AZP-FRD1201U-R312 Channel Radio Control Receiver

Request for Confidentiality Date PHOENIX TEST-LAB GmbH Königswinkel 10 D32825 Blomberg Germany RE: Certification Application FCC ID:AZPFRD1201U-R3 Please be advised that the following information is to be held confidential on behalf of think dig High Tech Solutions GmbH: • Schematics • Block Diagram • Technical Description The application contains technical information which Futaba Corporation of America deems to be trade secrets and proprietary. If made public, the information might be used to the disadvantage of the applicant in the market place. Thank you for your attention to this matter. Signatory Johann Roidt

FCC ID: AZP-FRD1201U-R3

EMV-PrüfzentrumEMI/EMC-Testcenter Page 1 of 31 Pages Straubing, April 11, 2001 T E S T - R E P O R T No. 55503-10219 for FRD-1201U-R2 Remote Control Receiver module Applicant:Futaba Corporation Purpose of testing:To show compliance with FCC Code of Federal Regulations, Part 15 Subpart B Class B Industry Canada Radio Standards Specification RSS-210 Issue 2, Section 6.1 (Category I Equipment) Note: The test data of this report relate only to the individual item which has been tested. This report shall not be reproduced except in full extent without the written approval of the testing laboratory. EMV-Prüfzentrum EMI/EMC-Testcenter FCC-ID: AZP-FRD1201U-R3 Test Report No. 55503-10219 Page 2 of 31 Pages Table of Contents 1. Administrative Data ....................................................................................3 2. Identification of Test Laboratory .................................................................4 3. Summary of Test Results ...........................................................................5 4. Operation Mode of EUT..............................................................................6 5. Configuration of EUT and Peripheral Devices............................................7 6. Measuring Methods ....................................................................................8 6.1. Radiated Emission 30 MHz - 1 GHz (FCC §15.109 / RSS-210 Section 7.3) ..........................................................................9 6.2. Radiated Emission 1 GHz - 2.5 GHz (FCC §15.109 / RSS-210 Sections 7.3).......................................................................11 7. Equipment List..........................................................................................13 8. Photographs Taken During Testing..........................................................15 9. List of Measurements ...............................................................................18 9.1. List of Measurements According To FCC Part 15 Subpart B ...........................................................................................19 9.2. List of Measurements According To Industry Canada RSS-210.............................................................................................20 10. Referenced Regulations ...........................................................................21 11. Test Results..............................................................................................22 EMV-Prüfzentrum EMI/EMC-Testcenter FCC-ID: AZP-FRD1201U-R3 Test Report No. 55503-10219 Page 3 of 31 Pages 1.Administrative Data Equipment Under Test (EUT):FRD-1201U-R2 Serial number(s):--- Type of equipment:Remote Control Receiver module Parts/accessories:--- FCC-ID: AZP-FRD1201U-R3 Applicant:Futaba Corporation (full address)R/C Engineering Unit 1 1080, Yabuzuka Chosei-son Chosei-gun Chiba-ken, 299-4395 Japan Contract identification:--- Contact person:Mr. Toshikazu Hama Manufacturer:Futaba Corporation Receipt of EUT:December 11, 2000 Date of test:April 9 to 10, 2001 Note:--- Responsible for testing:Rupert Kohlhäufl Responsible for test report:Rupert Kohlhäufl (cb) EMV-Prüfzentrum EMI/EMC-Testcenter FCC-ID: AZP-FRD1201U-R3 Test Report No. 55503-10219 Page 4 of 31 Pages 2.Identification of Test Laboratory Test Laboratory:Senton GmbH EMI/EMC Test Center (full address):Aeussere Fruehlingstrasse 45 D-94315 Straubing Germany Contact person:Mr. Johann Roidt Communication:Telephone(+49) 0 94 21 / 55 22-0 Fax (+49) 0 94 21 / 55 22-99 eMail:[email protected] FCC registration no.:90926 Industry Canada file number:IC 3050 EMV-Prüfzentrum EMI/EMC-Testcenter FCC-ID: AZP-FRD1201U-R3 Test Report No. 55503-10219 Page 5 of 31 Pages 3.Summary of Test Results The tested sample complies with the requirements set forth in the FCC Part 15 Subpart B Class B of the Federal Communication Commission (FCC). and the Radio Standards Specification RSS-210 Issue 2, Section 6.1 for Low Power Licence-Exempt Radiocommuniction Devices of Industry Canada. Johann RoidtRupert Kohlhäufl Technical ManagerTest Engineer EMV-Prüfzentrum EMI/EMC-Testcenter FCC-ID: AZP-FRD1201U-R3 Test Report No. 55503-10219 Page 6 of 31 Pages 4.Operation Mode of EUT - FCC test setup EMV-Prüfzentrum EMI/EMC-Testcenter FCC-ID: AZP-FRD1201U-R3 Test Report No. 55503-10219 Page 7 of 31 Pages 5.Configuration of EUT and Peripheral Devices Configuration of EUT • EUT is configured as stand-alone device in horizontal position • receiver module separated from host equipment Configuration of cables of EUT • data lines connected to host equipment • external power supply: 7 V DC Configuration of peripheral devices connected to EUT --- EMV-Prüfzentrum EMI/EMC-Testcenter FCC-ID: AZP-FRD1201U-R3 Test Report No. 55503-10219 Page 8 of 31 Pages 6.Measuring Methods EMV-Prüfzentrum EMI/EMC-Testcenter FCC-ID: AZP-FRD1201U-R3 Test Report No. 55503-10219 Page 9 of 31 Pages 6.1.Radiated Emission 30 MHz - 1 GHz (FCC §15.109 / RSS-210 Section 7.3) Radiated emissions are measured over the frequency range from 30 MHz to 1 GHz. The bandwidth of the EMI-receiver is set to 120 kHz and the detector- function is set to CISPR quasi-peak. The test setup is made in accordance with ANSI C63.4-1992. Measurements are made in both the horizontal and vertical planes of polarization. Preliminary scans are taken in a semi-anechoic room using a spectrum analyzer with the detector function set to peak. Hand-held or body-worn devices are rotated through three orthogonal axes to determine which attitude and configuration produces the highest emission relative to the limit and therefore shall be used for final testing. All tests are performed at a test-distance of 3 meters. For final testing an open-area test-site is used. During the tests the EUT is rotated all around and the receiving-antenna is raised and lowered from 1 meter to 4 meters to find the maximum levels of emissions. The cables and equipment is placed and moved within the range of position likely…

Text truncated - open the document above for the full version.

EMV-Prüfzentrum EMI/EMC-Testcenter Test Report No. 55503-10219 Page 16 of 31 Pages Photos No. 8.1 - 8.2 Test setup for radiated emission pre-test 30 MHz - 1 GHz and final test 1 GHz - 2.5 GHz (semi anechoic room) EMV-Prüfzentrum EMI/EMC-Testcenter Test Report No. 55503-10219 Page 17 of 31 Pages Photo No. 8.3 - 8.4 Test setup for radiated emission final test 30 MHz - 1 GHz (open area test site)