2AW4JMJFL2020050601Floor Lamp

B ① ② ③ ④ ⑤ ⑦ ⑧ ⑨ ⑩ 1.Connect the light cap with the iron pope by spinning clockwise, 2.Then connect the iron pipe with the other iron pipes by spinning clockwise, 3.At last , connect iron pope with the lamp base by spinning clockwise. ⑥ Shade 4.Fix the upper and lower iron hoop on the shade in one 5.Then roll the two iron until the shade end to end 6.At last dign the end of shade and press it Bulb 7.Place the lamp cover atthe bulb interface 8.Install the bulb Modle name: MJFL2020050601 FCC ID: 2AW4JMJFL2020050601 Federal Communications Commission Notice This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

Dongguan Mingjian Lighting Technology Co., Ltd. Model Difference FCC ID: 2AW4JMJFL2020050601 Model : MJFL2020050601, MJFL2020050602, MJFL2020050603, MJFL2020050604 All models have same circuits diagram, PCB Layout, construction and rated power, only different is the model and the colour. Sincerely, Signature: Client’s name / title : Zhao Kunming /Manager Contact information / address : Room 201, Building No .18, Houjie Section, Houda Road, Houjie Town, Dongguan City, Guangdong Province, China.

CONFIDENTIALITY REQUEST for Certification Service in USA Federal Communication Commission Equipment Authorization Division, Application Processing Branch 7435 Oakland Mills Road Columbia, MD 21046 <2020-08-06> TO WHOM IT MAY CONCERN Pursuant to Paragraphs §0.457 and 0.459 of the Commission’s Rules (47 C.F.R.) and Section §552(b)(4) of the Freedom of Information Act, we requests confidentiality for the following products: FCC ID Model name 2AW4JMJFL2020050601 MJFL2020050601, MJFL2020050602, MJFL2020050603, MJFL2020050604 For the product stated above, we request that the following information be held confidential; Exhibits Long-Term Confidentiality Short-Term Confidentiality Short-Term Confidentiality Days External Photos Internal Photos Block Diagram Schematics Test Setup Photos User’s Manual Parts List Tune Up Operational Descriptions The long-term confidentiality exhibits contain our trade secrets and proprietary information that could be of benefit to our competitors. The short-term confidentiality on the basis of ensuring that business sensitive information remains confidential until the actual marketing of our new device. If you have any questions, please feel free to contact me at the address shown below. Sincerely, ------------------------------------ Name:Zhao Kunming / Manager Company: Dongguan Mingjian Lighting Technology Co., Ltd. Address: Room 201, Building No .18, Houjie Section, Houda Road, Houjie Town, Do ngguan City, Guangdong Province, China. Phone:18002657558 Fax:0769-82580151 E-Mail:[email protected]

Dongguan Mingjian Lighting Technology Co., Ltd. Room 201, Building No .18, Houjie Section, Houda Road, Houjie Town, Donggua n City, Guangdong Province, China. Tel: 18002657558 Fax: 0769-82580151 Federal Communications Commission Authorization and Evaluation Division Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 08/6/20 To whom it may concern: We, the undersigned, hereby authorize Eurofins Product Service GmbH to act on our behalf in all matters relating to applications for equipment authorization FCC ID: [2AW4JMJFL2020050601] including the signing of all documents related to these matters. Any and all acts carried out by Eurofins Product Service GmbH on our behalf shall have the same effect as acts of our own. We also hereby certify that no party to this application is subject to a denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. Sincerely, Name:Zhao Kunming / Manager Company: Dongguan Mingjian Lighting Technology Co., Ltd. Address: Room 201, Building No .18, Houjie Section, Houda Road, Houjie Town, Do ngguan City, Guangdong Province, China. Phone:18002657558 Fax:0769-82580151 E-Mail:[email protected]

