2BCV6-DOORRTXPXRemote Control

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet generalRF exposure requirement. The device can be used in portable exposure condition without restriction

(Shenzhen YuHan International Business Co.,Ltd.) (September 15, 2023) Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(i) request for (FCC ID: 2BCV6-DOORRTXPX) [Shenzhen YuHan International Business Co.,Ltd.] (“the applicant”) certifies that the equipment for which authorization is sought is not “covered” equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely, (Applicant signature) (Applicant printed name) Yin Yurong (Shenzhen YuHan International Business Co.,Ltd.) (September 15, 2023) Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(ii) request for (FCC ID: 2BCV6-DOORRTXPX) [Shenzhen YuHan International Business Co.,Ltd.] (“the applicant”) certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing “covered” equipment. Sincerely, (Applicant signature) (Applicant printed name) Yin Yurong

Attestation Statements (September 15, 2023) TO: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046, USA RE: Attestation Statements Part 2.911(d)(7) request for (FCC ID: 2BCV6-DOORRTXPX) (Shenzhen YuHan International Business Co.,Ltd.), the undersigned, hereby authorize (Owlivia Designs Inc.) to act as our designated U.S. agent for service of process, (Shenzhen YuHan International Business Co.,Ltd.) accepts to maintain an agent for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-related proceeding involving the equipment. (Owlivia Designs Inc.) accepts the responsibility to act as designated U.S. agent for service of process, provides an agent for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-related proceeding involving the equipment. Applicant Information： Company name: Shenzhen YuHan International Business Co.,Ltd. Contact Name: Yin Yurong Address: Room 310, No. 44, Langkou Industrial Park, Langkou Community, Dalang Street, Longhu a District, Shenzhen, Guangdong, 518000 China Telephone No: 13538214502 Email: [email protected] U.S. Agent Information: Company Name: Owlivia Designs Inc. Address: 1403 Nevis Dr, Naperville. IL 60565 Contact Name: Zheng Yang Telephone No: 630-420-2213 Email: [email protected] FRN: 0034244186 Applicant Signature: Agent Signature: Applicant printed name: Yin Yurong Agent printed name: Zheng Yang

Shenzhen YuHan International Business Co.,Ltd. Model Difference Data：September 15, 2023 Product description: Remote Control Model name: DoorRTXPX, YH-K03-P9-280-RT, YH-K03-P9-500-RT, YH-K03- P9-DSK-RT, YH-G1501-P9-280-RT, YH-G1501-P9-500-RT, YH-G1501-P9- DSK-RT Trade Name: N/A FCC ID: 2BCV6-DOORRTXPX All the model are the same circuit and RF module, except model names . Regards Sincerely Client’s signature : Client’s name / title : Yin Yurong（Director） Contact information / address： Room 310, No. 44, Langkou Industrial Park, Langkou Community, Dalang Str eet, Longhua District, Shenzhen, Guangdong, 518000 China

Shenzhen YuHan International Business Co.,Ltd. (September 15, 2023) Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: CONFIDENTIALITY REQUEST FOR (Remote Control / DoorRTXPX, YH- K03-P9-280-RT, YH-K03-P9-500-RT, YH-K03-P9-DSK-RT, YH-G1501-P9-280- RT, YH-G1501-P9-500-RT, YH-G1501-P9-DSK-RT / FCC ID: 2BCV6- DOORRTXPX) To Whom It May Concern: This letter serves as an official request for confidentiality under sections 0.457 and 0.459 of CFR 47. We have requested that the Exhibits Long-Term Confidentiality Short-Term Confidentiality NOTE 2 ID Label/Location No No Attestation Statement No No External Photos No ☐ Block Diagram ☒ ☐ Schematics ☒ ☐ Test Report No No Test Setup Photos No ☐ User’s Manual ☐ NOTE 1 ☒ Internal Photos ☐ NOTE 1 ☒ Parts List / Tune Up ☐ ☐ RF Exposure Info No No Operational Description ☒ ☐ Cover Letter(s) No No SDR Software / Security Info ☐ No required to be submitted with this application be permanently withheld from public review. Above mentioned document contains detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market. Please contact me if there is any information you may need. Sincerely, Signature: Name: Yin Yurong Title: Director

Shenzhen YuHan International Business Co.,Ltd. (September 15, 2023) Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: LETTER OF AGENT AUTHORIZATION To Whom It May Concern: We, the undersigned, hereby authorize (Shenzhen CTB Testing Technology Co., Ltd.) to act on our behalf in all matters relating to application for equipment authorization, including the signing of all documents relating to these matters. We also hereby certify that no party to the application authorized hereunder is subject to the denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C.853(a). This agreement expires one year from the current date. Sincerely, Signature: Name: Yin Yurong Title: Director

External Photos

FCC ID LABEL: Label Location: FCC ID: 2BCV6-DOORRTXPX Model No.: DoorRTXPX

Internal Photos ANT

Shenzhen CTB Testing Co., Ltd. FCC ID: 2BCV6-DOORRTXPX Portable device According to §15.247(e)(i) and §1.1307(b)(1), systems operating under the provisions of this section shall be operated in a manner that ensures that the public is not exposed to radio frequency energy level in excess of the Commission’s guidelines. According to KDB447498 D01 General RF Exposure Guidance V06 The 1-g SAR and 10-g SAR test exclusion thresholds for 100 MHz to 6 GHz at test separation distances ≤ 50 mm are determined by: [(max. power of channel, including tune-up tolerance, mW)/(min. test separation distance, mm)]·[√f(GHZ)] ≤ 3.0 for 1-g SAR and ≤ 7.5 for 10-g extremity SAR, where: • f(GHZ) is the RF channel transmit frequency in GHz • Power and distance are rounded to the nearest mW and mm before calculation • The result is rounded to one decimal place for comparison When the minimum test separation distance is < 5 mm, a distance of 5 mm is applied to determine SAR test exclusion. 433.825MHz: Modulation Channel Freq. (GHz) Conduct ed power (dBm) Conducte d power (mW) Tune-up power (dBm) Max tune-up power (dBm) Max tune-up power (mW) Distance (mm) Result calculatio n SAR Exclusion threshold SAR test exclusion ASK 0.43383 -9.64 0.11 -9±1 -8.00 0.16 <5 0.02088 3.00 YES Note:dbm=dbuv/m-95.2+4.7=81.86-95.2+4.7=-8.64dBm(ERP), so the conduct peak power=-8.64- 1=-9.64dBm Conclusion: For the max result : 0.02088≤ FCC Limit 3.0 for 1g SAR.

ANT PHTOT All measurements were performed radiated and therefore additional antenna gain documentation is not required.

Shenzhen CTB Testing Technology Co., Ltd. Report No.: CTB230912062RFX Report Tel: 4008-707-283 Web: http://www.ctb-lab.net Page 1 of 26 TEST REPORT Compiled by: Reviewed by: Approved by: Zhou Kui Arron Liu Bin Mei / Director The test report is effective only with both signature and specialized stamp. This result(s) shown in this report r Note: If there is any objection to the inspection results in this report, please submit a written report to the company within 15 days from the date of receiving the report. The test report is effective only with both signature and specialized stamp. This result(s) shown in this report refer only to the sample(s) tested. Without written approval of Shenzhen CTB Testing Technology Co., Ltd. this report can’t be reproduced except in full. The tested sample(s) and the sample information are provided by the client. “*” indicates the testing items were fulfilled by subcontracted lab. “#” indicates the items are not in CNAS accreditation scope. Product Name: Remote Control FCC ID: 2BCV6-DOORRTXPX Trademark: N/A Model Number: DoorRTXPX, YH-K03-P9-280-RT, YH-K03-P9-500-RT, YH-K03-P9-DSK-RT, YH-G1501-P9-280-RT, YH-G1501-P9-500-RT, YH-G1501-P9-DSK-RT Prepared For: Shenzhen YuHan International Business Co.,Ltd. Address: Room 310, No. 44, Langkou Industrial Park, Langkou Community, Dalang Street, Longhua District, Shenzhen, Guangdong, 518000 China Manufacturer: Shenzhen YuHan International Business Co.,Ltd. Address: Room 310, No. 44, Langkou Industrial Park, Langkou Community, Dalang Street, Longhua District, Shenzhen, Guangdong, 518000 China Prepared By: Shenzhen CTB Testing Technology Co., Ltd. Address: 1&2/F., Building A, No.26, Xinhe Road, Xinqiao, Xinqiao Street, Bao'an District, Shenzhen, Guangdong, China Sample Received Date: Aug. 31, 2023 Sample tested Date: Aug. 31, 2023 to Sep. 12, 2023 Issue Date: Sep. 12, 2023 Report No.: CTB230912062RFX Test Standards FCC Part15.231 ANSI C63.10:2013 Test Results PASS Remark: This is 433MHz radio test report. Shenzhen CTB Testing Technology Co., Ltd. Report No.: CTB230912062RFX Report Tel: 4008-707-283 Web: http://www.ctb-lab.net Page 2 of 26 TABLE OF CONTENT Test Report Declaration Page 1. VERSION ........................................................................................................................................ 3 2. TEST SUMMARY ........................................................................................................................... 4 3. MEASUREMENT UNCERTAINTY ................................................................................................. 5 4. PRODUCT INFORMATION AND TEST SETUP ............................................................................ 6 4.1 Product Information .......................................................................................................................... 6 4.2 Test Setup Configuration .................................................................................................................. 6 4.3 Support Equipment........................................................................................................................... 6 4.4 Test Mode ........................................................................................................................................ 7 4.5 Test Environment ............................................................................................................................. 7 5. TEST FACILITY AND TEST INSTRUMENT USED ....................................................................... 8 5.1 Test Facility ...................................................................................................................................... 8 5.2 Test Instrument Used ....................................................................................................................... 8 6. AC POWER LINE CONDUCTED EMISSION ................................................................................ 10 6.1 Block Diagram Of Test Setup ......................................................................................................... 10 6.2 Limit ................................................................................................................................................ 10 6.3 Test procedure ............................................................................................................................... 10 6.4 Test Result ..................................................................................................................................... 11 7. RADIATED EMISSION ................................................................................................................. 12 7.1 Block Diagram Of Test Setup ......................................................................................................... 12 7.2 Limit ................................................................................................................................................ 12 7.3 Test procedure ............................................................................................................................... 13 7.4 Test Result ..................................................................................................................................... 14 8. DWELL TIME ................................................................................................................................ 20 8.1 Block Diagram Of Test Setup ......................................................................................................... 20 8.2 Limit ................................................................................................................................................ 20 8.3 Test procedure ............................................................................................................................... 20 8.4 Test Result ....................................…

Text truncated - open the document above for the full version.

Radiated Emission Below 1G Above 1G