2AGCY-003RBacklit Remote

www.motormood.com Made in China Motormood Product Nam: Backlit Remote Model No.: 003R  The remote slides onto user’s sun visor via a clip. The remote consists of one button, which when pressed lights up the corresponding face decal using a RF signal.  The face attaches to a user’s rear window using adhesive clips. The face consists of a happy face image that lights up when it receives a RF signal from the remote.  After 7 seconds of being lit, the face automatically turns off. FCC Caution: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with www.motormood.com Made in China the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. IC Caution: This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Motormood Date: November 19, 2015 Federal Communications Commission Authorization and Evaluation Division Confidentiality Request regarding application for certification of FCC ID: 2AGCY-003R Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, we hereby request confidential treatment of information accompanying this application as outlined below: Exhibit Type File Name Schematics Block Diagram Operational Description SCH.pdf BlockDiagram.pdf CircuitDescription.pdf The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Motormood ................................................ Signature Jesse Kramer/ Founder ................................................ Typed name and Title

Motormood FCC ID: 2AGCY-003R POWER OF ATTORNEY Date: November 19, 2015 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 To Whom It May Concern: We, the undersigned, hereby authorize Waltek Services (ShenZhen) Co., Ltd. (Philo Zhong) on our behalf, to apply to the Federal Communications Commission on our equipment. Any and all acts carried out by Waltek Services (ShenZhen) Co., Ltd. (Philo Zhong) on our behalf shall have the same effect as acts of our own. This authorization expires on November 18, 2016. This is to advise that we are in full compliance with the Anti-Drug Abuse Act. We, Motormood are not subject to a denial of federal benefits pursuant to Section 5301 of the Anti-Drug Act of 1988, 21 USC853a, and no party to the application is subject to a denial of federal benefits pursuant to that section. Sincerely, Motormood ................................................................................. Signature Jesse Kramer/ Founder ................................................................................. Typed name and Title

Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn Photographs - C onstructional Details Model 003R- External Photos Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn

FCC Label Sample and Label Location for model: 003R The Label must not be a stick-on paper. The Label on these products must be permanently affixed to the product and readily visible at the time of purchase and must last the expected lifetime of the equipment not be readily detachable.

Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn Model 003R- Internal Phot os ANT Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn

Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn Page 1 of 25 TEST REPORT Reference No..................... : WTS15S1035900E FCC ID.............................. : 2AGCY-003R Applicant.......................... : Motormood Address............................ : 833 Bard St., Hermosa Beach, Los Angeles, CA 90254, USA Manufacturer.................... : H&M Electronic Company Limited Address............................ : 5B, Blk 7, Area C, New Lighting Source Industrial Base, Fo Shan, Guang Dong, China Product Name.................. : Backlit Remote Model No. ........................ : 003R Standards......................... : FCC CFR47 Part 15 Section 15.231: 2014 Date of Receipt sample.... : Oct. 24, 2015 Date of Test...................... : Oct. 25, 2015 – Nov. 25, 2015 Date of Issue.................... : Nov. 28, 2015 Test Result....................... : Pass Remarks: The results shown in this test report refer only to the sample(s) tested, this test report cannot be reproduced, except in full, without prior written permission of the company. The report would be invalid without specific stamp of test institute and the signatures of compiler and approver. Prepared By: Waltek Services (Shenzhen) Co., Ltd. Address: 1/F., Fukangtai Building, West Baima Road, Songgang Street, Baoan District, Shenzhen, Guangdong, China Tel :+86-755-83551033 Fax:+86-755-83552400 Compiled by: Approved by: Zero Zhou /Test Engineer Philo Zhong / Manager Reference No.: WTS15S1035900E Page 2 of 25 Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn Page 2 of 25 2 Test Summary Test Items Test Requirement Result Radiated Spurious Emissions 15.205(a) 15.209 15.231(a) PASS Periodic Operation 15.231(a) PASS Emission Bandwidth 15.231(c) PASS Antenna Requirement 15.203 PASS Maximum Permissible Exposure (Exposure of Humans to RF Fields) 1.1307(b)(1) PASS Reference No.: WTS15S1035900E Page 3 of 25 Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn 3 Contents Page 1 COVER PAGE ...................................................................................................................................... 1 2 TEST SUMMARY ............................................................................................................................................. 2 3 CONTENTS ....................................................................................................................................................... 3 4 GENERAL INFORMATION ............................................................................................................................. 4 4.1 GENERAL DESCRIPTION OF E.U.T. ....................................................................................................... 4 4.2 DETAILS OF E.U.T. ................................................................................................................................ 4 4.3 TEST MODE ........................................................................................................................................... 4 4.4 TEST FACILITY ....................................................................................................................................... 4 5 EQUIPMENT USED DURING TEST ............................................................................................................. 5 5.1 EQUIPMENTS LIST ................................................................................................................................. 5 5.2 MEASUREMENT UNCERTAINTY .............................................................................................................. 6 5.3 TEST EQUIPMENT CALIBRATION ........................................................................................................... 6 6 RADIATED SPURIOUS EMISSIONS ............................................................................................................ 7 6.1 EUT OPERATION ................................................................................................................................... 7 6.2 TEST SETUP .......................................................................................................................................... 8 6.3 SPECTRUM ANALYZER SETUP .............................................................................................................. 9 6.4 TEST PROCEDURE ............................................................................................................................... 10 6.5 SUMMARY OF TEST RESULTS ............................................................................................................. 11 7 PERIODIC OPERATION ............................................................................................................................... 12 8 EMISSION BANDWIDTH .............................................................................................................................. 15 8.1 TEST PROCEDURE ............................................................................................................................... 15 8.2 TEST RESULT ...................................................................................................................................... 15 9 ANTENNA REQUIREMENT ......................................................................................................................... 16 10 RF EXPOSURE ............................................................................................................................................... 17 2.1 REQUIREMENTS ........................................................................................................................................ 17 2.2 THE PROCEDURES / LIMIT ......................................................................................................................... 17 11 PHOTOGRAPHS – MODEL 003R TEST SETUP ............................................................…

Text truncated - open the document above for the full version.

Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn Photographs – Model 003R Test Setup Photograph – Radiation Spurious Emission Test S etup 26MHz to 30MHz From 30MHz to 1GHz Waltek Services (Shenzhen) Co.,Ltd. http://www.waltek.com.cn From 1GHz to 5GHz