2ADM5-ET-0122-49RC SHOOTING ROBO (49 MHz)

Warning Specifications Remote Standard Control Package Contents Product Overview Care and Maintenance Performance Tips FCC Statement This device complies with the part 15 of the FCC rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instructions may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or experienced radio/ TV technician for help. RF warning statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. IMPORTANT: BATTERY INFORMATION WARNING: TO AVOID BATTERY LEAKAGE: Keep All Relevant Information for Future Reference Batteries Installation - Remote Control Instruction Manual Thank you for purchasing the REMOTE CONTROL DART TANK. This manual provides more information about this DART TANK, please read the instructions before using. Remote Control Dart Tank x 1 Remote Control x 1 Suction Dart x 3 Instruction Manual x 1 Remote Control Dart Tank Suction Dart x 3 Base View Remote Controller Note: To avoid losing control, always pay attention when controlling the Remote Control Dart Tank. Press Forward Button to move forward the tank Forward Button Press Backward Button to move backward anti-clockwise the tank Forward Button This product is suitable to be used by people who has operating experience in remote toy or aged no less than 10 years old. Please do not put the product in your mouth to prevent choking hazard of small parts. Except the screw on the battery cover. Never try to open the product by unscrew the other screws of product. Nothing inside for service. Please do not put the finger into available interspaces. Please do not play the product in a brutal way such as throwing, crashing or twisting it. Please store the smaller-sized product accessories in places that are out of reach of children, in order to avoid the occurrence of accidents. Avoid placing the batteries in places in high temperatures and avoid exposure to heat. When young children are operating the product, it shall be ensured that the adults are guiding and making sure the product control is within the viewing range of the controller (or instructor) so that it makes the control of the toy more convenient. When the product is not in use, please switch off the power supplies of the toy, and remove the batteries from the product. Please note that we won’t take any responsibility for any wrong operation as this may result in severe injury or loss of property, and we cannot control the operating process during the time when the user assembles or uses this product. Once this product is sold, we won’t be responsible for any safety responsibility during the time the user operates or uses controls this products. Always use dry and soft cloth to clean this product. Avoid this product from being exposed to sunlight or heat. Avoid immersing these toys in water, otherwise, the electronic parts may be damaged. Check the product regularly. If any damages are discovered, please stop using immediately, until it is completely repaired in good working condition. 1. Do not drive the RC Dart Tank on grass, sand or go through water. 2. Do not drive the RC Dart Tank in windy or rainy weather. 3. Do not drive the RC Dart Tank into any sharp object. 4. Keep fingers, hair and loose clothing away from RC Dart Tank wheels. 5. Never aim the suction dart to eyes and anypart of body. To install batteries into the Remote Control Dart Tank, unscrew the screw on the battery box cover to open the cover. Insert 3 x “AA” 1.5V batteries (Not Included) into the battery box. Batteries should be placed as shown on the diagram. Put back in place the battery box cover and tighten the screw. Instruction Manual Instruction Manual Batteries Installation - Dart Tank Remote Control Dart Tank Power Supply: 3 x “AA” 1.5V Batteries (Alkaline type preferred, not included) Remote Control Power Supply: 2 x “AAA” 1.5V Batteries (not included) Power On/Off How to shoot the suction dart Slide the ON/OFF Switch to ON to turn on the RC Dart Tank. Slide the ON/OFF Switch to OFF to turn off the RC Dart Tank. 1. Put the suction darts into the barrel of the tank Made in China Distributed by 1616 Holdings, Inc. 701 Market Street, Suite 200 Philadelphia, PA 19106 1) The batteries used with this product are small parts and should be kept away from small children who still put things in their mouths. If they are swallowed, promptly see a doctor and have the doctor phone American Association of Poison Control Centers (1-800-222-1222). 2) Always purchase the correct size and grade of battery most suitable for intended use. 3) Do not mix old and new batteries, alkaline, standard (Carbon - Zinc) or rechargeable (Nickel-cadmium) batteries. 4) Clean the battery contacts and those of the device prior to battery installation. 5) Ensure the batteries are installed correctly with the rega…

Text truncated - open the document above for the full version.

49.86MHz 49.86MHz

202 FE D Aut 743 Col u Su b To w We , Com app to t h our We , that 21 U Thi s Sin c Sig n Prin Titl QA-F 20/08/13 DERAL CO thorization a 5 Oakland M umbia, MD bject: Agent whom it ma , Zeeva Inte mpliance La lication for hese matters behalf shal , the unders t includes FC U.S.C. 862. s authorizat cerely Your nature: nted Name: e: Vice P r FR-170-B OMMUNICA and Evaluat Mills Road D 21046 t Authorizat ay concern: ernational L aboratories Equipmen t s. All acts c l have the s signed, here CC benefits tion is valid rs, Akshay P B resident FCC ATIONS C tion Divisio tion Limited the u Corporation t authorizati carried out b same effect eby certify th s, pursuant t d until furthe Butani Zeeva Int Suite 100 Road, Ko Tel: +852 E-mail: a C Author COMMISSIO on undersigned n to act on i ion, includin by Bay Area as our own hat we are n to Section 5 er written n ternational Lim 07B, 10th Floo owloon Bay, H 2-2868 0511 | akshay.butan rization ONS d, hereby au its behalf in ng the signi a Complian action. not subject t 5301 of the otice from t mited or, Exchange T Hong Kong Fax: +852-2 5 [email protected] uthorize Bay n all matters ing of all do nce Laborato to a denial o Anti-Drug the applican Tower, 33 Wa 524 1986 com y Area relating to ocuments re ory Corpora of federal b Abuse Act nt. ang Chiu elating ation on enefits, of 1988,

EXHIBIT B - EUT EXTERNAL PHOTOGRAPHS Antenna

EXHIBIT A - FCC ID LABEL AND LOCATION FCC ID Label FCC ID Label Location Information = The label shown shall be permanently affixed at a conspicuous location on the device and be readily visible to the user at the time purchase (Labeling requirements per 2.925)

EXHIBIT C - EUT INTERNAL PHOTOGRAPHS

Technical Description TX-2A Coding IC and the peripheral oscillation modulation amplification circuit is composed. When the function button is pressed by the IC encoded into a set of binary serial code, by the modulation circuit to load the encoded signal into the carrier, amplified by amplification circuit and emitted by the antenna. Radio parameters Antenna gain：0dbi Antenna Type：Whip antenna Frequency：49.86MHz

Note: This report must not be used by the customer to claim product certification, approval, or endorsement by A2LA* or any agency of the Federal Government. This report may contain data that are not covered by the A2LA accreditation and are marked with an asterisk “★”. BACL is not responsible for the authenticity of any test data provided by the applicant. Data included from the applicant that may affect test results are marked with an asterisk ’*’. Customer model name, addresses, names, trademarks etc. are not considered data. This report cannot be reproduced except in full, without prior written approval of the Company. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested. This report is valid only with a valid digital signature. The digital signature may be available only under the Adobe software above version 7.0. FCC PART 15.235 TEST REPORT For Zeeva International Limited Suite 1007B,10th Floor, Exchange Tower, 33 Wang Chiu Road, Kowloon Bay, HongKong, China FCC ID: 2ADM5-ET-0122-49 R e p o r t T y p e : O r i g i n a l R e p o r t P r o d u c t T y p e : R C S H O O T IN G R O B O T (4 9 M H z) Report Number: RSZ200723833-00 Report Date: 2020-07-31 Reviewed By: Jimmy Xiao RF Engineer Test Laboratory: Bay Area Compliance Laboratories Corp. (Shenzhen) 6/F., West Wing, Third Phase of Wanli Industrial Building, Shihua Road, Futian Free Trade Zone, Shenzhen, Guangdong, China Tel: +86-755-33320018 Fax: +86-755-33320008 www.baclcorp.com.cn Bay Area Compliance Laboratories Corp. (Shenzhen) Report No.: RSZ200723833-00 FCC Part 15.235 Page 2 of 14 TABLE OF CONTENTS GENERAL INFORMATION ....................................................................................................................................... 3 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) .................................................................................... 3 OBJECTIVE ................................................................................................................................................................... 3 RELATED SUBMITTAL(S)/GRANT(S) ............................................................................................................................. 3 TEST METHODOLOGY .................................................................................................................................................. 3 TEST FACILITY ............................................................................................................................................................. 3 SYSTEM TEST CONFIGURATION .......................................................................................................................... 4 JUSTIFICATION ............................................................................................................................................................. 4 SPECIAL ACCESSORIES ................................................................................................................................................. 4 EQUIPMENT MODIFICATIONS ....................................................................................................................................... 4 BLOCK DIAGRAM OF TEST SETUP ................................................................................................................................ 4 SUMMARY OF TEST RESULTS ............................................................................................................................... 5 TEST EQUIPMENT LIST ........................................................................................................................................... 6 FCC §15.203 - ANTENNA REQUIREMENT ............................................................................................................. 7 APPLICABLE STANDARD .............................................................................................................................................. 7 ANTENNA CONNECTOR CONSTRUCTION ...................................................................................................................... 7 FCC §15.235(A) & 15.235 (B)&15.209 - RADIATED EMISSIONS AND BAND EDGES .................................. 8 APPLICABLE STANDARD .............................................................................................................................................. 8 MEASUREMENT UNCERTAINTY .................................................................................................................................... 8 EUT SETUP .................................................................................................................................................................. 8 EMI TEST RECEIVER SETUP ......................................................................................................................................... 9 TEST PROCEDURE ........................................................................................................................................................ 9 CORRECTED AMPLITUDE & MARGIN CALCULATION ................................................................................................... 9 TEST RESULTS SUMMARY ............................................................................................................................................ 9 TEST DATA ................................................................................................................................................................ 10 FCC§15.215(C) - 20DB EMISSION BANDWIDTH ................................................................................................ 13 APPLICABLE STANDARD ............................................................................................................................................ 13 TEST PROCEDURE ...............................................................…

Text truncated - open the document above for the full version.

EXHIBIT D - TEST SETUP PHOTOGRAPHS Radiated Emissions View