2AGRXMTG-100Wireless acoustic Transmission System

ANLEON Wireless Acoustic Transmission System Components ① MIC socket: input MIC or AUX signal (the signal input mode selection switch⑥ should match with the input signal) ② Power button: long press to turn on/off, short press for mute/speak ③ Power indicator: when the transmitter is turned on, the indicator is green. When it is in mute state, the indicator is flickering green. When it is at low power, the indicator is flickering red, please replace the battery timely ④ Antenna: 1/4 wave whip antenna ⑤ LCD panel: indicates the current working channel and battery power level ⑥ Signal input mode selection switch: shift the switch to "AUX" for line input mode and shift the switch to "MIC" for microphone input mode ⑦ Channel adjustment: short press "CH" button to shift to the needed channel, 6 channels for option ⑧ Battery compartment: assemble 2pcs of AA batteries Operating Instruction 1. Assemble the supplied batteries into the battery compartment and turn on the power, when the indicator lights up, it means the transmitter is under normal working status. 2. Insert the microphone into MIC socket(switch signal input mode to "MIC"position) 3. Turn on the receiver after assembling the batteries, when the indicator lights up, it means the receiver is under normal working status( adjust the CH button to match the channel with that of the transmitter) 4. Insert the earphone into headphone sockets⑤ and adjust the volume to gain the satisfied sound effect Cautions 1. Keep the distance between vocal and mic as 60cm to avoid high voice 2. Make sure the batteries are assembled with correct polarity to avoid damage 3. This product has been modulated by accurate equipment, do not dismantle it by yourself to avoid abnormal working 4. Do not use or store it under dusty, humid, high temperature and strong magnetic environment to avoid lifetime influence 5. Use standard new battery, it may lead to chemical material leakage and damage the electronic components if using inferior and low power battery 6. Take out the batteries when not using it for a long time 7. LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE. USE AS LOW A VOLUME AS POSSIBLE. Simple Trouble Shooting Trouble Possible reason Method The transmitter is not turned on Turn on the transmitter The receiver is not turned on Turn on the receiver Frequencies are not matched Adjust the CH button on the receiver to match the channel Receiver volume is too low Adjust the volume of the receiver No sound Battery power is low Replace with new battery The power indicator does not light Battery is assembled oppositely Check if the battery is assembled wrongly, reassemble it in the right way The receiver receives other sound or broadcasting The working channel is close to other frequency channel Adjust a new channel for the transmitter and the receiver Specification Frequency Range: UHF 650-680Mhz Power Supply: DC 3V/2pcs AA 1.5V batteries Operating Range: 50m (environment dependent) Transmit Power: <10dBm Operating Hours: 12Hours Product Content Transmitter 1pc Receiver 1 pc Headworn Microphone 1 pc Earphone 1 pc 3.5mm-3.5mm Conversion Cable 1 pc User Manual 1 pc Application Wireless tour guiding, simultaneous translation, audio-visual education

Shenzhen ANLEON Electronic Co.,LTD HuiLongYuan 1-2-303, Minzhi, Longhua, Shenzhen, China TEL: +86-755-27616536 FAX: +86-755-27616536 DOC ATTESTATION LETTER FCC ID: 2AGRXMTG-100 Date: Dec. 14, 2015 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 To whom it may concern: I, the undersigned, hereby attest to the fact that I will apply the Declaration of Conformity procedure to the computer peripheral. I understand the following FCC requirements: 1. Devices subject to the DoC procedure are required to be tested to show compliance with the FCC technical regulations by a recognized accredited testing laboratory. The testing laboratory must be accredited by a Commission approved accreditation body or designated under the terms of a government-to-government Mutual Recognition Agreement (MRA). A listing of those accredited testing laboratories that have been recognized by the Commission is published on the FCC Webpage: https://apps.fcc.gov/oetcf/eas/reports/TestFirmSearch.cfm (Select the "accredited" option to search for FCC recognized accredited test firms.) 2. Test facilities located in countries, where the U.S. does not have an operational Telcom MRA are not recognized by the FCC to test for the DoC procedure. 3. Pt 2.1077 contains the list of information that must be included in the Declaration of Conformity, which must be supplied with each product sold. The DoC compliance info shall be included in the User’s Manual or as a separate sheet. The info must contain the name, address, and phone number of the responsible party, which must be located within the United States. According to 2.909(c)(2), the responsible party is either the Manufacturer or if the product is imported the Importer. Sincerely, Li Tang / Manager

