AZPT7C-75Radio Control Transmitter

7CAP / 7CHP 7CHANNEL RADIO CONTROL SYSTEM INSTRUCTION MANUAL Technical updates and additional programming examples available at:www.futaba-rc.com\faq\7c-faq.html Entire Contents © Copyright 2003 1M23N13602 INTRODUCTION.............................3 Additional Technical Help, Support and Service.....3 Application, Export and Modification.............4 Meaning of Special Markings...................5 Safety Precautions (do not operate without reading) . .5 Introduction to the 7C . ........................7 Contents and Technical Specifications............9 Accessories ...............................10 Transmitter Controls & Switch Identification/Assignments..............11 Charging the Ni-Cd Batteries..................14 Stick Adjustments...........................15 Radio Installation...........................16 Range Checking & Aircraft Frequencies..........17 Transmitter Displays and Buttons ...............18 Warning and Error Displays...................19 AIRPLANE FUNCTIONS Map of Functions . . .........................21 Quick Guide to Setting up a 4-channel Airplane....22 ACRO BASICMENU FUNCTIONS................25 MODELSubmenu:MODELSEL.,COPYandNAME..25 Parameter(PARA.)Submenu: RESET,TYPE,MODUL, CH5 & CH7 ..............................28 ServoREVERSE.............................31 End Point (E. POINT).......................32 Idle Management:THR-CUT Dual Rates and Exponential (D/R,EXP).........34 TIMER...................................37 TRAINER..................................38 TRIM...................................39 SUB-TRIM.................................40 Fail Safe (F/S).............................41 ACRO ADVANCEMENU FUNCTIONS . . ........42 Wing types ................................42 (FLAPRN)Flaperon...................43 (FL-TRIM)Flap Trim...................44 ELEVON(see tail types)...................45 Tail types.................................45 ELEVON................................45 V-TAIL..................................46 SNAPROLL................................47 Mixes: definitions and types...................48 ELE-FLP................................49 Air Brake(A.BRAKE)......................52 FLP-ELE................................50 AIL-RUD................................51 Prog. Mixes(P-MIX1-3).................53 Other Equipment . . ...........................56 HELICOPTER FUNCTIONS...................57 Table of contents and reference info for helicopters . .57 Getting Started with a Basic Helicopter . . . . . . . . . .58 HELI-SPECIFICBASICMENU FUNCTIONS . . . . .61 MODEL TYPE(PARA.submenu) . . . . . . . . . .61 SWASHAFR (swashplate surface direction and travel correction) (not inH1)..............63 Setting up the Normal Flight Condition . . . . . . .65 TH-CUT(specialized settings for helicopter specific models)................................66 HELI-SPECIFICADVANCEMENU FUNCTIONS. . .67 Throttle Hold(TH-HOLD)...................67 TH-CRV, PI -CRVand Revolution Mix(REVO).....68 Idle-ups . . . . ............................69 Trims/offset . . . . . . . . . . . . . . . . . . . . . . . . . . . . .70 Hovering setups . . . . . . . . . . . . . . . . . . . . . . . . . .71 Gyros . . ...............................72 Glossary . . ..................................74 Note that in the text of this manual, beginning at this point, any time we are using a featureís specialized name or abbreviation, as seen on the screen of the 7C, that name, feature, or abbreviation will be exactly as seen on the radio's screen, including capitalization, and shown in aDIFFERENT TYPE STYLEfor clarity. Any time we mention a specific control on the radio itself, such as movingS WITCHA,KNOB VR,ortheTHROTTLESTICK,those words will be displayed as they are here. 2 TABLE OF CONTENTS ...................33 ......................20 INTRODUCTION Thank you for purchasing a Futaba ® 7C series digital proportional R/C system. This system is extremely versatile and may be used by beginners and pros alike. In order for you to make the best use of your system and to fly safely, please read this manual carefully. If you have any difficulties while using your system, please consult the manual, our online Frequently Asked Questions (on the web pages referenced below), your hobby dealer, or the Futaba Service Center. Owner's Manual and Additional Technical Help This manual has been carefully written to be as helpful to you, the new owner, as possible. There are many pages of setup procedures and examples. However, it need not be your sole resource of setup guidelines for your 7C. For example, pages 22-24 include setup instructions for a basic 4-channel airplane. The Frequently Asked Questions web page referenced below includes this type of step-by-step setup instructions for a variety of other model types, including multi-engine, complex gear installation, 7-servo aerobatic models, 140 degree CCPM, etc. Due to unforeseen changes in production procedures, the information contained in this manual is subject to change without notice. Support and Service:It is recommended to have your Futaba equipment serviced annually during your hobby's "off season" to ensure safe operation. IN NORTH AMERICA Please feel free to contact the Futaba Service Center for assistance in operation, use and programming. Please be sure to regularly visit the 7C Frequently Asked Questions web site at www.futaba-rc.com\faq\faq-7c.html. This page includes extensive programming, use, set up and safety information on the 7C radio system and is updated regularly. Any technical updates and US manual corrections will be available on this web page. If you do not find the answers to your questions there, please see the end of our F.A.Q. area for information on contacting us via email for the most rapid and convenient response. Donít have Internet access?Internet access is available at no charge at most public libraries, schools, and other public resources. We find internet support to be a fabulous reference for many modelers as items can be printe…

