2ACCJN003CDMA + LTE mobile phone for Sprint

Important Information for the ALCATEL ONETOUCH Conquest 2 Important Safety Information Important Safety Information 3 IMPORTANT SAFETY INFORMATION This booklet contains important operational and safety information that will help you safely use your phone. Failure to read and follow the information provided in this booklet may result in serious bodily injury, death, or property damage. General Precautions There are several simple guidelines to operating your phone properly and maintaining safe, satisfactory service. +To maximize performance, do not touch the bottom portion of your phone where the internal antenna is located while using the phone. +Speak directly into the mouthpiece. +Avoid exposing your phone and accessories to rain or liquid spills. If your phone does get wet, immediately turn the power off and remove the battery. +Do not expose your phone to direct sunlight for extended periods of time (such as on the dashboard of a car). +Although your phone is quite sturdy, it is a complex piece of equipment and can be broken. Avoid dropping, hitting, bending, or sitting on it. +Any changes or modifications to your phone not expressly approved in this document could void your warranty for this equipment and void your authority to operate this equipment. Note: For the best care of your device, only authorized personnel should service your phone and accessories. Failure to do so may be dangerous and void your warranty. Maintaining Safe Use of and Access to Your Phone Do Not Rely on Your Phone for Emergency Calls Mobile phones operate using radio signals, which cannot guarantee connection in all conditions. Therefore you should never rely solely upon any mobile phone for essential communication (e.g., medical emergencies). Emergency calls may not be possible on all cellular networks or when certain network services or mobile phone features are in use. Check with your local service provider for details. Using Your Phone While Driving Talking on your phone while driving (or operating the phone without a hands-free device) is prohibited in some jurisdictions. Laws vary as to specific restrictions. Remember that safety always comes first. Following Safety Guidelines To operate your phone safely and efficiently, always follow any special regulations in a given area. Turn your phone off in areas where use is forbidden or when it may cause interference or danger. Using Your Phone Near Other Electronic Devices Most modern electronic equipment is shielded from radio frequency (RF) signals. However, RF signals from wireless phones may affect inadequately shielded electronic equipment. RF signals may affect improperly installed or inadequately shielded electronic operating systems or entertainment systems in motor vehicles. Check with the manufacturer or their representative to determine if these systems are adequately shielded from external RF signals. Also check with the manufacturer regarding any equipment that has been added to your vehicle. 4 Important Safety Information Important Safety Information 5 Restricting Children’s Access to Your Phone Your phone is not a toy. Do not allow children to play with it as they could hurt themselves and others, damage the phone or make calls that increase your invoice. Using Your Phone With a Hearing Aid Device A number of Boost phones have been tested for hearing aid device compatibility. When some wireless phones are used with certain hearing devices (including hearing aids and cochlear implants), users may detect a noise which can interfere with the effectiveness of the hearing device. Some hearing devices are more immune than others to this interference noise, and phones also vary in the amount of interference noise they may generate. ANSI standard C63.19 was developed to provide a standardized means of measuring both wireless phone and hearing devices to determine usability rating categories for both. Ratings have been developed for mobile phones to assist hearing device users find phones that may be compatible with their hearing device. Not all phones have been rated for compatibility with hearing devices. Phones that have been rated have a label located on the box. Your ALCATEL ONETOUCH Conquest has an M4/T4 rating. These ratings are not guarantees. Results will vary depending on the user’s hearing device and individual type and degree of hearing loss. If a hearing device is particularly vulnerable to interference noise; even a phone with a higher rating may still cause unacceptable noise levels in the hearing device. Trying out the phone with your hearing device is the best way to evaluate it for your personal needs. M-Ratings: Phones rated M4 meet FCC requirements for hearing aid compatibility and Consult the manufacturer of any personal medical devices, such as pacemakers and hearing aids, to determine if they are adequately shielded from external RF signals. Note: Always turn off the phone in healthcare facilities, and request permission before using the phone near medical equipment. Turning Off Your Phone Before Flying Turn off your phone before boarding any aircraft. To prevent possible interference with aircraft systems, the U.S. Federal Aviation Administration (FAA) regulations require you to have permission from a crew member to use your phone while the plane is on the ground. To prevent any risk of interference, FCC regulations prohibit using your phone while the plane is in the air. Turning Off Your Phone in Dangerous Areas To avoid interfering with blasting operations, turn your phone off when in a blasting area or in other areas with signs indicating two-way radios should be turned off. Construction crews often use remote-control RF devices to set off explosives. Turn your phone off when you’re in any area that has a potentially explosive atmosphere. Although it’s rare, your phone and accessories could generate sparks. Sparks can cause an explosion or fire, resulting in bodily injury or even death. These areas are often, but not always, …

Text truncated - open the document above for the full version.

TCL Communication Ltd. 5F, C building, No. 232, Liang Jing Road, ZhangJiang High-Tech Park, Pudong Shanghai, P.R. China. 201203 Tel: +86 21 6146 0666 Fax: +86 21 6146 0602 http://tclcom.tcl.com Date 2015-01-19 To: Federal Communications Commission, Authorization & Evaluation Division, 7345 Oakland Mills Road Columbia, MD 21046 And American Certification Body, Inc. 6731 Whittier Avenue Suite C110 McLean, VA 22101 To Whom It May Concern: CTTL-Terminals Test Lab of China Academy of Telecommunication Research of MIIT is authorized to act on our behalf, until otherwise notified, for applications to American Certification Body, Inc. (ACB). We certify that we are not subject to denial of federal benefits, which includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, U.S.C. 862. Further, no party, as defined in 47 CFR1.2002 (b) to the application is subject to denial of federal benefits, that includes FCC benefits. Thank you. Regards, Zhizhou GONG Product Certification Manager TCL Communication Ltd.

