2ACPO-MM1Punk

Safety, Regulatory & Legal PUNK en 2Battery Use & SafetyWarning! Your product contains a battery which should only be removed by a SOL REPUBLIC approved service center or recycler. Do not try to remove or replace the battery yourself. Attempting to remove or replace the battery may damage the battery and may cause burning and injury. Do not try to take apart or fi x your product. Attempting to take apart or fi x your product may damage the battery and may cause burning and injury. Do not crush, bend, or expose your product to heat or liquid. This may damage the battery and may cause burning and injury. Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. Battery Charging During charging, keep your product and charger near room temperature for effi cient battery charging. New batteries are not fully charged.New batteries or batteries stored for a long time may take more time to charge. SOL REPUBLIC batteries and charging systems have circuitry that protects thebattery from damage from overcharging. Third Party AccessoriesUsing third party accessories, including but not limited to batteries, chargers, headsets, covers, cases, screen protectors, and memory cards, may impact your product’s performance. Using a non-SOL REPUBLIC battery or charger may present a risk of fi re, explosion, leakage, or other hazard. SOL REPUBLIC’s warranty does not cover damage to the product caused by non-SOL REPUBLIC batteries and/or chargers. Driving PrecautionsResponsible and safe driving is your primary responsibility when driving 3 a vehicle. Making calls or using applications while driving may cause distraction, and may be prohibited or restricted in certain areas—always obey local laws and regulations for the use of mobile devices and accessories in the vehicle. While driving, ALWAYS: • Keep your eyes on the road.• Use a handsfree device if available or required by law in your area.• Enter destination information into a navigation device before driving.• Use voice activated features (such as voice dial) and speaking features (such as audible directions), if available. • Concentrate on driving, and stop using the mobile device if you can not concentrate. Pull over safely before using your mobile device to send messages, surf the web, or use other applications. Caution About High Volume UsageWarning: Exposure to loud noise from any source for extended periods of time may affect your hearing. The louder the volume sound level, the less time is required before your hearing could be affected. To protect your hearing: • Limit the amount of time you use headsets or headphones at high volume.• Avoid turning up the volume to block out noisy surroundings.• Turn the volume down if you can not hear people speaking near you. If you experience hearing discomfort, including the sensation of pressure or fullness in your ears, ringing in your ears, or muffl ed speech, you should stop listening to the device through your speaker, headset or headphones and have your hearing checked. ChildrenKeep your product and its accessories away from small children. These products are not toys and may be hazardous to small children. For example, a choking hazard may exist for small, detachable parts. 4Use & CareTo care for your SOL REPUBLIC product, please observe the following: • Liquids - do not expose your product to water, rain, extreme humidity, sweat, or other liquids. • Drying - do not try to dry your product using a microwave oven, conventional oven, or dryer. • Extreme heat or cold - avoid temperatures below -10°C (14°F) or above 45°C (113°F). For battery powered accessories, do not recharge your accessory in temperatures below 0°C (32°F) or above 45°C (113°F). • Dust and dirt - do not expose your product to dust, dirt, sand, food, or similar materials. • Cleaning - to clean your product, use only a dry soft cloth. Do not use alcohol or other cleaning solutions. • Shock and vibration - do not drop your product or expose it to strong vibration. • Protection - to help protect your product, always make sure that all connector and compartment covers are closed and secure, and avoid carrying it with hard objects such as keys or coins. Changes or modifi cations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC Verifi cation of ConformityResponsible Party Name: SOL REPUBLIC INC. Address: 9375 SW Commerce Cir, Suite A9, Wilsonville, OR 97070 USA Phone Number: 1.503.682.0424 hereby declares that Product Name: PUNKModel Number: MM1FCC ID: 2ACPO-MM1 conforms to the following regulations: FCC Part 15, subpart B, section 15.107(a), 15.107(d) and section 15.109(a). 5 FCC Notice to UsersThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that …

Text truncated - open the document above for the full version.

