JI9-F24-131Industrial Radio Remote Control Transmitter

Certificates and reports shall not be reproduced except in full, without the written permission of H.B Compliance Solutions, LLC. Intentional Radiator Test Report For the Intercontinental Technologies, Ltd. TELECRANE F24‐10D‐TX Industrial Radio Remote Control Transmitter Tested under The FCC Rules contained in Title 47 of the CFR, Part 15.231 for Periodic Operation Prepared for: Intercontinental Technologies, Ltd. 558‐2 Plate Drive East Dundee, IL 60118 Prepared By: H.B. Compliance Solutions 254 W. Baseline Road, Suite # 103 Tempe, Arizona 85283 Reviewed By: Hoosamuddin Bandukwala Cert # ATL‐0062‐E Engineering Statement: The measurements shown in this report were made in accordance with the procedure indicated, and the emissions from this equipment were found to be within the limits applicable. I assume full responsibility for the accuracy and completeness of these measurements, and for the qualifications of all persons taking them. It is further stated that upon the basis of the measurement made, the equipment tested is capable of operation in accordance with the requirements of Part 15 of the FCC Rules under normal use and maintenance. HBCS Report # EMC_12009-20 Page 2 of 22 Report Status Sheet Revision # Report Date Reason for Revision Ø April 29, 2012 Initial Issue HBCS Report # EMC_12009-20 Page 3 of 22 Table of Contents EXECUTIVE SUMMARY ............................................................................................. 4 1. Testing Summary ......................................................................................... 4 EQUIPMENT CONFIGURATION................................................................................. 5 1. Overview ..................................................................................................... 5 2. Test Facility .................................................................................................. 6 3. Description of Test Sample .......................................................................... 6 4. Equipment Configuration ............................................................................ 6 5. Support Equipment ..................................................................................... 6 6. Ports and Cabling Information .................................................................... 6 7. Method of Monitoring EUT Operation ........................................................ 7 8. Mode of Operation ...................................................................................... 7 9. Modifications ............................................................................................... 7 10. Disposition of EUT ....................................................................................... 7 Criteria for Un‐Intentional Radiators ....................................................................... 8 1. Radiated Emissions ...................................................................................... 8 Emissions Tests Calculations ......................................................................... 9 Criteria for Intentional Radiators ........................................................................... 12 2. Conducted Emissions ................................................................................. 12 2. Occupied Bandwidth ................................................................................. 13 3. Deactivation Time ..................................................................................... 15 5. Duty Cycle .................................................................................................. 17 6. Radiated and Spurious Emissions .............................................................. 20 HBCS Report # EMC_12009-20 Page 4 of 22 EXECUTIVE SUMMARY 1. Testing Summary These tests were conducted on a sample of the equipment for the purpose of demonstrating compliance with Part 15.231. All tests were conducted using measurement procedure from ANSI C63.4‐2003, American National Standard for Methods of Measurement of Radio‐Noise Emissions from Low‐Voltage Electrical and Electronic Equipment in the range of 9kHz to 40GHz as appropriate. Test Name Test Method/Standard Result Comments Unintentional Radiated Emissions 15.109 Pass A/C Power Line Conducted Emissions 15.207(a) N/A Battery Powered Device. Uses 2 AA Batteries Occupied Bandwidth 15.231(c) Pass Deactivation Time 15.231(a)(1) Pass Duty Cycle 15.231 Pass Radiated & Spurious Emissions 15.231(b), 15.209(a), 15.205, 15.35(C) Pass HBCS Report # EMC_12009-20 Page 5 of 22 EQUIPMENT CONFIGURATION 1. Overview H.B Compliance Solutions was contracted by Intercontinental Technologies, Ltd. to perform testing on the Industrial Radio Remote Control Transmitter Model # TELECRANE F24‐10D‐TX Channel: 131 under the quotation number 12021011. This document describes the test setups, test methods, required test equipment, and the test limit criteria used to perform compliance testing of the Intercontinental Technologies, Industrial radio remote control transmitter. The tests were based on FCC Part 15 Rules. The tests described in this document were formal tests as described with the objective of the testing was to evaluate compliance of the Equipment Under Test (EUT) to the requirements of the aforementioned specifications. Intercontinental Technologies Ltd. should retain a copy of this document and it should be kept on file for at least five years after the manufacturing of the EUT has been permanently discontinued. The results obtained relate only to the item(s) tested. Product Name: TELECRANE Model(s) Tested: F24‐10D‐TX Channel: 131 FCC ID: JI9‐F24‐131 Supply Voltage Input: Primary Power : 3 Vdc Frequency Range: 433.6175 MHz (Channel # 131 Nominal) No. of Channels: 1 Type(s) of Modulation: FSK Range of Operation Power: 0.0000005 Watts (Radiated) Emission Designator: N/A Channel Spacing(s) None Test Item: Pre‐Production Type of Equipment : Portable Antenna …

Text truncated - open the document above for the full version.

Setup Photo # 1 Setup Photo # 2 Setup Photo # 3