KPB-VMT-F2Digital 100mW Transmitter

Exhibit_Identification of Equipment Labels (figures 1-3) Note: Unit is too small for FCC part 15 warning label. The warning is placed into the Operational Manual. Figure 1 FCC ID label attached to rear of transmitter Figure 2 Product description and operating frequency range label Figure 3 Model number and serial number label

Exhibit internal pictures of DUT VMT, Figures 1- 7 Figure 1 Solder Side View SD-SDI interface board 700-A1009X1-G Figure 2 Component Side View SD- SDI interface board 700-A1009X1-G Figure 3 Component Side View Rotary Switch interface board 700-A1057-G Figure 4 Solder Side View Rotary Switch interface board 700-A1057-G Figure 5 Soldered Side View main board Assy, VMT 700-A0985X3A-G Figure 6 Component Side View main board Assy, VMT 700-A0985X3A-G Figure 7 Component Side View main board Assy,(700-A0985X3A-G) with SD-SDI interface board (700-A1009X1-G) and Rotary Switch interface board (700-A1057-G) SD-SDI interface board Rotary Switch interface Board Main Board

Evaluation of MPE limit at a given distance Equation from page 18 of OET Bulletin 65, Edition 97-01 where:S = power density P = power input to the antenna G = power gain of the antenna in the direction of interest relative to an isotropic radiator R = distance to the center of radiation of the antenna Maximum peak output power --Conducted21.29 dBm 0.135(W) Antenna gain(typical):2.00(dBi) Maximum antenna gain:1.58(numeric) Evaluation distance:20.00(cm) Evaluation frequency:2472.00(MHz) Limit from table below:1 (mW/cm^2) Power density at Evaluation frequency:0.042(mW/cm^2) EUT complies FCC/LSGAC Local Official’s Guide to RF A LOCAL GOVERNMENT OFFICIAL'S GUIDE TO TRANSMITTING ANTENNA RF EMISSION SAFETY: RULES, PROCEDURES, AND PRACTICAL GUIDANCE 2 4R PG S  

Setup Photo for Radiated Spurious Emissions Testing: Setup Photo for Conducted Testing: