JPZ0085Shade Controller

Sivoia® QS Wireless Cellular Shade Automated shade with wireless (RF) control Installation and Programming Guide (please read before installing) English Inside mount 3 Outside mount 4 8 8.1 8.4 Start Here 1. Review components 2. Install mounting brackets 3. Install batteries 4. Install the shade in the brackets 5. Removing the shade from the brackets 6. Programming options Review components Included: 1 Batteries not included Tools required: Install mounting brackets Mount the left and right brackets 2 inches in from each end of the shade. Note: Mount additional brackets evenly between the end brackets and clear of the cord lift. 2 Close Open Close Open Open Preset Close Close Open Open Preset Close Close Open Open Preset Close Clos e Open Open Preset Close or Close Open Open Preset Close Install batteries Refer to the battery holders for proper battery alignment. Install the shade in the brackets Click the shade into place as shown below. 6 Programming RadioRA® 2 • For assignment and programming without RadioRA 2 design and programming software, refer to the RadioRA 2 setup guide, available at www.lutron.com/radiora2 • Otherwise, use the RadioRA 2 Essentials or Inclusive software to assign and program your cellular shades. HomeWorks® QS • Use the HomeWorks QS design and programming software to assign and program your cellular shades. Standalone • Proceed to steps 7 and 8 to assign and program your cellular shades with standalone controls. 7.1 7.2 Assign control: Close Open Close Open Open Preset Close Close Open Open Preset Close Close Open Open Preset Close Clos e Open Open Preset Close or Close Open Open Preset Close Hold “Close” (6 seconds) Shade LED blinks for 2 seconds Set the limits Note: Shade limits must either be set with a Pico ® or with RadioRA2 or Homeworks QS design and programming software. 8.2 Enter limit setup mode: Hold “Open” AND “Raise” (3 seconds) Shade LED blinks for 2 seconds, then remains on. 8.3 Adjust limits: Press “Raise” or “Lower” Shade LED remains on solid green. Save and exit: To set the upper limit: Hold “Open” (6 seconds) To set the lower limit: Hold “Close” (6 seconds) Shade LED blinks for 2 seconds, then turns off. e e Close Open Close Open Open Preset Close Close Open Open Preset Close Close Open Open Preset Close Clos e Open Open Preset Close or Close Open Open Preset Close Close Open Close Open Open Preset Close Close Open Open Preset Close Close Open Open Preset Close Clos e Open Open Preset Close or Close Open Open Preset Close Tap shade button - shade LED turns on solid green Tap shade button - Shade LED turns on solid green e Troubleshooting 10 SymptomSolution Shade does not go all the way down Fabric needs to relax (close shade for 24 hours then reset the lower limit) Reset the lower limit Shade hangs unevenly Ensure that fabric is not pinched in the mounting brackets For more information: www.lutron.com/ technicaldocumentlibrary/ window%20systems%20 warranty.pdf Contact the Lutron Technical Support Center at the numbers provided below or your local Lutron sales representative with questions concerning the installation or operation of the System or this Warranty, or to make a warranty claim. Please provide the exact model number when calling. Lutron, the Sunburst logo, Sivoia, RadioRA, HomeWorks, and Pico are registered trademarks of Lutron Electronics Co., Inc. Worldwide Headquarters | USA Lutron Electronics Co., Inc. 7200 Suter Road Coopersburg, PA 18036-1299 USA TEL: 1.610.282.3800 FAX: 1.610.282.3090 Technical Support: 1.800.523.9466 or 1.610.282.6701 Toll Free: 1.888.LUTRON EMAIL: [email protected] WEB: www.lutron.com/ shadingsolutions Europe Headquarters | United Kingdom Lutron EA Ltd 6 Sovereign Close London, E1W 3JF, UK TEL: +44.(0)20.7702.0657 FAX: +44.(0)20.7480.6899 Technical Support: +44. (0)20.7480.6899 FREEPHONE: 0800.282.107 Asian Headquarters | Singapore Lutron GL Ltd 15 Hoe Chiang Road #07-03 Singapore, 089316 TEL: +65.6220.4666 FAX: +65.6220.4333 Technical Support: 800.120.4491 ©2011 LUTRON Electronics Co., Inc. P/N 045-355 REV. A Limited warranty Number of years from date of shipment Percentage of cost of replacement parts credited by Lutron Up to 5100% More than 5 but not more than 8 50% More than 80% Restore factory defaults (optional) 9 Tap 3 times, hold 3 seconds, tap 3 times. e Shade LED blinks for 2 seconds after hold, then for 5 seconds after second triple-tap. Mounting brackets Cellular shadeMounting screws Endcaps Phillips-head screwdriver Cordless drill (optional) 5 Removing the shade from the brackets Use a flathead screwdriver to unclip the shade as shown. Enter shade setup mode: Enter shade setup mode: Close Open Close Open Open Preset Close Close Open Open Preset Close Close Open Open Preset Close Clos e Open Open Preset Close or Close Open Open Preset Close e 7 Assigning controls LED Rechargable batteries Side view FCC Information Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio and television reception, which can be determined by turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/ TV technician for help. Note: Changes or modifications not expressly approved by Lutron Electronics Co. could void the user’s authority to operate this equipment. * This device complies with Part 15 of the FCC R…

Text truncated - open the document above for the full version.

