2ADEWSFO-V1-041Remote Control Transmitter

One AGENCY FCC Information to User This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is con-nected. • Consult the dealer or an experienced radio/TV technician for help. Caution Modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC Compliance Information : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation Information to user. The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. In cases where the manual is provided only in a form other than paper, such as on a computer disk or over the Internet, the information required by this section may be included in the manual in that alternative form, provided the user can reasonably beexpected to have the capability to access information in that form. IMPORTANT NOTE: IMPORTANT Safety Instruction: 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this equipment near water. 6) Do not using near any heat sources such as radiators, heat resisters, stove, or other equipment that produce heat. One AGENCY Indigo Building 4, Office 1, 1st Floor, Alsafa2, Sheikh zayed Road, Dubai, UAE Tel: +971-4-371-9200 / Fax: +971-4-346-8857 URL: www.oneagencymea.com

One AGENCY Indigo Building 4, Office 1, 1st Floor, Alsafa2, Sheikh zayed Road, Dubai, UAE Tel No : +971-4-371-9200 Fax No : +971-4-346-8857 LETTER OF AUTHORIZATION To whom it may concern: We, the undersigned, hereby authorize Standard Engineering Co., Ltd., to act on our behalf in all manners relating to application for equipment authorization for FCC ID: 2ADEWSFO-V1-041. including signing of all documents relating to these matters. Any and all acts carried out by Standard Engineering Co., Ltd., on our behalf shall have the same affect as acts of our own. This authorization is valid until further written notice from One AGENCY Standard Engineering Co., Ltd. (Contact Person) Contact name: Soon Ho, Kim Position: Manager Phone: 82-41-663-9436 E-mail: [email protected] <Date> October 20, 2014 Sincerely, WooSung, Choi/ CEO Company Name: One AGENCY Address: #Indigo Building 4, Office 1, 1st Floor, Alsafa2, Sheikh zayed Road, Dubai, UAE TEL : +971-4-371-9200 FAX : +971-4-346-8857 Email : [email protected]

One AGENCY Indigo Building 4, Office 1, 1st Floor, Alsafa2, Sheikh zayed Road, Dubai, UAE Tel No : +971-4-371-9200 Fax No : +971-4-346-8857 Federal Communications Commission Authorization and Evaluation Division Confidentiality Request regarding application for certification of FCC ID: 2ADEWSFO-V1-041 Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, we hereby request confidential treatment of information accompanying this application as outlined below: Exhibit Type ■ Block Diagram ■Schematics ■Parts List ■Operational description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Pursuant to DA04-1705 June 15, 2004 of the Commission’s public notice, we also request temporary confidential treatment of information accompanying this application as outlined below: <Date> October 20, 2014 Sincerely, WooSung, Choi / CEO One AGENCY Email : [email protected]

One AGENCY Indigo Building 4, Office 1, 1st Floor, Alsafa2, Sheikh zayed Road, Dubai, UAE Tel No : +971-4-371-9200 Fax No : +971-4-346-8857 Subject: DoC declaration To Whom it may concern, We, as the grantee of this project FCC ID: 2ADEWSFO-V1-041, would like to declare that the composite portion categorized as computer peripheral has been authorized under the Declaration of Conformity procedures. Test Laboratory : Standard Engineering Co., Ltd. 377-11, Sinjang-ri, Eumam-myeon, Seosan-si, ChoongNam, South Korea <Date> October 20, 2014 Sincerely, WooSung, Choi/ CEO Company Name: One AGENCY Address: #Indigo Building 4, Office 1, 1st Floor, Alsafa2, Sheikh zayed Road, Dubai, UAE TEL : +971-4-371-9200 FAX : +971-4-346-8857 Email : [email protected]

Photo 1: Exterior Photographs Top Bottom Side 1 Side 2 Side 3 Side 4

Label Information 1. Label Location 2. Label Drawing Label position

Interior view of EUT Internal Photos View of Main PCB(Top) View of Main PCB(Bottom) View of Battery(Top) View of Battery(Bottom) View of Antenna

