
Text extracted from the exhibit documents filed with the FCC. Open a document above to read the original.
User Manual GSM Mobile Phone FCCID: 2ADOQTITANQ7 MADETRONICS LIMITED UNIT 5, 27/F., RICHMOND COMM. BLDG., 109 ARGYLE STREET, MONGKOK, KOWLOON HONG KONG Please read these instructions for use and have a good look at the illustration before using. 1 Warning: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to 2 which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. RF Exposure Information: The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Devic e Types GSM Mobile Phone (FCC ID: 2ADOQTITANQ7) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use when properly worn on the body is W/kg and head is 1.188W/kg. This device was tested for typical body worn operations with the back of the handset kept 5mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 5mm separation distance between the user's body and the back of the handset. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided. 1.336 3 1 Basic Information 1.1 Introduction Congratulations on your purchase of the mobile phone. Your phone provides many functions which are practical for daily use, such as a hands-free loudspeaker, MP3 player and so on. You can read the manual to understand how to use the mobile phone and experience the well-established functions and simple operation method. Please use the original accessory in order to achieve the best use of effects. Use of non-original components results in of the damage caused of by machinery, in which case we shall not be responsible. The contents are subject to changes without prior notice. 1.2 Safety precautions If your mobile phone is lost or stolen, please inform local telecommunication department or distributor to disable the mobile phone and SIM card. It will prevent the economic loss caused by illegal operation. When you contact telecommunication department, they will ask you the IMEI number (It is printed on the label in the rear of the mobile phone and you will find it after removing the battery). Please write down this number and keep it properly for future use. To avoid illegal operation, please take the preventative 4 measures, for example: Set PIN code of the SIM card and modify in time. Do not put the mobile phone at salient places before leaving your car. You'd better take it with you or lock it in the luggage. Set call barring. 1.3 Safety warnings and precautions Please read these precautions carefully before using this mobile phone to ensure safe and correct operation. 1.3.1 Precautions of using battery Do not short-circuit your battery. It can damage battery, and cause leakage, over heat, fire or explosion. Disposing battery in a fire can cause fire or explosion. Old batteries should be returned to your dealer or be disposed according to local regulations. Do not treat the battery as household waste. Keep metal objects (such as coins or key rings) away from the battery to avoid short circuit. Do not remove the battery without turning off the phone. Do not hold the battery in your mouth. The liquid of the battery can be toxic. Embedded battery shall be replaced by authorized dealers. Use only batteries approved by the phone manufacturer; otherwise, it may cause explosion. 5 Damage resulting from using un-authorized batteries and chargers will not be covered by the warranty. Avoid contact with any leaked liquid of the battery. If it touches your skin, wash your skin with fresh water and go to the hospital immediately. 1.3.2 Precautions of using charger Don’t use 220V AC power supply. It may cause electricity leakage, fire and damage the mobile phone and charger if you use other voltage. Charger short circuit is prohibited, otherwise it may cause electric shock, smoking and damage the charger. Do not use the charger if the power cord is damaged, otherwise it may cause fire and electric shock. Please clean the dust on the outlet in time. Do not put water container beside the charger to avoid overheating, electricity leakage and fault of the charger caused by splashed water. If the charger contacts water or other liquids, please cut off the power supply immediately to avo…
Text truncated - open the document above for the full version.