FCC CFR47 PART 15 SUBPART C INDUSTRY CANADA RSS-210 ISSUE 8 CERTIFICATION TEST REPORT FOR SHADE CONTROLLER MODEL NUMBER: CSV-SYJ-B AND CSV-SYJ-PS FCC ID: JPZ0085 IC: 2851A-JPZ0085 REPORT NUMBER: 1001411477 ISSUE DATE: 2011-08-24 Prepared for LUTRON ELECTRONICS INC 7200 SUTTER ROAD COOPERBURG PA 18036, USA Prepared by UNDERWRITERS LABORATORIES INC. 1285 WALT WHITMAN RD. MELVILLE, NY 11747, U.S.A. TEL: (631) 271-6200 FAX: (877) 854-3577 REPORT NO: 1001411477 DATE: 2011-08-24 FCC ID:JPZ0085 IC:2851A-JPZ0085 Page 2 of 71 UNDERWRITERS LABORATORIES INC. FORM NO: CCSUP4701D 1285 WALT WHITMAN RD, MELVILLE, NY 11747, USA TEL: (631) 271-6200 FAX: (877) 854-3577 This report shall not be reproduced except in full, without the written approval of Underwriters Laboratories Inc. Revision History Rev. Issue Date Revisions Revised By -- 2011- 08-24 Initial Issue B. DeLisi REPORT NO: 1001411477 DATE: 2011-08-24 FCC ID:JPZ0085 IC:2851A-JPZ0085 Page 3 of 71 UNDERWRITERS LABORATORIES INC. FORM NO: CCSUP4701D 1285 WALT WHITMAN RD, MELVILLE, NY 11747, USA TEL: (631) 271-6200 FAX: (877) 854-3577 This report shall not be reproduced except in full, without the written approval of Underwriters Laboratories Inc. TABLE OF CONTENTS 1. ATTESTATION OF TEST RESULTS .................................................................................... 4 2. TEST METHODOLOGY ........................................................................................................ 5 3. FACILITIES AND ACCREDITATION .................................................................................... 5 4. CALIBRATION AND UNCERTAINTY .................................................................................. 5 4.1. MEASURING INSTRUMENT CALIBRATION ................................................................ 5 4.2. SAMPLE CALCULATION ............................................................................................... 5 4.3. MEASUREMENT UNCERTAINTY ................................................................................. 5 5. EQUIPMENT UNDER TEST ................................................................................................. 6 5.1. DESCRIPTION OF EUT ................................................................................................. 6 5.2. DESCRIPTION OF AVAILABLE ANTENNAS ................................................................ 6 5.3. SOFTWARE AND FIRMWARE ...................................................................................... 6 5.4. WORST-CASE CONFIGURATION AND MODE ............................................................ 6 5.5. MODIFICATIONS ........................................................................................................... 6 5.6. DESCRIPTION OF TEST SETUP .................................................................................. 7 6. TEST AND MEASUREMENT EQUIPMENT ......................................................................... 9 7. ANTENNA PORT TEST RESULTS .................................................................................... 11 7.1. 20 dB AND 99% BW ..................................................................................................... 11 7.2. DUTY CYCLE ............................................................................................................... 15 8. RADIATED EMISSION TEST RESULTS ............................................................................ 18 8.1. TX RADIATED SPURIOUS EMISSION........................................................................ 18 8.2. RX RADIATED SPURIOUS EMISSION ....................................................................... 37 9. AC MAINS LINE CONDUCTED EMISSIONS ..................................................................... 54 10. SETUP PHOTOS ............................................................................................................. 67 REPORT NO: 1001411477 DATE: 2011-08-24 FCC ID:JPZ0085 IC:2851A-JPZ0085 Page 4 of 71 UNDERWRITERS LABORATORIES INC. FORM NO: CCSUP4701D 1285 WALT WHITMAN RD, MELVILLE, NY 11747, USA TEL: (631) 271-6200 FAX: (877) 854-3577 This report shall not be reproduced except in full, without the written approval of Underwriters Laboratories Inc. 1. ATTESTATION OF TEST RESULTS COMPANY NAME: LUTRON ELECTRONICS INC 7200 SUTTER ROAD COOPERBURG, PA 18036, USA EUT DESCRIPTION: Shade Controller MODEL: CSV-SYJ-B AND CSV-SYJ-PS SERIAL NUMBER: Non-serialized production unit DATE TESTED: 2011-08-11 to 2011-08-23 APPLICABLE STANDARDS STANDARD TEST RESULTS FCC PART 15 SUBPART C Pass INDUSTRY CANADA RSS-210 Issue 8, Annex 1 Pass INDUSTRY CANADA RSS-GEN Issue 3 Pass Underwriters Laboratories Inc. tested the above equipment in accordance with the requirements set forth in the above standards, using test results reported in the test report documents referenced below and/or documentation furnished by the applicant. All indications of Pass/Fail in this report are opinions expressed by Underwriters Laboratories Inc. based on interpretations of these calculations. The results show that the equipment is capable of demonstrating compliance with the requirements as documented in this report. Note: The results documented in this report apply only to the tested sample, under the conditions and modes of operation, as described by the referenced documents. This document may not be altered or revised in any way unless done so by Underwriters Laboratories Inc. and all revisions are duly noted in the revisions section. Any alteration of this document not carried out by Underwriters Laboratories Inc. will constitute fraud and shall nullify the document. This report must not be used by the client to claim product certification, approval, or endorsement by NVLAP, NIST, any agency of the Federal Government, or any agency of any government. Approved & Released For UL By: Tested By: Joseph Danisi Bob DeLisi Lead Engineering Assoicate Sr. Staff Engineer UL UL REPORT NO: 1001411477 DATE: 2011-08-…

Text truncated - open the document above for the full version.

1. SETUP PHOTOS ANTENNA PORT ANTENNA PORT RADIATED EMISSION ABOVE 30 MHz RADIATED EMISSIONS ABOVE 30 MHz (FRONT) RADIATED EMISSIONS ABOVE 30 MHz (BACK) AC MAINS LINE CONDUCTED EMISSION LINE CONDUCTED EMISSION (FRONT) END OF REPORT LINE CONDUCTED EMISSION (BACK)