2AHPN-WLCQi Wireless charger module

User Guide of Wireless Charger Module (WCM): The Wireless Charger Module (WCM) will be placed near the Dashboard of the Vehicle as shown the below picture. It interacts with the Radio module via dedicated TELON line. WCM send the status “Charger Available” to the Radio Module once it wakes up. When the user places the mobile phone on top of the WCM. The user must accept the request “Start Charging” on the Radio as shown below. The Wireless Charger operating frequency is 127 KHz. WARNING! This device must be used more than 17cms from the Driver’s knee. FCC Regulatory notices Modification statement Harman International Industries, Inc has not approved any changes or modifications to this device by the user. Any changes or modifications could void the user’s authority to operate the equipment. Interference statement (if it is not placed in the device) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Wireless notice This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This transmitter must not be co- located or operating in conjunction with any other antenna or transmitter. The antenna should be installed and operated with minimum distance of 17cm between the radiator and your body. FCC Class B digital device notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:  Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  Consult the dealer or an experienced radio/TV technician for help.

External pictures

FCC Label design and location.

WCM – Internal and External Photos WCM part Description Plastic Bottom cover Heatsink: it is an external part made of aluminium, will be placed between bottom cover and PCB. Plastic Top cover: Mobile phone will be placed on this part. Wireless charger PCB board WPC compliant coil: Coli wire with 105 stands of AWG 40. Back picture of Wireless charger PCB board Back picture of plastic cover.

DEKRA Testing and Certification, S.A.U. Parque Tecnológico de Andalucía, c/ Severo Ochoa nº 2 · 29590 Campanillas · Málaga · España C.I.F. A29 507 456 Report No: (NIE) 62807RAN.001 2020-10-19 Test report No: NIE: 62807RAN.001 Test report RF EXPOSURE REPORT ACCORDING TO IEEE Std C95.3-2002 ISED RSS-102 Issue 5:2015 ISED RSS-102-SPR-002 Issue 1:2016 (*) Identification of item tested Wireless Charger Module (WCM) (*) Trademark Harman (*) Model and /or type reference VW WLC (*) Other identification of the product HW version: 02.00 SW Version: 00.10.05 FCC ID : 2AHPN-WLC (*) Features No additional features except smartphone charging and Foreign Object detection (*) Manufacturer Company name: Harman da Amazonia Indústria Eletronica e Participações Ltda Postal address: Av. Cupiuba, nr. 401, Galpão B, Distrito Industrial Manaus - AM, Brazil, 69075-060 Test method requested, standard IEEE Std C95.3-2002: “IEEE Recommended Practice for Measurements and Computations of Radio Frequency Electromagnetic Fields With Respect to Human Exposure to Such Fields, 100 kHz–300 GHz”. FCC 47 CFR Part 2.1091 Radiofrequency radiation exposure evaluation: mobile devices. ISED RSS-102 Issue 5 (2015-03) – Radio Frequency Exposure Compliance of Radiocommunication Apparatus RSS-102-SPR-002 Issue 1 (2016-09). – Supplementary Procedure for Assessing Compliance with RSS-102 Nerve Stimulation Exposure Limits (3kHz a 10MHz) Summary IN COMPLIANCE Approved by (name / position & signature) Miguel Lacave Antennas Lab Manager Date of issue 2020-10-19 Report template No FAN39_01 (*) “Data provided by the client” DEKRA Testing and Certification, S.A.U. Parque Tecnológico de Andalucía, c/ Severo Ochoa nº 2 · 29590 Campanillas · Málaga · España C.I.F. A29 507 456 Report No: (NIE) 62807RAN.001 Page 2 of 41 2020-10-19 Index Competences and guarantees .................................................................................................... 3 General conditions ...................................................................................................................... 3 Uncertainty ................................................................................................................................. 3 Data provided by the client .......................................................................................................... 3 Usage of samples ....................................................................................................................... 4 Test sample description .............................................................................................................. 4 Identification of the client............................................................................................................. 4 Testing period and place ............................................................................................................. 4 Document history ........................................................................................................................ 4 Environmental conditions ............................................................................................................ 5 Remarks and comments ............................................................................................................. 5 Testing verdicts ........................................................................................................................... 5 Appendix A: FCC RF Exposure ................................................................................................... 6 General description of the device under evaluation .................................................................. 7 Evaluation Results .................................................................................................................... 7 Qi WPT Evaluation ................................................................................................................... 8 Appendix B: ISED RF Exposure ................................................................................................ 16 General description of the device under evaluation ................................................................ 17 Evaluation Results .................................................................................................................. 17 Qi WPT Evaluation ................................................................................................................. 18 Qi WPT Evaluation - ISED Nerve Stimulation ......................................................................... 20 Appendix C: RF Exposure Information ...................................................................................... 24 FCC RF Exposure evaluation for mobile devices .................................................................... 25 FCC MPE Evaluation .............................................................................................................. 25 ISED RF Exposure evaluation for mobile devices ................................................................... 26 ISED MPE Evaluation ............................................................................................................. 26 Appendix D: Photographs ......................................................................................................... 27 DEKRA Testing and Certification, S.A.U. Parque Tecnológico de Andalucía, c/ Severo Ochoa nº 2 · 29590 Campanillas · Málaga · España C.I.F. A29 507 456 Report No: (NIE) 62807RAN.001 Page 3 of 41 2020-10-19 Competences and guarantees DEKRA Testing and Certification is a testing laboratory accredited by the National Accreditation Body (ENAC - Entidad Nacional de Acreditación), to perform the tests indicated in the Certificate No. 51/LE 147. In order to assure the traceability to other national and international laboratories, DEKRA has a calibration and maintenance program for its measurement equipment. DEKR…

Text truncated - open the document above for the full version.

