2AQ85HY0021Bluetooth Low Energy module

© 2024 FDK CORPORATION 0 FDK-CONFIDENTIAL HY0021 - Label Design Label1 Product size is 10x3.5mm and not enough to attach the label. The label is going to be affixed on the packaging and user manual(Data Sheet).

RF exposure information Product information from applicant Applicant : FDK CORPORATION Applicant address : 2281 Washizu Kosai-shi Shizuoka, Japan FCC ID : 2AQ85HY0021 ISED ID : 31945- HY0021 HVIN : HY0021 Product description : Bluetooth low energy module Operating frequency range : 2402 - 2480 MHz Peak output power (Measured) : 4.83dBm @2402MHz, 4.74dBm @2440MHz, 4.80dBm @2480MHz (1Mbps) 4.85dBm @2404MHz, 4.80dBm @2440MHz, 4.82dBm @2478MHz (2Mbps) Time-averaged maximum e.i.r.p. : 1.83mW @2402MHz, 1.79mW @2440MHz, 1.82mW @2480MHz (1Mbps) (Measured) 1.84mW @2404MHz, 1.82mW @2440MHz, 1.83mW @2478MHz (2Mbps) Maximum antenna gain : -2.2 dBi Analysis for mobile use [For FCC] General frequency and separation-distance dependent MPE-based effective radiated power (ERP) thresholds are in Table B.1 to support an exemption from further evaluation from 300 kHz through 100 GHz, in accordance with KDB 447498 D04 Interim General RF Exposure Guidance v01. Since the minimum separation distance between the body of a nearby person and the radiating element of the product is 0.2 m, the threshold ERP is calculated to be 0.768 W for 2402 - 2480 MHz. On the other hand, the ERP of the product is calculated to be 0.50 dBm ( = 4.85 dBm – 2.2 dBi - 2.15 dB), which is equal to 0.00112 W and lower than the above threshold ERP (0.768 W). Therefore, the product meets the MPE-based exemption and further evaluation is not required. [For ISED] Field reference level (FRL) exposure evaluation is required if the separation distance between the user and/or bystander and the radiating element of the product is greater than 20 cm, except when the source-based, time-averaged maximum e.i.r.p. of the product is equal to or less than 1.31 x 10 -2 ƒ 0.6834 W (adjusted for tune-up tolerance), where ƒ is in MHz. The maximum e.i.r.p. of the product is 0.00184 W, which is less than the above exemption limit (2.68 W for 2402 MHz). Thus the product meets the exemption from the routine evaluation limits in Section 6.6 of RSS-102 Issue 6, and FRL exposure evaluation is not required.

This document is issued by the Company subject to its General Conditions of Service accessible at https://www.sgs.com/en/Terms-and-Conditions.aspx. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Unless otherwise stated the results shown in this Test Report refer only for the tested sample(s). Any holder of this document is advised that information contained hereon reflects the Company's findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. この試験報告書は、https://www.sgs.com/en/Terms-and-Conditions.aspxで入手が可能なサービスに関する一般的条件に則して発行されます。そちらに明記されている弊社の負うべき債務・補償 の範囲及び司法管轄の項目をご参照ください。他に特に明記のない限り、この試験報告書に記載された結果は、試験したサンプルのみに属します。この書面全体の複製以外には、弊社からの事前 の許可を得ること無く複製することを禁じます。この試験報告書を無断で変更、偽造、改ざんすることは違法であり、違反者に対しては法的手段を講じることとなります。 SGS Japan Inc. 3-5-23, Kitayamata, Tsuzuki-ku, Yokohama 224-0021, Japan t +81(0) 50 1780 7880 f +81(0) 45 592 7506 URL: https://www.sgsgroup.jp Member of the SGS Group (Société Générale de Surveillance) Issue Date: 23 Aug. 2024 Report No.: WE240617CB1-11 Model: HY0021 Page 1 of 60 TEST REPORT For Bluetooth low energy module In conformity with FCC Part 15C/ RSS-247 Issue 3 Model Name: HY0021 FCC ID: 2AQ85HY0021 ISED Cert No.: 31945- HY0021 Report No.: WE240617CB1-11 Issue Date: 23 Aug. 2024 Prepared for FDK CORPORATION 2281 Washizu Kosai-shi Shizuoka, Japan Prepared by SGS Japan Inc. 3-5-23, Kitayamata, Tsuzuki-ku, Yokohama, 224-0021, Japan Telephone: +81+(0)50-1780-7880 FAX: +81+(0)45- 592-7506 This document is issued by the Company subject to its General Conditions of Service accessible at https://www.sgs.com/en/Terms-and-Conditions.aspx. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Unless otherwise stated the results shown in this Test Report refer only for the tested sample(s). Any holder of this document is advised that information contained hereon reflects the Company's findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. この試験報告書は、https://www.sgs.com/en/Terms-and-Conditions.aspxで入手が可能なサービスに関する一般的条件に則して発行されます。そちらに明記されている弊社の負うべき債務・補償 の範囲及び司法管轄の項目をご参照ください。他に特に明記のない限り、この試験報告書に記載された結果は、試験したサンプルのみに属します。この書面全体の複製以外には、弊社からの事前 の許可を得ること無く複製することを禁じます。この試験報告書を無断で変更、偽造、改ざんすることは違法であり、違反者に対しては法的手段を講じることとなります。 SGS Japan Inc. 3-5-23, Kitayamata, Tsuzuki-ku, Yokohama 224-0021, Japan t +81(0) 50 1780 7880 f +81(0) 45 592 7506 URL: https://www.sgsgroup.jp Member of the SGS Group (Société Générale de Surveillance) Issue Date: 23 Aug. 2024 Report No.: WE240617CB1-11 Model: HY0021 Page 2 of 60 Table of Contents 1 General information ............................................................................................................................. 3 1.1 Product description from supplier .................................................................................................................................. 3 1.2 Test(s) performed/ Summary of test result..................................................................................................................... 4 1.3 Test facility .................................................................................................................................................................... 5 1.4 Measurement uncertainty ............................................................................................................................................... 5 1.5 Summary of test results .................................................................................................................................................. 6 1.6 Setup of equipment under test (EUT) ............................................................................................................................ 7 1.6.1 Test configuration of EUT ..................................................................................................................................... 7 1.6.2 Setup diagram of tested system .............................................................................................................................. 8 1.6.3 Operating condition ............................................................................................................................................... 9 1.7 Equipment modifications ............................................................................................................................................... 9 1.8 Deviation from the standard ........................................................................................................................................... 9 2 Test procedure and test data ............................................................................................................. 10 2.1 Occupied Bandwidth (99%) ......................................................................................................................................... 10 2.2 6dB Bandwidth .................…

Text truncated - open the document above for the full version.