2AGC7MD-02Remote Controller

User Manual for MD-02 This is a two button wireless remote control, one is the emission open signal button, the other one is fired off signal button, just press any button, the power indicator will lights, at the same time will launch a corresponding data wireless remote control signal of 3.5 seconds, the remote control will no longer transmitting, but the power indicator will have been on, until you let it go, press any button again and repeat the action above. FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.

Reference No.: WTS15S1036284E Waltek Services (Shenzhen) Co.,Ltd. http://www.w altek.com.cn 12 Photographs - Constructional Details 12.1 Model MD-02 - Appearance View Reference No.: WTS15S1036284E Waltek Services (Shenzhen) Co.,Ltd. http://www.w altek.com.cn Reference No.: WTS15S1036284E Waltek Services (Shenzhen) Co.,Ltd. http://www.w altek.com.cn

MD‐02_Label Location

Reference No.: WTS15S1036284E Waltek Services (Shenzhen) Co.,Ltd. http://www.w altek.com.cn 12.2 Model MD-02 - Internal View Reference No.: WTS15S1036284E Waltek Services (Shenzhen) Co.,Ltd. http://www.w altek.com.cn Reference No.: WTS15S1036284E Waltek Services (Shenzhen) Co.,Ltd. http://www.w altek.com.cn PCB Printed ANT

Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn Page 1 of 23 TEST REPORT Reference No. .................... : WTS15S1036284E FCC ID ................................ : 2AGC7MD-02 Applicant ............................ : MARVELLOUS DAY INDUSTRIAL INTERNATIONAL LIMITED Address .............................. : RM. 201, HANLEY HOUSE,776-778, NATHAN ROAD, MONGKOK, KOWLOON, HONG KONG. Manufacturer .................... : MARVELLOUS DAY ELECTRIC (SHEN ZHEN) CO., LTD. Address .............................. : LAI WU SHAN, DA LANG AREA, LONG HUA NEW DISTRICT, SHEN ZHEN. CHINA Product Name .................... : Remote Controller Model No. ........................... : MD-02 Standards........................... : FCC CFR47 Part 15 Section 15.231: 2014 Date of Receipt sample .... : Oct. 30, 2015 Date of Test ....................... : Oct. 31, 2015 ~ Nov. 02, 2015 Date of Issue ...................... : Nov. 02, 2015 Test Result ......................... : Pass Remarks: The results shown in this test report refer only to the sample(s) tested, this test report cannot be reproduced, except in full, without prior written permission of the company. The report would be invalid without specific stamp of test institute and the signatures of compiler and approver. Prepared By: Waltek Services (Shenzhen) Co., Ltd. Address: 1/F., Fukangtai Building, West Baima Road, Songgang Street, Baoan District, Shenzhen, Guangdong, China Tel :+86-755-83551033 Fax:+86-755-83552400 Tested by: Approved by: Zero Zhou / Test Engineer Philo Zhong / Manager Reference No.: WTS15S1036284E Page 2 of 23 Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn Page 2 of 23 2 Test Summary Test Items Test Requirement Result Conducted Emissions 15.207 N/A Radiated Spurious Emissions 15.205(a) 15.209 15.231(a) PASS Periodic Operation 15.231(a) PASS 20dB Bandwidth 15.231(c) PASS Antenna Requirement 15.203 PASS Reference No.: WTS15S1036284E Page 3 of 23 Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn 3 Contents Page 1 COVER PAGE ...................................................................................................................................... 1 2 TEST SUMMARY ............................................................................................................................................. 2 3 CONTENTS ....................................................................................................................................................... 3 4 GENERAL INFORMATION ............................................................................................................................. 4 4.1 GENERAL DESCRIPTION OF E.U.T. ....................................................................................................... 4 4.2 DETAILS OF E.U.T. ................................................................................................................................ 4 4.3 TEST FACILITY ....................................................................................................................................... 4 5 EQUIPMENT USED DURING TEST ............................................................................................................. 5 5.1 EQUIPMENTS LIST ................................................................................................................................. 5 5.2 MEASUREMENT UNCERTAINTY .............................................................................................................. 5 5.3 TEST EQUIPMENT CALIBRATION ........................................................................................................... 5 6 CONDUCTED EMISSION ............................................................................................................................... 6 7 RADIATED SPURIOUS EMISSIONS ............................................................................................................ 7 7.1 EUT OPERATION ................................................................................................................................... 7 7.2 TEST SETUP .......................................................................................................................................... 8 7.3 SPECTRUM ANALYZER SETUP .............................................................................................................. 9 7.4 TEST PROCEDURE ............................................................................................................................... 10 7.5 SUMMARY OF TEST RESULTS ............................................................................................................. 11 8 PERIODIC OPERATION ............................................................................................................................... 12 9 20DB BANDWIDTH ....................................................................................................................................... 15 9.1 TEST PROCEDURE ............................................................................................................................... 15 9.2 TEST RESULT ...................................................................................................................................... 15 10 ANTENNA REQUIREMENT ......................................................................................................................... 16 11 PHOTOGRAPHS- MODEL MD-02 TEST SETUP ..................................................................................... 17 11.1 RADIATION EMISSION TEST SETUP ..................................................................................................... 17 12 PHOTOGRAPHS - CONSTRUCTIONAL DETAILS ................................................................................. 18 12.1 MODEL MD-02 - APPEARANCE VIEW ................................................................................................. 18 12.2 M…

Text truncated - open the document above for the full version.

Reference No.: WTS15S1036284E Waltek Services (Shenzhen) Co.,Ltd. http://www.w altek.com.cn 11 Photographs- Model MD-02 Test Setup 11.1 Radiation Emission Test Setup From 30MHz to 1GHz Test site 2# Above 1G Hz Test site 1#