2AVI830019-308Wireless Remote Control Switch

External Photos TOP VIEW OF EUT BOTTOM VIEW OF EUT FRONT VIEW OF EUT BACK VIEW OF EUT LEFT VIEW OF EUT RIGHT VIEW OF EUT

FCC ID Label Location FCC ID: 2AVI830019-308 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Internal Photos OPEN VIEW OF EUT-1 OPEN VIEW OF EUT-2 OPEN VIEW OF EUT-3 INTERNAL VIEW OF EUT-1 INTERNAL VIEW OF EUT-2 INTERNAL VIEW OF EUT-3 Antenna INTERNAL VIEW OF EUT-4 INTERNAL VIEW OF EUT-5

Fulcrum Products Inc. Declaration concerning Antenna Specification It is hereby declared that the product Model No.: 30019-308 FCC ID: 2AVI830019-308 fulfills the requirement in FCC test relating to the antenna type. The device specified above confirms to the FCC recommendations for internal antenna type(s) described below: Type of antenna: Integral antenna Gain of the antenna: 1.5dBi Frequency range: 433.92 MHz The mounting of the antenna is fixed to the radio module and no other antenna should be used. Company name: Fulcrum Products Inc. Address: Room 301, 3rd floor,NO.26 Laowei 1st Zone, Shuidoulaowei, Yousong Community, Longhua District, Shenzhen, China Place: Shenzhen Date: 2020-01-17 Signature:

RF EXPOSURE EVALUATION 1. PRODUCT INFORMATION Product Description Wireless Remote Control Switch Model Name 30019-308 FCC ID 2AVI830019-308 2. EVALUATION METHOD According to 447498 D01 General RF Exposure Guidance v05 the 1-g and 10-g SAR test exclusion thresholds for 100 MHz to 6 GHz at test separation distances ≤ 50 mm are determined by: [(max. power of channel, including tune-up tolerance, mW)/(min. test separation distance, mm)] ·[√f(GHz)] ≤ 3.0 for 1-g SAR and ≤ 7.5 for 10-g extremity SAR. Where f(GHz) is the RF channel transmit frequency in GHz Power and distance are rounded to the nearest mW and mm before calculation 3. CALCULATION Pt= 69dBuV/m (3m) = less than 0.001 mW @ 434MHz The value of the Maximum output power Pt is referred to the test report of the CFR47 §15.249 No: AGC01184191208FE03 4. CONCLUSION The SAR evaluation is not required.

Page 1 of 28 FCC Test Report Report No.: AGC01184191208FE03 FCC ID : 2AVI830019-308 APPLICATION PURPOSE : Original Equipment PRODUCT DESIGNATION : Wireless Remote Control Switch BRAND NAME : LIGHT IT! MODEL NAME : 30019-308 APPLICANT : Fulcrum Products Inc. DATE OF ISSUE : Jan. 15, 2020 STANDARD(S) TEST PROCEDURE(S) : FCC Part 15 Subpart C Section 15.231 REPORT VERSION : V1.0 Attestation of Global Compliance (Shenzhen) Co., Ltd CAUTION: This report shall not be reproduced except in full without the written permission of the test laboratory and shall not be quoted out of context. Report No.: AGC01184191208FE03 Page 2 of 28 Report Revise Record Report Version Revise Time Issued Date Valid Version Notes V1.0 / Jan. 15, 2020 Valid Initial release Report No.: AGC01184191208FE03 Page 3 of 28 TABLE OF CONTENTS 1. VERIFICATION OF CONFORMITY ............................................................................................................ 4 2. GENERAL INFORMATION ......................................................................................................................... 5 2.1. PRODUCT DESCRIPTION .................................................................................................................. 5 3. MEASUREMENT UNCERTAINTY .............................................................................................................. 6 4. DESCRIPTION OF TEST MODES .............................................................................................................. 7 5. SYSTEM TEST CONFIGURATION ............................................................................................................ 7 5.1. CONFIGURATION OF EUT SYSTEM .................................................................................................. 7 5.2. EQUIPMENT USED IN EUT SYSTEM .................................................................................................. 7 5.3. SUMMARY OF TEST RESULTS ........................................................................................................... 7 6. TEST FACILITY .......................................................................................................................................... 8 7. TEST EQUIPMENT LIST ............................................................................................................................ 8 8. PROVISION FOR MOMENTARY OPERATION .......................................................................................... 9 8.1 MEASUREMENT PROCEDURE ........................................................................................................... 9 8.2 TEST SETUP ......................................................................................................................................... 9 8.3 TEST RESULT ..................................................................................................................................... 10 9. DUTY CYCLE CORRECTION FACTOR .................................................................................................... 11 9.1 MEASUREMENT PROCEDURE .......................................................................................................... 11 9.2 TEST SETUP ........................................................................................................................................ 11 9.3 TEST RESULT ...................................................................................................................................... 11 10. RADIATED EMISSION ............................................................................................................................ 14 10.1. MEASUREMENT PROCEDURE ...................................................................................................... 14 10.2. TEST SETUP .................................................................................................................................... 16 10.3. TEST RESULT .................................................................................................................................. 17 11. BANDWIDTH .......................................................................................................................................... 19 11.1. MEASUREMENT PROCEDURE ...................................................................................................... 19 11.2. TEST SETUP .................................................................................................................................... 19 11.3. TEST RESULT .................................................................................................................................. 20 APPENDIX A: PHOTOGRAPHS OF TEST SETUP ..................................................................................... 21 APPENDIX B: PHOTOGRAPHS OF EUT .................................................................................................... 22 Report No.: AGC01184191208FE03 Page 4 of 28 1. VERIFICATION OF CONFORMITY Applicant Fulcrum Products Inc. Address Room 301, 3rd floor,NO.26 Laowei 1st Zone, Shuidoulaowei, Yousong Community, Longhua District, Shenzhen, China Manufacturer Fulcrum Products Inc. Address Room 301, 3rd floor,NO.26 Laowei 1st Zone, Shuidoulaowei, Yousong Community, Longhua District, Shenzhen, China Factory Fulcrum Products Inc. Address Room 301, 3rd floor,NO.26 Laowei 1st Zone, Shuidoulaowei, Yousong Community, Longhua District, Shenzhen, China Product Designation Wireless Remote Control Switch Brand Name LIGHT IT! Test Model 30019-308 Date of test Dec. 27, 2019 to Jan. 16, 2020 Deviation No any deviation from the test method Condition of Test Sample Normal Test Result Pass Report Template AGCRT-US-BR/RF We hereby certify that: The above equipment was tested by Attestation of Global Compliance (Shenzhen) Co., Ltd. The test data, the energy emitted by the sample tested as described in this report is in compliance with the re…

Text truncated - open the document above for the full version.

Test Setup Photos FCC RADIATED EMISSION TEST SETUP