Long Term Confidentiality Request Letter Date: January 6, 2015 To: Federal Communications Commission, Authorization & Evaluation Division, 7435 Oakland Mills Road, Columbia, MD 21046 Re: MADETRONICS LIMITED FCC ID: 2ADOQTITANQ7 Confidentiality Request Gentlemen: This letter is to comply with 47 CFR 0.457 and 0.459 pertaining to confidentiality material. MADETRONICS LIMITED requests that the following documents regarding this submission for FCC ID: 2ADOQTITANQ7 be kept confidential: Exhibit Type File Name Block Diagram Block Diagram.pdf Schematics Schematics.pdf Operational Description Operational Description.pdf Part list BOM.pdf Tune-Up-Procedure Tune up procedure.pdf Those documents contain detailed system and equipment description and related information about the product which MADETRONICS LIMITED considers to be confidential proprietary, a custom design and, otherwise, not releasable to the general public. Since this design is a basis form which future technological products will evolve, MADETRONICS LIMITED considers this information would be of benefit to its competitors, and that the disclosure of the information in these documents would give competitors an unfair advantage in the market. Signatory MADETRONICS LIMITED
Appearance photograph of EUT Appearance photograph of EUT Appearance photograph of EUT Appearance photograph of EUT Appearance photograph of EUT Appearance photograph of EUT Appearance photograph of EUT Appearance photograph of EUT
FCC ID: 2ADOQTITANQ7 Label Location on EUT FCC ID Label: Size: 15mm * 20 mm GSM Mobile Phone M/N: TITANQ7 FCC ID: 2ADOQTITANQ7 Applicant:MADETRONICS LIMITED
Internal photograph of EUT Internal photograph of EUT Internal photograph of EUT Internal photograph of EUT Internal photograph of EUT Internal photograph of EUT GSM Antenna GSM Antenna Point Internal photograph of EUT Internal photograph of EUT Internal photograph of EUT Internal photograph of EUT BT Antenna GSM Antenna Internal photograph of EUT
Page 1 of 35 FCC SAR Compliance Test Report For MADETRONICS LIMITED UNIT 5, 27/F., RICHMOND COMM. BLDG.,109 ARGYLE STREET, MONGKOK, KOWLOON HONG KONG Model: TITAN Q7 Prepared By: Shenzhen Timeway Technology Consulting Co.,Ltd 5/F,Block 4,Anhua Industrial Zone.,No.8 TaiRan Rd.CheGongMiao,Futian District,Shenzhen,CHINA Tel(755)83448688 Fax(755)83442996 Report Number: FCC1412155-SAR FCC ID: 2ADOQTITANQ7 Report Date: 2015-02-12 Check By: Reviewed By: Testing laboratory: World Standardization Certification & Testing CO., LTD. Building A, Baoshi Science & Technology Park, Baoshi Road, Bao’an District, Shenzhen, Guangdong, China Tel: +86-755-26996192 Fax: +86-755-26996253 Report No.: FCC1412155-SAR SAR Evaluation Report Page 2 of 35 Table of contents 1 General information .......................................................................................................................................... 4 1.1 Notes ........................................................................................................................................................... 4 1.2 Application details ..................................................................................................................................... 4 1.3 Statement of Compliance .......................................................................................................................... 5 1.4 EUT Information ......................................................................................................................................... 6 1.5 Test standard/s: ......................................................................................................................................... 7 1.6 RF exposure limits ..................................................................................................................................... 8 1.7 SAR Definition ............................................................................................................................................ 8 2 Testing laboratory ............................................................................................................................................. 9 3 Test Environment .............................................................................................................................................. 9 4 Applicant and Manufacturer ............................................................................................................................ 9 5 SAR Measurement System .............................................................................................................................. 10 5.1 The Measurement System ...................................................................................................................... 10 5.2 Robot ......................................................................................................................................................... 11 5.3 Probe ......................................................................................................................................................... 11 5.4 Measurement procedure ......................................................................................................................... 12 5.5 Description of interpolation/extrapolation scheme .............................................................................. 12 5.6 Phantom .................................................................................................................................................... 13 5.7 Device Holder ........................................................................................................................................... 14 5.8 Video Positioning System ....................................................................................................................... 15 5.9 Tissue simulating liquids: dielectric properties ................................................................................... 16 5.10 Tissue simulating liquids: parameters .................................................................................................. 17 6 System Check .................................................................................................................................................. 18 6.1 System check procedure ........................................................................................................................ 18 6.2 System check results .............................................................................................................................. 19 7 Measurement uncertainty evaluation............................................................................................................ 20 7.1 Measurement uncertainty evaluation for SAR test .............................................................................. 20 7.2 Measurement uncertainty evaluation for system check ...................................................................... 21 8 SAR Test Test Configuration ......................................................................................................................... 22 8.1 GSM Test Configurations ........................................................................................................................ 22 Report No.: FCC1412155-SAR SAR Evaluation Report Page 3 of 35 9 Detailed Test Results ...................................................................................................................................... 23 9.1 Conducted Power measurements .......................................................................................................... 23 9.1.1 Conducted Power of GSM850 ................................................................................................................. 23 9.1.2 Conducted Power of GSM1900 .................................................…
Text truncated - open the document above for the full version.