2AC2CDR-2180Smart Plug

Smart Life Smart Living Manual Product name: Smart Plug Model name: DR-2180 Smart life Smart living .C#1F(E Login / Register Smart life Smart living  2( 5-& C##(2)FF Add Devices Smart life Smart living  *F .F(5- C+E F(ED Power strip &#) Smart life Smart living 3AEECEAA! 3AE&  3AE Timer Smart life Smart living 1D( 2+( Timer Smart life Smart living 3AE C)#(C+# 3AE Timer Smart life Smart living 3AE4(C#& 2)E(, Timer Smart life Smart living  *F .F(5- 2C ( Socket &#) Smart life Smart living 3AEECEAA! 3AE&  3AE Timer Smart life Smart living 1D( 2+( Timer Smart life Smart living 3AE C)#(C+# 3AE Timer Smart life Smart living 3AE4(C#& 2)E(, Timer Smart life Smart living Scenes 2#F  2#& C#(C# Smart life Smart living Profile EC!EC! (&((E# FF+CE Smart life Smart living Devices Sharing / Feedback / Settings , 2E#F  2E#&  - 2((#F FCC Statement˖ Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .This equipment should be installed and operated with minimum distance 20cm between the radiator& your body. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. 1 ISED RSS Warning/ISED RF Exposure Statement ISED RSS Warning: This device complies with Innovation, Science and Economic Development Canada licence‐exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause unde sired operation of the device. Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'e n compromettre le fonctionnement. ISED RF e xposure statement: This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator& your body.This transmitter must not be co‐located or operating in conjunction with an y other antenna or transmitter. Le rayonnement de la classe b repecte ISED fixaient un environnement non contrôlés.Installation et mise en œuvre de ce matériel devrait avec échangeur distance minimale entre 20 cm ton corps.Lanceurs ou ne peuvent pas coexister cette antenne ou capteurs avec d’autres.

DECLARATION Date: 2021-05-25 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 74 35 Oakland Mills Road Columbia, MD 21 046 We, NINGBO DIYA ELECTRIC APPLIANCE CO., LTD., hereby declare that product name:Smart Plug(FCC ID: 2AC2CDR-2180,model name :DR-2180,IH-SW007,EIS3-1004) are electrically identical with the PCB design, components and electro magnetic compatibility characteristics, and model: DR-2180 has been tested by BACL(Kunshan). The differences of them are as follows: The model name Please contact me if there is need for any additional clarif ication or information. Best Regards, Sig nature: Print Name: JINXIAN YANG Title:Manager Company Name: NINGBO DIYA ELECTRIC APPLIANCE CO., LTD. Add: SIMEN TOWN YUYAO CITY ZHEJIANG CHINA Tel: +86-0574-62160725 Fax: +86-0574-62161137 E-mail: [email protected]

Company Name: NINGBO DIYA ELECTRIC APPLIANCE CO.,LTD. Add: SIMEN TOWN YUYAO CITY ZHEJIANG CHINA Tel: +86-0574-62160725 Fax: +86-0574-62161137 E-mail: [email protected] FCC Confidential Authorization Date: 2021 -0 5- 25 FEDERAL COMMUNICATIONS COMMISSIONS Autho ri zation an d Evaluation Division 7435 Oakland Mills Road Columbi a, MD 21046 Subject: Confidentiality Request regarding application for certification of FCC ID: 2AC2CDR-2180 To: whom it may concern, In accordance with Sections 0.457 and 0.459 of the Commission’s Rules, NINGBO DIYA ELECTRIC APPLIANCE CO.,LTD. hereby requests long-term confidential treatment of information accompanying this application as outlined below: Block Diagram Schematics Operation Descript ion The above materials co ntain proprietary and confiden tial information not customarily re leased to the publ ic. The public disclosur e of these material s provides unjustifi ed benefits to its compe titors in the market. Sinc erely Yours, Signature: Printed Name: JINXIAN YANG Title:Manager

