KA2SM232A1G-cluster

Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Industry Canada statement: This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable. Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Déclaration d'exposition aux radiations: Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps.

1. Package Contents DSM-232 G-cluster Media Adapter G-cluster Holder USB Cable HDMI Cable 5V/1A Power Adapter -No USB port on the TV -Need to use gamepad for gaming Warranty Card GPL (General Public License) QIG (Quick Installation Guide) 2. Hardware Overview WPS/Reset Button Micro-USB USB HDMI Network information 15~20 sec, Reset to default setting Connect the supplied USB cable here and the other end into the USB port on the TV or power adapter Connect the game pad here Connect an HDMI cable here and the other end into your TV or home theater receiver 1. Please connect the HDMI cable and USB cable to the G- cluster media adapter 2. Please connect the HDMI cable and USB cable to the TV Please use the supplied power adapter when there is no USB port on the TV 3. Depending on the model of the TV, when using game pad, it may need to use the power adapter, not the USB terminal of the TV 4. After installation to a position that doesn’t block the ventilation holes of the TV back, please make sure the lighting of the LED lamp 5. Please switch to the HDMI input to which you have connected the G-cluster by using the remote control of the TV 6. Please set according to the simple setup guide that will make the initial configuration of the G-cluster 3. Installation

Page 1 CONSTRUCTION PHOTOS OF EUT Page 2 Page 3

Device Label P/N:JSM232LJPGCG.A1ES/N:XXXXXXXXXXXXXMAC ID:XXXXXXXXXXXXH/W Ver.:A1F/W Ver.:1.00.00 26.5 mm 15.0 mm 1.0 mm P/N:JSM232LJPGCG.A1ES/N:XXXXXXXXXXXXXMAC ID:XXXXXXXXXXXXH/W Ver.:A1F/W Ver.:1.00.00

Page 1 CONSTRUCTION PHOTOS OF EUT Page 2 Page 3

FCC ID: KA2SM232A1 Report No.: RF130305C16 Operational Description This device is a G-cluster, which operates in 2.4GHz band; the maximum data rate could be up to 72.2Mbps which OFDM technique. If the signal to noise radio is too poor which could not support 72.2Mbps, the 11Mbps data rate with DSSS technique will be applied. The transmitter of the EUT is powered by 5Vdc AC adapter or host equipment. The antenna is Printed antenna withourt antenna connector. For more detailed instruction, please take a look at the user’s manual.

