FHO-T2026Surface-mounted luminaire with LED

1 VIRRMO 2AA-2227346-1 English INSTALLATION INSTRUCTIONS CAUTION: Before starting, turn off power at main circuit panel. English CAUTION! The light source of this product is non- changeable light diodes (LED). Do not disassemble the product, as the light diodes can cause damage to the eyes. Do not immerse in water. Cleaning Use a damp cloth, never a strong cleaning agent. English This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions: 1. This device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation. WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. SAVE THESE INSTRUCTIONS 3 Français INSTRUCTIONS D’INSTALLATION ATTENTION: Coupez l’alimentation avant de procéder à l’installation. Français MISE EN GARDE! La source lumineuse du produit est composée de diodes (LED) qui ne se remplacent pas. Ne jamais démonter le produit, les diodes peuvent causer des blessures aux yeux. Ne pas plonger dans l’eau. Entretien Utiliser un chiffon humide, jamais d’agent nettoyant puissant. Français Cet appareil est conforme à la partie 15 des règles de la FCC. Son fonctionnement est soumis aux deux conditions suivantes: 1. Cet appareil ne doit pas provoquer de brouillage préjudiciable et 2. il doit accepter tout brouillage reçu, y compris le brouillage pouvant entraîner un mauvais fonctionnement. ATTENTION: Tout changement apporté à cet appareil non expressément approuvé par la partie responsable de la conformité est susceptible d’annuler le droit de l’utilisateur à se servir de cet équipement. NOTE: Cet équipement a été testé et déclaré conforme aux limites imposées aux appareils numériques de la classe B, en vertu de la partie 15 des règles de la FCC. Ces limites sont conçues pour assurer une protection suffisante contre les interférences nuisibles dans les installations résidentielles. Cet équipement génère, utilise et peut dégager de l’énergie de radiofréquence et, s’il n’est pas installé et utilisé conformément aux instructions du fabricant, provoquer un brouillage préjudiciable aux communications radio. Il n’existe toutefois aucune garantie qu’un équipement particulier ne sera pas victime de brouillage. Si cet équipement entraîne un brouillage préjudiciable à la réception des émissions radio ou de télévision, identifiable en mettant le terminal hors puis sous tension, il est recommandé à l’utilisateur de tenter de résoudre ce problème au moyen d’une ou plusieurs des mesures suivantes: - Orienter l’antenne réceptrice différemment ou la changer de place. - Augmenter la distance séparant l’équipement du récepteur. - Connecter l’appareil à une prise sur un circuit différent de celui auquel est branché le récepteur. - Obtenir de l’aide auprès du revendeur ou d’un technicien radio/TV expérimenté. CONSERVER CES MESURES DE SÉCURITÉ 4AA-2227346-1 Español INSTRUCCIONES DE MONTAJE ADVERTENCIA: Antes de comenzar el montaje, cortar la luz en el cuadro general. Español ¡ATENCIÓN! La fuente de luz de este producto son diodos de emisión de luz (LED) que no se reemplazan. No desmontes el producto, ya que la luz de los diodos puede dañar los ojos. No sumergir en agua. Limpieza Utiliza un paño humedecido, nunca detergentes fuertes. Español Este aparato cumple la parte 15 de las normas FCC. Su funcionamiento está sujeto a las dos condiciones siguientes: 1. Este aparato no debe provocar interferencias perjudiciales. 2. Debe aceptar cualquier interferencia que reciba, incluidas las interferencias que puedan suponer un mal funcionamiento. ATENCIÓN: Cualquier cambio o modificación que se realice sin ser aprobado expresamente por la parte responsable de la conformidad, es susceptible de anular el derecho del usuario a utilizar este equipo. NOTA: Se ha comprobado que este equipo cumple con las especificaciones de un dispositivo digital de clase B, de acuerdo con la sección 15 de la norma FCC. Estas especificaciones se han diseñado para garantizar una protección adecuada contra las interferencias nocivas en instalaciones domésticas. Este aparato genera, utiliza y puede emitir energía en radiofrecuencia y, si no se instala y utiliza según las instrucciones, puede causar interferencias en la radiocomunicación. Sin embargo, no hay garantía de que no se produzcan interferencias en instalaciones concretas. Si este equipo causa interferencias nocivas en la recepción de radio o televisión, lo que puedes comprobar encendiendo y apagando el aparato, puedes intentar corregir el problema, como sigue: - Reorienta o reubica la antena de recepción. - Aumenta la separación entre el equipo y el receptor. - Conecta el equipo a un circuito que no sea el del receptor. - Pide ayuda al vendedor o a un técnico de radio/TV. GUARDA ESTAS INSTRUCCIO…

Text truncated - open the document above for the full version.

© Inter IKEA Systems B.V. 2014 May 04, 2020 Federal Communications Commission 445 12 th Street SW Washington, DC 20554 Subject: Limited Agency Agreement IKEA of Sweden AB FCC ID: FHO-2026 To Whom It May Concern: We, IKEA of Sweden AB, hereby authorized Intertek Semko AB, Swedens to act as our Agent for the purpose of preparing application for FCC ID number FHO- T2026 under all applicable parts of the FCC rules and regulations. The effective date of this limited agency agreement is May 04, 2020. The Limited Agency Agreement expires on July 04 , 2020, unless sooner terminated or extended by written notice to Intertek Semko AB, Sweden and the Federal Communications Commission. This is to advise that we are in full compliance with the Anti-Drug Abuse Act. The applicant is not subject to a denial of federal benefits pursuant to Section 5301 of the Anti-Drug Act of 1988, 21 U.S.C. 862, and no party to the application is subject to a denial of federal benefits pursuant to that section. If you have any questions or comments, please do not hesitate to contact me. Sincerely, Ivan Susak Team Manager, Laws&Standards IKEA of Sweden AB [email protected] +4647681000

© Inter IKEA Systems B.V. 2014 May04, 2020 Attention: Application Examiner RE: Request for Confidentiality Applicant: IKEA of Sweden AB FCC ID: FHO-T2026 To Whom It May Concern: Permanent Confidentiality Request is hereby submitted by IKEA of Sweden AB to withhold permanently from public review certain portions of the application for equipment certification for the referenced FCC identifiers. This request for confidentiality is made pursuant to 47 CFR 0.457(d) and 0.459 of the FCC Rules. In particular, the following sections of the application are to be kept permanently confidential:  Schematics  Block diagram  Detailed Operational/Functional Description  Parts list Short-term Confidentiality Request is hereby submitted by IKEA of Sweden AB to withhold from public review for a period of 180 days from the date of the Grant of Equipment Authorization and prior to marketing, certain portions of the application for equipment certification for the referenced FCC identifiers. This request for confidentiality is made pursuant to 47 CFR 0.457(d) and 0.459 of the FCC Rules. In particular, the following sections of the application are to be kept confidential for a period of 180 days from the date of Authorization:  Test setup photos  External photos  Internal photos  User manual Rationale for request for confidentiality: IKEA of Sweden AB has invested considerable time and materials in research and development to produce the referenced product. [Permanent confidentiality: Disclosure of the permanently confidential portions of this application to competitors would not only give them significant competitive advantages in developing similar products, but would © Inter IKEA Systems B.V. 2014 also disclose successful implementation of unpublished, leading edge technology developed by us.] [Short term confidentiality: Disclosure of the short-term confidential portions of this application during the period of importation and/or distribution would reveal key aspects of proprietary technology to competitors and diminish the value of our investment in research and development.] Sincerely, Ivan Susak Team Manager –Laws & standards IKEA of Sweden AB [email protected] +4647681000

External photos T2026 Virrmo External photos light engine LED1803E13 Label location for T2026 Virrmo 90 Date code: YYWW 40

Test report no. 2010994STO-106 Annex 1 Page 1 (2) Intertek Semko AB Torshamnsgatan 43, Box 1103, SE-164 22 Kista, Sweden www.intertek.se ANNEX 1 Photos of EUT Test report no. 2010994STO-106 Annex 1 Page 2 (2) Intertek Semko AB Torshamnsgatan 43, Box 1103, SE-164 22 Kista, Sweden www.intertek.se

Label location for T2026 Virrmo 90 40

internal photos T2026 Virrmo Internal photos light engine LED1803E13

Test report No. 2010994STO-106 Page 2 (4) Intertek Semko AB Torshamnsgatan 43, Box 1103, SE-164 22 Kista, Sweden www.intertek.se Version 2.03 Revision History Test report number Date Description Changes 2010994STO-106 March 25, 2020 First release Test report No. 2010994STO-106 Page 3 (4) Intertek Semko AB Torshamnsgatan 43, Box 1103, SE-164 22 Kista, Sweden www.intertek.se Version 2.03 1.1 Reference type/model Test report no.: 1812503STO-001, Ed.2 Standards: FCC 47 CFR Part 15: Radio frequency device, Subpart B: Unintentional radiators. ICES-005 Issue 4: Lighting Equipment, Class B ICES-005 Issue 5: Lighting Equipment, Class B Equipment: LED module Type / model: LED1803E13 Brand name: IKEA Manufacturer: IKEA of Sweden AB Rating: 120 V AC, 50/60 Hz, 11 W 1.2 Opinions and interpretations This test report covers an alternative type/model, presumed to have the same emission-characteristics as the above mention tested reference type/model. According to the manufacturer, the alternative type/model is identical to the tested type/model except for the following differences: The luminaire T2026 Virrmo comprises of the LED module, type LED1803E13 and a lampshade, the only electric/electronic part is the separately emission tested module LED1803E13. Adding the lampshade is considered not to imply different emission-characteristics when compared to the tested LED module LED1803E13. Therefore, T2026 Virrmo is not tested, but considered to have the same emission-characteristics as the tested LED module LED1803E13. Rating plate T2026 Virrmo Test report No. 2010994STO-106 Page 4 (4) Intertek Semko AB Torshamnsgatan 43, Box 1103, SE-164 22 Kista, Sweden www.intertek.se Version 2.03 EUT photos are enclosed in Annex 1 to this report.

Test report no. 2021988STO-102 Annex 1 Page 1 (2) Intertek Semko AB Torshamnsgatan 43, Box 1103, SE-164 22 Kista, Sweden www.intertek.se ANNEX 1 Photos of EUT EUT Photos of test setup Test setup for conducted emission 150 kHz – 30 MHz Test report no. 2021988STO-102 Annex 1 Page 2 (2) Intertek Semko AB Torshamnsgatan 43, Box 1103, SE-164 22 Kista, Sweden www.intertek.se Test set up radiated emission 30 MHz – 1 GHz