2015-05-26 Federal Communications Commission Office of Engineering and Technology Equipment Authorization Division 7345 Oakland Mills Road Columbia, Maryland 21046 Subject: Confidentiality request or FCC ID: 2ACCJN003 To Whom It May Concern: Pursuant to Sections 0.457(d)(1)(ii) and 0.459 of the Commission’s Rules, (TCL Communication Ltd.) hereby requests permanent confidential treatment of information accompanying this application as outlined below: - Block Diagram - Schematics - Operational Description - BOM list/Tune-Up-Procedure The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. The Applicant understands that pursuant to Rule 0.457(d)(1)(ii), disclosure of this Application and all accompanying materials will not be made before the date of the Grant for this Application. Yours sincerely, Zhizhou GONG Product Certification Manager TCL Communication Ltd.

TLp0 TLp 0 025A2 025A2

©Copyright. All rights reserved by CTTL. FCC PART 15C TEST REPORT No. I15Z40867-SRD02 for TCL Communication Ltd. CDMA+LTE mobile phone for Sprint Model Name: 7046T FCC ID: 2ACCJN003 with Hardware Version: HW0001 Software Version: 7046TC01 Issued Date: 2015-05-15 Note: The test results in this test report relate only to the devices specified in this report. This report shall not be reproduced except in full without the written approval of CTTL. Test Laboratory: CTTL, Telecommunication Technology Labs, Academy of Telecommunication Research, MIIT No.52, HuayuanNorth Road, Haidian District, Beijing, P. R. China 100191. Tel:+86(0)10-62304633-2512,Fax:+86(0)10-62304633-2504 Email:[email protected], website:www.chinattl.com TESTING CNAS L0570 No. I15Z40867-SRD02 Page2 of 91 ©Copyright. All rights reserved by CTTL. REPORT HISTORY Report Number Revision Description Issue Date I15Z40867-SRD02 Rev.0 1st edition 2015-05-15 No. I15Z40867-SRD02 Page3 of 91 ©Copyright. All rights reserved by CTTL. CONTENTS 1. TEST LABORATORY ............................................................................................................... 4 1.1. TESTING LOCATION ........................................................................................................... 4 1.1. TESTING ENVIRONMENT ................................................................................................... 5 1.2. PROJECT DATA ................................................................................................................... 5 1.3. SIGNATURE .......................................................................................................................... 5 2. CLIENT INFORMATION ........................................................................................................... 6 2.1. APPLICANT INFORMATION ................................................................................................ 6 2.2. MANUFACTURER INFORMATION ...................................................................................... 6 3. EQUIPMENT UNDERTEST (EUT) AND ANCILLARY EQUIPMENT (AE) ............................. 7 3.1. ABOUT EUT .......................................................................................................................... 7 3.2. INTERNAL IDENTIFICATION OF EUT ................................................................................ 7 3.3. INTERNAL IDENTIFICATION OF AE ................................................................................... 7 3.4. NORMAL ACCESSORY SETTING ............................................................................................. 8 3.5. GENERAL DESCRIPTION ....................................................................................................... 8 4. REFERENCE DOCUMENTS .................................................................................................... 8 4.1. DOCUMENTS SUPPLIED BY APPLICANT ........................................................................ 8 4.2. REFERENCE DOCUMENTS FOR TESTING ...................................................................... 8 5. TEST RESULTS........................................................................................................................ 9 5.1. SUMMARY OF TEST RESULTS ................................................................................................ 9 5.2. STATEMENTS........................................................................................................................ 9 6. TEST FACILITIES UTILIZED ................................................................................................. 10 ANNEX A: DETAILED TEST RESULTS ........................................................................................ 11 A.1. MEASUREMENT METHOD ........................................................................................................ 11 A.2. PEAK OUTPUT POWER – CONDUCTED .................................................................................... 13 A.3. FREQUENCY BAND EDGES – CONDUCTED .............................................................................. 14 A.4. CONDUCTED EMISSION .......................................................................................................... 21 A.5. RADIATED EMISSION .............................................................................................................. 46 A.6. TIME OF OCCUPANCY (DWELL TIME) ....................................................................................... 65 A.7. 20DB BANDWIDTH ................................................................................................................. 75 A.8. CARRIER FREQUENCY SEPARATION ........................................................................................ 81 A.9. NUMBER OF HOPPING CHANNELS .......................................................................................... 84 A.10. AC POWERLINE CONDUCTED EMISSION ............................................................................... 88 ANNEX B: ACCREDITATION CERTIFICATE ............................................................................... 91 No. I15Z40867-SRD02 Page4 of 91 ©Copyright. All rights reserved by CTTL. 1. Test Laboratory 1.1. Testing Location Location 1:CTTL(huayuan North Road) Address: No. 52, Huayuan North Road, Haidian District, Beijing, P. R. China100191 Location 2:CTTL(Shouxiang) Address: No. 51 Shouxiang Science Building, Xueyuan Road, Haidian District, Beijing, P. R. China100191 No. I15Z40867-SRD02 Page5 of 91 ©Copyright. All rights reserved by CTTL. 1.1. Testing Environment Normal Temperature: 15-35°C Extreme Temperature: -10/+55°C Relative Humidity: 20-75% 1.2. Project data Testing Start Date: 2015-05-04 Testing End Date: 2015-05-15 1.3. Signature Xu Zhongfei (Prepared this test report) Li Zhibin (Reviewed this test report) Lv Songdong (Approvedthis test report) No. I15Z40867-SRD02 Page6 of 91 ©Copyright. All rights r…

Text truncated - open the document above for the full version.

CE C CE U Charger USB RE CCharger RE U USB RSE