2AX7W-IAFSRCRemote Control

JET 427 New Sanford Road LaVergne, Tennessee 37086Part No. M-415100 Ph.: 800-274-6848 Edition 1 11/2020 www.jettools.comCopyright © 2020 JET Operating Instructions and Parts Manual Industrial Air Filtration System Models IAFS-1700, IAFS-2400, IAFS-3000 2 1.0IMPORTANT SAFETY INSTRUCTIONS Whenusinganelectricalappliance,basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS AIR FILTRATION UNIT. WARNING – To reduce the risk of fire, electric shock, or injury: 1. Read and understand the entire owner’s manualbeforeattemptingassemblyor operation. 2. Read and understand the warnings posted on the unit and in this manual. Failure to comply with all of these warnings may cause serious injury. 3. Replace warning labels if they become obscured or removed. 4. Make certain the unit is properly grounded. 5. Disconnect the air filtration unit from the power source (unplug) before servicing or changing filters. 6. Keep guards and covers in place at all times when the filtration unit is in use. If removed for maintenance purposes, use extreme caution and replace the guards immediately after service is complete. 7. Check damaged parts. Before further use of a machine, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced. 8. Make your workshop child proof with padlocks, master switches or by removing safety keys. 9. Use recommended accessories; improper accessories may be hazardous. 10. Do not place this unit on an unstable surface, or where there is a risk of tipping over. Serious injury could occur if the unit tips over. 11. Do not use this air filtration unit with a damaged cord or plug. If the unit is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center. 12. If ceiling mounted, bottom of filtration unit must be at least 7 feet from the floor. 13. If ceiling mounted, mounts must be anchored to building structure which will support the weight of the air filtration unit. Never mount to surfaces such as dry wall or false ceiling grids. 14. To reduce risk of electric shock, do not expose filtration unit to water or rain. 15. Never duct a machine directly into the air filtration unit. 16. To avoid a potentially dangerous situation, do not use this equipment to filter volatile fumes or smoke. 17. Do not use this unit in high humidity environments. Doing so may cause electric shock and/or decreased performance of the unit. 18. Do not use this equipment to filter flammable vapors. This air filtration unit is designed and intended for the filtration of air borne dust only. It is neither designed nor intended for any other purpose whatsoever. If used for other purposes, JET disclaims any real or implied warranty and holds itself harmless from any injury that may result from that use. WARNING:This product can expose you to chemicals including lead which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to http://www.p65warnings.ca. gov. WARNING:Some dust, fumes and gases created by power sanding, sawing, grinding, drilling, welding and other construction activities contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead based paint crystalline silica from bricks, cement and other masonry products arsenic and chromium from chemically treated lumber Your risk of exposure varies, depending on how often you do this type of work. To reduce your exposure to these chemicals, work in a well- ventilated area and work with approved safety equipment, such as dust masks that are specifically designed to filter out microscopic particles. For more information go to http://www.p65warnings. ca.gov/ and http://www.p65warnings.ca.gov/wood. 3 Familiarize yourself with the following safety notices used in this manual: This means that if precautions are not heeded, it may result in minor injury and/or possible machine damage. This means that if precautions are not heeded, it may result in serious, or possibly even fatal, injury. SAVE THESE INSTRUCTIONS 2.0About this manual This manual is provided by JET, covering the safe operation and maintenance procedures for the JET IAFS series Air Filtration System. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown. Your machine has been designed and constructed to provide consistent, long-term operation if used in accordance with the instructions as set forth in this document. If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our web site: www.jettools.com. Retain this manual for future reference. If the machine transfers ownership, the manual should accompany it. Read and understand the entire contents of this manual before attempting assembly or operation. Failure to comply may cause serious injury. Register your product online - http://www.jettools.com/us/en/service-and-support/warranty/registration/ 4 3.0Table of contents SectionPage 1.0 IMPORTANT SAFETY INSTRUCTIONS ....................................................................................................... 2 2.0 About this manual .......................................................................................................................................... 3 3.0 Table of contents............................................................................................................................................ 4 4.0 Specifications for IAFS-series Air Fi…

Text truncated - open the document above for the full version.

CERPASS TECHNOLOGY CORP. Report No.: 2011065 Cerpass Technology Corp. Issued Date : Jan. 04, 2021 Page No. : 1 of 10 Photographs of EUT CERPASS TECHNOLOGY CORP. Report No.: 2011065 Cerpass Technology Corp. Issued Date : Jan. 04, 2021 Page No. : 2 of 10 CERPASS TECHNOLOGY CORP. Report No.: 2011065 Cerpass Technology Corp. Issued Date : Jan. 04, 2021 Page No. : 3 of 10 CERPASS TECHNOLOGY CORP. Report No.: 2011065 Cerpass Technology Corp. Issued Date : Jan. 04, 2021 Page No. : 10 of 10

Label Format: Label Position: This device complies with Part15 of the FCC Rules, Operation is subject to following two conditions: (1) This device may not cause harmful interference and, (2) This device must accept any interference received, including Interference that may cause undesired operation Model: IAFS-RC FCC ID：2AX7W-IAFSRC 35 mm 27 mm 35 mm x 27 mm

