2AWOX-LDTR02Wireless Remote

OUTOUT ININ OUTOUT BUTTONBUTTON ININ BUTTONBUTTON STARTSTART BUTTONBUTTON FCCFCC IDID NUMBERNUMBER LOCATIOLOCATIO 3-6.3B FEMALE TERMINAL WITHCOVER Φ8 TERMINAL CHART2CHART2 CHART1CHART1 ANTENNAANTENNA OUTOUT WHITEWHITE ININ WHITEWHITE POWER+REDPOWER+REDPOWER-BLACKPOWER-BLACK 1.The function instruction of the front plate please see the picture 1 2.Press the power on button for 3 seconds to start the remote, the blue wireless light will be on . The remote will close if there is no operation within 2mins by itself.Press OUT button , the winch will send out the rope (nylon rope /steel wire rope ), press IN button , the wich will recycle the rope (nylon rope /steel wire rope ) 3.Voltage of the sender :DC2-3.0V voltage of the receiver :DC9-15V 4.Distance ≤15M Due to the interference from the actual environment are always change when in use, So the usage distance of the remote will change (distance is shorter). 5.To learn the matching function, keep pressing the power on button of the sender until the green light flicker, in the meantime press the learn button on the receiver until the red light on , flicker, and closed with voice "tick", then it means it's successful to matching the sender. 6.the receiver function please see the picture 2 FCC Statement: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. RF warning for Portable device: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. ISED RSS Warning: This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. ISED RF exposure statement: This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. The device has been evaluated to meet general RF exposure requirement. Le matériel est conforme aux limites de dose d'exposition aux rayonnements énoncés pour fac un autre environnement. ce dispositif a été évalué à satisfaire l'exigence générale de l'exposition aux rf.

QA-FR-170-B Company: Keystone Automotive Operations, Inc. Add: 44 Tunkhann ock Avenue Exeter, PA 18643 United States Tel: 570 602-6749 Fax: 855-24 2-8922 E-mail: [email protected] FCC Authorization Date: 2020-11-18 FEDERAL COMMUNICATIONS COMMISSION Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Agent Authorization To whom it may concern: We, Keystone Automotive Operations, Inc., the undersigned, Hereby authorizes Bay Area Compliance Laboratories Corporation to act on its behalf in all matters relating to application for Equipment authorization, including the signing of all documents relating to these matters. All acts carried out by Bay Area Compliance Laboratories Corp . o n our behalf shall have the same effect as our own action. We, the undersig ned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. This authorization is valid until further written notice from the applicant. Sincerely Yours, Signature: Typed o r Printed Name: Fabbro Justin Title: Manager

Company: Keystone Automotive Operations, Inc. Add: 44 Tunkhannock Avenue Exeter, PA 18643 United States Tel: 570 602-6749 Fax: 855-242-8922 E-mail: [email protected] FCC Confidential Authorization Date:2020-11-18 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Confidentiality Request regarding application for certification of FCC ID: 2AWOX-LDTR02 To: whom it may concern, In accordance with Sections 0.457 and 0.459 of the Commission’s Rules, Keystone Automotive Operations, Inc. hereby requests long-term confidential treatment of information accompanying this application as outlined below: Block Diagram Schematics Operation Description The above materials contain proprietary and confidential information not customarily released to the public. The public disclosure of these materials provides unjustified benefits to its competitors in the market. Sincerely Yours, Sig nature: Typed or Printed Name: Fabbro Justin Title: Manager

EXHIBIT A - EUT EXTERNAL PHOTOGRAPHS

EXHIBIT B - EUT INTERNAL PHOTOGRAPHS Antenna

FCC PART 15.231 TEST REPORT For Keystone Automotive Operations, Inc. 44 Tunkhannock Avenue Exeter, PA 18643 United States FCC ID: 2AWOX-LDTR02 Report Type: Original Report Product Type: Wireless Remote Project Engineer: Tyrone Wang Report Number: RXM201118051-00A Report Date: 2020-12-03 Reviewed By: Oscar Ye EMC Manager Prepared By: Bay Area Compliance Laboratories Corp. (Kunshan) No.248 Chenghu Road, Kunshan, Jiangsu province, China Tel: +86-0512-86175000 Fax: +86-0512-88934268 www.baclcorp.com.cn Bay Area Compliance Laboratories Corp. (Kunshan) Report No.: RXM201118051-00A FCC Part 15.231 Page 2 of 23 TABLE OF CONTENTS GENERAL INFORMATION ....................................................................................................................................... 3 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ..................................................................................... 3 OBJECTIVE ................................................................................................................................................................... 3 RELATED SUBMITTAL(S)/GRANT(S) ............................................................................................................................. 3 TEST METHODOLOGY .................................................................................................................................................. 3 MEASUREMENT UNCERTAINTY .................................................................................................................................... 4 TEST FACILITY ............................................................................................................................................................. 4 SYSTEM TEST CONFIGURATION .......................................................................................................................... 5 JUSTIFICATION ............................................................................................................................................................. 5 EUT EXERCISE SOFTWARE .......................................................................................................................................... 5 EQUIPMENT MODIFICATIONS ....................................................................................................................................... 5 SUPPORT EQUIPMENT LIST AND DETAILS .................................................................................................................... 5 EXTERNAL I/O CABLE .................................................................................................................................................. 5 BLOCK DIAGRAM OF TEST SETUP ................................................................................................................................ 6 SUMMARY OF TEST RESULTS ............................................................................................................................... 7 TEST EQUIPMENT LIST ........................................................................................................................................... 8 FCC§15.203 - ANTENNA REQUIREMENT .............................................................................................................. 9 APPLICABLE STANDARD .............................................................................................................................................. 9 ANTENNA CONNECTED CONSTRUCTION ...................................................................................................................... 9 FCC §15.205, §15.209, §15.231 (B) - RADIATED EMISSIONS ............................................................................. 10 APPLICABLE STANDARD ............................................................................................................................................ 10 EUT SETUP ................................................................................................................................................................ 11 EMI TEST RECEIVER SETUP ....................................................................................................................................... 12 TEST PROCEDURE ...................................................................................................................................................... 12 CORRECTED AMPLITUDE & MARGIN CALCULATION ................................................................................................. 12 TEST RESULTS SUMMARY .......................................................................................................................................... 12 TEST DATA ................................................................................................................................................................ 12 FCC §15.231(A) (1) - DEACTIVATION TESTING ................................................................................................. 17 APPLICABLE STANDARD ............................................................................................................................................ 17 TEST PROCEDURE ...................................................................................................................................................... 17 TEST DATA ................................................................................................................................................................ 17 FCC §15.231(C) - 20DB EMISSION BANDWIDTH TESTING ............................................................................. 20 APPLICABLE STANDARD ............................................................................................................................................ 20 TEST PROCEDURE .......................................................................................…

Text truncated - open the document above for the full version.

EXHIBIT C - TEST SETUP PHOTOGRAPHS RadiatedEmissions (Below 1GHz) RadiatedEmissions (Above 1GHz)