Text truncated - open the document above for the full version.

Request for Confidentiality 21 April 2004 EMCCert DR. RAŠEK - Certification Institute- Boelwiese 5 D-91320 Ebermannstadt RE: Certification Application FCC ID: AZPT7C-75 Please be advised that the following information is to be held confidential on behalf of Futaba Corporation: • Schematics • Parts List • Block Diagram • Technical Description The application contains technical information which Futaba Corporation deems to be trade secrets and proprietary. If made public, the information might be used to the disadvantage of the applicant in the market place. Thank you for your attention to this matter.

FCC ID: AZPT7C-75 External Photos Page 1 of 2 FCC ID: AZPT7C-75 External Photos Page 2 of 2 FCC ID AZPT7C-75 FUTABA MADE IN TAIWAN

FCC ID AZPT7C-75 FUTABA MADE IN TAIWAN

FCC ID: AZPT7C-75 Internal Photos Page 1 of 6 FCC ID: AZPT7C-75 Internal Photos Page 2 of 6 FCC ID: AZPT7C-75 Internal Photos Page 3 of 6 FCC ID: AZPT7C-75 Internal Photos Page 4 of 6 FCC ID: AZPT7C-75 Internal Photos Page 5 of 6 FCC ID: AZPT7C-75 Internal Photos Page 6 of 6