CERPASS TECHNOLOGY CORP. Report No.: 2011065 Cerpass Technology Corp. Issued Date : Jan. 04, 2021 Page No. : 4 of 10 CERPASS TECHNOLOGY CORP. Report No.: 2011065 Cerpass Technology Corp. Issued Date : Jan. 04, 2021 Page No. : 5 of 10 CERPASS TECHNOLOGY CORP. Report No.: 2011065 Cerpass Technology Corp. Issued Date : Jan. 04, 2021 Page No. : 6 of 10 CERPASS TECHNOLOGY CORP. Report No.: 2011065 Cerpass Technology Corp. Issued Date : Jan. 04, 2021 Page No. : 7 of 10 Antenna position CERPASS TECHNOLOGY CORP. Report No.: 2011065 Cerpass Technology Corp. Issued Date : Jan. 04, 2021 Page No. : 8 of 10 RF Chip CERPASS TECHNOLOGY CORP. Report No.: 2011065 Cerpass Technology Corp. Issued Date : Jan. 04, 2021 Page No. : 9 of 10

CERPASS TECHNOLOGY CORP. Report No.: TEFL2011065 Cerpass Technology Corp. Issued date : Jan. 04, 2021 T-FD-505-0 Ver 1.4 Page No. : 1 of 32 FCC ID. : 2AX7W-IAFSRC FCC RADIO TEST REPORT Applicant : JPW Industries Address : 427 New Sanford Rd LaVergne, TN 37086 USA Equipment : Remote Control Model No. : IAFS-RC FCC ID. : 2AX7W-IAFSRC Trade Name : JET I HEREBY CERTIFY THAT : The sample was received on Nov. 19, 2020 and the testing was completed on Dec. 24, 2020 at Cerpass Technology Corp. The test result refers exclusively to the test presented test model / sample. Without written approval of Cerpass Technology Corp., the test report shall not be reproduced except in full. Approved by: Mark Liao / Supervisor Laboratory Accreditation: Cerpass Technology Corporation Test Laboratory CERPASS TECHNOLOGY CORP. Report No.: TEFL2011065 Cerpass Technology Corp. Issued date : Jan. 04, 2021 T-FD-505-0 Ver 1.4 Page No. : 2 of 32 FCC ID. : 2AX7W-IAFSRC Contents 1. Summary of Test Procedure and Test Results ................................................................................. 4 1.1 Applicable Standards ................................................................................................................. 4 2. Test Configuration of Equipment under Test ................................................................................... 5 2.1 Feature of Equipment under Test ............................................................................................... 5 2.2 Test Mode and Test Software ..................................................................................................... 5 2.3 Description of Test System ......................................................................................................... 5 2.4 General Information of Test ........................................................................................................ 6 2.5 Measurement Uncertainty .......................................................................................................... 6 3. Test Equipment and Ancillaries Used for Tests ............................................................................... 7 4. Antenna Requirements ....................................................................................................................... 8 4.1 Standard Applicable ................................................................................................................... 8 4.2 Antenna Construction and Directional Gain ............................................................................... 8 5. Test of AC Power Line Conducted Emission ................................................................................... 9 5.1 Test Limit .................................................................................................................................... 9 5.2 Test Procedures ......................................................................................................................... 9 5.3 Typical Test Setup .................................................................................................................... 10 5.4 Test Result and Data ................................................................................................................ 10 6. Test of Radiated Emission ............................................................................................................... 11 6.1 Test Limit .................................................................................................................................. 11 6.2 Test Procedures ....................................................................................................................... 12 6.3 Typical Test Setup .................................................................................................................... 14 6.4 Test Result and Data ................................................................................................................ 15 6.5 Test Photographs (30MHz~1GHz) ........................................................................................... 23 6.6 Test Photographs (Above 1GHz) ............................................................................................. 24 7. 20dB Bandwidth Measurement ........................................................................................................ 26 7.1 Test Procedure ......................................................................................................................... 26 7.2 Test Setup Layout .................................................................................................................... 26 7.3 Limits of Band Edges Measurement ........................................................................................ 26 7.4 Test Result and Data ................................................................................................................ 26 8. Transmission Time Control .............................................................................................................. 28 8.1 Test Procedure ......................................................................................................................... 28 8.2 Test Setup Layout .................................................................................................................... 28 8.3 Test Limit .................................................................................................................................. 28 8.4 Test Result and Data ................................................................................................................ 29 9. Radio Frequency Exposure ............................................................................................................. 31 9.1 Applicable Standards ............................................................................................................... 31 9.2 EUT Specification .…

Text truncated - open the document above for the full version.

CERPASS TECHNOLOGY CORP. Report No.: TEFL2011065 Cerpass Technology Corp. Issued date : Jan. 04, 2021 T-FD-505-0 Ver 1.4 Page No. : 23 of 32 FCC ID. : 2AX7W-IAFSRC 6.5 Test Photographs (30MHz~1GHz) Front View Rear View CERPASS TECHNOLOGY CORP. Report No.: TEFL2011065 Cerpass Technology Corp. Issued date : Jan. 04, 2021 T-FD-505-0 Ver 1.4 Page No. : 24 of 32 FCC ID. : 2AX7W-IAFSRC 6.6 Test Photographs (Above 1GHz) Front View Rear View CERPASS TECHNOLOGY CORP. Report No.: TEFL2011065 Cerpass Technology Corp. Issued date : Jan. 04, 2021 T-FD-505-0 Ver 1.4 Page No. : 25 of 32 FCC ID. : 2AX7W-IAFSRC Side View