2ABUP-FT0313JLRemote Control Transmitter

USER MANUAL FOR FT0313JL REMOTE CONTROL TRANSMITTER I. Operation Instructions 1.OFF the Fan  When fan are on, press this button, the fan shut down. 2.Fan control (1) Speed of the fan (1~6 level)  The number of indicators displayed corresponds to the current fan gear.  The lowest gear is 1st gear and the highest gear is 6th gear. OFF the fan LED inditor Fancontrol FT0313JL transmitter Light control (2) Direction of the fan Press the keycan change the running direction of the fan. (3) Breeze Mode: Press the key can change Between Speed 2 to Speed 4, at 40 seconds in a curve and circle speed. Reach one specific speed, it changes to another speed. 3.Light control Press the key ,control the functions of turning on and off lights, changingcolors. Press the key,turn down the brightness of the light. .Press the key,turn up the brightness of the light. 4. The transmitter use2pcs of 1.5V AAA battery, please install the battery correctly. II.Use precautions 1. When press the key of transmitter, the LED indicator doesn’t on, please inspect the battery installation. 2. When press the key of transmitter, the LED indicator flashing, that means the battery get low voltage, please replace a new one. 3. Please pull out of the battery from the transmitter when leaving unused for a long time. FCC Instructions ： This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --- Reorient or relocate the receiving antenna. --- Increase the separation between the product and receiver. --- Connect the product into an outlet on a circuit differentfrom that to which the receiver is connected. --- Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operationis subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause Undesired operation. Warning:Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the product. FCC ID: 2ABUP-FT0313JL IC Caution: RSS-Gen Issue 5 "&" RSS-Gen numéro 5 - English: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1)Thisdevicemaynotcauseinterference. (2)Thisdevicemustacceptanyinterference,includinginterferencethatmaycauseundesiredoperation ofthedevice. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. RF exposure statement: The equipment complies with IC Radiation exposure limit set forth for uncontrolled environment. - French: Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d'Innovation, Sciences et Développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes: (1) Cet appareil ne doit pas causer d'interférences. (2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement indésirable de l'appareil. Tout changement ou modification non expressément approuvé parla partie responsable de la conformité pourrait annuler l'autorité de l'utilisateur à utiliser l'équipement. Déclaration d'exposition RF: L'équipement est conforme à la limite d'exposition aux radiations de la IC établie pour un environnement non contrôlé. IC ： 25540-FT0313JL

Rev 1/26/2023 Shenzhen Funpower General Technology Co., Ltd. Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 USA Date: 04-26-2023 Ref: Attestation Statements Part 2.911(d)(5)(i) Filing FCC ID:2ABUP-FT0313JL Shenzhen Funpower General Technology Co., Ltd. (“the applicant”) certifies that the equipment for which authorization is sought is not “covered” equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely, Yi Chen Rev 1/26/2023 Shenzhen Funpower General Technology Co., Ltd. Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 USA Date: 04-26-2023 Ref: Attestation Statements Part 2.911(d)(5)(ii) Filing FCC ID: 2ABUP-FT0313JL Shenzhen Funpower General Technology Co., Ltd. (“the applicant”) certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing “covered” equipment. Sincerely, Yi Chen

Hualing Dong, President

Model: FT0313JL Page 1 of 4 Picture 1 Picture 2 Model: FT0313JL Page 2 of 4 Picture 3 Picture 4 Model: FT0313JL Page 3 of 4 Picture 5 Picture 6 Model: FT0313JL Page 4 of 4 Picture 7 Picture 8

FCC ID: 2ABUP-FT0313JL 25 mm 6 mm IC: 25540-FT0313JL Model: FT0313JL

Model: FT0313JL Page 1 of 3 Picture 1 Picture 2 Model: FT0313JL Page 2 of 3 Picture 3 Picture 4 Model: FT0313JL Page 3 of 3 Picture 5 Picture 6

RF Exposure Requirements 1 General Information Client Information Applicant ....................................... : Shenzhen Funpower General Technology Co.,Ltd. Address of applicant ................... : Room 201B, Gangwan Creative Building, NO.1041 Houhai Avenue, Nanshan District, Shenzhen City, PRC Manufacturer ................................. : The same as above Address of manufacturer ............. : The same as above General Description of E.U.T FCC ID ............................................ : 2ABUP-FT0313JL Equipment Type ............................ : Portable Device Product Name ............................... : Remote Control Transmitter Model No. ..................................... : FT0313JL Model Description ........................ : --- Rated Voltage ................................ : Battery 3V (2*1.5V AAA) Battery Capacity ........................... : --- Power Adapter .............................. : --- Technical Characteristics of EUT Operating Frequency ................... : 303.875MHz Max. Field Strength ...................... : 78.60dBuV/m (at 3m distance) Modulation .................................... : ASK Type of Antenna ........................... : PCB Antenna Antenna Gain ................................ : 0dBi Lowest oscillator .......................... 303.875MHz 2 RF Exposure Exemption According to S1.1307(b)(3) and 447498 D04 Interim General RF Exposure Guidance v01, system operating under the provisions of this section shall be operating in a manner that the public is not exposed to radiofrequency energy level in excess limit for maximum permissible exposure. FCC Rule Part 1.1307 (b)(3)(i)(A): The available maximum time-averaged power is no more than 1 mW, regardless of separation distance. This exemption may not be used in conjunction with other exemption criteria other than those in paragraph (b)(3)(ii)(A) of this section. Medical implant devices may only use this exemption and that in paragraph (b)(3)(ii)(A). 3 RF Exposure Evaluation Calculated the EIRP from the radiated field strength in the far field using Equation: EIRP=E Meas +20log(d Meas )-104.7 Where EIRP is the equivalent isotropically radiated power, in dBm E Meas is the field strength of the emission at the measurement distance, in dBμV/m d Meas is the measurement distance, in m 4 Calculation Result Radio Access Technology Min. Distance (cm) Prediction Frequency (MHz) Max. Field Strength (dBμV/m) EIRP (dBm) EIRP (mW) SAR Test Exclusion Threshold (mW) Result SRD 0.5 303.875 78.60 -16.56 0.02 1 Pass ======End of Report======

Model: FT0313JL Page 1 of 2 Test Setup For Radiated Emission (30MHz to 1GHz) Test Setup For Radiated Emission (Above 1GHz) Model: FT0313JL Page 2 of 2