G6D6420B4TOY Receiver

TROUBLE SHOOTING & SUPPORT Problem - Vehicle does not move or-moves slowly. - Make certain there are fresh alkaline batteries in the transmitter and that th ey have been installed in the correct posrtion. • Are the ( +) and H markings on the alkaline batteries in the same posrtion as the ( +) and H markings in the Transmitter Battery Compartment? - Has the internal battery in the vehicle beeO.charged? - Are the metal contact tabs touching, r\Jsty or dirty in the transmitter? • Make certain that the vehicle ON/OFF swrtch is in the "ON' position. Problem • Vehicle moves by itsett or exhibits reduced range from the transmitter. - Make certain there is no outside radio interference in your area. The best way to test this is to take the · ' vehicle as far away from radio towers, electrical lines or tall buildings as possible to ensure no further radio interference will occur. Always remove Batteries from transmitter when not in use.-· Do not dispose batteries in fire. Leakage, explosion and personal injury may occur. Do not attempt jumps or tricks with this vehicle. Do not attempt to remove internal battery. Adult supervision recommended. PROPER USE, PRECAUTIONS & CARE Swllch whk;le OFF when not in use. F.C.C. CAUTION: • Brush areas where dirt gets trapped.' Do not use chemicals or water to clean Changes or modWications not expressly approved by the party responsible for compliance could void the user"s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the ll!nlts for a Class B digital device, pursuant to Part t 5 or the FCC Rules. These limlts are designed to provide reasonable protection against harmful lnterterenoe in a resldentlal installation. This equipment generates. uses and can radiate radio frequency eoergy and. tt not lnstaRed and used in accordance with the instructions. may cause harmful interterenoe to radio communications. However, there Is no guarantee that Interference will not occur In a partlcular installatlon. ii this equipment does cause • harmful interference to radio or televtoon reception, which can be determined by turning the equipment off and on. the user Is encouraged to try to correct the Interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment Into an outlet on a circuit dtt1erent from that to which the receiver is connected. • Consult the dealer or an experlenoed radio/TV technician for help. OWNER'S MANUAL Please read and understand all precautions prior to use. Thank you for choosing a premium New Bright product. USA&Canada 30-0ay Limited Warranty New Bright Industries warrants to the original purchaser that this product will be free of defects in materials and workmanship for thirty (30) days from the date of purchase. In the event of such defect within the warranty period, New Bright will repair or replace the product at our sole discretion. This warranty does not cover damage resulting from unauthorized modifications, accident, misuse or abuse . Should your item have a defect covered under this warranty, first call the toll free number listed below. Most problems can be resolved in this manner. If necessary, you will be issued a Return Authorization number (RA) and instructions on how to obtain a Product Return Form. The Product Return Form Is to be used when returning a product to us (postage pre-paid and Insured by the consumer). When returning a defective product, please package the product, the Product Return Form and a copy of the dated sales receipt as proof of purchase. Be sure to mark the RA number on the Product Return Form. If the product is returned without a dated sales receipt, it will be excluded from coverage under this warranty. Please allow 4 to 6 weeks for delivery of repaired or replacement vehicies (depending on your location). New Bright Industries' liability for defects in materials and workmanship under this warranty shall be limited to repair or replacement at our sole discretion. In no event shall we be responsible for incidental, consequential or contingent damages (except in those states that do not allow this exciusion or limitation). Valid only in the USA & Canada. Contact New Bright Industries Customer Service Toil Free at: 1-877-NBI-TOYS (1-8n-624-8697) Monday through Friday, 8:00 AM to 5:00 PM Eastern Time .................. ,�:· -:: .. . . •'",., .,_ ··-··-1,, , l!"I , > UI •• '_.. REF-0246 U.S. Toy Sales and Marketing Co. Inc. 30260 Oak Creek Drive - 2nd Floor Wixom Ml 48393 1-877 -624-8697 . . . , . http://WWW.newbright.com/ JN145-20

Federal Communications Commission 7435 Oakland Mills Road Columbia MD 21046 Subject:Request for Confidentiality FCC ID: G6D6420B4 To Whom It May Concern: Pursuant to the provisions of Sections 0.457 and 0.459 of the Commission’s rules (47 CFR §§ 0.457, 0.459), we are requesting the Commission to withhold the following attachments as confidential document from public disclosure indefinitely. Schematic Diagram Block Diagram Theory of Operation Above mentioned document contains detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market. It is our understanding that all measurement test reports, FCC ID label format and correspondent during certification review process cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. Best Regards Company Name: New Bright Industrial Co., Ltd. Contact Name: Eric Kwok Title of Person ：Quality Manager Address: New Bright Building 11 Sheung Yuet Road, Kowloon Bay, Kowloon Hongkong Date: 2020/05/26

External Photographs Page 2 of 3 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. View of EUT-1 View of EUT-2 Page 3 of 3 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. View of EUT-3 View of EUT-4

FCC Label

Internal Photographs Page 2 of 5 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. Internal View of EUT-1 Internal View of EUT-2 Page 3 of 5 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. Internal View of EUT-3 Internal View of EUT-4 Antenna Page 4 of 5 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. Internal View of EUT-5 Internal View of EUT-6 Page 5 of 5 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. Internal View of EUT-7

