2AFKS-WLDONWireless Educational Robot

Wireless Thymio Intended for use by children aged 6 and older. Warning: Not suitable for children under 3 years of age. Instructions for the parents are included and should be observed. Please read carefully all safety information and operating instructions before using the robot, or letting your child play with the robot, to avoid personal injury or damage to property. Please keep this information as reference. ( D ) A ON/OFF/Validate B Choose/Direction C USB Connector D USB Dongle DIRECTIONS OF USE Contents: In addition to this instructions booklet, this package contains a Wireless Thymio robot, a USB dongle for wireless communication, a USB to micro USB cable for the recharge. Use of buttons: Press 3 sec. on the center button (A) to turn the robot on and off. The other buttons (B) allow changing the robot’s color. Each color corresponds to a different behavior (menu). Button (A) is used to start a behavior and to come back to the menu. Behaviors: Friendly (green) follows object / hand Explorer (yellow) avoids obstacles Fearful (red) runs away from object or hand, shock detection Investigator (cyan) follows a trail Obedient (purple) follows the commands from the buttons (B) Careful (blue) reacts to handclap Installation: Before connecting Thymio II to the computer, install Aseba Studio from: www.thymio.org The site contains explanations to program the robot. Use the USB dongle (D) that you received with the robot to connect it wirelessly to the computer. Connect the dongle to a USB port on your computer and turn your Thymio on. Then start Aseba Studio. Recharge: Connect Thymio to a computer with the provided USB cable or use compatible wall charger. Recharge must always be supervised by an adult. General Safety Warning: Operating temperature: 5 to 35° C (41 to 95° F). The robot should not be disassembled. Exposed batteries, wiring or circuits are hazardous for children. Not waterproof, do not put under water or expose to liquids. If your robot is damaged, gather the parts and store them in a safe place. Do not put your robot in a microwave oven or pressurized container, as it may cause fire or explosion. Small Parts Warning : Contains small parts that can be swallowed and present choking hazard. Not suitable for children under 3 years of age. FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the manufacturer’s instructions, may cause interference harmful to radio communications. There is no guarantee, however, that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio or TV technician for help. Battery Warning: This toy includes a rechargeable LiPo battery, which can be extremely hazardous if removed or improperly used or charged. Do not expose to heat, fire or solvents. Ingestion can be lethal, in case of ingestion consult a physician immediately. If you suspect battery damage (leakage, suspicious smell), disconnect the robot immediately and store it safely. Avoid contact with leakage. Always recharge under the supervision of an adult, through the provided USB cable and a computer or a certified wall charger, at a temperature between 5 and 35° C (41 to 95° F). You are solely liable for ensuring that the lithium battery is used correctly (charging, discharging, storage, etc.). The manufacturer and distributor shall have no liability for injury or damage to persons or property associated with lithium battery usage. This equipment should be installed and operated with a minimum distance 20cm between the radiator and your body

Label Size: 12*12mm

SGS-CSTC Standards Technical Services (Shanghai) Co., Ltd. Page: 1 of 3 Page 1 of 3 Internal Photos Applicant: Association Mobsya Address of Applicant: Association Mobsya Ch. de la Raye 13 1024 Ecublens Equipment Under Test (EUT): Product Name: Wireless Educational Robot Model No.(EUT): Wireless Dongle SGS-CSTC Standards Technical Services (Shanghai) Co., Ltd. Page: 2 of 3 Page 2 of 3 SGS-CSTC Standards Technical Services (Shanghai) Co., Ltd. Page: 3 of 3 Page 3 of 3 E EE En nn nd dd d

SGS-CSTC Standards Technical Services (Shanghai) Co., Ltd. 588 West Jindu Road,Songjiang District,Shanghai,China Telephone: +86 (0) 21 6191 5666 Fax: +86 (0) 21 6191 5678 [email protected] Report No.: SHEM150700227201 Page: 1 of 38 Parlam Zhan E&E Section Manager SGS-CSTC (Shanghai) Co., Ltd. The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. The report must not be used by the client to claim product certification, approval, or endorsement by NVLAP, NIST, or any agency of the federal government. All test results in this report can be traceable to National or International Standards. This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only 1 Cover Page FCC Part 15C TEST REPORT Application No.: SHEM1507002272CR Applicant: Association Mobsya FCC ID: 2AFKS-WLDON Equipment Under Test (EUT): NOTE: The following sample(s) was/were submitted and identified by the client as Product Name: Wireless Educational Robot Model No.(EUT): Wireless Dongle Standards: FCC PART 15 Subpart C: 2014 Date of Receipt: July 10, 2015 Date of Test: October 21, 2015 to October 23, 2015 Date of Issue: November 03, 2015 Test Result: Pass* *In the configuration tested, the EUT detailed in this report complied with the standards specified above. This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. SGS-CSTC Standards Technical Services (Shanghai) Co., Ltd. Report No.: SHEM150700227201 Page: 2 of 38 2 Version Revision Record Version Chapter Date Modifier Remark 00 / November 03, 2015 / Original Authorized for issue by: Engineer Eddy Zong Print Name Clerk Susie Liu Print Name Reviewer Keny Xu Print Name This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. SGS-CSTC Standards Technical Services (Shanghai) Co., Ltd. Report No.: SHEM150700227201 Page: 3 of 38 3 Test Summary Test Item FCC Requirement Test method Result Antenna Requirement FCC Part 15, Subpart C Section 15.203/15.247 (c) --- PASS AC Power Line Conducted Emission FCC Part 15, Subpart C Section 15.207 ANSI C63.10 (2013) Section 6.2 PASS Minimum 6dB Bandwidth FCC Part 15, Subpart C Section 15.247 (a)(2) ANSI C63.10 (2013) Section 11.8.1 PASS Conducted Peak Output Power FCC Part 15, Subpart C Section 15.247 (b)(3) ANSI C63.10 (2013) Secti…

Text truncated - open the document above for the full version.

SGS-CSTC Standards Technical Services (Shanghai) Co., Ltd. Page: 1 of 5 Page 1 of 5 Test Setup Photos Applicant: Association Mobsya Address of Applicant: Association Mobsya Ch. de la Raye 13 1024 Ecublens Equipment Under Test (EUT): Product Name: Wireless Educational Robot Model No.(EUT): Wireless Dongle SGS-CSTC Standards Technical Services (Shanghai) Co., Ltd. Page: 2 of 5 Page 2 of 5 1 Contents Page 1 CONTENTS............................................................................................................... 2 2 EQUIPMENT UNDER TEST PICTURES ............................................................. 3 2.1 Radiated Emission Test Setup ............................................................. 3 2.2 Conducted Emission Test Setup .......................................................... 4 SGS-CSTC Standards Technical Services (Shanghai) Co., Ltd. Page: 3 of 5 Page 3 of 5 2 EQUIPMENT UNDER TEST PICTURES 2.1 Radiated Emission Test Setup Below 30MHz 30MHz to 1GHz SGS-CSTC Standards Technical Services (Shanghai) Co., Ltd. Page: 4 of 5 Page 4 of 5 Above 1GHz 2.2 Conducted Emission Test Setup SGS-CSTC Standards Technical Services (Shanghai) Co., Ltd. Page: 5 of 5 Page 5 of 5 End