2AFGP-RC300RRemote Control Vibrator

RC300 How to Operate The vibrator and vibrating remote control can be used as independently functioning devices when only one is turned on. When both the vibrator and vibrating remote control are on, the vibrating remote control is in control of the vibration settings for itself and the vibrator, although you can still change the modes of the vibrator independently. Use the following directions to activate the devices and the vibration modes. Turn On: Press and hold the On/Off button for 1 second to turn on the device. Turn Off: Press and hold the On/Off button for 1 second to turn off the device. Selecting Vibration Mode: There are 6 vibration modes. To cycle through the modes on the vibrator briefly press the On/Off button. To cycle through the modes on the vibrating remote control press the + or - buttons. Each time a device is turned on, it will begin at Mode 1. Mode 1: Light continuous vibration Mode 2: Moderate continuous vibration Mode 3: Intense continuous vibration Mode 4: Pulsing wave vibration Mode 5: Flutter vibration Mode 6: Quick, rapid pulsation Lubricants Water based lubricants are recommended with these devices. Silicone and oil based lubricants can degrade the silicone material and should not be used. User Manual and Warranty Information Congratulations on your purchase of your Sova™ device! Before using, please read the information contained in this user manual to learn more about your product and proper use. Before use: wash and rinse the device with a mild anti-bacterial soap and warm water or a rubber and silicone friendly vibrator cleaner. Charging your Sova™ Vibrator 1. Make sure the vibrator is turned off before charging. Your Sova vibrator charges with the included DC adapter. Hold the vibrator with the chrome charging port cover facing down and rotate it to the left until you feel a click. (a) Remove the cover to expose the vibrator's adapter plug for charging. 2. Connect the cord to the vibrator's adapter plug and then connect the cord to the electrical outlet. (b) The indicator light in the adapter plug will flash while charging. When the vibrator is fully charged, the indicator light will glow steadily. 3. Disconnect the cord from the vibrator. Replace the charging port cover on the vibrator and rotate it to the right until it clicks into locked position. To aid in removing and replacing the covers to the devices, note the t I u indicators on the back of the covers and the raised I indicators on the devices. These symbols must align when securing the covers. Inserting Batteries into the Vibrating Remote Control Remove the battery cover of the vibrating remote control by rotating it to the left until you feel a click. Remove the inner battery cover (c) by releasing the snap. Insert two AAA batteries in the orientation as shown. Place the inner battery cover onto the device with the wire spring mating with the battery, with the negative (-) side facing upwards. (c) Place the battery cover back on the vibrating remote control by rotating to the right until you feel a click. Register your product online at www.enjoysova.com By registering your product, you will receive Proof of Ownership, Product protection, and Product registration. a b Vibrator Minus Button Minus Button Plus Button On/Off Button On/Off Button Removal String Charging Port Cover Battery Cover How to Use • Use only as directed. You are responsible for using Sova™ products in a safe manner. While this user manual does include safety notes, it is essential for you to employ common sense in intimate encounters. • Do not submerge device underwater. This is not a waterproof device. • Only use the Sova device with the charging port cover and battery cover and all components completely secure to prevent moisture from getting to the battery and the motor compartment. • Only insert silicone rubber end during use. Do not insert past the rubber coated portion of the device. • Do not insert chrome switch cap end of device during any use. • Do not share device with others. • If you are allergic to silicone, do not use. • If signs of an allergic reaction appear, immediately discontinue use of the device and contact your doctor. • Do not use device on swollen, inflamed areas, broken skin, or areas with poor circulation. • Do not use on any single area for an extended period of time. • Do not use the vibrating remote control internally. • The Sova device does not have a flared end and is not safe for use as an anal device. Do not use it in your or another individual's anus. • Avoid dropping your Sova device. It may scratch the coating or otherwise damage the device. Do not use the device if the surface is damaged in any way. • Do not use a Sova device that you know or suspect may be defective, for example having the appearance of a defective coating or containing corroded batteries. • Keep the device and batteries out of the reach of children and pets. Should the bat- tery, motor, or any parts of the device be inadvertently swallowed, please contact your doctor immediately. • Do not leave the Sova device unattended on any surface while it is operating. • Only use DC charger adapters provided by Sova. Safety Cleaning and Storage Cleaning Clean your Sova™ device before first use and between uses thereafter with warm water and mild antibacterial soap or a rubber and silicone friendly vibrator cleaner. Dry completely with a soft, lint-free cloth. While cleaning, avoid submerging the device into water as it is not a waterproof device. Do not allow water to enter the battery compartment. Do not clean with boiling water or wash it in the dishwasher as extreme temperatures may damage the device. Storage When your Sova device is clean and dry, place it in the included satin pouch and store in a cool, dry environment. Vibrating Remote Control On/Off/Mode Button ™ c Materials: Silicone Rubber: FDA 21 CFR 177.2600 Certified. Covers: Aluminum with UV coating Vibrator Battery: 3.7 Volt Lithium cell Remote Control Battery: Hol…

