A3LHXC6Compact Component System

COMPACT COMPONENT SYSTEM HX-C6 —Consists of CA-HXC6 and SP-HXC6 INSTRUCTIONS For Customer Use: Enter below the Model No. and Serial No. which are located either on the rear, bottom or side of the cabinet. Retain this information for future reference. Model No. Serial No. LVT1350-001A [J] CA-HXC6SP-HXC6 SP-HXC6 00-00_Cover[J].fm Page1 Tuesday,January18, 2005 4:47PM G-1 Warnings, Cautions and Others Mises en garde, précautions et indications diverses CAUTION To reduce the risk of electrical shocks, fire, etc.: 1Do not remove screws, covers or cabinet. 2Do not expose this appliance to rain or moisture. ATTENTION Afin d’éviter tout risque d’électrocution, d’incendie, etc.: 1Ne pas enlever les vis ni les panneaux et ne pas ouvrir le coffret de l’appareil. 2Ne pas exposer l’appareil à la pluie ni à l’humidité. Caution—STANDBY/ON button! Disconnect the mains plug to shut the power off completely. The STANDBY/ON button in any position does not disconnect the mains line. The power can be remote controlled. Attention—STANDBY/ON Commutateur! Déconnecter la fiche de secteur pour couper complètement le courant. Le commutateur STANDBY/ON (attente/sous tension) ne coupe jamais complètement la ligne de secteur, quelle que soit sa position. Le courant peut être télécommandé. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. CAUTION For U.S.A. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. CAUTION Changes or modifications not approved by JVC could void the user’s authority to operate the equipment. For the main unit: Declaration of Conformity Model Number:HX-C6 Trade Name:JVC Responsible Party: JVC Americas Corp. Address:1700 Valley Road, Wayne New Jersey 07470 Telephone Number: 973-317-5000 This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 00-00_Safty[J].fm Page1 Friday, January28,2005 9:40AM G-2 IMPORTANT FOR LASER PRODUCTS 1CLASS 1 LASER PRODUCT 2 CAUTION : Do not open the top cover. There are no user serviceable parts inside the Unit; leave all servicing to qualified service personnel. 3 CAUTION : Visible and invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam. 4REPRRODUCTION OF LABEL: CAUTION LABEL, PLACED INSIDE UNIT. IMPORTANT POUR PRODUITS LASER 1PRODUIT LASER CLASSE 1 2 ATTENTION : N’ouvrez pas le couvercle supérieur. Il n’y a aucune pièce réparable par l’utilisateur à l’intérieur de l’appareil; confiez toute réparation à un personnel qualifié. 3 ATTENTION : Risque de radiations laser wisible et invisible quand l’appareil est ouvert ou que le systéme de verrouillage ne fonctionne pas ou a été mis hors service. Évitez toute exposition directe au rayon. 4REPRODUCTION DE L’ÉTIQUETTE: ÉTIQUETTE DE PRÉCAUTION PLACÉE À L’INTERIEUR DE L’APPAREIL . Note to CATV system installer: This reminder is provided to call the CATV system installer’s attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. For Canada/pour le Canada CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQUAU FOND. For Canada/pour le Canada THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS AS SET OUT IN THE INTERFERENCE-CAUSING EQUIPMENT STANDARD ENTITLED “DIGITAL APPARATUS,” ICES-003 OF THE DEPARTMENT OF COMMUNICATIONS. CET APPAREIL NUMERIQUE RESPECTE LES LIMITES DE BRUITS RADIOELECTRIQUES APPLICABLES AUX APPAREILS NUMIRIQUES DE CLASSE B PRESCRITES DANS LA NORME SUR LE MATERIEL BROUILLEUR: “APPAREILS NUMERIQUES”, NMB-003 EDICTEE PAR LE MINISTRE DES COMMUNICATIONS. CAUTION! To avoid personal injury or accidentally dropping the unit, have two persons unpack, carry, and install the unit. 30 kg / 67 lbs. ATTENTION! Pour éviter toute bles…

Text truncated - open the document above for the full version.

