LTQFO4AM902TRXTPMS Receiver & RKE Transceiver

Document Title: BI-NEU RTM Homologation Description Page 1 / 5 BI-NEU Radio Transceiver Module (RTM) Homologation Document Part Number: DG9T-15K619-CF Table of Content 1. Preface ______________________________________________________________________________ 2 2. Configuration and Identification of Equipment Under Test (EUT)______________________________ 3 2.1 Description ______________________________________________________________________ 3 2.2 Identification-Labeling _____________________________________________________________ 3 2.3 Operation Declarations ____________________________________________________________ 3 2.3.1 Modes of Operation ______________________________________________________________ 4 2.3.2 Variants ________________________________________________________________________ 5 2.4 EUT Samples & Configuration_______________________________________________________ 5 2.4.1 Functional Configuration/Operation Modifications _______________________________________ 5 2.4.2 Production Intent _________________________________________________________________ 5 Document Title: BI-NEU RTM Homologation Description Page 2 / 5 1. Preface This document provides an overview of the North American Bi-Directional Radio Transceiver Module for Homologation Testing „NOTICE: This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. NOTICE: Changes or modifications made to this equipment not expressly approved by (manufacturer name) may void the FCC authorization to operate this equipment.” Document Title: BI-NEU RTM Homologation Description Page 3 / 5 2. Configuration and Identification of Equipment Under Test (EUT) 2.1 Description The EUT contains circuitry and software in order to receive Long range RF data from vehicle equipped Remote Keyless Entry Transmitters and short range RF data from Tire Pressure Wheel Sensors. The EUT demodulates and determines whether the demodulated data should be sent to vehicle Body Control Module via a dedicated vehicle serial bus. This EUT also generates RF data messages using vehicle status information from the CAN serial bus for long range RF transmissions to the Remote Keyless Entry transmitters based upon receipt of a Data request RF message. The following are pictures of the EUT: <Take & Insert Top & Bottom pictures of 902MHz BI-NEU Module (with housing)> <Take & Insert picture of 902MHz BI-NEU PCB top side and bottom side> 2.2 Identification-Labeling The following figures define the identification labeling for the EUT: <Take & Insert Picture of BI-NEU Label attached to housing> <Take & Insert Clear pictures of Text that is molded into the various sides of the BI Housing> 2.3 Operation Declarations The following table provides general operation declaration information for the EUT: Document Title: BI-NEU RTM Homologation Description Page 4 / 5 Equipment Type RF Receiver Country of Origin: Mexico Operating Voltage 7.0VDC to 24VDC 8.0 VDC to 16VDC (Nominal) Operating Temperature -40 deg C to + 105deg C Operating Freq Range 902.425 MHz +/- 210kHz (RKE Channel 1) 902.375 MHz +/- 210kHz (RKE Channel 2) 903.425MHz +/- 360kHz (PEPS Channel) 315.000 MHz +/- 360 kHz (TPM) Modulation FSK w/ + 7.5kHz Deviation (RKE) FSK w/ + 15kHz (PEPS) ASK (TPM) FSK w/ +35kHz deviation (TPM) RX Data Frame Size 105 bits (RKE) 80 bits (TPM) 85 bits to 160 bits (PEPS) RX Data Rate 2.1kbps +/- 0.4% (RKE) 9.6 kbps +/- 0.4% (TPM) 9.6 kbps +/- 0.4% (PEPS) RX Data Encoding Manchester Antenna Type: Integral Diversity antenna structure for RKE and single antenna for TPM reception (Insert dimensions from part dwg) TX Operating Freq Range 902.425 MHz +/- 40kHz (RKE Channel 1) 902.375 MHz +/- 40kHz (RKE Channel 2) Antenna Gain N/A TX Data Frame Size 37 bits TX Modulation OOK TX Data Encoding Manchester TX Data Rate 1.95kHz +/- 0.4% 2.3.1 Modes of Operation The EUT is powered via a fused feed from the vehicle battery power distribution center and the feed is always active. 2.3.1.1 Receive The EUT has two modes of Receiver operation depending upon the vehicle status: Receiver is periodically activated and deactivated (Polling mode) whenever the RTM is not awake and the vehicle CAN serial bus is asleep. o Note: Polling operation requires RKE Fob ID’s to be learned and/or TPM functionality to be enabled. Receiver is continuously active whenever RTM is awake or vehicle CAN serial bus is awake. 2.3.1.2 Transmit The EUT transmit operation is activated whenever a valid received RF data message contains a Vehicle status request action code. TX mode is terminated when the message has been transmitted. RX mode will not be active when the EUT TX mode is in operation. Vehicle status request transmission from RKE Fob occurs either following a vehicle Remote Start or Stop request or after a certain period of time expires following the receipt of a function pending status request. Document Title: BI-NEU RTM Homologation Description Page 5 / 5 2.3.2 Variants The EUT only supports one configuration setting $DE00 = 0x1 2.4 EUT Samples & Configuration One unmodified sample, one receive test sample for low band reception (315MHz), one receive test sample for high band reception (903MHz) and eight transmit test samples were provided to the homologation vendor for certification testing and approval in the countries defined in the statement of work. 2.4.1 Functional Config…

Text truncated - open the document above for the full version.