STANDARD ENGINEERING FCC ID : 2ADEWSFO-V1-041 Report Number : STD-FCC-14060 Page 1/19 1. Applicant Name : One AGENCY Address : Indigo Building 4, Office 1, 1st Floor, Alsafa2, Sheikh zayed Road, Dubai, UAE FCC ID : 2ADEWSFO-V1-041 2. Products Name : Remote Control Transmitter Model No. : SFO-V1-041 Variant Model No. : N/A Manufacturer GIORDON AUDIO ALARM EQUIPMENT CO.,LTD Address : NO.25 EAST TONGXING ROAD, DONGSHENG, ZHONGSHAN 3. Test Standard: 47 CFR Part 15, Subpart C 4. Test Method: ANSI C63.10-2009 5. Test Result: PASS 6. Dates of Test: October 04, 2014 to October 07, 2014 7. Date of Issue: October 08, 2014 8. Test Laboratory: Standard Engineering Co. Ltd. FCC Designation Number : 624439 TEST REPORT Tested by Approved by SoonHo, Kim / Test Engineer SeongSeok, Seo / Compliance Engineer This report may not be reproduced without the full written consent of Standard Engineering Laboratory. Standard Engineering Co. Ltd. 145, Hwanggeumteo-gil, Eumam-myeon, Seosan-si, Chungcheongnam-do 356-844, Republic of Korea Tel.: +82-41-663-9436, Fax :+82-41-663-9434 www.stdeng.com STANDARD ENGINEERING FCC ID : 2ADEWSFO-V1-041 Report Number : STD-FCC-14060 Page 2/19 1. Test Summary TestTest RequirementTest methodResult Antenna Requirement 47 CFR Part 15, Subpart C Section 15.203 ANSI C63.10(2009) PASS Field Strength of the Fundamental Signal 47 CFR Part 15, Subpart C Section 15.231 (b) ANSI C63.10(2009) PASS Spurious Emissions 47 CFR Part 15, Subpart C Section 15.231 (b)/15.209 ANSI C63.10(2009) PASS 20dB Bandwidth 47 CFR Part 15, Subpart C Section 15.231 (c) ANSI C63.10(2009) PASS Dwell time 47 CFR Part 15 Subpart C Section 15.231 (a) (1) ANSI C63.10(2009) PASS STANDARD ENGINEERING FCC ID : 2ADEWSFO-V1-041 Report Number : STD-FCC-14060 Page 3/19 2. TABLE OF CONTENTS 1. Test Summary...........................................................................................................................................................2 2. Table of Contents....................................................................................................................................................3 3. General Information...............................................................................................................................................4 3.1 Client Information............................................................................................................................................4 3.2 General Description of E.U.T........................................................................................................................4 3.3 Details of E.U.T..................................................................................................................................................4 3.4 Test Environment and Mode.......................................................................................................................4 3.5 Description of Support Units ......................................................................................................................4 3.6 Abnormalities from Standard Conditions...............................................................................................5 3.7 Other Information Requested by the Customer..................................................................................5 3.8 Test Location.....................................................................................................................................................5 4. Equipment Used during Test..............................................................................................................................6 5. Test Results and Measurement Data...............................................................................................................7 5.1 Antenna Requirement....................................................................................................................................7 5.2 Spurious Emissions..........................................................................................................................................8 5.2.1Spurious Emissions.......................................................................................................................................8 5.2.1.1 Field Strength Of The Fundamental Signal..............................................................................11 5.2.1.2 Spurious Emissions...........................................................................................................................12 5.3 20dB Bandwidth.............................................................................................................................................15 5.4 Deactivated time............................................................................................................................................17 ** APPENDIX............................................................................................................................................................19 STANDARD ENGINEERING FCC ID : 2ADEWSFO-V1-041 Report Number : STD-FCC-14060 Page 4/19 Operation Frequency : 315MHz Channel Numbers: 1 Modulation Type: ASK Antenna Type: PCB Pattern Antenna Power Supply: 6.0V DC (3.0V x 2 “Lithium Battery") Test Voltage: DC 6.0V 3. General Information 3.1. Client Information Applicant : One AGENCY Address of Applicant : Indigo Building 4, Office 1, 1st Floor, Alsafa2, Sheikh zayed Road, Dubai, UAE Manufacturer : GIORDON AUDIO ALARM EQUIPMENT CO.,LTD Address of Manufacturer : NO.25 EAST TONGXING ROAD, DONGSHENG, ZHONGSHAN 3.2. General Description of E.U.T. Product Name : Remote Control Transmitter Model No. : SFO-V1-041 3.3. Details of E.U.T. 3.4. Test Environment and Mode Operating Environment: Temperature : 26.5 °C Humidity : 47% RH Atmospheric Pressure : 1023 mbar Test mode: Transmitting mode : Keep the EUT in transmitting mode with modulation. 3.5. Description of Support…

Text truncated - open the document above for the full version.