2ABMI-ES053BBluetooth Speaker

FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. Modifications not authorized by the manufacturer may void users authority to operate this device. FCC INFORMATION: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 0f the FCC Rules. These limits are designed to provide reasonable protection against harmful interference m a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures : ● Reorient or relocate the receiving antenna. ● Increase the separation between the equipment and receiver. ● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ● Consult the dealer or an experienced radio/TV technician for help. OPERATING INSTRUCTIONS 4. During playback: ● Press and hold the or Buttons to adjust volume level. (When the volume is set to maximum or minimum, beeps sound will be heard). ● Press the button to pause; press again to resume. ● Press and release the or Button repeatedly to skip tracks. 5. If the unit is paired to Cell Phone: ● When a call is incoming during listening, press the Button to hook off then speak to the built in microphone to answer the phone. When finished, press the Button to hook on then resume to music playback. 6. When finished listening, slide the Power ON/ OFF Switch to OFF position to shut off the unit. AUX mode 1. Connected the 3.5mm plug on the unit to the AUX Out / Line Out/Phone jack on any external audio player. 2. Slide the Power ON/OFF Switch to ON position to power on the unit, Blue Indicator is light and blinking. 3. Enter to AUX mode by press and hold the button approx. 1 second until the Blue Indicator stop blinking. Plays the music in the connected Player as usual. OPERATING INSTRUCTIONS 4. During Playback: ● Press and hold the or Buttons to adjust volume level. 5. To resume to BT mode, press and hold the button approx. 1 second until the Blue Indicator start blinking. 6. When finished listening, slide the Power ON/OFF Switch to OFF position to shut off the unit. Specification: Power source-----Built in DC 3.7V, Lithium-ion rechargeable battery. Recharge by DC 5V, 0.5A from Computer or USB Charge through Micro USB jack (Computer and USB Charger not included). Battery life--------Approximate 6 hours for music playback Audio Output Power------3.2W RMS (1.6W per channel) Speaker Impedance------4 Ohm, 3W X 2 Noted: The specifications are subject to change without notice. Accessories: 1x User’s manual 1x USB cable (For charging only). Craig warrants this product to be free from manufacturing defects in material and workmanship under normal use for a period of 90 days from date of purchase. If service is required, please return the product to the store where it was purchased for exchange; or, pack the unit in the original packing material with all accessories if applicable, a copy of your sales receipt and a Cashier’s check or Money Order for $7.00 (to cover shipping and handling costs) payable to Craig Electronics Inc. For consumers in Canada, please make sure that the cashier check or money order is redeemable through a U.S. bank. Ship your product freight pre-paid. Your unit will be repaired, replaced or if the unit can not be repaired or replaced, a refund will be forwarded to you within four weeks of receipt of your unit. Please ship your unit to: This warranty is void if the product has been: a) Used in a commercial application or rental. b) Damaged through misuse, negligence, or abuse. c) Modified or repaired by anyone other than an authorized Craig service center. d) Damaged because it is improperly connected to any other equipment. Craig Electronics Inc. 1160 NW 163 Drive Miami, Fl 33169 Note: This warranty does not cover: a) Ordinary adjustments as outlined in the Owner’s Manual which can be performed by the customer. b) Damage to equipment not properly connected to the product. c) Any cost incurred in shipping the product for repair. d)Damage to the product not used in the USA. This warranty is not transferable and only applies to the original purchase. Any implied warranties, including the warranty of merchantability, are limited in duration to the period of this expressed warranty and no warranty whether expressed or implied shall apply to the product thereafter. Under no circumstance shall Craig be liable for any loss or consequential damage arising out of the use of this product. This warranty gives specific legal rights. However, you may have other rights which may vary from state to state. Some states do not allow limitations on implied warranties or exclusion of consequential damage. Therefore, these restrictions may not apply to you. Printed in China CMA3546BT_WC_E0GH1_B0US To Obtain Service on your Product email:[email protected] OPERATING INSTRUCTIONS BT (Blue Tooth): In first time use or re-pairing to new BT device, pairing the unit to external BT device as below: 1. Slide the Power ON/OFF Switch to ON position. Blue Indicator will light and blinking. 2. Power on the external BT device and enter to searching mode. Start pairing as the on screen instructions on the external BT device. After paired, the blinking frequency of the Blue Indicator will slow down. (For details pairing procedures, please refer to the user’s manual of your BT device). Notes: …

Text truncated - open the document above for the full version.

ELE ELECTRICAL TECHNOLOGY CO., LTD. Add: 2F, Block C1, JingBo Industrial park, YanTian, FengGang, DongGuan, GuangDong, China Tel: 0769-87842787 Fax: 0769-82010618 FCC Authorization Date: 2013-12-31 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Agent Authorization To whom it may concern: We, ELE ELECTRICAL TECHNOLOGY CO., LTD., the undersigned, Hereby authorizes Bay Area Compliance Laboratories Corporation to act on its behalf in all matters relating to application for Equipment authorization, including the signing of all documents relating to these matters. All acts carried out by Bay Area Compliance Laboratories Corp. our behalf shall have the same effect as our own action. We, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 853(a). This authorization is valid until further written notice from the applicant. Sincerely Yours, Signature: Mary Yin, Sales Manager