PDF created with pdfFactory Pro trial version www.pdffactory.com

Page : 14 of 14 Samsung EMC Testing and Certification Laboratory Project NO. :LBE050564 This report shall not be reproduced except in full, without the written approval of SEC EMC Testing laboratory. 4.2 EUT Photography Picture 5. EUT (front view) Picture 6. EUT (rear view)

FCC ID SAMPLE LABEL & LOCATION LABELLING REQUIREMENTS PER §§ 2.925 & §§ 15.19 The Label shown shall be permanently affixed at a conspicuous location on the device and be readily visible to the user at the time of purchase. (SEE NEXT PAGE)

PDF created with pdfFactory Pro trial version www.pdffactory.com PDF created with pdfFactory Pro trial version www.pdffactory.com PDF created with pdfFactory Pro trial version www.pdffactory.com

Page : 1 of 14 Samsung EMC Testing and Certification Laboratory Project NO. :LBE050564 This report shall not be reproduced except in full, without the written approval of SEC EMC Testing laboratory. EMC Test Report According to FCC Part 15 Subpart B Project No. LBE050564 Equipment under Test Address 516229, Chen Jiang town, Huizhou City, Guangdong Province, China Product Name Compact Component System Model Name CA-HXC6 Manufacturer SAMSUNG ELECTRONICS HUIZHOU CO., LTD Brand Name JVC Variant Model See Page 3 FCC ID A3LHXC6 Date of Test March 18 ~ 19, 2005 Issued Date March 21, 2005 Name/Position Signature Tested by Tae Young, Jang Test Engineer Reviewed by No Cheon, Park Manager of EMC Lab. Authorized by Seung Kyu, Cha Chief of EMC Lab. 1. This test reports does not constitute an endorsement by NIST/NVLAP or U.S Government. 2. This test report is to certify that the tested device properly complies with the requirements of FCC Rules and Regulations Part 15 Subpart B Unintentional Radiators. All tests necessary to show compliance to the requirements were and these results met the specifications requirement. This laboratory is registered by the NIST/NVLAP, U.S.A. The test reported herein have been performed in accordance with its terms of registration. Page : 2 of 14 Samsung EMC Testing and Certification Laboratory Project NO. :LBE050564 This report shall not be reproduced except in full, without the written approval of SEC EMC Testing laboratory. Table of Contents 1. General Information 1.1 Basic Information related Product 1.2 Detail Information related Product 1.3 Test Configuration 1.4 EUT Operating Conditions 1.5 Applied Standard 1.6 Test Facility 2. Summary of Test Results 3. Description of individual tests 3.1 Conducted Emission 3.2 Radiated Emission 4. Appendix A 4.1 Test Photography 4.2 EUT Photography Page : 3 of 14 Samsung EMC Testing and Certification Laboratory Project NO. :LBE050564 This report shall not be reproduced except in full, without the written approval of SEC EMC Testing laboratory. 1. General Information 1.1 Basic Information related Product Applicant SAMSUNG ELECTRONICS HUIZHOU CO., LTD Model name CA-HXC6 Applicant Address 516229, Chen Jiang town, Huizhou City, Guangdong Province, China Contact Person Oh Won, Seo Kind of product Compact Component System Valiant list None Manufacturer SAMSUNG ELECTRONICS HUIZHOU CO., LTD 1.2 Detail Information related Product Specification Item(s) Description Power Supply AC 110 ~ 120V, 60Hz Power consumption 90W/110VA USB USB Version 1.1 Dimension 175 mm x 373 mm x 389 mm 1.3 Operating Mode and Condition The system was configured for testing in typical fashion use. Cables were attached to each of the available I/O Ports. Where applicable, peripherals were attached to the I/O cables. The mode of operation utilized for testing was selected to best simulate typical EUT use. - USB Streaming 1.4 Equipment Modifications No equipment modifications were required. Page : 4 of 14 Samsung EMC Testing and Certification Laboratory Project NO. :LBE050564 This report shall not be reproduced except in full, without the written approval of SEC EMC Testing laboratory. 1.5 Test Configuration Used EUT and Peripherals Seq Device Model Name Serial # Maker FCC ID A Audio Systems HX-C6 - JVC A3LAT50L6 B Note PC X15 BA68-02276A20 SAMSUNG DoC C Speaker PSFS6102 - SAMSUNG - D Head Phone - - SAMSUNG - E Loop Antenna - - JVC - F Remote Controller - - JVC - Port Description Connect Cable Length [m] Shielded [Y/N] Remark 1 Power 1.5 No to the Mains 2 Ant 1 in 1.5 Yes To the SG 3 USB 1.5 Yes To the PC 4 AUX 1.5 Yes Not termination 5 Speaker 1.5 No To the Speaker 6 Headphone 1.5 No To The Headphone Page : 5 of 14 Samsung EMC Testing and Certification Laboratory Project NO. :LBE050564 This report shall not be reproduced except in full, without the written approval of SEC EMC Testing laboratory. Block Diagram 1.6 Applied Standards List Applied Standards Test Procedure FCC Part15 Subpart B ANSI C63.4 : 2003 Page : 6 of 14 Samsung EMC Testing and Certification Laboratory Project NO. :LBE050564 This report shall not be reproduced except in full, without the written approval of SEC EMC Testing laboratory. 1.7 Test Facility General Information The sites are constructed in conformance with the requirements of ANSI C63.4 and CISPR 16-1, 16-2. This EMC Testing Lab. is accredited by Korea Laboratory Accreditation Scheme(KOLAS) which signed the International Laboratory Accreditation Cooperation (ILAC) Mutual Recognition Arrangement (MRA) for the above test item(s) and test method(s). This Lab. is operated as testing laboratory in accordance with the requirements of ISO/IEC 17025:1998. Accreditation and Listing Uncertainty Test Item Expanded Uncertainty Radiated Emission 5.09 Conducted Emission 1.64 (According to NAMAS Pub.NIS81) Page : 7 of 14 Samsung EMC Testing and Certification Laboratory Project NO. :LBE050564 This report shall not be reproduced except in full, without the written approval of SEC EMC Testing laboratory. 2. Summary of Test Results Result : PASS The equipment under test(EUT) has been found to comply with the applied standards. Test Name Applied Standard Result Electromagnetic Emission Test 3.1 Conducted Emission FCC Part15 Subpart B Complied 3.2 Radiated Emission FCC Part15 Subpart B Complied Page : 8 of 14 Samsung EMC Testing and Certification Laboratory Project NO. :LBE050564 This report shall not be reproduced except in full, without the written approval of SEC EMC Testing laboratory. 3. Description of Individual Tests 3.1 Conducted Emission Test Information Test Engineer Tae Young, Jang Test Date March 19, 2005 Climate Condition Ambient Temperature : 20.5 Relative Humidity : 38% Test Place Shield Room #5 Test Equipments Calibration Equipment Modal Name Manufacturer Serial No. Next Date Interval L.I.S.N ESH3-Z5 R&S 100261 2005-07-23 12 Test Software EP5CE TOYO None N/A N/A Spectrum Analyzer E7405A Agilent US4110272 2005-08-26 12 Field strength meter ESS-3…

Text truncated - open the document above for the full version.

Page : 12 of 14 Samsung EMC Testing and Certification Laboratory Project NO. :LBE050564 This report shall not be reproduced except in full, without the written approval of SEC EMC Testing laboratory. 4. Appendix A 4.1 Test Photography Picture 1. Conducted Emission(Front View) Picture 1. Conducted Emission(Side View) Page : 13 of 14 Samsung EMC Testing and Certification Laboratory Project NO. :LBE050564 This report shall not be reproduced except in full, without the written approval of SEC EMC Testing laboratory. Picture 3. Radiated Emission (Front View) Picture 4. Radiated Emission (Rear View)