KA2WL3600APA1802.11n single band Unified Access Point

©Copyright 2011. All rights reserved. Unified Access Point Administrator's Guide Product Model: DWL-3600AP DWL-6600AP DWL-8600AP Unified Wired & Wireless Access System Release 2.0 November 2011 D-LinkUnified Access Point Administrator’s Guide November 2011Page 2 Unified Access Point Administrator’s Guide D-LinkUnified Access Point Administrator’s Guide November 2011Page 3 Unified Access Point Administrator’s Guide Table of Contents Section 1: About This Document .....................................................................................12 Document Organization...............................................................................................................................12 Additional Documentation...........................................................................................................................12 Document Conventions................................................................................................................................13 Online Help, Supported Browsers, and Limitations....................................................................................14 Section 2: Getting Started ...............................................................................................15 Administrator’s Computer Requirements...................................................................................................16 Wireless Client Requirements......................................................................................................................17 Dynamic and Static IP Addressing on the AP...............................................................................................17 Recovering an IP Address.......................................................................................................................18 Discovering a Dynamically Assigned IP Address ....................................................................................18 Installing the UAP.........................................................................................................................................19 Basic Settings................................................................................................................................................22 Connecting to the AP Web Interface by Using the IPv6 Address...........................................................24 Using the CLI to View the IP Address...........................................................................................................24 Configuring the Ethernet Set tings................................................................................................................25 Using the CLI to Configure Ethernet Settings.........................................................................................26 Configuring IEEE 802.1X Authentication......................................................................................................27 Using the CLI to Configure 802.1X Authentication Information ............................................................27 Verifying the Installation..............................................................................................................................28 Configuring Security on the Wireless Access Point.....................................................................................29 Section 3: Viewing Access Point Status............................................................................30 Viewing Interface Status..............................................................................................................................31 Wired Settings (Internal Interface) ........................................................................................................31 Wireless Settings....................................................................................................................................31 Viewing Events.............................................................................................................................................32 Configuring Persistent Logging Options.................................................................................................32 Configuring the Log Relay Host for Kernel Messages ............................................................................34 Enabling or Disabling the Log Relay Host on the Events Page...............................................................34 Viewing Transmit and Receive Statistics.....................................................................................................36 Viewing Associated Wireless Client Information........................................................................................38 Viewing TSPEC Client Associations..............................................................................................................39 Link Integrity Monitoring .......................................................................................................................41 Viewing Rogue AP Det ection.......................................................................................................................41 D-LinkUnified Access Point Administrator’s Guide November 2011Page 4 Unified Access Point Administrator’s Guide Saving and Importing the Known AP List...............................................................................................44 Viewing Managed AP DHCP Information.....................................................................................................45 Viewing TSPEC Status and Statistics Information........................................................................................45 Viewing TSPEC AP Statistics Information.....................................................................................................47 Viewing Radio Statistics Information....................................................…

Text truncated - open the document above for the full version.

Report No.: 110927E06 1 CONSTRUCTION PHOTOS OF EUT Report No.: 110927E06 2 Adapter: AMS3-0502500FU Report No.: 110927E06 3 Adapter: CF1505-B Report No.: 110927E06 4 Report No.: 110927E06 5

Label Drawing Label location

Report No.: 110927E06 6 Report No.: 110927E06 7 Report No.: 110927E06 8 Report No.: 110927E06 9 Report No.: 110927E06 10

Report No.: SA110927E06 Report Format Version 4.0.0. 1 RF EXPOSURE REPORT REPORT NO.: SA110927E06 MODEL NO.: DWL-3600AP, DWL-3600AP(PC) FCC ID: KA2WL3600APA1 RECEIVED: Sep. 27, 2011 TESTED: Oct. 22, 2011 ISSUED: Dec. 01, 2011 APPLICANT: D-Link Corporation ADDRESS: No.289, Sinhu 3rd Rd., Neihu District, Taipei City 114, Taiwan, R.O.C. ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch Hsin Chu Laboratory LAB ADDRESS: No. 81-1, Lu Liao Keng, 9th Ling, Wu Lung Tsuen, Chiung Lin Hsiang, Hsin Chu Hsien 307, Taiwan This test report consists of 6 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced, except in full, without the written approval of our laboratory. The client should not use it to claim product certification, approval or endorsement by any government agency. The test results in the report only apply to the tested sample. Report No.: SA110927E06 Report Format Version 4.0.0. 2 TABLE OF CONTENTS RELEASE CONTROL RECORD....................................................................................3 1. CERTIFICATION.....................................................................................................4 2. RF EXPOSURE LIMIT.............................................................................................5 3. MPE CALCULATION FORMULA............................................................................5 4. CLASSIFICATION...................................................................................................5 5. CALCULATION RESULT OF MAXIMUM CONDUCTED POWER..........................6 Report No.: SA110927E06 Report Format Version 4.0.0. 3 RELEASE CONTROL RECORD ISSUE NO. REASON FOR CHANGE DATE ISSUED SA110927E06 Original release Dec. 01, 2011 Report No.: SA110927E06 Report Format Version 4.0.0. 4 1.CERTIFICATION PRODUCT: 802.11n single band Unified Access Point BRAND NAME: D-Link MODEL NO.: DWL-3600AP, DWL-3600AP(PC) TEST SAMPLE: MASS-PRODUCTION TESTED: Oct. 22, 2011 APPLICANT: D-Link Corporation STANDARDS: FCC Part 2 (Section 2.1091) FCC OET Bulletin 65, Supplement C (01-01) IEEE C95.1 The above equipment (Model: DWL-3600AP) has been tested by Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch, and found compliance with the requirement of the above standards. The test record, data evaluation & Equipment Under Test (EUT) configurations represented herein are true and accurate accounts of the measurements of the sample’s EMC characteristics under the conditions specified in this report. PREPARED BY : , DATE: Dec. 01, 2011 ( Claire Kuan, Specialist) APPROVED BY : , DATE: Dec. 01, 2011 ( May Chen, Deputy Manager ) Report No.: SA110927E06 Report Format Version 4.0.0. 5 2. RF EXPOSURE LIMIT LIMITS FOR MAXIMUM PERMISSIBLE EXPOSURE (MPE) FREQUENCY RANGE (MHz) ELECTRIC FIELD STRENGTH (V/m) MAGNETIC FIELD STRENGTH (A/m) POWER DENSITY (mW/cm 2 ) AVERAGE TIME (minutes) LIMITS FOR GENERAL POPULATION / UNCONTROLLED EXPOSURE 300-1500 ... ... F/1500 30 1500-100,000 ... ... 1.0 30 F = Frequency in MHz 3. MPE CALCULATION FORMULA Pd = (Pout*G) / (4*pi*r 2 ) where Pd = power density in mW/cm 2 Pout = output power to antenna in mW G = gain of antenna in linear scale Pi = 3.1416 R = distance between observation point and center of the radiator in cm 4. CLASSIFICATION The antenna of this product, under normal use condition, is at least 20cm away from the body of the user. So, this device is classified as Mobile Device. 5.Antenna Gain There are two antennas provided to this EUT, please refer to the following table: Transmitter Circuit Manufacturer Model No. Antenna Type Gain (dBi) Antenna Connector Chain (0) WHA YU GROUP C037-511129-AW1 PIFA 5.8 I-PEX Chain (1) WHA YU GROUP C037-511129-AW2 PIFA 5.3 I-PEX The EUT incorporates CDD function with 802.11g. Report No.: SA110927E06 Report Format Version 4.0.0. 6 6. CALCULATION RESULT OF MAXIMUM CONDUCTED POWER For WLAN: 15.247(2.4GHz) 802.11b: FREQUENCY BAND (MHz) MAX POWER (mW) ANTENNA GAIN (dBi) DISTANCE (cm) POWER DENSITY (mW/ cm 2 ) LIMIT (mW/cm 2 ) 2412-2462 380.2 5.8 20 0.288 1.00 802.11g: FREQUENCY BAND (MHz) MAX POWER (mW) ANTENNA GAIN (dBi) DISTANCE (cm) POWER DENSITY (mW/ cm 2 ) LIMIT (mW/cm 2 ) 2412-2462 533.0 8.6 20 0.768 1.00 Directional gain = 10 log[(10 G1/20 + 10 G2/20 ) 2 / 2] Effective Legacy Gain (dBi)=8.6 802.11n(20MHz): FREQUENCY BAND (MHz) MAX POWER (mW) ANTENNA GAIN (dBi) DISTANCE (cm) POWER DENSITY (mW/ cm 2 ) LIMIT (mW/cm 2 ) 2412-2462 876.7 5.8 20 0.663 1.00 802.11n(40MHz): FREQUENCY BAND (MHz) MAX POWER (mW) ANTENNA GAIN (dBi) DISTANCE (cm) POWER DENSITY (mW/ cm 2 ) LIMIT (mW/cm 2 ) 2422-2452 279.4 5.8 20 0.211 1.00 ---END---

