2BDFR-RQBK7390M Garage Door remote

FCC compliance statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Covered Equipment Attestation Letter For Certification Service in the USA Federal Communication Commission Equipment Authorization Division, Application Processing Branch 7435 Oakland Mills Road Columbia, MD 21048 To whom it may concern Pursuant to Section 2.911(d)(5)(i)‐(ii) of the Commission’s Rules (47 C.F.R.) we attest as follows for the product listed below: FCC ID Model name 2BDFR‐RQBK7 RQBK7,RQBK7‐3,RQBK5,RQBK5‐A,RQBK5‐B, RQBK8, RQBK8‐A,RQBK8‐B We, applicant Company Name: Xiamen Runqun Intelligent Technology Co., Ltd Address: Room 702, No. 1819-2, Lvling Road, Siming District, Xiamen,Fujian,China Phone: 15259265190 certify that the equipment for which authorization is sought is not “covered” equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. We certify that, as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing “covered” equipment. If you have any questions, please feel free to contact us at the address shown below. Sincerely, 2023‐11‐11 Signature Date Printed Name of Signee: Lan Xianchun Company: Xiamen Runqun Intelligent Technology Co., Ltd Address: Room 702, No. 1819-2, Lvling Road, Siming District, Xiamen,Fujian,China Phone: 15259265190 Email: [email protected]

Xiamen Runqun Intelligent Technology Co., Ltd Room 702, No. 1819-2, Lvling Road, Siming District, Xiamen,Fujian,China Declaration Letter Date: Nov.11,2023 To : Federal Communications Commission Authorization and Evaluation Division 1435 Oakland Mills Road Columbia, MD 21046 To Whom It May Concern: For our business issue and marketing requirement, we would like to list different model number on the FCC certificates and reports, as following: FCC ID: 2BDFR-RQBK7 Model Number: RQBK7，RQBK7，RQBK7-3,RQBK5,RQBK5-A,RQBK5-B,RQBK8, RQBK8-A,RQBK8-B Model Difference: The difference between models is for different market sale, the other (hardware and software) was the same as before. Sincerely, Name / Title Lan Xianchun/Manager Company Name Xiamen Runqun Intelligent Technology Co., Ltd Company Address Room 702, No. 1819-2, Lvling Road, Siming District, Xiamen,Fujian,China Tel: 15259265190 Fax: Email: [email protected]

Confidentiality Request Letter For Certification Service in the USA Federal Communication Commission Equipment Authorization Division, Application Processing Branch 7435 Oakland Mills Road Columbia, MD 21048 To whom it may concern Pursuant to Paragraphs §0.457 and 0.459 of the Commission’s Rules (47 C.F.R.) and Section §552(b)(4) of the Freedom of Information Act, we request confidentiality for the documentation of the following products: FCC ID Model name 2BDFR‐RQBK7 RQBK7,RQBK7‐3,RQBK5,RQBK5‐A,RQBK5‐ B,RQBK8, RQBK8‐A,RQBK8‐B For the products listed above, we request permanent confidentiality for all applicable exhibits as there are:  the Operational Description  the Block Diagram  the Schematics The above listed exhibits contain trade secrets and proprietary information that could be of benefit to our competitors. If you have any questions, please feel free to contact us at the address shown below. Sincerely, Nov.11,2023 Signature Date Printed Name of Signee: Lan Xianchun Company: Xiamen Runqun Intelligent Technology Co., Ltd Address: Room 702, No. 1819-2, Lvling Road, Siming District, Xiamen,Fujian,China Phone: 15259265190 Fax: Email: [email protected]

External Photographs FCC ID: 2BDFR-RQBK7

Label Sample for FCC ID: 2BDFR-RQBK7 FCC ID: 2BDFR-RQBK7 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Size for the label: 8mm X 16mm Product Name : 390M Garage Door remote Model : RQBK7 FCC ID :2BDFR-RQBK7

Internal photographs FCC ID: 2BDFR-RQBK7 Antenna

Radio frequency radiation exposure evaluation: portable devices 1.1 Radio Frequency Exposure Compliance 1.1.1 Electromagnetic Fields RESULT: Pass Test Specification Test item : treadmill Identification / Type No. : RQBK7, RQBK7-3,RQBK5,RQBK5-A, RQBK5-B,RQBK8,RQBK8-A,RQBK8-B FCC ID : 2BDFR-RQBK7 Test standard : CFR47 FCC Part 2: Section 2.1093 FCC KDB Publication 447498 v06 Measurement Record: EIRP[dBm] = E[dBuV/m]− 95.2 = 89.15 – 95.2 =-6.05dBm Since maximum peak output power of the transmitter is -16.8 dBm ≈0.25mW < 22mW. Hence the EUT is excluded from SAR evaluation according to FCC KDB Publication 447498 D01 General RF Exposure Guidance v06.

Antenna Picture Applicant: Xiamen Runqun Intelligent Technology Co., Ltd Address of applicant: Room 702, No. 1819-2, Lvling Road, Siming District, Xiamen,Fujian,China Model: RQBK7 Antenna Type: PCB antenna Transmitter: The thick line of the entire circle shape along the edge of the PCB pointed by the arrow is the transmitting antenna, with a length of 114.045mm and a width of 1.2 mm.

BSL Technology Co., Ltd. Report No.: BSL231031901602RF Page 1 of 20 FCC Part 15C Measurement and Test Report For Xiamen Runqun Intelligent Technology Co., Ltd FCC ID: 2BDFR-RQBK7 FCC Rule(s): FCC Part 15.231(a) Product Description: 390M Garage Door remote Tested Model: RQBK7 Report No.: BSL231031901602RF Tested Date: Oct. 15~Nov.16, 2023 Issued Date: Nov. 16, 2023 Tested By: Lris. Yao / Engineer Reviewed By: Livi. Xiao / EMC Manager Approved & Authorized By: Salon.ouyang/ PSQ Manager Prepared By: BSL Testing Co.,LTD. 1/F, Building B, Xinshidai GR Park, Shiyan Street, Bao'an District, Shenzhen, ShiyanStreet, Bao'an District, Shenzhen,Guangdong,518052,People’s Republic of China Tel: 400-882-9628 Fax: 86- 755-26508703 BSL Technology Co., Ltd. Report No.: BSL231031901602RF Page 2 of 20 TABLE OF CONTENTS 1. GENERAL INFORMATION ................................................................................................................................... 3 1.1 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ............................................................................... 3 1.2 TEST STANDARDS ................................................................................................................................................... 4 1.3 TEST METHODOLOGY ............................................................................................................................................. 4 1.4 TEST FACILITY ....................................................................................................................................................... 4 1.5 EUT SETUP AND TEST MODE ................................................................................................................................. 4 1.5 EUT SETUP AND TEST MODE ................................................................................................................................. 5 1.6 MEASUREMENT UNCERTAINTY .............................................................................................................................. 5 1.7 TEST EQUIPMENT LIST AND DETAILS ..................................................................................................................... 6 2. SUMMARY OF TEST RESULTS ........................................................................................................................... 7 3. ANTENNA REQUIREMENT .................................................................................................................................. 8 3.1 STANDARD APPLICABLE ......................................................................................................................................... 8 3.2 TEST RESULT.......................................................................................................................................................... 8 4. CONDUCTED EMISSIONS .................................................................................................................................... 9 4.1 TEST PROCEDURE ................................................................................................................................................... 9 4.2 BASIC TEST SETUP BLOCK DIAGRAM ..................................................................................................................... 9 4.3 ENVIRONMENTAL CONDITIONS .............................................................................................................................. 9 4.4 TEST RECEIVER SETUP ........................................................................................................................................... 9 4.6 CONDUCTED EMISSIONS TEST DATA .................................................................................................................... 10 5. RADIATED EMISSIONS ....................................................................................................................................... 11 5.1 STANDARD APPLICABLE ....................................................................................................................................... 11 5.2 TEST PROCEDURE ................................................................................................................................................. 12 5.3 CORRECTED AMPLITUDE & MARGIN CALCULATION ............................................................................................ 14 5.4 ENVIRONMENTAL CONDITIONS ............................................................................................................................ 14 5.5 SUMMARY OF TEST RESULTS/PLOTS .................................................................................................................... 14 6. 20DB BANDWIDTH ............................................................................................................................................... 16 6.1 STANDARD APPLICABLE ....................................................................................................................................... 16 6.1 TEST PROCEDURE ................................................................................................................................................. 16 6.2 ENVIRONMENTAL CONDITIONS ............................................................................................................................ 16 6.3 SUMMARY OF TEST RESULTS/PLOTS .................................................................................................................... 16 7. TRANSMISSION TIME ......................................................................................................................................... 18 7.1 STANDARD APPLICABLE ....................................................................................................................................... 18 7.2 TEST PROCEDURE ........................................................…

Text truncated - open the document above for the full version.

Test Setup Photos FCC ID: 2BDFR-RQBK7