RF_160, Issue 03 Declaration of Authorization We Name: Shenzhen ANLEON Electronic Co.,LTD Address: HuiLongYuan 1-2-303, Minzhi, Longhua City: Shenzhen Country: China Declare that: Name Representative of agent: Tracy Qi Agent Company name: Shenzhen CTL Testing Technology Co., Ltd. Address: Floor 1-A, Baisha Technology Park, No.3011, Shahexi Road, Nanshan District, Shenzhen, China 518055 City: Shenzhen Country: China is authorized to apply for Certification of the following product(s): Product description: Wireless acoustic Transmission System Type designation: MTG-100 Trademark: ANLEON on our behalf. Date: Dec. 14, 2015 City: Shenzhen Name: Li Tang Function: Manager Signature:

Shenzhen ANLEON Electronic Co.,LTD HuiLongYuan 1-2-303, Minzhi, Longhua, Shenzhen, China TEL: +86-755-27616536 FAX: +86-755-27616536 DATE 12-04-2015 Equipment Autorisation Division Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 FCC ID: 2AGRXMTG-100 Product Name: Wireless acoustic Transmission System Request for Confidentiality Pursuant to Sections 0.457 and 0.459 of the commissions rules, we hereby request that the following documents be held confidential: (List here the documents for which you are seeking confidentiality – for example ...) • Schematics • Block diagram • Operation description • BOM • Tune-up Procedure These materials contain trade secrets and proprietary information and are not customarily released to the public. The public disclosure of this information might be harmful to the company and provide unjustified benefits to our competitors. Dated this 12-04-2015 By: Li Tang Signature Printed Title: Manager On behalf of : Shenzhen ANLEON Electronic Co.,LTD Telephone: +86-755-27616536

FCC ID Label Information 1. Label location: 2. FCC ID Label: Model: MTG-100 FCC ID: 2AGRXMTG-100 FCCID Label Location

STANDARD APPLICABLE According to §1.1307 (b)(1), system operating under the provisions of this section shall be operated in a manner that ensure that the public is not exposed to radio frequency energy level in excess of the Commission’s guideline. This is a portable device. Per KDB 447498 05r02, the device used distance is 5mm from body. LIMIT MEASUREMENT RESULTS Per KDB 447498 05r02 Max peak output power is 9.04dBm (8.01mW) at 652.5MHz. 8.01*√0.6525/5=1.294<3 The SAR measurement is not necessary.