Text truncated - open the document above for the full version.

External Power Supply for 2AFGP-RC300R

2AFGP-RC300R

2AFGP-RC300R

Report No.: 150624061GZU-001 Issued: 2015-07-28 FCC ID: 2AFGP-RC300R Page 2 of 18 CONTENT TEST REPORT ....................................................................................................................................................................... 1 CONTENT ............................................................................................................................................................................... 2 1 TEST RESULTS SUMMARY ...................................................................................................................................... 3 2 TEST RESULTS CONCLUSION ................................................................................................................................ 4 3 LABORATORY MEASUREMENTS .......................................................................................................................... 5 4 TEST RESULTS ............................................................................................................................................................ 6 4.1 CONDUCTED DISTURBANCE VOLTAGE AT MAINS PORTS .............................................................................................. 6 4.1.1 Used Test Equipment ......................................................................................................................................... 6 4.1.2 Block Diagram of Test Setup ............................................................................................................................. 6 4.1.3 Test Setup and Procedure .................................................................................................................................. 6 4.1.4 Limit ................................................................................................................................................................... 7 4.1.5 Test Data............................................................................................................................................................ 8 4.1.6 Emission Curve .................................................................................................................................................. 9 4.1.7 Measurement Uncertainty.................................................................................................................................. 9 4.2 RADIATED EMISSION (30 MHZ -1000 MHZ) .............................................................................................................. 10 4.2.1 Used Test Equipment ....................................................................................................................................... 10 4.2.2 Block Diagram of Test Setup ........................................................................................................................... 10 4.2.3 Test Setup and Procedure ................................................................................................................................ 10 4.2.4 Limit ................................................................................................................................................................. 11 4.2.5 Test Data.......................................................................................................................................................... 12 4.2.6 Test Curve ........................................................................................................................................................ 13 4.2.7 Measurement uncertainty ................................................................................................................................ 14 4.3 RADIATED EMISSION ABOVE 1 GHZ ........................................................................................................................... 15 4.3.1 Used Test Equipment ....................................................................................................................................... 15 4.3.2 Block Diagram of Test Setup ........................................................................................................................... 15 4.3.3 Test Setup and Procedure ................................................................................................................................ 16 4.3.4 Limit ................................................................................................................................................................. 16 4.3.5 Test Data.......................................................................................................................................................... 17 4.3.6 Test Curve ........................................................................................................................................................ 18 4.3.7 Measurement uncertainty ................................................................................................................................ 18 Report No.: 150624061GZU-001 Issued: 2015-07-28 FCC ID: 2AFGP-RC300R Page 3 of 18 1 TEST RESULTS SUMMARY Classification of EUT: Class B Test Item Standard Result Conducted disturbance voltage at mains ports FCC Part 15: 2014, Subpart B Pass Radiated emission (30 MHz–1 GHz) FCC Part 15: 2014, Subpart B Pass Radiated emission (Above 1 GHz) FCC Part 15: 2014, Subpart B Pass Remark: Reference publication is used for methods of measurement: ANSI C63.4:2014 Remark: 1. The symbol “N/A” in above table means Not Applicable. 2. When determining the test results, measurement uncertainty of tests has been considered. Report No.: 150624061GZU-001 Issued: 2015-07-28 FCC ID: 2AFGP-RC300R Page 4 of 18 2 Test Results Conclusion (with Justification) RE: EMC Testing Pursuant to FCC Part 15, Subpart B, Subpart C Performed on the Remote Control Vibrator, Models: RC300, RC30WXYZ. We tested the Remote Control Vibrator, Mode…

Text truncated - open the document above for the full version.

2AFGP-RC300R