EMOIBT73NGlowTunes Bluetooth Rechargeable Mini Speaker

FCC Information FCC Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. • Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. • NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. CAN ICES-3 (B)/NMB-3(B) Canada Statement This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage; (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance. Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 2.5 de RSS 102 et la conformité à l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information canadienne sur l'exposition et la conformité de rf. QDID: B020770 IMPORTANT Read before proceeding If you have any question regarding the operation or use of this product, please visit www.ihome.com to view answers to frequently asked questions. To learn more about this and other iHome products, please visit us online at www.ihome.com For Models That Use Lithium Batteries • Lithium batteries can explode or cause burns if disassembled, shorted, recharged, exposed to water, fire, or high temperatures & not handled appropriately • Do not place loose batteries in a pocket, purse, or other container containing metal objects, do not mix with used or other battery types, or store with hazard- ous or combustible materials. • Store in cool, dry, ventilated area. • Follow applicable laws and regulations for transport and disposal. A Consumer Guide to Product Safety IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Water and Moisture – The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. 2. Ventilation – The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block ventilation openings. Also, it should not be placed in a built-in installation, such as a bookcase or cabinet, which may impede the flow of air through the ventilation openings. 3. Heat – The unit should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat. 4. Power Sources – The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. 5. Power-Cable Protection – Power supply cables should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. It is always best to have a clear area from where the cable exits the unit to where it is plugged into an AC socket. 6. Cleaning – The unit should be cleaned only as recommended. See the Maintenance section of this manual for cleaning instructions. 7. Objects and Liquid Entry – Care should be taken so that objects do not fall and liquids are not spilled into any openings or vents located on the product. 8. Attachments – Do not use attachments not recommended by the product manufacturer. 9. Lightning and Power Surge Protection – Unplug the unit from the wall socket and disconnect the antenna or cable system during a lightning storm or when it is left unattended and unused for long periods of time. This will prevent damage to the product due to lightning and power-line surges. 10. Overloading – Do not overload wall sockets, extension cords, or integral co…

Text truncated - open the document above for the full version.

Label Location on EUT

Rubber pad iBT73 Model plate (Taide) On bottom panel of all colors Material: Black label Heavy glued label Print: cool grey 7C (text) Matt Coating 27.7mmW x 27.7mmH Mar 17, 2015 (Taide) Date code location don’t print the dot line iBT73 iBT73 N ( Canada ) Model: iBT73 (USA) Service No: iBT73-B-B Mfd & Serviced by SDI Technologies Inc. www.ihome.com Patents: www.ihome.com/patents Charging Voltage : DC 5V 500mA Toll Free: 1 (800) 288 2792 Made in China FCC ID: EMOIBT73N / IC: 986B-IBT73N Mar 26, 2015 (Taide)

Antenna

TRF No. FCC Part 15.247/A Page 1 of 71 Report No. KAD150423117E Ver.1.0 ELECTROMAGNETIC EMISSIONS COMPLIANCE REPORT INTENTIONAL RADIATOR CERTIFICATION TO FCC PART 15 SUBPART C REQUIREMENT OF GlowTunes Bluetooth Rechargeable Mini Speaker Model No.: iBT73, iBT73N, iBT73X, iBT73XC (X denotes as color of cabinet) Trade Mark: iHome FCC ID: EMOIBT73N Report No.: KAD150423117E Issue Date: June 30, 2015 Prepared for SDI Technologies Inc 1299, Main Street, Rahway, NJ 07065, U.S.A. Prepared by DONGGUAN EMTEK CO., LTD. No.281, Guantai Road, Nancheng District, Dongguan, Guangdong, China TEL: 86-769-22807078 FAX: 86-769-22807079 This report shall not be reproduced, except in full, without the written approval of DONGGUAN EMTEK CO., LTD. TRF No. FCC Part 15.247/A Page 2 of 71 Report No. KAD150423117E Ver.1.0 VERIFICATION OF COMPLIANCE Applicant: SDI Technologies Inc 1299, Main Street, Rahway, NJ 07065, U.S.A. Manufacturer: SDI Technologies Inc 1299, Main Street, Rahway, NJ 07065, U.S.A. Product Description: GlowTunes Bluetooth Rechargeable Mini Speaker Trade Mark: iHome Model Number: iBT73, iBT73N, iBT73X, iBT73XC (X denotes as color of cabinet) (Note: The samples are the same except model number. So iBT73 was selected for full test.) We hereby certify that: The above equipment was tested by DONGGUAN EMTEK CO., LTD. The test data, data evaluation, test procedures, and equipment configurations shown in this report were made in accordance with the procedures given in ANSI C63.10-2013 and the energy emitted by the sample EUT tested as described in this report is in compliance with conducted and radiated emission limits of FCC Rules Part 15.247(2014). Date of Test : April 23, 2015 to June 17, 2015 Prepared by : Ivy Huang/Editor Reviewer : Hong Yang/Supervisor Approved & Authorized Signer : Sam Lv/Manager TRF No. FCC Part 15.247/A Page 3 of 71 Report No. KAD150423117E Ver.1.0 Modified Information Version Summary Revision Date Report No. Ver.1.0 Original Report / KAD150423117E TRF No. FCC Part 15.247/A Page 4 of 71 Report No. KAD150423117E Ver.1.0 Table of Contents 1. GENERAL INFORMATION ................................................................................................ 6 1.1 PRODUCT DESCRIPTION ................................................................................................................... 6 1.2 TEST FACILITY ................................................................................................................................. 7 2. SYSTEM TEST CONFIGURATION .................................................................................... 8 2.1 EUT CONFIGURATION ...................................................................................................................... 8 2.2 EUT EXERCISE ................................................................................................................................ 8 2.3 TEST PROCEDURE ........................................................................................................................... 8 2.4 LIMITATION....................................................................................................................................... 9 2.5 CONFIGURATION OF TESTED SYSTEM ............................................................................................ 12 3. SUMMARY OF TEST RESULTS ..................................................................................... 13 4. DESCRIPTION OF TEST MODES ................................................................................... 14 5. TEST SYSTEM UNCERTAINTY ...................................................................................... 15 6. CONDUCTED EMISSIONS TEST .................................................................................... 16 6.1 MEASUREMENT PROCEDURE: ........................................................................................................ 16 6.2 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION) ................................................................... 16 6.3 MEASUREMENT EQUIPMENT USED: ................................................................................................ 16 6.4 MEASUREMENT RESULT: ................................................................................................................ 16 6.5 CONDUCTED MEASUREMENT PHOTOS: .......................................................................................... 19 7. RADIATED EMISSION TEST ........................................................................................... 20 7.1 MEASUREMENT PROCEDURE ......................................................................................................... 20 7.2 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION) ................................................................... 22 7.3 MEASUREMENT EQUIPMENT USED: ................................................................................................ 23 7.4 MEASUREMENT RESULT ................................................................................................................. 24 7.5 RADIATED MEASUREMENT PHOTOS: .............................................................................................. 36 8. CHANNEL SEPARATION TEST ...................................................................................... 37 8.1 MEASUREMENT PROCEDURE ......................................................................................................... 37 8.2 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION) ................................................................... 37 8.3 MEASUREMENT EQUIPMENT USED: ................................................................................................ 37 8.4 MEASUREMENT RESULTS: .............................................................................................................. 37 9. 20DB BANDWIDTH TEST ............................................................................................... 44 9.1 M…

Text truncated - open the document above for the full version.