JT3KDI100-TSECURITY DEVICE TRANSMITTER

FCC ID: AZ489FT3797 LIST OF EXHIBITS DESCRIPTION EXHIBIT REFERENCE I. Identification label information12.983-(f) & General Information1a 1. Production Plans2.981-(a) 2. Application References2.1061 3. Data Submittal Procedure 4. Similar Applications II. Certification of Data2 III. External Photographs32.983-(g) IV. Block Diagrams4 1. Frequency Stabilizing4A 2. Modulation Limiting4B and Post Limiter Filter 3.Harmonic Suppression 4C 4.Power Limiting4D V. Schematic Diagrams52.983-(d)-7 VI. Test Report6 1. Data Index6 2. RF Output Data6A2.985 3. Modulation Characteristics2.987 A. Audio Response & Low Pass Filter Response6B, 9C B. Modulation Limiting6D 4. Occupied Bandwidth6E2.989 5. Conducted Spurious Emissions 6F2.991 6. Radiated Spurious Emissions6G2.993 7. Frequency Stability (Temperature & Supply Voltage)6H-1, 9H-22.995 8. Transient Frequency Behavior6I90.214 VII. Test Set-up Procedures72.999 VIII. Instruction Manual8 2.983-(d)-8 IX. Internal Photographs.9 2.983-(g) X. Parts List and Tune-Up procedures102.983-(d)-6, 9 XI. RF Exposure Information112.1093 XII. Operational Description12 2.983- (d)1,2,3,4,5 1. Technical Characteristics 2. Application XIII. Cover Letter13 FCC ID: AZ489FT3797 IDENTIFICATION LABEL LOCATION X See The Attached Photograph Or Sketch Back Of Radio Back Of Radio Under Belt Clip TYPE X The label is a paper polyester film laminate with a pressure sensitive adhesive backing. The adhesive is a permanent type acrylic with a minimum peel strength of 40 oz/ inch. The label is laser etched into the Urethane paint, exposing the Nickel plating on the Zamak casting substrate. Since no adhesive is required, the label is permanent and tamper-proof. (** - NOTE- The label attached below is a paper polyester film laminate, as described above. This is just for sample purposes, as the actual label is laser etched into the casting) MARKINGS (TEXT) See the Attached Photograph, Exhibit 3-4. EXHIBIT 1 FCC ID: AZ489FT3797 GENERAL INFORMATION I.Production Plans—Pursuant 2.983 ( c ). Quantity production is planned. II.Application References -- Pursuant 2.1061 Reference is made to the following Motorola “Application References” 1. Portable Products and their application. 2. Portable Products Transmitter Modulations Methods. III.Data Submittal Procedure: Data is supplied in accordance with Part 2, Sub-part J of the Commissions’ Rules. IV.Similar, currently Type Accepted Transmitter, FCC ID: AZ489FT3793. EXHIBIT 1a FCC ID: AZ489FT3797