Test report no.: 1-3570/11-01-03 2012-04-19 Page 45 of 54 Annex B External photographs of the EUT Photo documentation: Photo 1: Photo 2: Test report no.: 1-3570/11-01-03 2012-04-19 Page 46 of 54 Photo 3: Photo 4: Test report no.: 1-3570/11-01-03 2012-04-19 Page 47 of 54 Photo 5: Photo 6: Test report no.: 1-3570/11-01-03 2012-04-19 Page 48 of 54 Photo 7: Photo 8:

Test report no.: 1-3570/11-01-03 2012-04-19 Page 50 of 54 Annex C Internal photographs of the EUT Photo documentation: Photo 1: Photo 2: Test report no.: 1-3570/11-01-03 2012-04-19 Page 51 of 54 Photo 3: Photo 4: Test report no.: 1-3570/11-01-03 2012-04-19 Page 52 of 54 Photo 5:

2012-05-30 Page 1 of 54 TEST REPORT Test report no.: 1-3570/11-01-03-B Testing laboratory Applicant CETECOM ICT Services GmbH Untertuerkheimer Strasse 6 – 10 66117 Saarbruecken / Germany Phone: + 49 681 5 98 - 0 Fax: + 49 681 5 98 - 9075 Internet: http://www.cetecom.com e-mail: [email protected] Accredited Testing Laboratory: The testing laboratory (area of testing) is accredited according to DIN EN ISO/IEC 17025 (2005) by the Deutsche Akkreditierungsstelle GmbH (DAkkS) The accreditation is valid for the scope of testing procedures as stated in the accreditation certificate with the registration number: D-PL-12076-01-01 Area of Testing: Radio/Satellite Communications DELPHI DEUTSCHLAND GmbH Delphiplatz 1 42119 Wuppertal / GERMANY Fax: +49 2261 97-2351 Contact: Achim Göckener e-mail: [email protected] Phone: +49 2261 97-1351 Manufacturer Delphi Delco Elecronics de Mexico S. de R.L. de C.V. Avenida Fomento Industrial SN. Parque Industrial del Norte PLZ Reybosa Tamaulipas 88736 / MEXICO Test standard/s 47 CFR Part 15 Title 47 of the Code of Federal Regulations; Chapter I Part 15 - Radio frequency devices RSS - 210 Issue 8 Spectrum Management and Telecommunications - Radio Standards Specification Low-power Licence-exempt Radiocommunication Devices (All Frequency Bands): Category I Equipment For further applied test standards please refer to section 3 of this test report. Test Item Kind of test item: TPMS Receiver & RKE Transceiver Model name: FO4 FCC ID: LTQFO4AM902TRX IC: 3659A‐FO4AM902TRX Frequency range: 902.335 – 903.465 MHz Technology tested: Modulated carrier Antenna: Internal antenna Power Supply: 12.50 V DC by power supply Temperature Range: -40°C to +105 °C This test report is electronically signed and valid without handwriting signature. For verification of the electronic signatures, the public keys can be requested at the testing laboratory. Test report authorised: Test performed: Marco Bertolino Tobias Wittenmeier Testing Manager Test report no.: 1-3570/11-01-03-B 2012-05-30 Page 2 of 54 1 Table of contents 1 Table of contents ............................................................................................................................................ 2 2 General information ....................................................................................................................................... 3 2.1 Notes and disclaimer .......................................................................................................................... 3 2.2 Application details ............................................................................................................................... 3 3 Test standard/s ............................................................................................................................................... 3 4 Test environment ............................................................................................................................................ 4 5 Test item .......................................................................................................................................................... 4 6 Test laboratories sub-contracted ................................................................................................................. 4 7 Summary of measurement results ............................................................................................................... 5 8 RF measurement testing ............................................................................................................................... 6 8.1 Description of test setup .................................................................................................................... 6 8.1.1 Radiated measurements............................................................................................................. 6 8.1.2 Conducted measurements.......................................................................................................... 7 8.2 Additional comments .......................................................................................................................... 7 8.3 RSP100 test report cover sheet / performance test data ................................................................ 8 9 Measurement results ...................................................................................................................................... 9 9.1 Timing of the transmitter .................................................................................................................... 9 9.2 Switch off time ................................................................................................................................... 12 9.3 Emission bandwidth .......................................................................................................................... 13 9.4 Field strength of the fundamental ................................................................................................... 18 9.5 Field strength of the harmonics and spurious ............................................................................... 20 9.6 Receiver spurious emission (radiated) ........................................................................................... 34 10 Test equipment and ancillaries used for tests ................................................................................... 38 11 Observations ......................................................................................................................................... 39 Annex A Photographs of the test setup ...................................................................................................... 40 Annex B External photographs of the EUT ................................................................................................. 45 Annex C Internal photographs of the EUT ...........................…

Text truncated - open the document above for the full version.

Test report no.: 1-3570/11-01-03-B 2012-05-30 Page 40 of 54 Annex A Photographs of the test setup Photo documentation: Photo 1: Photo 2: Test report no.: 1-3570/11-01-03-B 2012-05-30 Page 41 of 54 Photo 3: Photo 4: Test report no.: 1-3570/11-01-03-B 2012-05-30 Page 42 of 54 Photo 5: Photo 6: Test report no.: 1-3570/11-01-03-B 2012-05-30 Page 43 of 54 Photo 7: Photo 8: Test report no.: 1-3570/11-01-03-B 2012-05-30 Page 44 of 54 Photo 9: