EMOT150Weather Band Radio with Nature sounds and alarm

22/0.2/2001 10:4223333839COMTRAD IND LTD PAGEas Model: T-lSO'X' Date: February 22, 2001 Weather Band: sl~- pas-sed from antenna into the Weatller Band- RF Amp. Q21 , Mixer Q25 together VJitll Weather Band Oscillator Q24 and selected by SW20 for Channel 1-7 selection, the IF 455KHz was Amplifier and demodulated by Q26, Q27, Q28 & Q29 passed in the IC I Audio Amplifier to Spea1(er. W11en Sound Chip IC2 has turned on & passed in ICl Audio Amplifier to Speal(er, at the sal)1e time weather ba11d signal will be muted. Page 1 / 1 pages /d£O9 T.1S0XTD.doc P.05 22-FEE-2001 11:102333383998% The equipment under test (BUT) is a weather band radio with nature sound and alarm clock function. The operating frequency of the weather band is from 162.40 to 162.55 MHz. The BUT is powered by 120V AC/DC adaptor or three' AA 'size batteries. At the front panel of the BUT, it consists of four nature sound buttons, time setting and weather band on/off buttons, and the weather band channels selector and volume control knob are located at the side panel. This BUT is designed to receive the weather information broadcasting from local weather band stations. And, the nature sound function is mainly for relaxation purpose .

• The test results rep orted in this test rep ort shall refer only to the samp le actually tested and shall not refer or be deemed to refer to bulk from which such a samp le may be said to have been obtained. • This rep ort shall not be rep roduced excep t in full without p rior authorization from Intertek Testing Services Hong Kong Limit ed Inte rte k Te sting Se rvice s Hong Kong Ltd. 2/F., Garment Centre, 576 Castle Peak Road, Kowloon, Hong Kong. Tel: (852) 2173 8888 Fax: (852) 2745 8306 SDI Technologies Inc. Application For Certification (FCC ID: EMOT150) Superheterodyne Receiver WO# 0101086 DY/sc March 1, 2001 • The test results rep orted in this test rep ort shall refer only to the samp le actually tested and shall not refer or be deemed to refer to bulk from which such a samp le may be said to have been obtained. • This rep ort shall not be rep roduced excep t in full without p rior authorization from Intertek Testing Services Hong Kong Limit ed • For Terms And Conditions of the services, it can be p rovided up on request. Inte rte k Te sting Se rvice s Hong Kong Ltd. 2/F., Garment Centre, 576 Castle Peak Road, Kowloon, Hong Kong. Tel: (852) 2713 8888 Fax: (852) 2745 8306 FCC ID: EMOT150 INTERTEK TESTING SERVICES FCC ID: EMOT150 i LIST OF EXHIBITS INTRODUCTION EXHIBIT 1 :General Description EXHIBIT 2 :System Test Configuration EXHIBIT 3 :Emission Results EXHIBIT 4 :Equipment Photographs EXHIBIT 5 :Product Labelling EXHIBIT 6 :Technical Specifications EXHIBIT 7 :Instruction Manual EXHIBIT 8 :Miscellaneous Information INTERTEK TESTING SERVICES FCC ID: EMOT150 ii MEASUREMENT/TECHNICAL REPORT SDI Technologies Inc. - MODEL: TIMEX T-150'X' FCC ID: EMOT150 This report concerns (check one:)Original Grant X Class II Change _____ Equipment Type: Superheterodyne Receiver (example: computer, printer, modem, etc.) Deferred grant requested per 47 CFR 0.457(d)(1)(ii)?Yes No X If yes, defer until: date Company Name agrees to notify the Commission by: date of the intended date of announcement of the product so that the grant can be issued on that date. Transition Rules Request per 15.37?Yes No X If no, assumed Part 15, Subpart B for unintentional radiator - the new 47 CFR [10-1-96 Edition] provision. Report prepared by:Daniel Yau Intertek Testing Services Hong Kong Ltd. 2/F., Garment Centre, 576, Castle Peak Road, Kowloon, Hong Kong Phone:852-2173-8542 Fax:852-2371-0914 INTERTEK TESTING SERVICES FCC ID: EMOT150 iii Table of Contents 1.0 General Description ................................................................................................................ 2 1.1 Product Description............................................................................................................. 2 1.2 Related Submittal(s) Grants.................................................................................................2 1.3 Test Methodology................................................................................................................ 3 1.4 Test Facility......................................................................................................................... 3 2.0 System Test Configuration ...................................................................................................... 5 2.1 Justification.......................................................................................................................... 5 2.2 EUT Exercising Software ....................................................................................................5 2.3 Special Accessories ............................................................................................................. 5 2.4 Equipment Modification......................................................................................................6 2.5 Support Equipment List and Description ............................................................................ 6 3.0 Emission Results ...................................................................................................................... 8 3.1 Field Strength Calculation ................................................................................................... 9 3.1 Field Strength Calculation (cont’d) ................................................................................... 10 3.2 Radiated Emission Configuration Photograph .................................................................. 11 3.3 Radiated Emission Data .................................................................................................... 12 3.4 Conducted emission Configuration Photograph ................................................................ 15 3.5 Conducted Emission Data ................................................................................................. 17 4.0 Equipment Photographs ....................................................................................................... 19 5.0 Product Labelling .................................................................................................................. 21 6.0 Technical Specifications ........................................................................................................ 23 7.0 Instruction Manual ................................................................................................................ 25 8.0 Miscellaneous Information ................................................................................................... 27 8.1 Discussion of Pulse Desensitization .................................................................................. 28 8.2 Calculation of Average Factor .......................................................................................... 29 8.3 Emissions Test Procedures ................................................................................................ 30 8.3 Emissions Test Procedures (cont'd)...........................................................…

Text truncated - open the document above for the full version.