2AEGB754938136Remote control car toy series

BATTERY REPLACEMENT REMOVE SCREW TO OPEN BATTERY COMPARTMENT COVER. THIS UNIT REQUIRES 6 “AA” (1.5V) BATTERIES (NOT INCLUDED). ALWAYS REPLACE ALL SIX BATTERIES AT THE SAME TIME. REPLACE BATTERY COMPARTMENT COVER AND SAREW. ALKALINE BATTERIES ARE RECOMMENDED FOR BEST PERFORMANCE. DO NOT MIX OLD AND NEW BATTERIES. DO NOT MIX ALKALINE,STANDARD (CARBON-ZING) , OR RECHARGEABLE (NICKEL-CADMIUM) BATTERIES. NON-RECHAGEABLE BATTERIES ARE NOT TO BE RECHARGED. BATTERIES ARE TO BE INSERTED WITH THE CORRECT POLARITY. EXHAUSTED BATTERIES ARE TO BE REMOVED FROM THE TOY. DISPOSE OF BATTERY(IES) SAFELY. DO NOT DISPOSE OF THIS PRODUCT IN A FIRE.THE BATTERIES INSIDE MAY EXPLOSE OR LEAX. THE SUPPLY TERMINALS ARE NOT TO BE SHORT-CIRCUITED. PLEASE KEEP THIS INFORMATION FOR FUTURE REFERENCE. REMOVE THE BATTERIES WHEN NOT IN USE. ADULT SUPPERVISION IS RECONMMENDED. DO NOT MIX BATTERIES WITH DIFFERNET BRABDE.MIXED BATTERIES. MAY ADVERSELY AFFECT PERFORMANCE ,LEAK OF OVERHEAT. BATTERY REPLACEMENT REMOVE SCREW TO OPEN BATTERY COMPARTMENT COVER. THIS UNIT REQUIRES 1 “9-VOLT” BATTERY (NOT INCLUDED). REPLACE BATTERY COMPARTMENT COVER AND SAREW. ALKALINE BATTERIES ARE RECOMMENDED FOR BEST PERFORMANCE. NOTE:”MODIFICATIONS NOT AUTHORIZED BY THE MANUFACTURER MAY VOID USERS AUTHORITY TOOPERATE THIS DEVICE”.THIS EOUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH LIMITS FOR A CLASS B DIGITAL DEVICE,PURSUANT TO PART 15 OF THE FCC RULES.THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE IN A RESIDENTIAL INSTALLATION.THIS EQUIPMENT GENERATES.USES AND CAN RADIATE RADIO FREQUENCY ENERGY AND.OF NOT INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTION,MAY CAUSE HARMFUL INTERFERENCE TO RADIO DOMMUNICATIONS,HOWEVER,,THESE IS NO GUARANTEE THAT INTERFERENCE WILL NOT OCCUR IN A PARTICCULAR INSTALLATION,IF THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO RADIO OR TELEVISION RECEPTION,WHICH CAN BE DETERMINED BY TURNING THE EQUIPMENT OFF AND ON.THE USER IS ENCOURAGED TO TRY TO CORRECT THE INTERFENCE BY ONE OR MORE OF THE FOLLOWING MEASURES: -REORIENT OR RELOCATE THE RECEVIVING ANTENNA -INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER -CONNECT THE EQUIPMENT INTO AN OUTLET ON ACIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER IS CONNECTED -CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER IS CONNECTED -CONSULT THE DEALER OR AN EXPERIENCED RADIO/TV TECHNICIAN FOR HELP. Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help.

External Photo

Internal Photo

SGS-CSTC Standards Technical Services Co., Ltd. Guangzhou Branch 198 Kezhu Road, Scientech Park, Guangzhou Economic & Technological Development District, Guangzhou, China 510663 Telephone: +86 (0) 20 82155555 Fax: +86 (0) 20 82075059 Email: [email protected] Report No.: GZEM150300103901 Page: 1 of 16 FCC ID: 2AEGB754938136 . Jerry Chan Manager The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. The report must not be used by the client to claim product certification, approval, or endorsement by NVLAP, NIST, or any agency of the federal government. All test results in this report can be traceable to National or International Standards. This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at http://www.sgs.com/en/Terms-and-Conditions.aspxand,for electronic format documents, subject to Terms and Conditions for Electronic Documents at http://www.sgs.com/en/Terms-and-Conditions/Terms-e-Document.aspx. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 30 days only. 1 Cover Page TEST REPORT Application No.: GZEM1503001039CR Applicant: Chenghai District Shantou City Manufacturer: The same as apllicant FCC ID: 2AEGB754938136 Product Name: Remote control car toy series Product Description: Radio control toys with 27.145 MHz as carrier Model No.: KS703, 901, 23828, 23838, 23888, 23868, 33388, 33588, 33688, 33888, 33988 ♣ ♣ ♣♣ ♣ Please refer to section 3 of this report for further details. Standards: CFR 47 PART 15 Subpart C: 2014 section 15.227 Date of Receipt: 2015-03-20 Date of Test: 2015-03-23 to 2015-03-24 Date of Issue: 2015-04-15 Test Result : Pass* * In the configuration tested, the EUT detailed in this report complied with the standards specified above. Please refer to section 3 of this report for further details. SGS-CSTC Standards Technical Services Co., Ltd. Guangzhou Branch Report No.: GZEM150300103901 Page: 2 of 16 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at http://www.sgs.com/en/Terms-and-Conditions.aspxand,for electronic format documents, subject to Terms and Conditions for Electronic Documents at http://www.sgs.com/en/Terms-and-Conditions/Terms-e-Document.aspx. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 30 days only. 2 Version Revision Record Version Chapter Date Modifier Remark 00 2015-04-15 Original Authorized for issue by: Tested By 2015-03-23 to 2015-03-24 (Jack Liang) /Project Engineer Date Prepared By 2015-04-01 (Icy Chen) / Clerk Date Checked By 2015-04-01 (Jerry Chan / Reviewer Date SGS-CSTC Standards Technical Services Co., Ltd. Guangzhou Branch Report No.: GZEM150300103901 Page: 3 of 16 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at http://www.sgs.com/en/Terms-and-Conditions.aspxand,for electronic format documents, subject to Terms and Conditions for Electronic Documents at http://www.sgs.com/en/Terms-and-Conditions/Terms-e-Document.aspx. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 30 days only. 3 Te…

Text truncated - open the document above for the full version.

Test Setup Photo 1.1 RADIA TED EMISSI ON (30MHZ-1GHZ)