ELE ELECTRICAL TECHNOLOGY CO., LTD. Add: 2F,Block C1,JingBo Industrial park,YanTian,FengGang,DongGuan,GuangDong,China Tel: 0769-87842787 Fax: 0769-82010618 FCC Confidential Authorization Date: 2013-12-31 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Confidentiality Request regarding application for certification of FCC ID: 2ABMI-ES053B Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, we hereby request confidential treatment of information accompanying this application as outlined below:  Detailed Circuit Schematics of EUT--- (Long term)  Block Diagram--- (Long term)  Circuit Description--- (Long term) The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely Yours, Signature: Mary Yin, Sales Manager

EXHIBIT B - EUT EXTERNAL PHOTOGRAPHS EUT—All View EUT—Top View EUT—Bottom View EUT— Left Side View EUT- Right Side View EUT—All View EUT—Top View EUT—Bottom View EUT— Left Side View EUT- Right Side View

EXHIBIT A - FCC ID LABELING AND LOCATION FCC ID Label Proposed FCC ID Label Location The label shown shall be permanently affixed at a conspicuous location on the device and be readily visible to the user at the time purchase (Labeling requirements per 2.925) Label Here

EXHIBIT B - EUT EXTERNAL PHOTOGRAPHS EUT- Uncover View EUT- Main Board Off View EUT- Battery View EUT- Main Board Top View EUT- Main Board Bottom View EUT- RF Module View EUT- Top Cover Off View

Note: This test report is prepared for the customer shown above and for the device described herein. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratories Corp. This report must not be used by the customer to claim product certification, approval, or endorsement by NVLAP*, or any agency of the Federal Government. * This report may contain data that are not covered by the NVLAP accreditation and shall be marked with an asterisk “★” (Rev.2). This report is valid only with a valid digital signature. The digital signature may be available only under the Adobe software above version 7.0. FCC PART 15.247 TEST REPORT For ELE ELECTRICAL TECHNOLOGY CO., LTD. 2F, Block C1, JingBo Industrial Park, YanTian, FengGang, DongGuan, GuangDong, China Report Type: Original Report Product Type: Bluetooth Speaker Test En gineer: Allen Qiao Re port Number: R2DG131221001-00 Re port Date: 2014-01-03 Reviewed B y: Ivan Cao RF Leade r Test Laboratory: Bay Area Compliance Laboratories Corp. (Dongguan) No.69 Pulongcun, Puxinhu Industrial Zone, Tangxia, Dongguan, Guangdong, China Tel: +86-769-86858888 Fax: +86-769-86858891 www.baclcorp.com.cn FCC ID: 2ABMI-ES053B Bay Area Compliance Laboratories Corp. (Dongguan) Report No.: R2DG131221001-00 FCC Part 15.247 Page 2 of 68 TABLE OF CONTENTS GENERAL INFORMATION ....................................................................................................................................... 4 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ..................................................................................... 4 OBJECTIVE ................................................................................................................................................................... 4 RELATED SUBMITTAL(S)/GRANT(S) ............................................................................................................................. 4 TEST METHODOLOGY .................................................................................................................................................. 4 TEST FACILITY ............................................................................................................................................................. 4 SYSTEM TEST CONFIGURATION .......................................................................................................................... 6 DESCRIPTION OF TEST CONFIGURATION ...................................................................................................................... 6 EUT EXERCISE SOFTWARE .......................................................................................................................................... 6 EQUIPMENT MODIFICATIONS ....................................................................................................................................... 6 SUPPORT EQUIPMENT LIST AND DETAILS .................................................................................................................... 6 EXTERNAL I/O CABLE .................................................................................................................................................. 6 BLOCK DIAGRAM OF TEST SETUP ................................................................................................................................ 7 SUMMARY OF TEST RESULTS ............................................................................................................................... 8 FCC §15.247 (i) & §1.1310 & §2.1093- RF EXPOSURE ............................................................................................... 9 APPLICABLE STANDARD .............................................................................................................................................. 9 FCC §15.203 - ANTENNA REQUIREMENT ........................................................................................................... 10 APPLICABLE STANDARD ............................................................................................................................................ 10 ANTENNA CONNECTOR CONSTRUCTION .................................................................................................................... 10 FCC §15.207 (a) – AC LINE CONDUCTED EMISSIONS ..................................................................................... 11 APPLICABLE STANDARD ............................................................................................................................................ 11 MEASUREMENT UNCERTAINTY .................................................................................................................................. 11 EUT SETUP ................................................................................................................................................................ 11 EMI TEST RECEIVER SETUP ....................................................................................................................................... 12 TEST PROCEDURE ...................................................................................................................................................... 12 CORRECTED AMPLITUDE & MARGIN CALCULATION ................................................................................................. 12 TEST EQUIPMENT LIST AND DETAILS ......................................................................................................................... 13 TEST RESULTS SUMMARY .......................................................................................................................................... 13 TEST DATA ................................................................................................................................................................ 13 FCC §15.209, §15.205 & §15.247(d) - SPURIOUS EMISSIONS ....…

Text truncated - open the document above for the full version.

EXHIBIT D - TEST SETUP PHOTOGRAPHS Conducted Emissions - Front View Conducted Emissions – Side View Radiated Emission -Front View (Below 1GHz) Radiated Emission - Rear View (Below 1GHz) Radiated Emission -Front View (Above 1GHz) Radiated Emission - Rear View (Above 1GHz)