EXHIBIT A - EUT EXTERNAL PHOTOGRAPHS

FCC ID: 2AC2CDR-2180 120VAC Type:DR-2180 Smart Plug 40mm 70mm

EXHIBIT B - EUT INTERNAL PHOTOGRAPHS PCB Antenna

Bay Area Compliance Laboratories Corp. (Kunshan) Report No.: RSHA210525002-00B FCC Part 15.247 Page 14 of 68 FCC §15.247 (I) & §1.1310 & §2.1091 - MAXIMUM PERMISSIBLE EXPOSURE (MPE) Applicable Standard According to subpart 15.247 (i) and subpart 1.1310, 2.1091 systems operating under the provisions of this section shall be operated in a manner that ensures the public is not exposed to RF energy level in excess of the communication guidelines. Limits for General Population/Uncontrolled Exposure Frequency Range (MHz) Electric Field Strength (V/m) Magnetic Field Strength (A/m) Power Density (mW/cm 2 ) Averaging Time (minutes) 0.3-1.34 614 1.63 *(100) 30 1.34-30 824/f 2.19/f *(180/f²) 30 30-300 27.5 0.073 0.2 30 300-1500 / f/1500 30 1500-100,000 / 1.0 30 f = frequency in MHz; * = Plane-wave equivalent power density Calculated Formulary: Predication of MPE limit at a given distance S = PG/4πR² = power density (in appropriate units, e.g. mW/cm 2 ); P = power input to the antenna (in appropriate units, e.g., mW); G = power gain of the antenna in the direction of interest relative to an isotropic radiator, the power gain factor, is normally numeric gain; R = distance to the center of radiation of the antenna (appropriate units, e.g., cm); Calculated Data: Mode Frequency Range (MHz) Maximum Antenna Gain Tune-up Output Power Evaluation Distance (cm) Power Density (mW/cm 2 ) MPE Limit (mW/cm 2 ) (dBi) (numeric) (dBm) (mW) 802.11b 2412-2462 1.50 1.41 18.00 63.10 20 0.0177 1.0 802.11g 1.50 1.41 19.00 79.43 20 0.0223 1.0 802.11n- HT20 1.50 1.41 18.50 70.79 20 0.0199 1.0 802.11 n-HT40 2422-2452 1.50 1.41 19.00 79.43 20 0.0223 1.0 Note: The Tune-up output power was declared by the Manufacturer. Conclusion: The device meets FCC MPE at 20 cm distance.

FCC PART 15.247 TEST REPORT For NINGBO DIYA ELECTRIC APPLIANCE CO., LTD. SIMEN TOWN YUYAO CITY ZHEJIANG CHINA FCC ID: 2AC2CDR-2180 Report Type: Original Report Product Type: Smart Plug Project Engineer: Jack Jiao Report Number: RSHA210525002-00B Report Date: 2021-06-10 Reviewed By: Oscar Ye EMC Manager Prepared By: Bay Area Compliance Laboratories Corp. (Kunshan) No.248 Chenghu Road, Kunshan, Jiangsu province, China Tel: +86-0512-86175000 Fax: +86-0512-88934268 www.baclcorp.com.cn Bay Area Compliance Laboratories Corp. (Kunshan) Report No.: RSHA210525002-00B FCC Part 15.247 Page 2 of 68 TABLE OF CONTENTS GENERAL INFORMATION ....................................................................................................................................... 4 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ..................................................................................... 4 OBJECTIVE ................................................................................................................................................................... 4 RELATED SUBMITTAL(S)/GRANT(S) ............................................................................................................................. 4 TEST METHODOLOGY .................................................................................................................................................. 5 MEASUREMENT UNCERTAINTY .................................................................................................................................... 5 TEST FACILITY ............................................................................................................................................................. 5 SYSTEM TEST CONFIGURATION .......................................................................................................................... 6 DESCRIPTION OF TEST CONFIGURATION ...................................................................................................................... 6 EQUIPMENT MODIFICATIONS ....................................................................................................................................... 6 EUT EXERCISE SOFTWARE .......................................................................................................................................... 6 SUPPORT EQUIPMENT LIST AND DETAILS .................................................................................................................... 9 EXTERNAL I/O CABLE .................................................................................................................................................. 9 BLOCK DIAGRAM OF TEST SETUP .............................................................................................................................. 10 SUMMARY OF TEST RESULTS ............................................................................................................................. 12 TEST EQUIPMENT LIST ......................................................................................................................................... 13 FCC §15.247 (I) & §1.1310 & §2.1091 - MAXIMUM PERMISSIBLE EXPOSURE (MPE) .................................. 14 APPLICABLE STANDARD ............................................................................................................................................ 14 CALCULATED FORMULARY: ....................................................................................................................................... 14 CALCULATED DATA: .................................................................................................................................................. 14 FCC §15.203 - ANTENNA REQUIREMENT ........................................................................................................... 15 APPLICABLE STANDARD ............................................................................................................................................ 15 ANTENNA CONNECTOR CONSTRUCTION .................................................................................................................... 15 FCC §15.207 (a) – AC LINE CONDUCTED EMISSIONS ..................................................................................... 16 APPLICABLE STANDARD ............................................................................................................................................ 16 EUT SETUP ................................................................................................................................................................ 16 EMI TEST RECEIVER SETUP ....................................................................................................................................... 16 TEST PROCEDURE ...................................................................................................................................................... 17 FACTOR & OVER LIMIT CALCULATION ...................................................................................................................... 17 TEST RESULTS SUMMARY .......................................................................................................................................... 17 TEST DATA ................................................................................................................................................................ 17 FCC §15.209, §15.205 & §15.247(d) - SPURIOUS EMISSIONS ............................................................................. 20 APPLICABLE STANDARD ............................................................................................................................................ 20 EUT SETUP ................................................................................................................................................................ 20 …

Text truncated - open the document above for the full version.

EXHIBIT C - TEST SETUP PHOTOGRAPHS Conducted Emissions - Front Side Conducted Emissions - Left Side Radiated Emissions (Below 1GHz) Radiated Emissions (Above 1GHz)