FCC ID: 2AW4JMJFL2020050601 FCC ID: 2AW4JMJFL2020050601 FCC ID: 2AW4JMJFL2020050601

FCC ID: 2AW4JMJFL2020050601 FCC ID: 2AW4JMJFL2020050601 Ant FCC ID: 2AW4JMJFL2020050601

Page1of21ReportNo.:UNIA20072909FR-01 FCCRADIOTESTREPORT FCCID:2AW4JMJFL2020050601 Product ：FloorLamp TradeName ： N/A ModelName：MJFL2020050601 SerialModel： MJFL2020050602,MJFL2020050603, MJFL2020050604 ReportNo.：UNIA20072909FR-01 Preparedfor DongguanMingjianLightingTechnologyCo.,Ltd. Room201,BuildingNo.18,HoujieSection,HoudaRoad,HoujieTown,Dongguan City,GuangdongProvince,China. Preparedby ShenzhenUnitedTestingTechnologyCo.,Ltd. 2F,AnnexBldg,JiahuangyuanTechPark,#365Baotian1Rd,Tiegang Community,XixiangStr,Bao'anDistrict,Shenzhen,China Page2of21ReportNo.:UNIA20072909FR-01 TESTRESULTCERTIFICATION Applicant’sname....................: DongguanMingjianLightingTechnologyCo.,Ltd. Address ...................................... : Room201,BuildingNo.18,HoujieSection,HoudaRoad,HoujieT own,DongguanCity,GuangdongProvince,China. Manufacture'sName..............: DongguanMingjianLightingTechnologyCo.,Ltd. Address ...................................... : Room201,BuildingNo.18,HoujieSection,HoudaRoad,HoujieT own,DongguanCity,GuangdongProvince,China. Productdescription Productname............................... : FloorLamp TradeMark ................................. : N/A Modeland/ortypereference . : MJFL2020050601,MJFL2020050602,MJFL2020050603, MJFL2020050604 Standards .................................. : FCCRulesandRegulationsPart15SubpartCSection15.249 ANSIC63.10:2013 ThisdevicedescribedabovehasbeentestedbyShenzhenUnitedTestingTechnology Co.,Ltd.,andthetestresultsshowthattheequipmentundertest(EUT)isincompliance withtheFCCrequirements.Anditisapplicableonlytothetestedsampleidentifiedinthe report. Thisreportshallnotbereproducedexceptinfull,withoutthewrittenapprovalofUNI,this documentmaybealteredorrevisedbyShenzhenUnitedTestingTechnologyCo.,Ltd., personnelonly,andshallbenotedintherevisionofthedocument. DateofTest ............................................... : Date(s)ofperformanceoftests...............:Jul.10~22,2020 DateofIssue..............................................:Jul.23,2020 TestResult .................................................. :Pass Testby: Bobliao/Enginner Reviewer: Kahnyang/Supervisor Approved&AuthorizedSigner: Liuze/Manager Page3of21ReportNo.:UNIA20072909FR-01 TableofContentsPage 1.TESTSUMMARY...................................................................................................................4 1.1TESTPROCEDURESANDRESULTS....................................................................................4 1.2TESTFACILITY............................................................................................................................4 1.3MEASUREMENTUNCERTAINTY............................................................................................4 2.GENERALINFORMATION ................................................................................................... 5 2.1GENERALDESCRIPTIONOFEUT.........................................................................................5 2.3OperationofEUTduringtesting................................................................................................5 2.4DESCRIPTIONOFTESTSETUP.............................................................................................5 2.5MEASUREMENTINSTRUMENTSLIST..................................................................................6 3.CONDUCTEDEMISSIONSTEST.......................................................................................7 3.1ConductedPowerLineEmissionLimit ..................................................................................... 7 3.2TestSetup ..................................................................................................................................... 7 3.3TestProcedure ............................................................................................................................. 7 3.4TestResult .................................................................................................................................... 7 4.RADIATEDEMISSIONTEST.............................................................................................10 4.1RadiationLimit...........................................................................................................................10 4.2TestSetup...................................................................................................................................10 4.3TestProcedure...........................................................................................................................11 4.4TestResult...................................................................................................................................11 5.BANDEDGE ......................................................................................................................... 16 5.1Limits...........................................................................................................................................16 5.2TestProcedure...........................................................................................................................16 5.3TestResult..................................................................................................................................16 6.OCCUPIEDBANDWIDTHMEASUREMENT..................................................................18 6.1TestSetup ................................................................................................................................... 18 6.2TestProcedure ........................................................................................................................... 18 6.3MeasurementEquipmentUsed ............................................................................................... 18 6.4TestResult .................................................................................................................................. 18 7.ANTENNAREQUIREMENT......................................…

Text truncated - open the document above for the full version.

FCC ID: 2AW4JMJFL2020050601 Radiated Emission (Below 1G) Radiated Emission (Above 1G) FCC ID: 2AW4JMJFL2020050601 Conducted Emission