2AWKQ-WR1CWireless Remote

REMOTE OPERATION 5%25%50%75%100% 1 2 3 FCC STATEMENT : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving an tenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

FCC ID: 2AWKQ-WR1C

Label Location On EUT Label Product Name: Wireless Remote Model No.: WR-1C FCC ID: 2AWKQ-WR1C This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

FCC ID: 2AWKQ-WR1C ANT

version01 YUJET INTERNATIONAL CORPORATION LIMITED Declaration concerning Antenna Specification It is hereby declared that the product Model No.: WR-1C FCC ID : 2AWKQ-WR1C fulfills the requirement in FCC test relating to the antenna type. The device specified above confirms to the FCC recommendations for internal antenna type(s) described below: Model No. of antenna: WR-1C Type of antenna:Monopole Antenna Gain of the antenna: 2.5 dBi Frequency range:2412MHz~2462MHz The mounting of the antenna is fixed to the radio module and no other antenna should be used. Company name: YUJET INTERNATIONAL CORPORATION LIMITED Address: 3501 THE CENTRE, 99 QUEEN'S RD CENTRAL, HONG KONG, China City: HONG KONG ZIP / Postal code: N/A Country:China Place:ChinaDate: 2020-07-16 Signature:

Report No.: 18220WC00063802FCC ID: 2AWKQ-WR1CPage 1 of 62 FCC SAR Test Report Client Name: YUJET INTERNATIONAL CORPORATION LIMITED Address: 3501 THE CENTRE, 99 QUEEN’S RD CENTRAL. HONG KONG Product Name: Wireless Remote Date: Jul. 15, 2020 Shenzhen Anbotek Compliance Laboratory Limited Report No.: 18220WC00063802FCC ID: 2AWKQ-WR1CPage 2 of 62 Contents 1. Statement of Compliance ........................................................................................................... 6 2. General Information ..................................................................................................................... 7 2.1Client Information ................................................................................................................................................................... 7 2.2Description of Equipment Under Test (EUT) ..................................................................................................................... 7 2.3Device Category and SAR Limits ........................................................................................................................................ 8 2.4Applied Standard .................................................................................................................................................................... 8 2.5Environment of Test Site ....................................................................................................................................................... 8 2.6Test Configuration .................................................................................................................................................................. 8 3. Specific Absorption Rate (SAR) ................................................................................................ 9 3.1Introduction .............................................................................................................................................................................. 9 3.2SAR Definition ......................................................................................................................................................................... 9 4. SAR Measurement System ...................................................................................................... 10 4.1E-Field Probe ........................................................................................................................................................................ 11 4.2Data Acquisition Electronics (DAE) .................................................................................................................................. 11 4.3Robot ...................................................................................................................................................................................... 12 4.4Measurement Server ........................................................................................................................................................... 12 4.5Phantom ................................................................................................................................................................................. 13 4.6Device Holder ....................................................................................................................................................................... 15 4.7Data Storage and Evaluation ............................................................................................................................................. 16 5. Test Equipment List ................................................................................................................... 18 6. Tissue Simulating Liquids ......................................................................................................... 19 7. System Verification Procedures .............................................................................................. 21 8. EUT Testing Position ................................................................................................................ 23 8.1Body Worn Position ............................................................................................................................................................. 23 9. Measurement Procedures ........................................................................................................ 24 9.1Spatial Peak SAR Evaluation ............................................................................................................................................ 24 9.2Power Reference Measurement ....................................................................................................................................... 25 9.3Area Scan Procedures ........................................................................................................................................................ 25 9.4Zoom Scan Procedures ...................................................................................................................................................... 26 9.5Volume Scan Procedures ................................................................................................................................................... 27 9.6Power DriftMonitoring ........................................................................................................................................................ 27 10. Conducted Power ...................................................................................................................... 28 11. Antenna Location ......................................................................................................................... 29 12. SAR Test Results Summary ................................................................................................…

Text truncated - open the document above for the full version.

ReportNo.:18220WC00063801FCCID:2AWKQ-WR1CPage1of45 Code:AB-RF-05-a FCCTESTREPORT ClientName:YUJETINTERNATIONALCORPORATIONLIMITED Address: 3501THECENTRE,99QUEEN'SRDCENTRAL,HONG KONG,China ProductName:WirelessRemote Date:Jul.15,2020 ShenzhenAnbotekComplianceLaboratoryLimited ReportNo.:18220WC00063801FCCID:2AWKQ-WR1CPage2of45 Code:AB-RF-05-a Contents 1.GeneralInformation ............................................................................................................................................... 5 1.1.ClientInformation ....................................................................................................................................... 5 1.2.DescriptionofDevice(EUT) ..................................................................................................................... 5 1.3.AuxiliaryEquipmentUsedDuringTest ................................................................................................... 5 1.4.DescriptionofTestModes ........................................................................................................................ 6 1.5.Listofchannels ........................................................................................................................................... 7 1.6.DescriptionOfTestSetup ......................................................................................................................... 8 1.7.TestEquipmentList .................................................................................................................................... 9 1.8.MeasurementUncertainty ....................................................................................................................... 10 1.9.DescriptionofTestFacility ...................................................................................................................... 10 2.SummaryofTestResults ................................................................................................................................... 11 3.ConductedEmissionTest ................................................................................................................................... 12 3.1.TestStandardandLimit .......................................................................................................................... 12 3.2.TestSetup .................................................................................................................................................. 12 3.3.TestProcedure .......................................................................................................................................... 12 4.RadiationSpuriousEmissionandBandEdge ................................................................................................ 13 4.1.TestStandardandLimit .......................................................................................................................... 13 4.2.TestSetup .................................................................................................................................................. 13 4.3.TestProcedure .......................................................................................................................................... 14 4.4.TestData .................................................................................................................................................... 15 5.MaximumPeakOutputPowerTest .................................................................................................................. 22 5.1.TestStandardandLimit .......................................................................................................................... 22 5.2.TestSetup .................................................................................................................................................. 22 5.3.TestProcedure .......................................................................................................................................... 22 5.4.TestData .................................................................................................................................................... 22 6.6DBOccupyBandwidthTest ............................................................................................................................. 25 6.1.TestStandardandLimit .......................................................................................................................... 25 6.2.TestSetup .................................................................................................................................................. 25 6.3.TestProcedure .......................................................................................................................................... 25 6.4.TestData .................................................................................................................................................... 25 7.PowerSpectralDensityTest .............................................................................................................................. 29 7.1.TestStandardandLimit .......................................................................................................................... 29 7.2.TestSetup .................................................................................................................................................. 29 7.3.TestProcedure .......................................................................................................................................... 29 7.4.TestData .................................................................................................................................................... 29 8.100kHzBandwidthofFrequencyBandEdgeRequirement ......................................................................... 32 8.1.TestStandardandLimit ...............…

Text truncated - open the document above for the full version.

FCC ID: 2AWKQ-WR1C Photo of Radiation Emission Test