2AJFG561128Urban Active Vehicle 2.1 315MHz

Urban Active Vehicle (Maven) Installation Instruction Sheet Rev 2.5 (Applies to GM P/Ns 84735894 and 84735895) Step 1: Install supplied Y-harness into vehicle (either snap-in or flange style depending on vehicle requirements). Step 2: Turn vehicle on. Step 3: Plug accessory module into supplied Y-harness. Step 4: Wait for 1 to 2minutes to allow accessory to read vehicle VIN. Step 5: Verify correct hashed VIN using any BLE scanning tool. Step 6: If hashed VIN does not match use BLE scanning tool to complete a radio level connection. Step 7: Confirm correct hashed VIN using BLE scanning tool. Step 8: Secure accessory to vehicle with connectors facing down. Step 9: Accessory installation is complete. Urban Active Vehicle (Maven) Installation Instruction Sheet Rev 2.5 (Applies to GM P/Ns 84735894 and 84735895) Step 1: Install supplied Y-harness into vehicle (either snap-in or flange style depending on vehicle requirements). Step 2: Turn vehicle on. Step 3: Plug accessory module into supplied Y-harness. Step 4: Wait for 1 to 2minutes to allow accessory to read vehicle VIN. Step 5: Verify correct hashed VIN using any BLE scanning tool. Step 6: If hashed VIN does not match use BLE scanning tool to complete a radio level connection. Step 7: Confirm correct hashed VIN using BLE scanning tool. Step 8: Secure accessory to vehicle with connectors facing down. Step 9: Accessory installation is complete. Urban Active Vehicle (Maven) Installation Instruction Sheet Rev 2.5 (Applies to GM P/Ns 84735894 and 84735895) Step 1: Install supplied Y-harness into vehicle (either snap-in or flange style depending on vehicle requirements). Step 2: Turn vehicle on. Step 3: Plug accessory module into supplied Y-harness. Step 4: Wait for 1 to 2minutes to allow accessory to read vehicle VIN. Step 5: Verify correct hashed VIN using any BLE scanning tool. Step 6: If hashed VIN does not match use BLE scanning tool to complete a radio level connection. Step 7: Confirm correct hashed VIN using BLE scanning tool. Step 8: Secure accessory to vehicle with connectors facing down. Step 9: Accessory installation is complete. Urban Active Vehicle (Maven) Installation Instruction Sheet Rev 2.5 (Applies to GM P/Ns 84735894 and 84735895) Step 1: Install supplied Y-harness into vehicle (either snap-in or flange style depending on vehicle requirements). Step 2: Turn vehicle on. Step 3: Plug accessory module into supplied Y-harness. Step 4: Wait for 1 to 2minutes to allow accessory to read vehicle VIN. Step 5: Verify correct hashed VIN using any BLE scanning tool. Step 6: If hashed VIN does not match use BLE scanning tool to complete a radio level connection. Step 7: Confirm correct hashed VIN using BLE scanning tool. Step 8: Secure accessory to vehicle with connectors facing down. Step 9: Accessory installation is complete. FCC ID: 2AJFG561128 or 2AJFG561129 Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IC: 21819-561128 or 21819-561129 This device complies with Industry Canada license-exempt RSSs. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme aux normes d’exemption de licence RSS d’Industry Canada. Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas causer d’interférence et (2) cet appareil doit accepter toute interférence, notamment les interferences qui peuvent affecter son fonctionnement FCC ID: 2AJFG561128 or 2AJFG561129 Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IC: 21819-561128 or 21819-561129 This device complies with Industry Canada license-exempt RSSs. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme aux normes d’exemption de licence RSS d’Industry Canada. Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas causer d’interférence et (2) cet appareil doit accepter toute interférence, notamment les interferences qui peuvent affecter son fonctionnement FCC ID: 2AJFG561128 or 2AJFG561129 Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IC: 21819-561128 or 21819-561129 This device complies with Industry Canada license-exempt RSSs. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme aux normes d’exemption de licence RSS d’Industry Canada. Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas causer d’interfé…

Text truncated - open the document above for the full version.

1 307 Robbins Dr. Troy, MI 48083 248.838.9680 Urban Active Vehicle Module Pictures 2 307 Robbins Dr. Troy, MI 48083 248.838.9680

1 307 Robbins Dr. Troy, MI 48083 248.838.9680 561128 Label Picture Location The label is located on the lower half of the housing, opposite end from the connectors and opposite side from the Maven logo.

1 307 Robbins Dr. Troy, MI 48083 248.838.9680 Urban Active Vehicle Internal Module Pictures 2 307 Robbins Dr. Troy, MI 48083 248.838.9680

NVLAP LAB CODE 200065-0 TEST REPORT Report Number: 13092603-E1V3 Applicant : VAST PRODUCTION SERVICES 307 ROBBINS DRIVE TROY, MI 48083, U.S.A FCC ID ISED Model Number : : : 2AJFG561128 21819-561128 84735894 EUT Description : URBAN ACTIVE VEHICLE 2.1 315MHz Test Standard(s) : FCC 47 CFR PART 15 SUBPART C INDUSTRY CANADA RSS 210 Issue 10 INDUSTRY CANADA RSS-GEN Issue 5 Date of Issue: July 14, 2020 Prepared by: UL Verification Services Inc. 47173 Benicia Street Fremont, CA 94538 U.S.A. TEL: (510) 319-4000 FAX: (510) 661-0888 REPORT NO: 13092603-E1V3 DATE: 7/14/2020 FCC ID: 2AJFG561128 ISED: 21819-561128 Page 2 of 30 UL VERIFICATION SERVICES INC 47173 BENICIA STREET, FREMONT, CA 94538, USA TEL: (510) 319-4000 FAX: (510) 661-0888 This report shall not be reproduced except in full, without the written approval of UL Verification Services Inc.. Revision History Rev. Issue Date Revisions Revised By V1 6/12/2020 Initial Issue Steven Tran V2 7/13/2020 Updated Section 5.3, 7.2 and added 7.3 Transmission Time & addressed reviewer’s comments Vien Tran V3 7/14/2020 Updated Section 7.2 Test Procedure per reviewer’s comments Vien Tran REPORT NO: 13092603-E1V3 DATE: 7/14/2020 FCC ID: 2AJFG561128 ISED: 21819-561128 Page 3 of 30 UL VERIFICATION SERVICES INC 47173 BENICIA STREET, FREMONT, CA 94538, USA TEL: (510) 319-4000 FAX: (510) 661-0888 This report shall not be reproduced except in full, without the written approval of UL Verification Services Inc.. TABLE OF CONTENTS 1. ATTESTATION OF TEST RESULTS ................................................................................. 4 2. TEST METHODOLOGY ..................................................................................................... 6 3. FACILITIES AND ACCREDITATION ................................................................................. 6 4. DECISION RULES AND MEASUREMENT UNCERTAINTY .............................................. 7 4.1. METROLOGICAL TRACEABILITY .............................................................................. 7 4.2. DECISION RULES ....................................................................................................... 7 4.3. MEASUREMENT UNCERTAINTY ............................................................................... 7 4.4. SAMPLE CALCULATION ............................................................................................ 7 5. EQUIPMENT UNDER TEST ............................................................................................... 8 5.1. DESCRIPTION OF EUT .............................................................................................. 8 5.2. MAXIMUM FUNDAMENTAL FIELD STRENGTH......................................................... 8 5.3. DESCRIPTION OF AVAILABLE ANTENNAS .............................................................. 8 5.4. WORST-CASE CONFIGURATION AND MODE .......................................................... 8 5.5. DESCRIPTION OF TEST SETUP ................................................................................ 9 6. TEST AND MEASUREMENT EQUIPMENT ......................................................................12 7. ANTENNA PORT TEST RESULTS ...................................................................................13 7.1. 20 dB AND 99% BW ...................................................................................................13 7.2. DUTY CYCLE .............................................................................................................15 7.3 TRANSMISSION TIME ...............................................................................................19 8. RADIATED EMISSION TEST RESULTS...........................................................................20 9. SETUP PHOTOS ...............................................................................................................29 REPORT NO: 13092603-E1V3 DATE: 7/14/2020 FCC ID: 2AJFG561128 ISED: 21819-561128 Page 4 of 30 UL VERIFICATION SERVICES INC 47173 BENICIA STREET, FREMONT, CA 94538, USA TEL: (510) 319-4000 FAX: (510) 661-0888 This report shall not be reproduced except in full, without the written approval of UL Verification Services Inc.. 1. ATTESTATION OF TEST RESULTS COMPANY NAME: Vast Production Services 307 Robbins Drive Troy, MI 48083, U.S.A. EUT DESCRIPTION : URBAN ACTIVE VEHICLE 2.1 315MHz MODEL: 84735894 SERIAL NUMBER: hh089068 (Radiated) DATE TESTED: April 20, 2020 to July 09, 2020 APPLICABLE STANDARDS STANDARD TEST RESULTS FCC PART 15 SUBPART C Complies INDUSTRY CANADA RSS-210 Issue 10, Annex A Complies INDUSTRY CANADA RSS-GEN Issue 5 Complies UL Verification Services Inc. tested the above equipment in accordance with the requirements set forth in the above standards. The test results show that the equipment tested is capable of demonstrating compliance with the requirements as documented in this report. The results documented in this report apply only to the tested sample, under the conditions and modes of operation as described herein. It is the manufacturer's responsibility to assure that additional production units of this model are manufactured with identical electrical and mechanical components. All samples tested were in good operating condition throughout the entire test program. Measurement Uncertainties are published for informational purposes only and were not taken into account unless noted otherwise. This document may not be altered or revised in any way unless done so by UL Verification Services Inc. and all revisions are duly noted in the revisions section. Any alteration of this document not carried out by UL Verification Services Inc. will constitute fraud and shall nullify the document. This report must not be used by the client to claim product certification, approval, or endorsement by NVLAP, NIST, any agency of the Federal Government, or any agency of the U.S. government. REPORT NO: 13092603-E1V3 DATE: 7/14/2020 FCC ID: 2AJFG561128 ISED: 21819-561128 Page 5 of 3…

Text truncated - open the document above for the full version.

REPORT NO: 13092603-E1V3 DATE: 7/14/2020 FCC ID: 2AJFG561128 ISED: 21819-561128 Page 29 of 30 UL VERIFICATION SERVICES INC 47173 BENICIA STREET, FREMONT, CA 94538, USA TEL: (510) 319-4000 FAX: (510) 661-0888 This report shall not be reproduced except in full, without the written approval of UL Verification Services Inc.. 9. SETUP PHOTOS RADIATED RF MEASUREMENT SETUP BELOW 30MHz (FRONT) BELOW 30MHz (BACK) BELOW 1GHz (FRONT) BELOW 1GHz (BACK) ABOVE 1GHz (FRONT) ABOVE 1GHz (BACK) REPORT NO: 13092603-E1V3 DATE: 7/14/2020 FCC ID: 2AJFG561128 ISED: 21819-561128 Page 30 of 30 UL VERIFICATION SERVICES INC 47173 BENICIA STREET, FREMONT, CA 94538, USA TEL: (510) 319-4000 FAX: (510) 661-0888 This report shall not be reproduced except in full, without the written approval of UL Verification Services Inc.. ORIENTATIONS X-ORIENTATION Y-ORIENTATION Z-ORIENTATION END OF TEST REPORT