DEKRA Testing and Certification, S.A.U. Parque Tecnológico de Andalucía, c/ Severo Ochoa nº 2 · 29590 Campanillas · Málaga · España C.I.F. A29 507 456 Report No: (NIE) 62807REM.003 2020-08-13 The standard marked with [#] is not covered by ENAC accreditation. Test report No: NIE: 62807REM.003 Test report FCC Rules and Regulations CFR 47, Part 18.305, Subpart C (10-1-19 Edition) & [#] ISED RSS-216 Issue 2 and ICES001 (*) Identification of item tested Wireless Charger Module (WCM) (*) Trademark Harman (*) Model and /or type reference VW WLC Other identification of the product HW Version: 02.00 SW Version: 00.10.05 (*) Features No additional features except smartphone charging and Foreign Object detection Manufacturer Harman International Industries, Inc. 30001 Cabot Drive. 48377 Novi, Michigan. USA Test method requested, standard FCC Rules and Regulations CFR 47, Part 18.305, Subpart C (10-1-19 Edition) & [#] ISED RSS-216 Issue 2 and ICES001 Summary IN COMPLIANCE Approved by (name / position & signature) Rafael López EMC Consumer & RF Lab. Manager Date of issue 2020-08-13 Report template No FDT08_22 (*) “Data provided by the client” DEKRA Testing and Certification, S.A.U. Parque Tecnológico de Andalucía, c/ Severo Ochoa nº 2 · 29590 Campanillas · Málaga · España C.I.F. A29 507 456 Report No: (NIE) 62807REM.003 Page 2 of 21 2020-08-13 Index Competences and guarantees .................................................................................................... 3 General conditions ...................................................................................................................... 3 Uncertainty ................................................................................................................................. 3 Data provided by the client .......................................................................................................... 3 Usage of samples ....................................................................................................................... 4 Test sample description .............................................................................................................. 4 Identification of the client............................................................................................................. 5 Testing period and place ............................................................................................................. 6 Document history ........................................................................................................................ 6 List of equipment used during the test......................................................................................... 7 Environmental conditions ............................................................................................................ 8 Remarks and comments ............................................................................................................. 9 Testing verdicts ........................................................................................................................... 9 Summary .................................................................................................................................... 9 Appendix A: Test results ........................................................................................................... 10 DEKRA Testing and Certification, S.A.U. Parque Tecnológico de Andalucía, c/ Severo Ochoa nº 2 · 29590 Campanillas · Málaga · España C.I.F. A29 507 456 Report No: (NIE) 62807REM.003 Page 3 of 21 2020-08-13 Competences and guarantees DEKRA Testing and Certification is a testing laboratory accredited by the National Accreditation Body (ENAC - Entidad Nacional de Acreditación), to perform the tests indicated in the Certificate No. 51/LE 147. DEKRA Testing and Certification is a FCC recognized accredited testing laboratory with appropriate scope of accreditation that include testing performed in this test report, FCC designation number ES0004. In order to assure the traceability to other national and international laboratories, DEKRA Testing and Certification has a calibration and maintenance program for its measurement equipment. DEKRA Testing and Certification guarantees the reliability of the data presented in this report, which is the result of the measurements and the tests performed to the item under test on the date and under the conditions stated on the report and, it is based on the knowledge and technical facilities available at DEKRA Testing and Certification at the time of performance of the test. DEKRA Testing and Certification is liable to the client for the maintenance of the confidentiality of all information related to the item under test and the results of the test. The results presented in this Test Report apply only to the particular item under test established in this document. IMPORTANT: No parts of this report may be reproduced or quoted out of context, in any form or by any means, except in full, without the previous written permission of DEKRA Testing and Certification. General conditions 1. This report is only referred to the item that has undergone the test. 2. This report does not constitute or imply on its own an approval of the product by the Certification Bodies or competent Authorities. 3. This document is only valid if complete; no partial reproduction can be made without previous written permission of DEKRA Testing and Certification. 4. This test report cannot be used partially or in full for publicity and/or promotional purposes without previous written permission of DEKRA Testing and Certification and the Accreditation Bodies. Uncertainty Uncertainty (factor k=2) was calculated according to the DEKRA Testing and Certification internal document PODT000. The total uncertainty of the measurement system for the measured radio disturbance characteristics of EUT from 150kHz to 30 MHz is I = ±5,08 dB for qu…

Text truncated - open the document above for the full version.

DEKRA Testing and Certification, S.A.U. Parque Tecnológico de Andalucía, c/ Severo Ochoa nº 2 · 29590 Campanillas · Málaga · España C.I.F. A29 507 456 Report No: (NIE) 62807REM.003 2020-08-13 Appendix B: Photographs DEKRA Testing and Certification, S.A.U. Parque Tecnológico de Andalucía, c/ Severo Ochoa nº 2 · 29590 Campanillas · Málaga · España C.I.F. A29 507 456 Report No: (NIE) 62807REM.003 Page 2 of 2 2020-08-13