2AUKF-G18GPS Tracker

GPS indicator (yellow) GSM indicator (red) Backup battery switch SIM Card slot GPS TRACKER USER MANUAL Please read the user manual carefully before installation. 1 Product Introduction Thank you for choosing our GPS. This manual describes the main functions, installation, maintenance and precautions of the terminal. Please read this manual carefully. Product front view Product rear view 2.Internal structure Standard packing Item Unit 1 2 3 4 Device Power cable User manual Warranty card 1 1 1 1 Unit Piece Piece Piece Relay Piece Item Unit Product interface definition and wire connection Optional accessory Interface definition table NO. Color Definition Yellow Orange Black Red Connect to relay ACC Negative pole Positive pole Parameters and Functions Parameter list Item Specifications Voltage Current Size Targeting Positioning accuracy DC 9V-90V 25mA@12V(Quiescent current 10mA) GPS Positioning accuracy <10m (This data is for reference only, which is measured by company laboratory, sometimes error is related to the terrain and the vehicle location) Communication network Communication method Working temperature Light alarm Net weight GPRS TCP/IP -25°C-75°C YES 27g Backup battery working time 0.5hour Installation instructions ①Equipment installation Check GPS appearance and accessories of the device. ②Install the SIM card Put the SIM card into the deck and confirm if the SIM Card
has internet access and call/sms services. ③Installation location A. Keep dry and away from air conditioning vents. B. Avoid installation in long-term vibration areas. C. Be away from radiation interference areas. T rouble Shooting Weak signal Unable to receive satellites properly Take device to the open sky areas Problem Description Solution Unable to boot Low battery Charge the battery SIM card is in wrong position Check SIM card Dirty SIM card Wipe SIM card SIM card is damaged or invalid Replace SIM card No GSM service Move the device in GSM network area Weak singal Move to open sky areas Poor connection Check the power wire connection SIM card GPRS service failed Contact the SIM Card supplier SIM card arrears Recharge fee Wrong command Send correct format SMS again SMS no reply Enable SMS service GPS parameters setting failed For defects devices not damaged by human factors, we will replace a new one, if it corresponds to our warranty policy. Function Specification Description Collision alarm Device will detect collision and upload alarm. Default setting is off. Driver behavior Device will detect rapid acceleration, harsh breaking and sharp turn. Rollover alarm Device will detect and upload alarm if vehicle in rollover. Remove alarm Device will detect and upload alarm if illegal removal happened. Low battery alarm Low battery alarm will be triggered if vehicle voltage goes below 5V(T urn on backup battery
switch). Vehicle status detection Fuse blown Replace the same specification fuse Structure Description 1.Structure appearance y o b r Under the rear windshield or in the trunk Inside the dashboard Under front windshield Under the wiper Car Fail connect to the network Can not be charged Qty Can not get GPS location 23 56 Fast flash: GSM initialization Slow flashing: GSM receiving signal normally Fast flash: GPS signal search GPS located Long light: GPRS online No light: no GSM signal received/ no SIM card inserted No light: GPS sleep/not at work Indicator status GSM (red) GPS (yellow) Light type Lamp status 1. Platform(www.wanwaygps.com) 2. Android and IOS APP Scan the qr code to download app or search “wanwaytrack” Access to Platform There are two methods to login in the platform or app. 1. Login by IMEI number

(the 15 digits in the back of the device),
password: the last 6 digits of IMEI number. 2. Contact the supplier to create an account for you. 7 NO. NO. 1.Parameters checking SMS content: <CKWW> 2.Cut off oil&Recover oil setting Cut off Oil:RELAY ,1# Recover Oil:RELAY,0# 3.Time zone setting GMT,E,6# SMS Command Setting 4 Near the interior of the headlight cover Inside the taillight Key switch Under the seat Motorcycle E-bike FCC Statement： Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. Customers Data Customers Name Telephone Address Model Type IMEI number Purchase Data Invoice No Company Address Warranty Card Please keep the warranty card carefully This product is subject to any technical change without prior notice. Product appearance and color are subject to the actual product. GPRS 900:34.00dBm, GPRS 1800:30.50dBm FCC Radiation Exposure Statement: This equipment complies with FCC…

Text truncated - open the document above for the full version.