Shenzhen CTL Testing Technology Co., Ltd. Tel: +86-755-89486194 Fax: +86-755-26636041 FCC PART 74H Test Report FCC ID: 2AGRXMTG-100 Report Reference No......................: CTL1511103241-WF Compiled by ( position+printed name+signature)..: File administrators Jacky Chen Name of the organization performing the tests ( position+printed name+signature)..: Test Engineer Tracy Qi Approved by ( position+printed name+signature)..: Manager Tracy Qi Date of issue.....................................: Nov. 23, 2015 Testing Laboratory Name..............: Shenzhen CTL Testing Technology Co., Ltd. Address.............................................: Floor 1-A, Baisha Technology Park, No.3011, Shahexi Road, Nanshan District, Shenzhen, China 518055 Applicant’s name............................: Shenzhen ANLEON Electronic Co.,LTD Address.............................................: HuiLongYuan 1-2-303, Minzhi, Longhua, Shenzhen, China Test specification: Standard ...........................................: FCC Part 74 Subpart H—Low Power Auxiliary Stations TRF Originator ..................................: Shenzhen CTL Testing Technology Co., Ltd. Master TRF.......................................: Dated 2011-01 Shenzhen CTL Testing Technology Co., Ltd. All rights reserved. This publication may be reproduced in whole or in part for non-commercial purposes as long as the Shenzhen CTL Testing Technology Co., Ltd. is acknowledged as copyright owner and source of the material. Shenzhen CTL Testing Technology Co., Ltd. takes no responsibility for and will not assume liability for damages resulting from the reader's interpretation of the reproduced material due to its placement and context. Test item description .................... : Wireless acoustic Transmission System Trade Mark .......................................: ANLEON Model/Type reference.......................: MTG-100 Modulation..................................: FM Channel Separation ........................... 200KHz Power Supply..............................: DC 3.0V from battery(2*AA) Operating Frequency Range............: From 650 MHz to 680 MHz Result................................................: Positive V1.0 Page 2 of 31 Report No.: CTL1511103241-WF T E S T R E P O R T Test Report No. : CTL1511103241-WF Nov. 23, 2015 ______________________________________________________________________________________________ Date of issue Equipment under Test : Wireless acoustic Transmission System Model /Type : MTG-100 Applicant : Shenzhen ANLEON Electronic Co.,LTD Address : HuiLongYuan 1-2-303, Minzhi, Longhua, Shenzhen, China Manufacture : Shenzhen ANLEON Electronic Co.,LTD Address : HuiLongYuan 1-2-303, Minzhi, Longhua, Shenzhen, China Test Result according to the standards on page 4: Positive The test report merely corresponds to the test sample. It is not permitted to copy extracts of these test result without the written permission of the test laboratory. V1.0 Page 3 of 31 Report No.: CTL1511103241-WF Contents 1. TEST STANDARDS 4 2. SUMMARY 5 2.1. General Remarks 5 2.2. Equipment Under Test 5 2.3. Short description of the Equipment under Test (EUT) 5 2.4. EUT operation mode 6 2.5. EUT configuration 6 2.6. Related Submittal(s) / Grant (s) 6 2.7. Modifications 6 3. TEST ENVIRONMENT 7 3.1. Address of the test laboratory 7 3.2. Test Facility 7 3.3. Environmental conditions 7 3.4. Configuration of Tested System 7 3.5. Statement of the measurement uncertainty 8 3.6. Equipments Used during the Test 8 3.7. General Technical Requirements and Summary of Test Results 9 4. TEST CONDITIONS AND RESULTS 10 4.1. OUTPUT POWER MEASUREMENT 10 4.2. MODULATION CHARACTERISTICS 12 4.3. OCCUPIED BANDWIDTH OF EMISSION 14 4.4. FIELD STRENGTH OF EMISSION 17 4.5. FREQUENCY STABILITY MEASUREMENT 24 5. TEST SETUP PHOTOS OF THE EUT 26 6. EXTERNAL AND INTERNAL PHOTOS OF THE EUT 27 V1.0 Page 4 of 31 Report No.: CTL1511103241-WF 1. TEST STANDARDS The tests were performed according to following standards: FCC Part 74 Subpart H—Low Power Auxiliary Stations TIA-603-C(2004)-Land Mobile FM or PM Communications Equipment Measurement and Performance Standsrds FCC Part 2: FREQUENCY ALLOCA-TIONS AND RADIO TREATY MAT-TERS; GENERAL RULES AND REG-ULATIONS ANSI C63.10-2013 ANSI C63.4-2014 V1.0 Page 5 of 31 Report No.: CTL1511103241-WF 2. SUMMARY 2.1. General Remarks Date of receipt of test sample : Nov. 10, 2015 Testing commenced on : Nov. 10, 2015 Testing concluded on : Nov. 23, 2015 2.2. Equipment Under Test Power supply system utilised Power supply voltage : ○ 120V / 60 Hz ○ 115V / 60Hz ○ 12 V DC ○ 24 V DC ● Other (specified in blank below) DC 3.0 V from battery (2*AA) 2.3. Short description of the Equipment under Test (EUT) The Two-Way Radio/Transceiver, Model: LS-A8 VHF or the “EUT” as referred to in this report; more general information as follows, for more details, refer to the user’s manual of the EUT. Name of EUT Wireless acoustic Transmission System Model Number MTG-100 FCC ID 2AGRXMTG-100 Modilation Type FM Channel Separation 200KHz Antenna Type External Frequency Range From 652.5 MHz to 677.5 MHz Channel list Channel Frequency (MHz) 1 652.5 2 657.5 3 662.5 4 667.5 5 672.5 6 677.5 Test frequency list Channel Frequency (MHz) Low 652.5 Middle 667.5 High 677.5 V1.0 Page 6 of 31 Report No.: CTL1511103241-WF 2.4. EUT operation mode The EUT has been tested under typical operating condition. 2.5. EUT configuration The following peripheral devices and interface cables were connected during the measurement: ● - supplied by the manufacturer ○ - supplied by the lab 2.6. Related Submittal(s) / Grant (s) This submittal(s) (test report) is intended for FCC ID: 2AGRXMTG-100 filing to comply with the FCC Part 74H Rules. 2.7. Modifications No modifications were implemented to meet testing criteria. V1.0 Page 7 of 31 Report No.: CTL1511103241-WF 3. TEST ENVIRONMENT 3.1. Address of the test laboratory Shenzhen CTL Testing Technology Co., Ltd. Floor 1-A, Baisha Technology Park, No. 3011, Shahex…

Text truncated - open the document above for the full version.