model No. : ACR1501, ACR1501R1, ACR1501R2, ACR1501R3, ACR1501R4, ACR1501R5, ACR1501R6, ACR1501R7, ACR1501R8, ACR1501R9 d) Power Supply : Adapter:DSA-12PFA-05 FUS 050200 I/P: 100-240V~ 50/60Hz, 0.5A O/P:5Vdc, 2A Regulation Applied : FCC Rules and Regulations Part 15 Subpart C I HEREBY CERTIFY THAT: The data shown in this report were made in accordance with the procedures given in ANSI C63.10-2009, and the energy emitted by the device was founded to be within the limits applicable. I assume full responsibility for accuracy and completeness of these data. Note: 1. The result of the testing report relate only to the item tested. 2. The testing report shall not be reproduced expect in full, without the written approval of ETC Summary of Tests Test Results Radiated Emission Pass Conducted Emission Pass Emission Bandwidth Pass Output Power Pass 100 kHz Bandwidth of Band Edges Pass Power Density Pass Out-of-Band Conducted Emission Pass ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Rev. No 1.0 Date Test Item Received : Apr. 13, 2015 Date Test Campaign Completed : Jun. 07, 2015 Date of Issue : Jun. 24, 2015 Test Engineer : (Jiapeng Chen, En gineer ) Approve & Authorized Signer : S. S. Liou, Section Manager EMC Dept. II of ELECTRONICS TESTING CENTER, TAIWAN ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Rev. No 1.0 Table of Contents Page 1 GENERAL INFORMATION ....................................................................................................... 1 1.1 Product Description...................................................................................................................... 1 1.2 Characteristics of Device ............................................................................................................. 1 1.3 Test Methodology ........................................................................................................................ 1 1.4 Test Facility.................................................................................................................................. 1 2 PROVISIONS APPLICABLE...................................................................................................... 2 2.1 Definition ..................................................................................................................................... 2 2.2 Requirement for Compliance ....................................................................................................... 3 2.3 Restricted Bands of Operation ..................................................................................................... 5 2.4 Labeling Requirement .................................................................................................................. 5 2.5 User Information .......................................................................................................................... 6 3. SYSTEM TEST CONFIGURATION .......................................................................................... 7 3.1 Justification .................................................................................................................................. 7 3.2 Devices for Tested System........................................................................................................... 7 4 RADIATED EMISSION MEASUREMENT .............................................................................. 8 4.1 Applicable Standard ..................................................................................................................... 8 4.2 Measurement Procedure............................................................................................................... 8 4.3 Measuring Instrument ................................................................................................................ 10 4.4 Radiated Emission Data ............................................................................................................. 11 4.5 Field Strength Calculation ......................................................................................................... 29 4.6 Photos of Radiation Measuring Setup........................................................................................ 30 5 CONDUCTED EMISSION MEASUREMENT ........................................................................ 31 5.1 Standard Applicable ................................................................................................................... 31 5.2 Measurement Procedure............................................................................................................. 31 5.3 Conducted Emission Data .......................................................................................................... 32 5.4 Result Data Calculation ............................................................................................................. 34 5.5 Conducted Measurement Equipment ......................................................................................... 34 5.6 Photos of Conduction Meas…

Text truncated - open the document above for the full version.

ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 30 of 89 Sheets Rev. No 2.0 4.6 Photos of Radiation Measuring Setup (30MHz to 1GHz) ETC Report No. : 15-04-RBF-022-04 FCC ID.: 2ABEAACR1501 Sheet 35 of 89 Sheets Rev. No 2.0 5.6 Photos of Conduction Measuring Setup