Company: Shanghai WanWayTech Co., Ltd Add: 23rd Floor, Yibo Mansion, No.1999 Wenchuan Road, Baoshan District, Shanghai, China Tel: +86-18438623792 Fax: +86-18438623792 E-mail: [email protected] DECLARATION Dear Sir or Madam: We, Shanghai WanWayTech Co., Ltd, hereby declare that product: GPS Tracker (Model name: G18, G20, G21, EV18, G18P, G18W. FCC ID: 2AUKF-G18), these models are electrically identical with the PCB design, components and electromagnetic compatibility characteristics. And G18 has been tested by BACL. Please contact me if there is need for any additional clarification or info rmation. Best Regards, Signature: Print Name: Sophia Lee Title: Manager FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oa kland Mills Road Columbia, MD 21046 The differences of them are as follows: The model name Date: 2019-12-17

QA-FR-170-B Company: Shanghai WanWayTech Co., Ltd Ad d: 23rd Floor, Yibo Mansion, No.1999 Wenchuan Road, Baoshan District, Shanghai, China Tel: +86-18438623792 Fax: +86-18438623792 FCC Authorization Date: 2019-12-17 FEDERAL COMMUNICATIONS COMMISSION Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Agent Authorization To whom it may concern: We, Shanghai WanWayTech Co., Ltd, the undersigned, Hereby authorizes Bay Area Compliance Laboratories Corporation to act on its behalf in all matters relating to application for Equipment authorization, including the signing of all documents relating to these matters. All acts carried out by Bay Area Compliance Laborato ries Corp. on our behalf shall have the same effect as our own action. We, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. This authorization is valid until further written notice from the applicant. Sincerely Yours, Signature: Typed or Printed Name: Sophia Lee Title: Manager

Company Name: Shanghai WanWayTech Co., Ltd Add: 23rd Floor, Yibo Mansion, No.1999 Wenchuan Road, Baoshan District, Shanghai, China Tel: +86-18438623792 Fax: +86-18438623792 E-mail: [email protected] FCC Confidential Authorization Date:2019-1 2-17 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Confidentiality Request regarding application for certification of FCC ID: 2AUKF-G18 To: whom it may concern, In accordance with Sections 0.457 and 0.459 of the Commission’s Rules, Shanghai WanWayTech Co., Ltd hereby requests long-term confidential treatment of information accompanying this application as outlined below: The above materials contain proprietary and confidential information not customarily released to the public. The public disclosure of these materials provides unjustified benefits to its competitors in the market. Sincerely Yours, Signature: Typed or Printed Name: Sophia Lee Title: Manager Block Diagram Schematics Operation Description  Bom  Tune up procedure

EXHIBIT A - EUT EXTERNAL PHOTOGRAPHS

EXHIBIT B - EUT INTERNAL PHOTOGRAPHS GPS AntennaGPRS Antenna

Bay Area Compliance Laboratories Corp.( Kunshan) Report No.: RSHF191217001-00B FCC Part 22H/24E Page 11 of 30 FCC §1.1310 & §2.1091- MAXIMUM PERMISSIBLE EXPOSURE (MPE) Applicable Standard According to subpart 15.247 (i) and subpart 1.1310, 2.1091 systems operating under the provisions of this section shall be operated in a manner that ensures the public is not exposed to RF energy level in excess of the communication guidelines. Limits for General Population/Uncontrolled Exposure Frequency Range (MHz) Electric Field Strength (V/m) Magnetic Field Strength (A/m) Power Density (mW/cm 2 ) Averaging Time (minutes) 0.3-1.346141.63*(100)30 1.34-30824/f2.19/f*(180/f²)30 30-30027.50.0730.230 300-1500/f/150030 1500-100,000/1.030 f = frequency in MHz; * = Plane-wave equivalent power density Calculated Formulary: Pre dication of MPE limit at a given distance S = PG/4πR² = power density (in appropriate units, e.g. mW/cm 2 ); P = power input to the antenna (in appropriate units, e.g., mW); G = power gain of the antenna in the direction of interest relative to an isotropic radiator, the power gain factor, is normally numeric gain; R = distance to the center of radiation of the antenna (appropriate units, e.g., cm); Bay Area Compliance Laboratories Corp.( Kunshan) Report No.: RSHF191217001-00B FCC Part 22H/24E Page 12 of 30 Calculated Data: Mode Frequency Range (MHz) Antenna Gain Target Output Power Evaluation Distance (cm) Power Density (mW/cm 2 ) MPE Limit (mW/ cm 2 ) (dBi) (numeric)(dBm)(mW) GPRS 850 824.2-848.8 0. 01 .00 26.50 446.68 20 0.0889 0.55 GPRS 1900 1850.2-1909.8 0. 01 .00 23.00 199.53 20 0.0397 1.00 Note: Antenna Gain (numeric): 0.0dBi (1.0) for GPRS 850 mode. Antenna Gain (numeric): 0.0 dBi (1.0) for GPRS 1900 mode. 3. GSM 850: Tune-up maximum output power : 1 slot 33.00dBm, 2 slots 32.00dBm, 3 slots 30.50dBm, 4 slots 29.50dBm, so the tune-up time based Ave. power compared to sloted Av e. power is 26.50dBm. PCS 1900: Tune-up Maximum output power: 1 slot 29.00dBm, 2 slots 28.00dBm, 3 slots 27.00dBm, 4 slots 2 6.00dBm, so the tune-up time based Ave. power compared to sloted Ave. power is 23.00 dBm. Number of Time slot 1 2 3 4 Duty Cycle 1:8 1:4 1:2.66 1:2 Time based Ave. power compared to slotted Ave. power -9 dB -6 dB -4.25 dB -3 dB Resul t: The device meet FCC MPE at 20 cm distance.