Report No.: SA121218C03A 1 of 6 Report Format Version 5.0.0 Reference No.: 130305C16 RF EXPOSURE REPORT REPORT NO.: SA121218C03A MODEL NO.: DSM-232 FCC ID: KA2SM232A1 RECEIVED: Mar. 05, 2013 TESTED: Mar. 15, 2013 ISSUED: Mar. 21, 2013 APPLICANT: D-Link Corporation ADDRESS: 17595 Mt. Hermann, Fountain Valley, CA 92708, U.S.A. ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB ADDRESS: No. 47, 14th Ling, Chia Pau Vil., Lin Kou Dist., New Taipei City, Taiwan, R.O.C. TEST LOCATION: No. 19, Hwa Ya 2nd Rd, Wen Hwa Tsuen, Kwei Shan Hsiang, Taoyuan Hsien 333, Taiwan, R.O.C. This report is for your exclusive use. Any copying or replication of this report to or for any other person or entity, or use of our name or trademark, is permitted only with our prior written permission. This report sets forth our findings solely with respect to the test samples identified herein. The results set forth in this report are not indicative or representative of the quality or characteristics of the lot from which a test sample was taken or any similar or identical product unless specifically and expressly noted. Our report includes all of the tests requested by you and the results thereof based upon the information that you provided to us. You have 60 days from date of issuance of this report to notify us of any material error or omission caused by our negligence, provided, however, that such notice shall be in writing and shall specifically address the issue you wish to raise. A failure to raise such issue within the prescribed time shall constitute your unqualified acceptance of the completeness of this report, the tests conducted and the correctness of the report contents. Unless specific mention, the uncertainty of measurement has been explicitly taken into account to declare the compliance or non-com pliance to the specification. This report should not be used by the client to claim product certification, approval, or endorsement by any government agencies. Report No.: SA121218C03A 2 of 6 Report Format Version 5.0.0 Reference No.: 130305C16 TABLE OF CONTENTS RELEASE CONTROL RECORD ................................................................................................ 3 1. CERTIFICATION ............................................................................................................. 4 2. RF EXPOSURE ............................................................................................................... 5 2.1 LIMITS FOR MAXIMUM PERMISSIBLE EXPOSURE (MPE) ......................................... 5 2.2 MPE CALCULATION FORMULA .................................................................................... 5 2.3 CLASSIFICATION ........................................................................................................... 5 2.4 CALCULATION RESULT OF MAXIMUM CONDUCTED POWER .................................. 6 Report No.: SA121218C03A 3 of 6 Report Format Version 5.0.0 Reference No.: 130305C16 RELEASE CONTROL RECORD ISSUE NO. REASON FOR CHANGE DATE ISSUED SA121218C03A Original release. Mar. 21, 2013 Report No.: SA121218C03A 4 of 6 Report Format Version 5.0.0 Reference No.: 130305C16 1. CERTIFICATION PRODUCT: G-cluster MODEL: DSM-232 BRAND: G-cluster APPLICANT: D-Link Corporation TESTED: Mar. 15, 2013 TEST SAMPLE: ENGINEERING SAMPLE STANDARDS: FCC Part 2 (Section 2.1091) FCC OET Bulletin 65, Supplement C (01-01) IEEE C95.1 The above equipment (Model: DSM-232) has been tested by Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch, and found compliance with the requirement of the above standards. The test record, data evaluation & Equipment Under Test (EUT) configurations represented herein are true and accurate accounts of the measurements of the sample’s EMC characteristics under the conditions specified in this report. PREPARED BY : , DATE : Mar. 21, 2013 Suntee Liu / Specialist APPROVED BY : , DATE : Mar. 21, 2013 Ken Liu / Senior Manager Report No.: SA121218C03A 5 of 6 Report Format Version 5.0.0 Reference No.: 130305C16 2. RF EXPOSURE 2.1 LIMITS FOR MAXIMUM PERMISSIBLE EXPOSURE (MPE) FREQUENCY RANGE (MHz) ELECTRIC FIELD STRENGTH (V/m) MAGNETIC FIELD STRENGTH (A/m) POWER DENSITY (mW/cm 2 ) AVERAGE TIME (minutes) LIMITS FOR GENERAL POPULATION / UNCONTROLLED EXPOSURE 300-1500 ... ... F/1500 30 1500-100,000 ... ... 1.0 30 F = Frequency in MHz 2.2 MPE CALCULATION FORMULA Pd = (Pout*G) / (4*pi*r2) where Pd = power density in mW/cm2 Pout = output power to antenna in mW G = gain of antenna in linear scale Pi = 3.1416 R = distance between observation point and center of the radiator in cm 2.3 CLASSIFICATION The antenna of this product, under normal use condition, is at least 20cm away from the body of the user. So, this device is classified as Mobile Device. Report No.: SA121218C03A 6 of 6 Report Format Version 5.0.0 Reference No.: 130305C16 2.4 CALCULATION RESULT OF MAXIMUM CONDUCTED POWER MAX POWER (dBm) ANTENNA GAIN (dBi) DISTANCE (cm) POWER DENSITY (mW/cm 2 ) LIMIT (mW/cm 2 ) 23.31 1.96 20 0.067 1

Report No.: RF121218C03A 1 of 50 Report Format Version 5.1.0 Reference No.: 130305C16 FCC TEST REPORT REPORT NO.: RF121218C03A MODEL NO.: DSM-232 FCC ID: KA2SM232A1 RECEIVED: Mar. 05, 2013 TESTED: Mar. 15, 2013 ISSUED: Mar. 21, 2013 APPLICANT: D-Link Corporation ADDRESS: 17595 Mt. Hermann, Fountain Valley, CA 92708, U.S.A. ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB ADDRESS: No. 47, 14th Ling, Chia Pau Vil., Lin Kou Dist., New Taipei City, Taiwan, R.O.C. TEST LOCATION: No. 19, Hwa Ya 2nd Rd, Wen Hwa Tsuen, Kwei Shan Hsiang, Taoyuan Hsien 333, Taiwan, R.O.C. This report is for your exclusive use. Any copying or replication of this report to or for any other person or entity, or use of our name or trademark, is permitted only with our prior written permission. This report sets forth our findings solely with respect to the test samples identified herein. The results set forth in this report are not indicative or representative of the quality or characteristics of the lot from which a test sample was taken or any similar or identical product unless specifically and expressly noted. Our report includes all of the tests requested by you and the results thereof based upon the information that you provided to us. You have 60 days from date of issuance of this report to notify us of any material error or omission caused by our negligence, provided, however, that such notice shall be in writing and shall specifically address the issue you wish to raise. A failure to raise such issue within the prescribed time shall constitute your unqualified acceptance of the completeness of this report, the tests conducted and the correctness of the report contents. Unless specific mention, the uncertainty of measurement has been explicitly taken into account to declare the com pliance or non-compliance to the specification. This report should not be used by the client to claim product certification, approval, or endorsement by TAF or any government agencies. Report No.: RF121218C03A 2 of 50 Report Format Version 5.1.0 Reference No.: 130305C16 TABLE OF CONTENTS RELEASE CONTROL RECORD ............................................................................................................ 4 1. CERTIFICATION ..................................................................................................................... 5 2. SUMMARY OF TEST RESULTS ............................................................................................ 6 2.1 MEASUREMENT UNCERTAINTY .......................................................................................... 6 3. GENERAL INFORMATION ..................................................................................................... 7 3.1 GENERAL DESCRIPTION OF EUT ....................................................................................... 7 3.2 DESCRIPTION OF TEST MODES ......................................................................................... 8 3.2.1 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL ......................................... 9 3.3 DESCRIPTION OF SUPPORT UNITS ................................................................................. 11 3.3.1 CONFIGURATION OF SYSTEM UNDER TEST .................................................................. 12 3.4 GENERAL DESCRIPTION OF APPLIED STANDARDS ...................................................... 13 4. TEST TYPES AND RESULTS .............................................................................................. 14 4.1 RADIATED EMISSION AND BANDEDGE MEASUREMENT ............................................... 14 4.1.1 LIMITS OF RADIATED EMISSION AND BANDEDGE MEASUREMENT ............................ 14 4.1.2 TEST INSTRUMENTS .......................................................................................................... 15 4.1.3 TEST PROCEDURES ........................................................................................................... 16 4.1.4 DEVIATION FROM TEST STANDARD ................................................................................. 16 4.1.5 TEST SETUP ........................................................................................................................ 17 4.1.6 EUT OPERATING CONDITIONS ......................................................................................... 17 4.1.7 TEST RESULT ...................................................................................................................... 18 4.2 CONDUCTED EMISSION MEASUREMENT ....................................................................... 29 4.2.1 LIMITS OF CONDUCTED EMISSION MEASUREMENT ..................................................... 29 4.2.2 TEST INSTRUMENTS .......................................................................................................... 29 4.2.3 TEST PROCEDURES ........................................................................................................... 30 4.2.4 DEVIATION FROM TEST STANDARD ................................................................................. 30 4.2.5 TEST SETUP ........................................................................................................................ 30 4.2.6 EUT OPERATING CONDITIONS ......................................................................................... 30 4.2.7 TEST RESULTS .................................................................................................................... 31 4.3 6DB BANDWIDTH MEASUREMENT ................................................................................... 35 4.3.1 LIMITS OF 6DB BANDWIDTH MEASUREMENT ................................................................. 35 4.3.2 TEST SETUP ........................................................................................................................ 35 4.3.3 TEST INSTRUMENTS ......................................................................…

Text truncated - open the document above for the full version.

1 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST (Test Mode A) 2 CONDUCTED EMISSION TEST (Test Mode B) 3 RADIATED EMISSION TEST (Test Mode A) 4 RADIATED EMISSION TEST (Test Mode B)