EMV-PrüfzentrumEMI/EMC-Testcenter Page 1 of 60 Pages Straubing, 29 March 2004 T E S T - R E P O R T No. 55503-40121 for T7CAP 75 MHz R/C Transmitter Applicant: Futaba Corporation Purpose of testing: To show compliance with - FCC Code of Federal Regulations, CFR 47, Part 95 - FCC Code of Federal Regulations, CFR 47, Part 2, Subpart J Note: The test data of this report relate only to the individual item which has been tested. This report shall not be reproduced except in full extent without the written approval of the testing laboratory. EMV-PrüfzentrumEMI/EMC-Testcenter FCC-ID: Test Report No. 55503-40121 Page 2 of 60 Pages Table of Contents 1. Administrative Data..............................................................................................3 2. Identification of Test Laboratory...........................................................................4 3. Summary of Test Results.....................................................................................5 4. Operation Mode of EUT.......................................................................................6 5. Configuration of EUT and Peripheral Devices......................................................7 6. Measuring Methods.............................................................................................8 6.1. Maximum Transmitter Power (§95.639)........................................................8 6.2. Frequency tolerance (§95.623)...................................................................10 6.3. Emission Bandwidth (§95.633)....................................................................12 6.4. Unwanted Emission 30 MHz - 1 GHz (§95.635, §95.639)...........................13 7. Photographs of Test Setups..............................................................................15 8. Equipment List...................................................................................................18 9. Referenced Regulations....................................................................................20 10. List of Measurements.........................................................................................21 11. Test Results.......................................................................................................22 12. Additional Results..............................................................................................34 13. Additional Information supplementary to the Test Report...................................59 13.1. Calculation of the necessary bandwidth (Section 2.202b)...........................59 13.2. Additional Information.................................................................................60 EMV-PrüfzentrumEMI/EMC-Testcenter FCC-ID: Test Report No. 55503-40121 Page 3 of 60 Pages 1. Administrative Data Equipment Under Test (EUT): T7CAP 75 MHz Serial number(s): 001 Type of equipment: R/C Transmitter Type of emission: 7K0F1D (PCM) Parts/accessories: --- FCC-ID: Applicant: Futaba Corporation (full address) R/C Engineering Unit 1 1080, Yabutsuka Chosei-son, Chosei-gun, Chiba-ken, 299-4395 Japan Contract identification: --- Contact person: Mr. Fujita Manufacturer: Futaba Corporation Receipt of EUT: February 24, 2004 Dates of test: Februar 26 to March 8, 2004 Note: --- Responsible for testing: Thomas Eberl Responsible for test report: Thomas Eberl EMV-PrüfzentrumEMI/EMC-Testcenter FCC-ID: Test Report No. 55503-40121 Page 4 of 60 Pages 2. Identification of Test Laboratory Test Laboratory: Senton GmbH EMI/EMC Test Center (full address): Aeussere Fruehlingstrasse 45 D-94315 Straubing Germany Contact person: Mr. Johann Roidt Communication: Telephone (+49) 0 94 21 / 55 22-0 Fax (+49) 0 94 21 / 55 22-99 eMail: [email protected] FCC registration number: 90926 Industry Canada file number: IC 3050 EMV-PrüfzentrumEMI/EMC-Testcenter FCC-ID: Test Report No. 55503-40121 Page 5 of 60 Pages 3. Summary of Test Results The tested sample complies with the requirements for R/C Transmitters set forth in the The Code of Federal Regulations 47, Part 95, Subpart C & E and The Code of Federal Regulations 47 Part 2, Subpart J. of the Federal Communication Commission (FCC). Johann Roidt Thomas Eberl Laboratory Manager Test Engineer EMV-PrüfzentrumEMI/EMC-Testcenter FCC-ID: Test Report No. 55503-40121 Page 6 of 60 Pages 4. Operation Mode of EUT • transmitting continuously 1 • with battery supply nominal 9.6 V DC) 2 • antenna extended to maximum 3 • operating with f = 75.730 MHz For conducted measurements a dummy load was used as delivered by applicant. A short description of the circuit and the method to stop modulation can be found in the following figure. 1 Modulation as indicated on appropriate test record 2 For conducted measurements replaced by external DC supply 3 For radiated emissions only EMV-PrüfzentrumEMI/EMC-Testcenter FCC-ID: Test Report No. 55503-40121 Page 7 of 60 Pages 5. Configuration of EUT and Peripheral Devices EUT is configured as stand-alone device Configuration of cables of EUT Not applicable Configuration of peripheral devices connected to EUT Not applicable EMV-PrüfzentrumEMI/EMC-Testcenter FCC-ID: Test Report No. 55503-40121 Page 8 of 60 Pages 6. Measuring Methods 6.1. Maximum Transmitter Power (§95.639) The maximum transmitter power was measured conducted and radiated. 6.1.1. Conducted Maximum Transmitter Power A spectrum analyzer / EMI test receiver was connected to the output of the transmitter power amplifier (conducted measurement) via dummy load while EUT was operating in transmit mode using the assigned frequency. The trace mode of the spectrum analyzer was set to max hold with: RBW = 100 kHz, VBW = 100 kHz, span = 1 MHz, sweep = 20 ms (auto mode) See figure 1 for the measurement setup. Test equipment used (see equipment list for details): 02, 18, 51, 69, 70, 71 5 8 3 1 6 4 7 2 Figure 1: Measurement setup for testing on antenna connector 1 Transmitter (EUT) 5 Test cable 2 Dummy load 6 DC-block 3 Wooden table 7 Attenu…

Text truncated - open the document above for the full version.

EMV-PrüfzentrumEMI/EMC-Testcenter FCC-ID: Test Report No. 55503-40121 Page 16 of 60 Pages Test setup unwanted radiation 30 MHz - 1 GHz g EMV-PrüfzentrumEMI/EMC-Testcenter FCC-ID: Test Report No. 55503-40121 Page 17 of 60 Pages Test setup unwanted radiation 30 MHz - 1 GHz (continued)