The results reported herein have been performed in accordance with the laboratory’s terms of accreditation. This report shall not be reproduced except in full without the written approval of the Laboratory. The results in this report apply to the test sample(s) mentioned above at the time of the testing period only and are not to be used to indicate applicability to other similar products. This report does not imply that the product(s) has met the criteria for certification. FCC Part15, Subpart B ICES-003 TEST REPORT For TOY Receiver MODEL NUMBER:6420B4 FCC ID: G6D6420B4 REPORT NUMBER: 4789478332.1 ISSUE DATE: May 15, 2020 Prepared for NEW BRIGHT INDUSTRIAL CO., LTD 9/F., NEW BRIGHT BUILDING, 11 SHEUNG YUET ROAD, KOWLOON BAY, KOWLOON, HONG KONG. Prepared by UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch Building 10, Innovation Technology Park, No. 1, Li Bin Road, Song Shan Lake Hi- Tech Development Zone Dongguan, 523808, People’s Republic of China Tel: +86 769 22038881 Fax: +86 769 33244054 Website: www.ul.com REPORT NO.: 4789478332.1 Page 2 of 22 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch FORM NO: 10-SL-F0035 This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. Revision History Rev. Issue Date Revisions Revised By V0 05/15/2020 Initial Issue REPORT NO.: 4789478332.1 Page 3 of 22 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch FORM NO: 10-SL-F0035 This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. Summary of Test Results Standard Test Item Limit Result Remark FCC Part15, Subpart B ANSI C63.4-2014 ICES-003 Issue 6 Conducted Disturbance Class B N/A NOTE (1) NOTE (2) Radiated Disturbance below 1 GHz Class B PASS Radiated Disturbance above 1 GHz Class B PASS NOTE (3) Note: (1) “N/A” denotes test is not applicable in this test report, the TOY Receiver was charged by controller, The controller was powered by battery only. (2) This test is only applicable for devices which can be charged or powered by AC power cable. (3) If the highest frequency of the internal sources of the EUT is less than 108 MHz, the measurement shall only be made up to 1 GHz. If the highest frequency of the internal sources of the EUT is between 108 MHz and 500 MHz, the measurement shall only be made up to 2 GHz. If the highest frequency of the internal sources of the EUT is between 500 MHz and 1 GHz, measurement shall only be made up to 5 GHz. If the highest frequency of the internal sources of the EUT is above 1 GHz, the measurement shall be made up to 5 times the highest frequency or 40 GHz, whichever is less. (4) This test report is only published to and used by the applicant, and it is not for evidence purpose in China. (5) The measurement result for the sample received is <Pass> according to < FCC Part15, Subpart B and ICES-003 Issue 6 > when <Accuracy Method> decision rule is applied. REPORT NO.: 4789478332.1 Page 4 of 22 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch FORM NO: 10-SL-F0035 This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. CONTENTS 1. ATTESTATION OF TEST RESULTS ..................................................................................... 5 2. TEST METHODOLOGY ......................................................................................................... 6 3. FACILITIES AND ACCREDITATION ..................................................................................... 6 4. CALIBRATION AND UNCERTAINTY ................................................................................... 7 4.1. MEASURING INSTRUMENT CALIBRATION ........................................................... 7 4.2. MEASUREMENT UNCERTAINTY ............................................................................ 7 5. EQUIPMENT UNDER TEST .................................................................................................. 8 5.1. DESCRIPTION OF EUT ........................................................................................... 8 5.2. TEST MODE ............................................................................................................. 8 5.3. EUT ACCESSORY ................................................................................................... 8 5.4. SUPPORT UNITS FOR SYSTEM TEST ................................................................... 8 6. MEASURING EQUIPMENT AND SOFTWARE USED........................................................... 9 7. EMISSION TEST ................................................................................................................. 10 7.1. RADIATED EMISSIONS MEASUREMENT ............................................................. 10 REPORT NO.: 4789478332.1 Page 5 of 22 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch FORM NO: 10-SL-F0035 This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. 1. ATTESTATION OF TEST RESULTS Applicant Information Company Name: NEW BRIGHT INDUSTRIAL CO., LTD Address: 9/F., NEW BRIGHT BUILDING, 11 SHEUNG YUET ROAD, KOWLOON BAY, KOWLOON, HONG KONG. Manufacturer Information Company Name: NEW BRIGHT INDUSTRIAL CO., LTD Address: 9/F., NEW BRIGHT BUILDING, 11 SHEUNG YUET ROAD, KOWLOON BAY, KOWLOON, HONG KONG. EUT Information EUT Name: TOY Receiver Model: 6420B4 Sample Status: Normal Sample ID: 3053676 Sample Received Date: May 11, 2020 Date of Tested: May 11, 2020 ~ May 14, 2020 APPLICABLE STANDARDS STANDARD TEST RESULTS FCC Part15, Subpart B PASS ICES-003 Issue 6 PASS Prepared By: Checked By: Colin Yu Shawn Wen Project Engineer Laboratory Leader Approved By: Stephen Guo Labo…

Text truncated - open the document above for the full version.

Appendix II Setup Photographs Radiated Emissions below 1GHz test setup photo Radiated Emissions above 1GHz test setup photo