Authority to Act as Agent Authority to Act as Agent Date: 2014-7-30 To Whom It May Concern: We, the undersigned, hereby authorize SGS-CSTC Standards Technical Services Co., Ltd. (SGS) Shenzhen Branch and Hellen Wang in SGS-CSTC Standards Technical Servic;es Co., Ltd. (SGS) ?h~o;;:hen Bra ncb to act on our behalf in all matters relating to all processes required in FCC approval and any communication needed with the national authority, shall have the same legal authority as acts on our own behalf. We certify that we are not subject to denial offederal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of1988, 21 U.S. C. 862. Further, no party, as defined in 47 CFR 1.2002 (b), to the application is subject to denial of federal benefits, that includes FCC benefits. Thank you Agency Agreement Expiration Date: 12 Months By:-/A lz~-- Brian Knauss Title: Project Manager On behalf of: SOL REPUBLIC INC Telephone: +1415.860.3127 SOL REPUBLIC, Inc. • 1375 Mission St., San Francisco, CA 94103 USA • +1.877-400.0310 CONFIDENTIAL Vicky Yuan

2ACPO-MM1

1 Photographs - EUT Constructional Details Test Model No.: MM1

FCC ID: 2ACPO-MM1 IC: 12232A-MM1 XXXXX R XXX-XXXXXX XXXXXXXXXXXXXX TRA REGISTERED No: nnnnnnn DEALER No: xxxxxxx 421T00001 Assembled in China 421T00001 INPUT VOLTAGE: CMIIT ID: xxxxxx MODEL: MM1 25mm FreightSans MediumSC FreightSans MediumSC

1 Photographs - EUT Constructional Details Test Model No.: MM1

SGS-CSTC Standards Technical Services Ltd. No. 1 W orkshop, M-10, Middle section, Science & Technology Park, Nanshan District, Shenzhen, Guangdong, China 518057 Telephone: +86 (0) 755 2601 2053 Fax: +86 (0) 755 2671 0594 Email: [email protected] Report No.: SZEM140700375802 Page: 1 of 96 Authorized Signature: Jack Zhang EMC Laboratory Manager The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of SGS International Electrical Approvals or testing done by SGS International Electrical Approvals in connection with, distribution or use of the product described in this report must be approved by SGS International Electrical Approvals in writing. The report must not be used by the client to claim product certification, approval, or endorsement by NVLAP, NIST, or any agency of the federal government. All test results in this report can be traceable to National or International Standards. “This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only.” 1 Cover page FCC REPORT Application No: SZEM1407003758RF Applicant: SOL REPUBLIC, INC. Manufacturer: SOL REPUBLIC, INC. Product Name: Punk Model No.(EUT): MM1 Trade Mark: Punk FCC ID: 2ACPO-MM1 Standards: 47 CFR Part 15, Subpart C (2013) Date of Receipt: 2014-07-19 Date of Test: 2014-07-28 to 2014-08-05 Date of Issue: 2014-08-07 Test Result: PASS * * In the configuration tested, the EUT complied with the standards specified above. SGS-CSTC Standards Technical Services Ltd. Report No.: SZEM140700375802 Page: 2 of 96 “This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only.” 2 Version Revision Record Version Chapter Date Modifier Remark 00 2014-08-07 Original Authorized for issue by: Tested By 2014-08-05 (Owen Zhou) /Project Engineer Date Prepared By 2014-08-07 (Hedy Wen) /Clerk Date Checked By 2014-08-08 (Emen Li) /Reviewer Date SGS-CSTC Standards Technical Services Ltd. Report No.: SZEM140700375802 Page: 3 of 96 “This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only.” 3 Test Summary Test Item Test Requirement Test method Result Antenna Requirement 47 CFR Part 15, Subpart C Section 15.203/15.247 (c) ANSI C63.10 (2009) PASS AC Power Line Conducted Emission 47 CFR Part 15, Subpart C Section 15.207 ANSI C63.10 (2009) PASS …

Text truncated - open the document above for the full version.

1 Photographs - EUT Test Setup Test Model No.: MM1 1.1 Conducted Emissions 1.2 Radiated Emission