Report No.: RF110927E06 1 Report Format Version 4.0.0 FCC TEST REPORT REPORT NO.: RF110927E06 MODEL NO.: DWL-3600AP, DWL-3600AP(PC) FCC ID: KA2WL3600APA1 RECEIVED: Sep. 27, 2011 TESTED: Oct. 04 to 27, 2011 ISSUED: Dec. 01, 2011 APPLICANT: D-Link Corporation ADDRESS: No.289, Sinhu 3rd Rd., Neihu District, Taipei City 114, Taiwan, R.O.C. ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch Hsin Chu Laboratory LAB ADDRESS : No. 81-1, Lu Liao Keng, 9th Ling,Wu Lung Tsuen, Chiung Lin Hsiang, Hsin Chu Hsien 307, Taiwan This test report consists of 84 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product certification, approval, or endorsement by TAF or any government agencies. The test results in the report only apply to the tested sample. Report No.: RF110927E06 2 Report Format Version 4.0.0 Table of Contents RELEASE CONTROL RECORD........................................................................................4 1. CERTIFICATION....................................................................................................5 2. SUMMARY OF TEST RESULTS............................................................................6 2.1 MEASUREMENT UNCERTAINTY..........................................................................7 3. GENERAL INFORMATION.....................................................................................8 3.1 GENERAL DESCRIPTION OF EUT.......................................................................8 3.2 DESCRIPTION OF TEST MODES.......................................................................10 3.2.1 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL........................11 3.3 GENERAL DESCRIPTION OF APPLIED STANDARDS.......................................14 3.4 DESCRIPTION OF SUPPORT UNITS..................................................................15 3.5 CONFIGURATION OF SYSTEM UNDER TEST...................................................16 4. TEST TYPES AND RESULTS..............................................................................18 4.1 CONDUCTED EMISSION MEASUREMENT........................................................18 4.1.1 LIMITS OF CONDUCTED EMISSION MEASUREMENT......................................18 4.1.2 TEST INSTRUMENTS..........................................................................................18 4.1.3 TEST PROCEDURES..........................................................................................19 4.1.4 DEVIATION FROM TEST STANDARD.................................................................19 4.1.5 TEST SETUP.......................................................................................................20 4.1.6 EUT OPERATING CONDITIONS.........................................................................20 4.1.7 TEST RESULTS (With adapter 1).........................................................................21 4.1.8 TEST RESULTS (With adapter 2).........................................................................23 4.2 RADIATED EMISSION MEASUREMENT.............................................................27 4.2.1 LIMITS OF RADIATED EMISSION MEASUREMENT...........................................27 4.2.2 TEST INSTRUMENTS..........................................................................................28 4.2.3 TEST PROCEDURES..........................................................................................29 4.2.4 DEVIATION FROM TEST STANDARD.................................................................29 4.2.5 TEST SETUP.......................................................................................................30 4.2.6 EUT OPERATING CONDITIONS.........................................................................30 4.2.7 TEST RESULTS...................................................................................................31 4.3 6dB BANDWIDTH MEASUREMENT....................................................................60 4.3.1 LIMITS OF 6dB BANDWIDTH MEASUREMENT..................................................60 4.3.2 TEST INSTRUMENTS..........................................................................................60 4.3.3 TEST PROCEDURE.............................................................................................60 4.3.4 DEVIATION FROM TEST STANDARD.................................................................60 4.3.5 TEST SETUP.......................................................................................................60 4.3.6 EUT OPERATING CONDITIONS.........................................................................60 4.3.7 TEST RESULTS...................................................................................................61 4.4 MAXIMUM PEAK OUTPUT POWER....................................................................65 4.4.1 LIMITS OF MAXIMUM PEAK OUTPUT POWER MEASUREMENT.....................65 4.4.2 INSTRUMENTS....................................................................................................65 Report No.: RF110927E06 3 Report Format Version 4.0.0 4.4.3 TEST PROCEDURES..........................................................................................65 4.4.4 DEVIATION FROM TEST STANDARD.................................................................65 4.4.5 TEST SETUP.......................................................................................................66 4.4.6 EUT OPERATING CONDITIONS.........................................................................66 4.4.7 TEST RESULTS...................................................................................................67 4.5 POWER SPECTRAL DENSITY MEASUREMENT................................................69 4.5.1 LIMITS OF POWER SPECTRAL DENSITY MEASUREME…

Text truncated - open the document above for the full version.

Report No.: 110927E06 1 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST(Mode 1~2) Report No.: 110927E06 2 CONDUCTED EMISSION TEST(Mode 3) Report No.: 110927E06 3 RADIATED EMISSION TEST