Note: This test report is prepared for the customer shown above and for the device described herein. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratories Corp. This report is valid only with a valid digital signature. The digital signature may be available only under the Adobe software above version 7.0. FCC PART 22H, PART 24E TEST REPORT For Shanghai WanWayTech Co., Ltd 23rd Floor, Yibo Mansion, No.1999 Wenchuan Road, Baoshan District, Shanghai, China FCC ID: 2AUKF-G18 Report Type: Original Report Product Type: GPS Tracker Test Engineer: Chao Gao Re port Number: RSHF191217001-00B Re port Date: 2020-02-11 Reviewed B y: Oscar Ye EMC Manager Prepared By: Bay Area Compliance Laboratories Corp. (Kunshan) No.248 Chenghu Road, Kunshan, Jiangsu province, China Tel: +86-0512-86175000 Fax: +86-0512-88934268 www.baclcorp.com.cn Bay Area Compliance Laboratories Corp.( Kunshan) Report No.: RSHF191217001-00B FCC Part 22H/24E Page 2 of 30 TABLE OF CONTENTS GENERAL INFORMATION ....................................................................................................................................... 3 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ..................................................................................... 3 OBJECTIVE ................................................................................................................................................................... 3 RELATED SUBMITTAL(S)/GRANT(S) ............................................................................................................................. 3 TEST METHODOLOGY .................................................................................................................................................. 4 MEASUREMENT UNCERTAINTY .................................................................................................................................... 5 TEST FACILITY ............................................................................................................................................................. 5 SYSTEM TEST CONFIGURATION .......................................................................................................................... 6 JUSTIFICATION ............................................................................................................................................................. 6 CHANNEL LIST ............................................................................................................................................................. 6 EQUIPMENT MODIFICATIONS ....................................................................................................................................... 6 SUPPORT EQUIPMENT LIST AND DETAILS .................................................................................................................... 6 EXTERNAL I/O CABLE .................................................................................................................................................. 6 BLOCK DIAGRAM OF TEST SETUP ................................................................................................................................ 7 SUMMARY OF TEST RESULTS ............................................................................................................................... 8 TEST EQUIPMENT LIST ........................................................................................................................................... 9 FCC §1.1310 & §2.1091- MAXIMUM PERMISSIBLE EXPOSURE (MPE) ............................................................ 11 APPLICABLE STANDARD ............................................................................................................................................ 11 CALCULATED FORMULARY: ....................................................................................................................................... 11 CALCULATED DATA: .................................................................................................................................................. 12 FCC §2.1047 - MODULATION CHARACTERISTIC ............................................................................................ 13 FCC §2.1046; § 22.913 (A); § 24.232 (C); - RF OUTPUT POWER ........................................................................ 14 APPLICABLE STANDARDS........................................................................................................................................... 14 TEST PROCEDURE ...................................................................................................................................................... 14 TEST DATA ................................................................................................................................................................ 15 FCC §2.1049, §22.917, §22.905 & §24.238; - OCCUPIED BANDWIDTH ............................................................. 17 APPLICABLE STANDARDS........................................................................................................................................... 17 TEST PROCEDURE ...................................................................................................................................................... 17 TEST DATA ................................................................................................................................................................ 17 FCC § 2.1051; § 22.917 (A); § 24.238 (A); - SPURIOUS EMISSIONS AT ANTENNA TERMINALS ............... 20 APPLICABLE STANDARDS........................................................................................................................................... 20 TEST PROCEDURE ...............................................................................................…

Text truncated - open the document above for the full version.